nvdimm/btt: reject an arena whose nfree is below the lane count
In the Linux kernel, the following vulnerability has been resolved:
nvdimm/btt: reject an arena whose nfree is below the lane count
The BTT info block's nfree field, the number of reserve free blocks, is
read from the medium without validation. btt_freelist_init() and
btt_rtt_init() size the per-lane freelist[] and rtt[] arrays by nfree,
but the I/O path indexes them by the lane from nd_region_acquire_lane(),
which is bounded by nd_region->num_lanes (ND_MAX_LANES), not by nfree.
A crafted or foreign arena whose nfree is below the lane count makes
freelist[lane]/rtt[lane] run past the allocation: an out-of-bounds write.
btt.rst documents t
parisc: eisa: Fix infinite loop when parsing invalid IRQ value
In the Linux kernel, the following vulnerability has been resolved:
parisc: eisa: Fix infinite loop when parsing invalid IRQ value
When an invalid value is passed via the "eisa_irq_edge=" kernel
command line parameter (e.g. "eisa_irq_edge=16,5"), eisa_irq_setup()
prints an error message and continues without advancing the current
position. As a result the same invalid value is parsed again and
again, causing an infinite loop while the kernel boots.
Advance to the next comma-separated entry, or stop parsing when there
is no next entry, before continuing so that the remaining entries are
processed normally.
powerpc/kexec_file: Prevent kexec range truncation
In the Linux kernel, the following vulnerability has been resolved:
powerpc/kexec_file: Prevent kexec range truncation
Sashiko AI review pointed out the following issue.
The __merge_memory_ranges() function incorrectly handles overlapping
memory ranges when merging them. Although sort_memory_ranges() sorts all
ranges by their start address in ascending order beforehand, the merge
logic remains defective in two ways:
1. It compares the current range's start against the previous element (i-1)
instead of the running target index (idx)
2. It unconditionally overwrites 'ranges[idx].end' with 'ranges[i].end'.
This logic flaw leads to criti
powerpc/mm: fix wrong addr_pfn tracking in compound vmemmap population
In the Linux kernel, the following vulnerability has been resolved:
powerpc/mm: fix wrong addr_pfn tracking in compound vmemmap population
vmemmap_populate_compound_pages() uses addr_pfn to determine the PFN
offset within a compound page and to decide whether the current vmemmap
slot should be populated as a head page mapping or should reuse a tail
page mapping.
However, addr_pfn is advanced manually in parallel with addr. The loop
itself progresses in vmemmap address space, so each PAGE_SIZE step in addr
covers PAGE_SIZE / sizeof(struct page) struct page slots. Since addr_pfn
is compared against nr_pages in data-PFN units, it should adv
s390/vfio-ap: fix stale pqap_hook pointer on error in vfio_ap_mdev_set_kvm()
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio-ap: fix stale pqap_hook pointer on error in vfio_ap_mdev_set_kvm()
In vfio_ap_mdev_set_kvm(), kvm->arch.crypto.pqap_hook is set to
&matrix_mdev->pqap_hook before the update locks are acquired and the
mdev list is checked for a conflicting assignment. If another mdev is
already attached to the same KVM instance, the function returns -EPERM
without restoring the hook pointer, leaving kvm->arch.crypto.pqap_hook
pointing at the failing matrix_mdev instead of the mdev that legitimately
owns the KVM.
Since matrix_mdev->kvm is never set on this error path,
vfio_ap_mdev_
s390/vfio-ap: Fix control domain removal in vfio_ap_mdev_cfg_remove
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio-ap: Fix control domain removal in vfio_ap_mdev_cfg_remove
The vfio_ap_config_remove function uses the bitmap_andnot function to clear
bits from the matrix_mdev->matrix.adm bitmap (specifies the control domains
assigned to the mdev). This prevents the explicitly unplugged control
domains from being removed the KVM guest. The bitmap_and function is used
instead.
