net: bridge: stop fast-leave after deleting a port group
In the Linux kernel, the following vulnerability has been resolved:
net: bridge: stop fast-leave after deleting a port group
br_multicast_leave_group() iterates mp->ports with pp = &p->next in
its fast-leave path. After br_multicast_del_pg() removes p,
continuing the loop advances pp through the deleted entry.
If multicast-to-unicast was enabled, the bridge can hold multiple port
groups for the same port and group with different source MAC
addresses. Once multicast-to-unicast is disabled,
br_port_group_equal() matches those entries by port only. A fast leave
can then delete one entry and continue from its stale next pointer,
leaving mp->po
In the Linux kernel, the following vulnerability has been resolved:
net: pktgen: fix proc entry use-after-free
pktgen_change_name() replaces pkt_dev->entry while holding t->if_lock.
pktgen_remove_device() removes the same entry before
_rem_dev_from_if_list() takes that lock.
This allows the following interleaving:
CPU 0 (NETDEV_CHANGENAME) CPU 1 (kpktgend)
if_lock(t)
proc_remove(pkt_dev->entry)
proc_remove(pkt_dev->entry)
pkt_dev->entry = proc_create_data(...)
if_unlock(t)
The kthread can pass the stale proc_dir_entry to proc_remove() after the
rename path has freed it. A reproducer with
um: vector: fix use-after-free in vector_mmsg_rx()
In the Linux kernel, the following vulnerability has been resolved:
um: vector: fix use-after-free in vector_mmsg_rx()
When vector_mmsg_rx() discards a packet whose overlay header fails
verify_header(), it frees the skb and continues the loop:
if (header_check < 0) {
dev_kfree_skb_irq(skb);
vp->estats.rx_encaps_errors++;
continue;
}
The normal and short-packet paths fall through to the bottom of the
loop body, which clears the consumed slot and advances the cursors:
(*skbuff_vector) = NULL;
mmsg_vector++;
skbuff_vector++;
The verify_header() < 0 path skips that via continue, so the freed skb
is left in skbuff_vector[] and the
In the Linux kernel, the following vulnerability has been resolved:
veth: convert frag_list skbs before running XDP
A frag_list skb can reach veth with data_len set but nr_frags zero.
veth_convert_skb_to_xdp_buff() only converts skbs that are shared,
locked, have frags[], or do not have enough headroom. It later uses
skb_is_nonlinear() to decide whether to set XDP_FLAGS_HAS_FRAGS and
xdp_frags_size.
That exposes frag_list data to XDP as if it were stored in frags[], but
frags[] is empty. AF_XDP copy mode can then trust the bogus XDP fragment
metadata, walk an empty fragment entry, and crash in memcpy() from
__xsk_rcv().
Route non-linear s
vxlan: use neigh_ha_snapshot() in route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use neigh_ha_snapshot() in route_shortcircuit()
The neighbour hardware address n->ha can be updated asynchronously by the
neighbour subsystem, protected by n->ha_lock seqlock. Reading n->ha without
holding the seqlock loop can lead to torn reads or reading a partially updated
MAC address.
Use neigh_ha_snapshot() in route_shortcircuit() to safely copy n->ha under
read_seqbegin()/read_seqretry() lock protection before using it.
Note that arp_reduce() and neigh_reduce() seem to have the same issue
left for future patches.
vxlan: use pskb_network_may_pull() for transmit path header pulls
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use pskb_network_may_pull() for transmit path header pulls
In vxlan_xmit(), arp_reduce(), and vxlan_mdb_entry_skb_get(), pskb_may_pull() was
being called to verify the availability of network layer headers (ARP, IPv6/ND,
IP/IPv6 MDB keys).
However, during transmit skb->data points to the MAC header, so skb_network_offset(skb)
is ETH_HLEN (14 bytes). Using pskb_may_pull(skb, len) only checks len bytes from skb->data
rather than skb_network_offset(skb) + len, which can leave part of the network header
in non-linear frags.
Replace these remaining pskb_may_pull() calls
vxlan: use pskb_network_may_pull() in route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use pskb_network_may_pull() in route_shortcircuit()
route_shortcircuit() currently calls pskb_may_pull(skb, sizeof(struct iphdr))
(or ipv6hdr), which checks if bytes are available starting from skb->data.
