In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: free AP_VLAN bc_buf SKBs outside IRQ lock
ieee80211_do_stop() removes AP_VLAN packets from the parent AP
ps->bc_buf while holding ps->bc_buf.lock with IRQs disabled. It then
calls ieee80211_free_txskb() before dropping the lock.
ieee80211_free_txskb() is not just a passive SKB release. For SKBs with
TX status state it can report a dropped frame through cfg80211/nl80211,
and that path can reach netlink tap transmit. This is the same reason
the pending queue cleanup in ieee80211_do_stop() already unlinks SKBs
under the queue lock and frees them after IRQ stat
wifi: cfg80211: use wiphy work for socket owner autodisconnect
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: use wiphy work for socket owner autodisconnect
nl80211_netlink_notify() walks the cfg80211 wireless device list when a
NETLINK_GENERIC socket is released. If the socket owns a connection, the
notifier queues the embedded wdev->disconnect_wk work item.
That work is a plain work_struct today. NETDEV_GOING_DOWN cancels it, but a
NETLINK_URELEASE notifier that already observed conn_owner_nlportid can
queue it after that cancel returns. _cfg80211_unregister_wdev() then
removes the wdev from the list and waits for RCU readers, but
synchronize_net() does not drain
wifi: brcmfmac: initialize SDIO data work before cleanup
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: initialize SDIO data work before cleanup
brcmf_sdio_probe() stores the newly allocated bus in sdiodev->bus before
allocating the ordered workqueue. If that allocation fails, the function
jumps to fail and calls brcmf_sdio_remove().
brcmf_sdio_remove() unconditionally cancels bus->datawork. Initialize the
work item before the first failure path that can reach brcmf_sdio_remove(),
so the cleanup path always observes a valid work object.
This issue was found by our static analysis tool and then confirmed by
manual review of the probe error path and the remove
wifi: cfg80211: bound element ID read when checking non-inheritance
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: bound element ID read when checking non-inheritance
cfg80211_is_element_inherited() reads the first data octet of the
candidate element (id = elem->data[0]) to look it up in an extension
non-inheritance list. It does so after testing elem->id, but without
verifying that the element actually has a data octet. A zero-length
extension element (WLAN_EID_EXTENSION with length 0) therefore makes it
read one octet past the end of the element.
_ieee802_11_parse_elems_full() runs this check for every element of a
frame once a non-inheritance context exists -- e.g. w
firmware: arm_ffa: Fix out-of-bound writes in ffa_setup_and_transmit()
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Fix out-of-bound writes in ffa_setup_and_transmit()
Sashiko (locally) reports multiple out-of-bound issues in
ffa_setup_and_transmit:
1) Writing ep_mem_access->reserved can write out of bounds for FFA
versions < 1.2 as ffa_emad_size_get() returns 16 bytes in that case
while reserved has an offset of 24.
Instead of zeroing fields, memset the struct to zero first based on
the FFA version.
2) Make sure there is enough size to write constituents.
While at it, convert the only sizeof() in the driver that uses a
type instead of variable.
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Fix Endpoint Memory Access Descriptor offset calculation
Use the descriptor's `ep_mem_offset` to calculate the start of the endpoint
memory access array and to comply with the FF-A spec instead of defaulting
to `sizeof(struct ffa_mem_region)`.
This requires moving `ffa_mem_region_additional_setup()` earlier in the setup
flow.
Also, add sanity checks to ensure the calculated descriptor offsets do not
exceed `max_fragsize`.
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix UAF in sock clone early bailouts
Similar to recent commit 9b51a6155d14 ("bpf,fork: wipe ->bpf_storage
before bailouts that access it"), sk_clone() performs an initial
shallow copy of the socket field ->sk_bpf_storage via sock_copy()
for the cloned socket newsk.