s390/vfio-ap: Fix dereference matrix_mdev->kvm without checking for NULL
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio-ap: Fix dereference matrix_mdev->kvm without checking for NULL
The ap_driver structure has two fields which are function pointers to
callbacks:
* .on_config_changed: called at the start of the AP bus scan function to
notify the device driver that the host AP
configuration has changed and the associated AP
devices will be added or removed accordingly. This
gives the implementor a chance to evaluate the
configuration changes and respond to them before
s390/vfio-ap: Fix hot-unplug skipped when last AP adapter or domain removed
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio-ap: Fix hot-unplug skipped when last AP adapter or domain removed
The vfio_ap_mdev_hot_unplug_cfg() function uses the return value of
bitmap_andnot() to determine whether the guest APCB needs to be updated.
However, bitmap_andnot() returns false when the resulting destination
bitmap is empty. This means that if the only adapter, domain or control
domain assigned to an mdev is removed from the host's AP configuration,
the bit is correctly cleared from the shadow APCB, but bitmap_andnot()
returns false because the result is an empty bitmap. Consequently,
do_hotplug
s390/vfio-ap: Fix missing lock required to access list of ap_matrix_mdev objects
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio-ap: Fix missing lock required to access list of ap_matrix_mdev objects
In order to traverse or add/remove ap_matrix_mdev objects in the
matrix_dev->mdev_list, the matrix_dev->guests_lock mutex must be held.
There are two functions that access the list without holding the mutex:
vfio_ap_mdev_probe function
~~~~~~~~~~~~~~~~~~~~~~~~~~~
The vfio_ap_mdev_probe function uses the matrix_dev->mdevs_lock
mutex to guard the add of a newly created ap_matrix_mdev object to the
matrix_dev->mdev_list. This mutex does not protect list access; its purpose
is to guard against con
s390/vfio-ap: Fix NULL deref in status_show() during queue probe
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio-ap: Fix NULL deref in status_show() during queue probe
When vfio_ap_mdev_probe_queue() creates the sysfs attribute group,
the queue's driver data has not yet been set. A concurrent read of
the 'status' attribute can therefore call dev_get_drvdata() and
get NULL, which is then passed directly to
vfio_ap_mdev_for_queue() where q->apqn is unconditionally
dereferenced, causing a NULL pointer dereference.
Fix this by acquiring the update locks before calling
sysfs_create_group(). The status_show() function acquires
guests_lock before reading the driver data, so any co
In the Linux kernel, the following vulnerability has been resolved:
mtd: afs: validate v2 image info bounds
The AFS v2 parser uses footer[8] to locate the image information block
inside the current erase block, then uses the image information
region_count to walk entries from a fixed local array. The footer offset
and region count come from flash contents and are not checked against the
erase block or the local image-info array before use.
Reject v2 entries whose image information offset would underflow the
erase block calculation, and reject region counts that cannot fit in the
local image-info array before walking region entries.
mtd: mtdoops: free page bitmap when the backing MTD is removed
In the Linux kernel, the following vulnerability has been resolved:
mtd: mtdoops: free page bitmap when the backing MTD is removed
mtdoops_notify_add() allocates oops_page_used when the configured MTD
device is registered. mtdoops_notify_remove() detaches from that device
but leaves the bitmap allocated. If the same MTD device is later
registered again, the add path allocates a new bitmap and overwrites the
old pointer, leaking one vmalloc allocation per remove/add cycle.
This is only visible when the backing MTD device can disappear and be
registered again while mtdoops remains loaded, so the usual static MTD
case does not expose it.
F
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: validate ONFI extended parameter page sections
nand_flash_detect_ext_param_page() allocates the length declared by the
ONFI parameter page, then treats the data as a fixed header followed by
variable-length sections. It reads that header and advances over sections
without first proving that the fixed page and each current section fit in
the allocation.
