batman-adv: tp_meter: directly shut down timer on cleanup
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: directly shut down timer on cleanup
batadv_tp_sender_cleanup() was calling timer_delete_sync() followed by
timer_delete() to guard against the timer handler re-arming itself between
the two calls. This double-deletion hack relied on the sending status being
set to 0 to suppress re-arming.
Replace both calls with a single timer_shutdown_sync(). This function both
waits for any running timer callback to complete (like timer_delete_sync())
and permanently disarms the timer so it cannot be re-armed afterwards,
making re-arming prevention unconditional and
batman-adv: tt: fix TOCTOU race for reported vlans
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix TOCTOU race for reported vlans
The local TT based TVLV is generated by first checking the number of VLANs
which have at least one TT entry. A new buffer with the correct size for
the VLANs is then allocated. Only then, the list of VLANs s used to fill
the VLAN entries in the buffer. During this time, the meshif_vlan_list_lock
is held. But the actual number of TT entries of each VLAN can still
increase during this time - just not the number of VLANs in the list.
But the prefilter used in the buffer size calculation might still cause an
increase of the nu
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: avoid empty VLAN responses
The commit 16116dac2339 ("batman-adv: prevent TT request storms by not
sending inconsistent TT TLVLs") added checks to the local (direct) TT
response code. But the response can also be done indirectly by another node
using the global TT state. To avoid such inconsistency states reported in
the original fix, also avoid sending empty VLANs for replies from the
global TT state.
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix negative last_changeset_len
batadv_piv_tt::last_changeset_len len was declared as s16, but the field is
never intended to hold a negative value. When a value greater than 32767 is
assigned, it wraps to a negative signed integer.
In batadv_send_my_tt_response(), last_changeset_len is temporarily widened
to s32. The incorrectly negative s16 value propagates into the s32, causing
batadv_tt_prepare_tvlv_local_data() to allocate a full sized buffer but
populates only a small portion of it with the collected changeset. All
remaining bits are kept uninitialize
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix negative tt_buff_len
batadv_orig_node::tt_buff_len was declared as s16, but the field is never
intended to hold a negative value. When a value greater than 32767 is
assigned, it wraps to a negative signed integer.
In batadv_send_other_tt_response(), tt_buff_len is temporarily widened to
s32. The incorrectly negative s16 value propagates into the s32, causing
batadv_tt_prepare_tvlv_global_data() to allocate a full sized buffer but
populates only a small portion of it with the collected changeset. All
remaining bits are kept uninitialized.
Using an u16 a
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) reject implausible blackbox record_count
adm1266_nvmem_read_blackbox() loops over a record_count that comes
straight from byte 3 of the BLACKBOX_INFO response. The destination
buffer is data->dev_mem, sized for the nvmem cell's declared 2048
bytes (ADM1266_BLACKBOX_MAX_RECORDS * ADM1266_BLACKBOX_SIZE = 32 * 64).
A device that reports a record_count greater than 32 -- whether due
to firmware bugs, bus corruption, or a non-responsive slave returning
0xff -- would walk read_buff past the end of the dev_mem allocation
on the trailing iterations.