If sk_clone() bails out early (e.g. if sk_filter_charge() fails) prior
to calling bpf_sk_storage_clone(), newsk->sk_bpf_storage still points
to the parent socket's BPF local storage. When newsk is subsequently
freed via sk_free(), the deallocation path (__sk_destruct() ->
bpf_sk_storage_free()) destroys the
ppp: defer channel free to an RCU grace period to fix pppol2tp RX UAF
In the Linux kernel, the following vulnerability has been resolved:
ppp: defer channel free to an RCU grace period to fix pppol2tp RX UAF
pppol2tp_recv() runs in the L2TP UDP-encap softirq RX path:
l2tp_udp_encap_recv() -> l2tp_recv_common() -> pppol2tp_recv()
-> ppp_input(&po->chan)
It runs under rcu_read_lock() holding only an l2tp_session reference and
takes NO reference on the internal PPP channel (struct channel,
chan->ppp) that ppp_input() dereferences.
The pppox socket is SOCK_RCU_FREE, so 'po' and the embedded ppp_channel
are RCU-safe. But the internal struct channel is a separate allocation
that ppp_release_channel() frees
net/iucv: take a reference on the socket found in afiucv_hs_rcv()
In the Linux kernel, the following vulnerability has been resolved:
net/iucv: take a reference on the socket found in afiucv_hs_rcv()
afiucv_hs_rcv() looks up the destination socket under iucv_sk_list.lock,
drops the lock, and then passes the socket to the afiucv_hs_callback_*()
handlers without holding a reference. AF_IUCV sockets are not
RCU-protected and are freed synchronously by iucv_sock_kill() ->
sock_put(), so a concurrent close can free the socket in the window
between read_unlock() and the handler, which then dereferences freed
memory (for example sk->sk_data_ready() in afiucv_hs_callback_syn()).
Take a reference with sock_hold()
scsi: core: wake eh reliably when using scsi_schedule_eh
In the Linux kernel, the following vulnerability has been resolved:
scsi: core: wake eh reliably when using scsi_schedule_eh
Drivers which use the scsi_schedule_eh function to run the error handler
currently risk the error handler thread never waking once all commands are
timed out or inactive. There is no enforced memory order between setting
the host into error recovery state and counting busy commands. This can
result in a race with scsi_dec_host_busy where neither CPU sees both
conditions of all commands inactive and the host error state to request
waking the error handler.
To fix this, run the scsi_schedule_eh's scsi_eh_wakeup from a
ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered
In the Linux kernel, the following vulnerability has been resolved:
ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered
sata_dwc_enable_interrupts() is called before platform_get_irq() and
ata_host_activate(), leaving the SATA controller's interrupt mask
enabled without a registered handler. If a later step fails (irq
request, phy init, etc.) or if the controller asserts an interrupt
during probe, the irq line may fire with no handler, causing a
spurious interrupt storm.
Move sata_dwc_enable_interrupts() after ata_host_activate() so that
interrupts are only unmasked once the handler is registered and the
core
Bluetooth: mgmt: fix locking in unpair_device/disconnect_sync
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: mgmt: fix locking in unpair_device/disconnect_sync
Dereferencing RCU-protected pointers outside critical sections is
invalid and may lead to UAF.
Take hdev->lock for hci_conn lookup and hci_abort_conn(). Don't use RCU
to ensure the conn is fully initialized at this point.
Bluetooth: mgmt: hold reference for hci_conn in mgmt_pending_cmds
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: mgmt: hold reference for hci_conn in mgmt_pending_cmds
Dereferencing RCU-protected pointers outside critical sections is
invalid and may lead to UAF. Use of hci_conn in hci_sync callbacks also
needs to hold refcount to avoid UAF.
Take appropriate locks for hci_conn lookups, and take refcount for
hci_conn pointers stored in mgmt_pending_cmd so that the pointer stays
valid.
When accessing conn->state, ensure hdev->lock is held to avoid data
race.
Bluetooth: hci_qca: Clear memdump state on invalid dump size
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_qca: Clear memdump state on invalid dump size
qca_controller_memdump() allocates qca->qca_memdump before processing
the first dump packet. For a sequence-zero packet it then disables IBS,
marks memdump collection active, and reads the advertised dump size.