However, in vxlan_xmit(), skb->data points to the MAC header, so
skb_network_offset(skb) is ETH_HLEN (14 bytes). Using pskb_may_pull(skb, 20)
only checks 20 bytes from skb->data (which is 14 bytes MAC header + 6 bytes of
IP header), leaving the rest of the IP header potentially un-pulled in non-linear
frags. Subsequent dereferences of ip_hdr(skb)->daddr can read be
ublk: reset kernel-owned dev_info fields in ublk_ctrl_add_dev()
In the Linux kernel, the following vulnerability has been resolved:
ublk: reset kernel-owned dev_info fields in ublk_ctrl_add_dev()
ublk_ctrl_add_dev() memcpy()s the userspace ublksrv_ctrl_dev_info into
ub->dev_info and then fixes up the fields the driver owns, but misses
->state and ->ublksrv_pid.
A device added with ->state = UBLK_S_DEV_LIVE passes the
"->state != UBLK_S_DEV_DEAD" test that ublk_stop_dev_unlocked() uses as its
proxy for "a disk is attached", while ->ub_disk is still NULL, so DEL_DEV
right after ADD_DEV oopses in del_gendisk(). UBLK_S_DEV_QUIESCED plus
UBLK_F_USER_RECOVERY dies one step earlier, in ublk_force_abort_dev()
tracing: Check return value of __register_event() in trace_module_add_events()
In the Linux kernel, the following vulnerability has been resolved:
tracing: Check return value of __register_event() in trace_module_add_events()
trace_module_add_events() ignores the return value of __register_event()
and unconditionally calls __add_event_to_tracers() for each event.
If __register_event() fails (for example, if event_init() fails), the
trace_event_call is not added to ftrace_events list, but
__add_event_to_tracers() still creates a trace_event_file pointing to it.
If module loading subsequently fails and module memory is freed, tracing
state retains a stale trace_event_call pointer in trace_event_file,
leading to a use-a
scsi: scsi_debug: Fix REPORT ZONES alloc_len underflow OOB write
In the Linux kernel, the following vulnerability has been resolved:
scsi: scsi_debug: Fix REPORT ZONES alloc_len underflow OOB write
resp_report_zones() sizes the reply buffer from the CDB allocation
length. The v3 fix rounds alloc_len up with ALIGN() before deriving the
descriptor count:
rep_max_zones = (ALIGN((u64)alloc_len, RZONES_DESC_HD) -
RZONES_DESC_HD) >> ilog2(RZONES_DESC_HD);
arr_len = (u64)RZONES_DESC_HD * (rep_max_zones + 1);
For alloc_len in 0xFFFFFFC1..0xFFFFFFFF, ALIGN() rounds up to
0x100000000, so arr_len is 4 GB. On 32-bit, kzalloc()'s size_t is 32-bit
and truncates 0x100000000 to 0; kzalloc(0) returns ZERO_SIZE_PT
High · CVSS 8.8EPSS 1.47%Public exploitNo fix published
sctp: prevent peer transport count overflow
In the Linux kernel, the following vulnerability has been resolved:
sctp: prevent peer transport count overflow
sctp_assoc_add_peer() increments the association's 16-bit transport_count
for every new unique peer. Adding the 65,536th transport wraps the count to
zero.
SCTP sock_diag uses transport_count to reserve the INET_DIAG_PEERS payload,
then copies one sockaddr_storage for every entry in transport_addr_list.
After the wrap, a diagnostic dump reserves an empty payload and writes
8 MiB of peer addresses past the skb tail.
Reject a new unique peer when transport_count has reached U16_MAX. Perform
the check after the existing-peer lookup
gpio: pch: use raw_spinlock_t for the register lock
In the Linux kernel, the following vulnerability has been resolved:
gpio: pch: use raw_spinlock_t for the register lock
pch_irq_type() is registered as the irq_chip .irq_set_type callback and
takes chip->spinlock with spin_lock_irqsave(). This callback is reached
from __setup_irq() -> __irq_set_trigger() -> chip->irq_set_type() while
the caller holds desc->lock, a raw_spinlock_t, with hardirqs disabled.
That context is not sleepable, but on PREEMPT_RT a regular spinlock_t is
an rtmutex-backed sleeping lock, so acquiring it there is invalid.