Cap rec
hwmon: (pmbus/adm1266) include PEC byte in pmbus_block_xfer read buffer
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) include PEC byte in pmbus_block_xfer read buffer
adm1266_pmbus_block_xfer() sets up the read transaction with
.buf = data->read_buf,
.len = ADM1266_PMBUS_BLOCK_MAX + 2,
but read_buf in struct adm1266_data is declared as
u8 read_buf[ADM1266_PMBUS_BLOCK_MAX + 1];
For a max-length block response (length byte = 255 + up to 1 PEC
byte), the i2c controller is told to write 257 bytes into a 256-byte
buffer, putting one byte past the end of read_buf. The same response
also makes the subsequent PEC compare
if (crc != msgs[1].buf[msgs[1].buf[0] + 1])
hwmon: (pmbus/adm1266) bounce blackbox records through a protocol-sized buffer
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) bounce blackbox records through a protocol-sized buffer
adm1266_pmbus_block_xfer() copies the device-supplied block payload
into the caller-provided buffer using the device-supplied length:
memcpy(data_r, &msgs[1].buf[1], msgs[1].buf[0]);
The helper does not know how large data_r is and trusts the device to
return at most one record's worth of bytes. adm1266_nvmem_read_blackbox()
violates that contract: it advances read_buff inside data->dev_mem in
ADM1266_BLACKBOX_SIZE (64-byte) strides while the helper is willing to
write up to ADM1266_PMBUS_BLO
hwmon: (pmbus/adm1266) cap PDIO scan in get_multiple at ADM1266_PDIO_NR
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) cap PDIO scan in get_multiple at ADM1266_PDIO_NR
adm1266_gpio_get_multiple() iterates the PDIO portion of the
caller-supplied mask using
for_each_set_bit_from(gpio_nr, mask,
ADM1266_GPIO_NR + ADM1266_PDIO_STATUS) {
...
}
where ADM1266_PDIO_STATUS is the PMBus command code (0xE9, i.e. 233),
not the number of PDIO pins. The intended upper bound is
ADM1266_GPIO_NR + ADM1266_PDIO_NR = 25.
gpiolib hands in a mask sized for gc.ngpio (= 25 bits on this chip),
so the iteration walks find_next_bit() up to 242, reading up to 217
extra bits (a h
hwmon: (pmbus/adm1266) reject short block-read responses in the GPIO accessors
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) reject short block-read responses in the GPIO accessors
adm1266_gpio_get() and adm1266_gpio_get_multiple() both compose the
pin-status word as
pins_status = read_buf[0] + (read_buf[1] << 8);
right after i2c_smbus_read_block_data(), guarding only against an
error return. A well-behaved device returns 2 bytes for
GPIO_STATUS/PDIO_STATUS, but the helper happily reports a 0- or
1-byte response too. If the device returns 0 bytes, both read_buf
slots are uninitialized stack memory; if it returns 1 byte, read_buf[1]
is.
The composed value then flows th
netfilter: x_tables: allocate hook ops while under mutex
In the Linux kernel, the following vulnerability has been resolved:
netfilter: x_tables: allocate hook ops while under mutex
arp/ip(6)t_register_table() add the table to the per-netns list via
xt_register_table() before allocating the per-netns hook ops copy
via kmemdup_array(). This leaves a window where the table is
visible in the list with ops=NULL.
If the pernet exit happens runs concurrently the pre_exit callback finds
the table via xt_find_table() and passes the NULL ops pointer to
nf_unregister_net_hooks(), causing a NULL dereference:
general protection fault in nf_unregister_net_hooks+0xbc/0x150
RIP: nf_unregister_net_hooks (
netfilter: x_tables: add and use xtables_unregister_table_exit
In the Linux kernel, the following vulnerability has been resolved:
netfilter: x_tables: add and use xtables_unregister_table_exit
Previous change added xtables_unregister_table_pre_exit to detach the
table from the packetpath and to unlink it from the active table list.
In case of rmmod, userspace that is doing set/getsockopt for this table
will not be able to re-instantiate the table:
1. The larval table has been removed already
2. existing instantiated table is no longer on the xt pernet table list.
This adds the second stage helper:
unlink the table from the dying list, free the hook ops (if any) and do
the audit notification. It r
netfilter: ebtables: move to two-stage removal scheme
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ebtables: move to two-stage removal scheme
Like previous patches for x_tables, follow same pattern in ebtables.
We can't reuse xt helpers: ebt_table struct layout is incompatible.
table->ops assignment is now done while still holding the ebt mutex
to make sure we never expose partially-filled table struct.
netfilter: bridge: eb_tables: close module init race
In the Linux kernel, the following vulnerability has been resolved:
netfilter: bridge: eb_tables: close module init race
sashiko reports for unrelated patch:
Does the core ebtables initialization in ebtables.c suffer from a similar race?
