PatchFirst · Latest vulnerabilities
Vulnerabilities published for linux-hwe-6.2 in the last 30 days: 1054. Listed in the KEV catalogue: 0.
Vulnerabilities: 18743
In the Linux kernel, the following vulnerability has been resolved: riscv, bpf: Fix kernel stack corruption in tailcall with CFI When CONFIG_CFI_CLANG is enabled, prog->bpf_func already skips the kcfi instruction during setup. Including it again in the tailcall jump offset causes it to jump over an extra 4 bytes, skipping the stack pointer adjustment, which will result in kernel stack corruption.
In the Linux kernel, the following vulnerability has been resolved: bpf, riscv: Fix extable handling for arena load_acquire emit_atomic_ld_st() returns 1 to have build_body() skip the zext after a sub-word load_acquire. The caller does "ret = ret ?: add_exception_handler(...)", which skips add_exception_handler() on any non-zero ret, so the extable entry is missing and a faulting PROBE_ATOMIC load_acquire oopses. REG_DONT_CLEAR_MARKER leaves rd stale on fault, and the verifier still thinks the load overwrote it, so a program can leak it through a map. Check ret >= 0 before calling add_exception_handler(), and pass rd for LOAD_ACQ so the f
In the Linux kernel, the following vulnerability has been resolved: bpf: Fix offset warn check for bpf_res_spin_lock Sashiko pointed out correctly that the case statement for BPF_RES_SPIN_LOCK incorrectly checks offset for BPF_SPIN_LOCK. Fix it by checking res_spin_lock_off instead.
In the Linux kernel, the following vulnerability has been resolved: bpf: Preserve unique-field state across nested structs btf_find_struct_field() initializes a fresh seen mask for every recursive descent. Unique special fields in different levels of the same aggregate therefore do not see one another. The duplicate fields can reach btf_parse_fields(), where they trigger an invariant WARN_ON_ONCE(). A crafted user BTF can consequently trigger the warning before map creation checks capabilities. Initialize the seen mask once in btf_find_field() and pass the same pointer through struct, datasec, and nested-struct walks. This gives the entire
In the Linux kernel, the following vulnerability has been resolved: RDMA/erdma: Fix CEQ tasklet use-after-free on removal Each CEQ interrupt handler only schedules eqc->tasklet. The tasklet calls erdma_ceq_completion_handler(), which reads the DMA-coherent EQ ring through get_next_valid_eqe() and updates eq->dbrec through notify_eq(). erdma_ceqs_uninit() frees each CEQ IRQ and then destroys its EQ. free_irq() prevents another hard IRQ and waits for an in-flight handler, but it does not drain a tasklet that the handler already scheduled. The tasklet can therefore access eq->qbuf or eq->dbrec after erdma_eq_destroy() frees them. Clearing ce
In the Linux kernel, the following vulnerability has been resolved: RDMA/mana_ib: drain QP references after partial table insertion mana_table_store_ud_qp() publishes a QP at its send-queue id before inserting the receive-queue id, dropping the XArray lock between the two xa_insert_irq() calls. A concurrent completion handler can look up the QP and take a transient reference. When the second insertion fails, the rollback erased only the send-queue entry and returned, leaving both the initial table reference and the transient reference outstanding while RDMA core frees the QP, causing a use-after-free. Drain the reference as normal destruct
In the Linux kernel, the following vulnerability has been resolved: RDMA/core: Fix use after free in ib_query_qp() When querying a QP via the netlink flow the only synchronization mechanism for the said QP is rdma_restrack_get(), meanwhile during the QP destroy path rdma_restrack_del() is called at the end of the ib_destroy_qp_user() function which is too late, since by then the vendor specific resources for said QP would already be destroyed, and till the rdma_restrack_del() is called this QP can still be accessed, which could cause the use after free below. Fix this by moving the rdma_restrack_begin_del() to the start of the ib_destroy_q