This was confirmed on a PREEMPT_RT kernel with lockdep
(PROVE_RAW_LOCK_NESTING and DEBUG_ATOMIC_SLE
In the Linux kernel, the following vulnerability has been resolved:
s390/qeth: Check CAP_NET_ADMIN for private ioctls
Gate the SIOCDEVPRIVATE ioctl commands SIOC_QETH_ADP_SET_SNMP_CONTROL,
SIOC_QETH_GET_CARD_TYPE and SIOC_QETH_QUERY_OAT with CAP_NET_ADMIN
capable check to ensure unprivileged users cannot invoke them.
s390/zcrypt: Close speculative mem read possibility
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Close speculative mem read possibility
The domain value is extracted from a given CCA or EP11 ioctl struct
when a CPRB is about to be sent. Thus this is a user controlled value.
Under some special conditions (custom device node used, administrative
load) this value is used as an array index after bounds checking, but
without speculation barrier.
Add the missing array_index_nospec() call to prevent speculative
execution where this domain value is used.
net: openvswitch: fix potential UAF on meter attach failure
In the Linux kernel, the following vulnerability has been resolved:
net: openvswitch: fix potential UAF on meter attach failure
While attaching a newly created meter attach_meter() function makes
the new meter visible to other CPUs but can still fail afterwards.
On failure, it detaches the meter back and returns an error.
However, this is an unexpected behavior for the ovs_meter_cmd_set()
that uses a plain kfree(meter) on attach failure without waiting for
RCU readers to stop using it, assuming it was never visible.
This is never a problem for ovs-vswitchd as it always creates meters
before creating any flows that use them. But the UAF c
net: openvswitch: fix skb leak on flow key update failure during ct
In the Linux kernel, the following vulnerability has been resolved:
net: openvswitch: fix skb leak on flow key update failure during ct
ovs_ct_execute() always steals or frees the skb on failure while
ovs_flow_key_update() does not. So, if it fails and we return right
away, the skb ends up leaked.
Fix that by breaking instead and letting the common error handling
code at the bottom of the loop to free the skb properly.
This is a very unlikely scenario as it requires the packet to become
unparseable by applying a set of actions on a previously parseable skb,
but should be fixed nevertheless.
Reported by Sashiko.
i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
In the Linux kernel, the following vulnerability has been resolved:
i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
Fix a severe AB/BA deadlock between the Common Clock Framework (CCF)
and the I2C adapter lock, which triggers when an I2C-controlled clock
generator client (like the Si5351) is registered or modified under the CCF.
During an i2c client clock (generator) frequency change, the CCF acquires its global
'prepare_lock' mutex and the driver calls i2c_transfer() to update the client's
chip registers, stalling for the adapter's I2C bus lock.
Concurrently, an independent, parallel transfer on the same
i2c: imx: Cancel hrtimer before clearing slave pointer
In the Linux kernel, the following vulnerability has been resolved:
i2c: imx: Cancel hrtimer before clearing slave pointer
In i2c_imx_unreg_slave(), the slave pointer is set to NULL after
disabling interrupts. However, a pending interrupt might already
have started the hrtimer (i2c_imx_slave_timeout) before the pointer
was cleared. If the hrtimer fires after i2c_imx->slave is set to
NULL, the timer callback i2c_imx_slave_finish_op() will call
i2c_imx_slave_event() with a NULL slave pointer, which results in a
use-after-free / NULL pointer dereference.
Fix by canceling the hrtimer and waiting for it to complete after
disabling interrupts,
In the Linux kernel, the following vulnerability has been resolved:
can: ems_usb: validate CPC message lengths
ems_usb_read_bulk_callback() walks CPC messages packed in one USB
receive buffer.
Check that each declared message fits in the URB payload. Also require the
type-specific payload to cover the fields used by the CAN, state, error and
overrun handlers.
In the Linux kernel, the following vulnerability has been resolved:
can: etas_es58x: es58x_read_bulk_callback(): fix RX buffer leak on URB resubmit failure
es58x_read_bulk_callback() resubmits the RX URB after processing a received
packet. If the resubmit succeeds, the URB remains anchored and will be
handled by the normal RX path or by teardown.
However, if usb_submit_urb() fails, the callback unanchors the URB and then
returns directly. This skips the existing free_urb path, so the coherent
transfer buffer allocated with usb_alloc_coherent() is not released.
Reuse the existing free_urb path after a resubmit failure so that the RX
cohere