If the controller reports a zero dump size, the error path frees the
local qca_memdump object and returns without clearing qca->qca_memdump
or undoing the collection state. A later memdump work item initializes
its local pointer from qca->qca_memdump and skips allocation when that
pointer is non-NULL, so i
smb/client: handle overlapping allocated ranges in fallocate
In the Linux kernel, the following vulnerability has been resolved:
smb/client: handle overlapping allocated ranges in fallocate
smb3_simple_fallocate_range() can skip holes when an allocated range
returned by the server starts before the current fallocate offset. The
skipped hole is not zero-filled, but fallocate still returns success. A
later write to that hole may therefore fail with ENOSPC.
The function queries allocated ranges so that it can preserve existing
contents and write zeroes only into holes. However, the server may return
a range that starts before the current fallocate offset.
For example, assume the fallocate request is [
bpf, sockmap: Reject unhashed UDP sockets on sockmap update
In the Linux kernel, the following vulnerability has been resolved:
bpf, sockmap: Reject unhashed UDP sockets on sockmap update
UDP sockets get SOCK_RCU_FREE set when (auto-)bound. This means
sk_is_refcounted(unbound) = true, while sk_is_refcounted(bound) = false.
Because sockmap accepts unbound UDP sockets, a BPF program can increment a
socket's refcount via lookup. If the socket is subsequently bound, the
transition from unbound to bound causes bpf_sk_release() to skip the
decrement of the refcount, causing a memory leak.
unreferenced object 0xffff88810bc2eb40 (size 1984):
comm "test_progs", pid 2451, jiffies 4295320596
hex dump (fi
In the Linux kernel, the following vulnerability has been resolved:
drm/xe/guc: Keep scheduler timeline name alive
The scheduler keeps a pointer to the timeline name, but q->name
is freed with the exec queue while scheduler fences can still
reference it.
Store the name in struct xe_guc_exec_queue so it shares
the scheduler's RCU-deferred lifetime.
(cherry picked from commit 41075f0eb5dcbd3b065d15f15ef7bbe9315188e8)
drm/xe/guc: Hold device ref until queue teardown completes
In the Linux kernel, the following vulnerability has been resolved:
drm/xe/guc: Hold device ref until queue teardown completes
GuC exec queue destruction can run asynchronously. If the final device
put happens from a destroy worker, drmm cleanup can end up draining
the same workqueue and deadlock.
Hold a drm_device reference for the queue lifetime and drop it after
queue teardown completes. This keeps drmm cleanup from running while
async destroy work is still pending.
Move GuC destroy work to a module-lifetime Xe workqueue and flush it
on PCI remove so hot-unbind/rebind still waits for pending destroy work.
With queue-held device refs,
ksmbd: pin conn during async oplock break notification
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: pin conn during async oplock break notification
smb2_oplock_break_noti() and smb2_lease_break_noti() store a ksmbd_conn
pointer in an async ksmbd_work and then queue that work on ksmbd-io. The
work only increments conn->r_count, which prevents teardown from passing
the pending-request wait after the increment, but it does not pin the
struct ksmbd_conn object.
If connection teardown races with an oplock break notification, the last
conn reference can be dropped before the queued worker finishes. The
worker then uses the freed conn in ksmbd_conn_write() and
ksmbd_co
net/sched: act_tunnel_key: Defer dst_release to RCU callback
In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_tunnel_key: Defer dst_release to RCU callback
Fix a race-condition use-after-free in tunnel_key_release_params().
The function releases the metadata_dst of the old params synchronously
via dst_release() while deferring the params struct free with
kfree_rcu(). A concurrent tunnel_key_act() reader on the datapath may
still hold the old params pointer (under rcu_read_lock_bh) and proceed
to call dst_clone(¶ms->tcft_enc_metadata->dst) after the writer's
dst_release has already pushed the dst's rcuref to RCUREF_DEAD.
[email protected] produced a