Reject pages shorter than the fixed header, track the remaining variable
area while walking sections, and require the ECC section to contain every
field read from struct onfi_ext_ecc_info. Use device-scoped dia
batman-adv: fix stale receive device on merged fragments
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: fix stale receive device on merged fragments
Fragment reassembly reuses the skb from the highest-numbered buffered
fragment as the merged packet. When that fragment was received on a hard
interface which is deleted before the chain completes, the merged skb can
re-enter the receive path with a stale skb->dev and skb_iif.
batadv_batman_skb_recv() passes such merged packets through the normal
receive handlers again. DAT and bridge loop avoidance both derive the ARP
header length from skb->dev, so they can dereference the freed net_device
before the packet reaches
batman-adv: mcast: linearize skbuff for packet generation
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: mcast: linearize skbuff for packet generation
batadv_mcast_forw_packet() and batadv_mcast_forw_scrape() is not only
called (indirectly) by the unsharing+linearizing batadv_recv_mcast_packet()
handler. When it is called (indirectly) by batadv_mcast_forw_mcsend() then
it will be unshared but not linearized. The SKB_LINEAR_ASSERT() can
therefore cause a fatal BUG().
The linearization should happen during the expansion of the head because
the scrape function can be hit already during the initial
batadv_mcast_forw_mode() selection code:
* batadv_interface_tx
* bata
batman-adv: dat: avoid unaligned fault in IP extraction
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: dat: avoid unaligned fault in IP extraction
Independent of the alignment of the ARP packet in the SKB, either the
batadv_arp_ip_src or the batadv_arp_ip_dst will have an unaligned access
(on HW without native unaligned read support).
Use get_unaligned() to handle this properly on all architectures.
batman-adv: bla: fix freeing of claims on meshif deletion
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: fix freeing of claims on meshif deletion
When the mesh interface is getting deleted, then
batadv_bla_del_backbone_claims() (via batadv_bla_purge_backbone_gw()) could
make sure that all claims gets removed. But this function is only executed
when bat_priv->bla.claim_hash is not NULL. And since batadv_bla_free() is
always setting it to NULL before it is (indirectly) called, it was never
actually executed.
But the batadv_bla_purge_claims() -> batadv_handle_unclaim() is at the
moment too fragile because the BLA code is not handling the rehashing in
batadv_bla_
clk: meson: align gxbb_32k_clk_sel number of parents with actual count
In the Linux kernel, the following vulnerability has been resolved:
clk: meson: align gxbb_32k_clk_sel number of parents with actual count
The following out-of-bounds read has been observed by Christian on a
GXBB WeTek Hub:
==================================================================
BUG: KASAN: global-out-of-bounds in __clk_register+0x1b70/0x2418
Read of size 8 at addr ffffd66320cf88e0 by task swapper/0/1
CPU: 0 UID: 0 PID: 1 Comm: swapper/0 Not tainted 7.0.0-rc5 #1 PREEMPT
Hardware name: WeTek Hub (DT)
Call trace:
show_stack+0x14/0x20 (C)
dump_stack_lvl+0x74/0x94
print_report+0x164/0x4b0
kasan_report+0x98/0xd8
__asan_report_lo
ASoC: cs35l33: drain threaded IRQ before runtime suspend
In the Linux kernel, the following vulnerability has been resolved:
ASoC: cs35l33: drain threaded IRQ before runtime suspend
cs35l33_runtime_suspend() currently switches the codec into
regcache_cache_only(true) and powers it down without first quiescing the
threaded IRQ registered by devm_request_threaded_irq(). That leaves a
window where cs35l33_irq_thread() can still run after suspend has closed
off live register access.
A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1/2 after cache_only has been
enabled,
ASoC: cs35l34: drain threaded IRQ before runtime suspend
In the Linux kernel, the following vulnerability has been resolved:
ASoC: cs35l34: drain threaded IRQ before runtime suspend
cs35l34_runtime_suspend() currently switches the codec into
regcache_cache_only(true), asserts reset low, and powers the device off
without first quiescing the threaded IRQ registered by
devm_request_threaded_irq(). That leaves a window where
cs35l34_irq_thread() can still run after suspend has removed live
hardware access.
A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1..4 after cach