In the Linux kernel, the following vulnerability has been resolved: RDMA/core: Fix potential use after free in ib_destroy_cq_user() When accessing a CQ via the netlink path the only synchronization mechanism for the said CQ is rdma_restrack_get(). Currently, rdma_restrack_del() is invoked at the end of ib_destroy_cq_user(), which is too late, since by that point vendor-specific resources associated with the CQ might already be freed. This can leave a short window where the CQ remains accessible through restrack, leading to a potential use-after-free. Fix this by moving the rdma_restrack_begin_del() call to the start of ib_destroy_cq_user()
In the Linux kernel, the following vulnerability has been resolved: RDMA/core: Fix potential use after free in ib_destroy_srq_user() When accessing a SRQ via the netlink path the only synchronization mechanism for the said SRQ is rdma_restrack_get(). Currently, rdma_restrack_del() is invoked at the end of ib_destroy_srq_user(), which is too late, since by that point vendor-specific resources associated with the SRQ might already be freed. This can leave a short window where the SRQ remains accessible through restrack, leading to a potential use-after-free. Fix this by moving the rdma_restrack_begin_del() call to the start of ib_destroy_srq
In the Linux kernel, the following vulnerability has been resolved: RDMA/core: Fix potential use after free in counter_release() When accessing a counter via the netlink path the only synchronization mechanism for the said counter is rdma_restrack_get(). Currently, rdma_restrack_del() is invoked at the end of counter_release(), which is too late, since by that point vendor-specific resources associated with the counter might already be freed. This can leave a short window where the counter remains accessible through restrack, leading to a potential use-after-free. Fix this by moving the rdma_restrack_del() call to be before the freeing of
In the Linux kernel, the following vulnerability has been resolved: RDMA/core: Fix potential use after free in ib_free_cq() When accessing a CQ via the netlink path the only synchronization mechanism for the said CQ is rdma_restrack_get(). Currently, rdma_restrack_del() is invoked at the end of ib_free_cq(), which is too late, since by that point vendor-specific resources associated with the CQ might already be freed. This can leave a short window where the CQ remains accessible through restrack, leading to a potential use-after-free. Fix this by moving the rdma_restrack_del() call to be before the freeing of the vendor-specific resources
In the Linux kernel, the following vulnerability has been resolved: RDMA/core: Fix potential use after free in ib_dealloc_pd_user() When accessing a PD via the netlink path the only synchronization mechanism for the said PD is rdma_restrack_get(). Currently, rdma_restrack_del() is invoked at the end of ib_dealloc_pd_user(), which is too late, since by that point vendor-specific resources associated with the PD might already be freed. This can leave a short window where the PD remains accessible through restrack, leading to a potential use-after-free. Fix this by moving the rdma_restrack_begin_del() call to the start of ib_dealloc_pd_user()
In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scmi: Fix requested device removal race scmi_protocol_device_unrequest() drops scmi_requested_devices_mtx while notifying listeners but continues to retain the per-protocol list head. When two SCMI drivers for the same protocol unregister concurrently, one thread can remove the final request and free the list head while the other is running its notifier. The latter then dereferences the freed list head after reacquiring the mutex and can free it a second time. Complete the list and IDR updates, including freeing an empty list head, before dropping the mutex.
In the Linux kernel, the following vulnerability has been resolved: iommu/amd: Fix undefined behavior in devid_write debugfs function When for_each_pci_segment() loop completes without finding a matching segment, the pci_seg pointer is not NULL but points to an invalid memory location (the list head). Accessing pci_seg->id after the loop causes undefined behavior. Fix this by handling the successful case inside the loop and returning -EINVAL after the loop if no matching segment is found.