Once nf_register_sockopt() completes, the sockopts are exposed globally.
sockopt has to be registered last, just like in ip/ip6/arptables.
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: cortina: Make RX SKB per-port
The SKB used to assemble packets from fragments in gmac_rx()
is static local, but the Gemini has two ethernet ports, meaning
there can be races between the ports on a bad day if a device
is using both.
Make the RX SKB a per-port variable and carry it over between
invocations in the port struct instead.
Zero the pointer once we call napi_gro_frags(), on error (after
calling napi_free_frags()) or if the port is stopped.
Zero it in some place where not strictly necessary just to
emphasize what is going on.
This was found by Sash
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: cortina: Carry over frag counter
The gmac_rx() NAPI poll function assembles packets in an
SKB from a ring buffer.
If the ring buffer gets completely emptied during a poll cycle,
we exit gmac_rx(), but the packet is not yet completely
assembled in the SKB, yet the fragment counter frag_nr is
reset to zero on the next invocation.
Solve this by making the RX fragment counter a part of the
port struct, and carry it over between invocations.
Reset the fragment counter only right after calling
napi_gro_frags(), on error (after calling napi_free_frags())
or if st
net/smc: reject CHID-0 ACCEPT that matches an empty ism_dev slot
In the Linux kernel, the following vulnerability has been resolved:
net/smc: reject CHID-0 ACCEPT that matches an empty ism_dev slot
On the SMC-D client, slot 0 of ini->ism_dev[]/ini->ism_chid[] is
reserved for an SMC-Dv1 device. smc_find_ism_v2_device_clnt()
populates V2 entries starting at index 1, so when no V1 device is
selected slot 0 is left in its kzalloc()'ed state with ism_dev[0] ==
NULL and ism_chid[0] == 0.
smc_v2_determine_accepted_chid() then matches the peer's CHID against
the array starting from index 0 using the CHID alone. A malicious
peer replying to a SMC-Dv2-only proposal with d1.chid == 0 matches
the empty slot, ini->i
net: tls: fix off-by-one in sg_chain entry count for wrapped sk_msg ring
In the Linux kernel, the following vulnerability has been resolved:
net: tls: fix off-by-one in sg_chain entry count for wrapped sk_msg ring
When an sk_msg scatterlist ring wraps (sg.end < sg.start),
tls_push_record() chains the tail portion of the ring to the head
using sg_chain(). An extra entry in the sg array is reserved for
this:
struct sk_msg_sg {
[...]
/* The extra two elements:
* 1) used for chaining the front and sections when the list becomes
* partitioned (e.g. end < start). The crypto APIs require the
* chaining;
* 2) to chain tailer SG entries after the message.
net: tls: prevent chain-after-chain in plain text SG
In the Linux kernel, the following vulnerability has been resolved:
net: tls: prevent chain-after-chain in plain text SG
Sashiko points out that if end = 0 (start != 0) the current
code will create a chain link to content type right after
the wrap link:
This would create a chain where the wrap link points directly
to another chain link. The scatterlist API sg_next iterator
does not recursively resolve consecutive chain links.
meaning this is illegal input to crypto.
The wrapping link is unnecessary if end = 0. end is the entry after
the last one used so end = 0 means there's nothing pushed after
the wrap:
end start
drm/msm/snapshot: fix dumping of the unaligned regions
In the Linux kernel, the following vulnerability has been resolved:
drm/msm/snapshot: fix dumping of the unaligned regions
The snapshotting code internally aligns data segment to 16 bytes. This
works fine for DPU code (where most of the regions are aligned), but
fails for snapshotting of the DSI data (because DSI data region is
shifted by 4 bytes). Fix the code by removing length alignment and by
accurately printing last registers in the region. While reworking the
code also fix the 16x memory overallocation in
msm_disp_state_dump_regs().
Patchwork: https://patchwork.freedesktop.org/patch/725449/