In the Linux kernel, the following vulnerability has been resolved: thermal: intel: int3400: clean up ODVP on probe failures evaluate_odvp() creates per-ODVP sysfs files before the thermal zone and later probe resources are registered. The current unwind path only calls cleanup_odvp() from the late sysfs failure path, so failures after evaluate_odvp() but before that label, including thermal_tripless_zone_device_register() failures, leave the ODVP files and storage behind. Move the ODVP cleanup to the common ART/TRT unwind path so every failure after evaluate_odvp() releases the ODVP state. Also clear the cached ODVP pointers in cleanup_od
In the Linux kernel, the following vulnerability has been resolved: ext4: fix ABBA deadlock in ext4_xattr_inode_cache_find() Syzbot/stress-ng reported an ABBA deadlock in ext4 when exercising concurrent xattr workloads (using the ea_inode mount/format option). The deadlock occurs between the running transaction and the eviction thread: - Task 1 (stress-ng): Holds a reference to a shared mbcache_entry (ce) and calls ext4_xattr_inode_cache_find() -> ext4_iget() to retrieve the corresponding EA inode. Since the EA inode is currently being evicted, ext4_iget() blocks in __wait_on_freeing_inode() waiting for eviction to complete. - Task
In the Linux kernel, the following vulnerability has been resolved: ext4: clear stale xarray tags on folios skipped during writeback In data=journal mode, the writeback thread can hit the WARN_ON_ONCE(sb_rdonly(sb)) in ext4_journal_check_start() while the superblock is being remounted read-only during reboot: Workqueue: writeback wb_workfn (flush-253:0) RIP: 0010:ext4_journal_check_start+0x8b/0xd0 Call Trace: __ext4_journal_start_sb+0x3c/0x1e0 mpage_prepare_extent_to_map+0x4af/0x580 ext4_do_writepages+0x3c0/0x1080 ext4_writepages+0xc8/0x1a0 do_writepages+0xc4/0x180 __writeback_single_inode+0x45/0x2f0 writeback_sb_inodes+0x26b
In the Linux kernel, the following vulnerability has been resolved: ext4: drain in-flight DIO before buffered write fallback generic/746 started failing intermittently on ext3 (no-extent inodes). The test triggers 'Page cache invalidation failure on direct I/O' warnings and subsequent fsync returns -EIO. Adding a 50ms delay between ext4_buffered_write_iter() and filemap_write_and_wait_range() in ext4_dio_write_iter() makes the race almost always reproducible. On no-extent inodes, DIO writes to holes cannot use unwritten extents, so ext4_iomap_alloc() leaves m_flags=0 and ext4_map_blocks() returns 0. The iomap layer then returns -ENOTBLK, c
In the Linux kernel, the following vulnerability has been resolved: ext4: use fsdata to track inline data write state and fix race Instead of checking the live inode state (ext4_has_inline_data(inode) and ext4_test_inode_state(inode, EXT4_STATE_MAY_INLINE_DATA)) in the write_end handlers, use the fsdata parameter of the address space operations to explicitly pass down the state in which write_begin prepared the write. A concurrent thread (such as ext4_page_mkwrite()) can convert the inline data to an extent between write_begin and write_end. If this happens, the write_end handlers would previously miss the inline write_end path and fall th
In the Linux kernel, the following vulnerability has been resolved: ext4: validate readdir offset before accessing dirent A corrupted directory can trigger the following KASAN report when ext4_readdir() resumes from an invalid position: BUG: KASAN: use-after-free in __ext4_check_dir_entry+0x5ef/0x820 Read of size 2 at addr ffff88810a646000 by task repro_linear/509 Call Trace: <TASK> dump_stack_lvl+0x53/0x70 print_report+0xd0/0x630 kasan_report+0xce/0x100 __ext4_check_dir_entry+0x5ef/0x820 ext4_readdir+0xcde/0x2b70 iterate_dir+0x1a1/0x520 __x64_sys_getdents64+0x12b/0x220 do_syscall_64+0xf9/0x540 entry_SY
Check your installed stack and versions against the current vulnerability feeds.