iio: pressure: bmp280: fix out-of-bounds access in sampling frequency lookup
In the Linux kernel, the following vulnerability has been resolved:
iio: pressure: bmp280: fix out-of-bounds access in sampling frequency lookup
The sampling frequency tables store each frequency as an integer part and
a fractional part in micro units. num_sampling_freq_avail is initialized
to the number of flattened integer elements because read_avail() returns
the table as a flat array.
bmp280_write_sampling_frequency(), however, indexes the same table as a
two-dimensional array and uses num_sampling_freq_avail as the number of
rows. Convert the flattened element count back to the number of rows
before iterating over the table.
iio: pressure: rohm-bm1390: Return error when read fails
In the Linux kernel, the following vulnerability has been resolved:
iio: pressure: rohm-bm1390: Return error when read fails
The data reading function ignores the cached error value, and
unconditionally returns 0. Return cached 'ret' -value after stopping
the measurement so user knows if read failed and data is garbage.
iio: proximity: aw96103: validate firmware data length
In the Linux kernel, the following vulnerability has been resolved:
iio: proximity: aw96103: validate firmware data length
The firmware parser reads a length from the binary header and then uses
it to walk six-byte register/value entries. A truncated firmware image
can make the parser read beyond the copied firmware buffer. A value
smaller than the four-byte count field also underflows, producing a very
large length.
Read the little-endian field with get_unaligned_le32(), as previously
proposed by David Lechner. Validate the header size, reject an
underflowed length, ensure the resulting payload is contained in the
firmware image, and requ
iio: proximity: pulsedlight: fix iio_device left registered on PM setup failure
In the Linux kernel, the following vulnerability has been resolved:
iio: proximity: pulsedlight: fix iio_device left registered on PM setup failure
pm_runtime_set_active() failing in probe() jumps to error_unreg_buffer,
which only calls iio_triggered_buffer_cleanup() -- it does not undo the
iio_device_register() that already succeeded a few lines above. probe()
then returns the error, the devm-managed indio_dev is freed, but the
iio core still has it registered: the sysfs/chardev nodes stay live and
point at freed memory.
Add an error_unreg_dev label that unregisters the iio device before
falling through to the existing buffer cleanup, mir
iio: trigger: cancel reenable_work before freeing trigger
In the Linux kernel, the following vulnerability has been resolved:
iio: trigger: cancel reenable_work before freeing trigger
iio_trigger_notify_done_atomic() defers ->reenable() into
trig->reenable_work on the system workqueue, and the worker dereferences
the owning trigger through container_of(). Nothing cancels this work
before iio_trig_release() frees the trigger, so a worker armed by the
last in-flight IRQ can outlive the free and touch freed memory.
Cancel it at the top of iio_trig_release(), which every free path
reaches through the device core's final put_device().
Found by an in-house static analysis tool.
In the Linux kernel, the following vulnerability has been resolved:
perf: Require kernel access for text poke events
Perf events with exclude_kernel=1 can be opened without kernel perf
access. However, exclude_kernel does not suppress text-poke sideband
records. Every PERF_RECORD_TEXT_POKE is marked PERF_RECORD_MISC_KERNEL
and contains a raw kernel instruction address.
An unprivileged task can therefore open and mmap a task-local software
event with text_poke=1. Both opening a count-only tracepoint event and
configuring UDP GRO for ESP-in-UDP cause updates to inline static calls;
the observer receives the relocated addresses of the modifie
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Fix _gaccess_shadow_fault()
In some circumstances, it is possible that the page of nested guest
memory that is being shadowed is not present at all in the parent guest
gmap. dat_entry_walk() will not find any leaf entry and return with
-ENOENT, which will erroneously be propagated all the way to userspace.
Fix by manually calling gmap_link() on the memory of the nested guest
that is being shadowed if the mapping was not already present.
KVM: s390: Add missing srcu in kvm_s390_set_irq_state()
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Add missing srcu in kvm_s390_set_irq_state()
Like kvm_s390_inject_vcpu(), kvm_s390_set_irq_state() also needs the
kvm->srcu or the slots lock when performing the Store status operation.
Fix by taking kvm->srcu in kvm_s390_set_irq_state().
KVM: s390: Properly handle NULL pointer in dat_cond_set_storage_key()
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Properly handle NULL pointer in dat_cond_set_storage_key()
Some callers pass NULL as oldkey. Calling page_cond_set_storage_key()
will cause that NULL pointer to get dereferenced.
Fix by checking for NULL and assigning the pointer to a dummy local
variable to avoid crashes.
KVM: s390: Fix potential races in dat skey functions
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Fix potential races in dat skey functions
When dat_cond_set_storage_key() finds a large page, it will
conditionally set the storage key in absolute memory using
large_crste_to_phys() to get the absolute address.
There is a race window between dat_entry_walk() and
large_crste_to_phys(): the large page could have been split
concurrently, and large_crste_to_phys() might be called with a crste
that does not designate a large page, leading to crashes.
Similar issues were also present in dat_set_storage_key().
dat_get_storage_key() and dat_reset_reference_bit() did
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Fix race in _destroy_pages_crste()
Use READ_ONCE() in _destroy_pages_crste() to read the crste, avoid
dereferencing the pointer multiple times.
In the Linux kernel, the following vulnerability has been resolved:
s390/uv: Prevent potential out-of-bounds read
When the system has more than 85 secrets, the uv_secret_list struct
array only holds up to 85 items per page, resulting in an out of bounds
read in find_secret_in_page if the targeted secret is in the next page
or not stored at all.
Fix this by looping over the number of stored secrets which is the
per sub-list count of stored secrets and not the overall count.
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix divide-by-zero in btf_struct_walk()
When an access goes past the struct and the last member is a flexible
array, btf_struct_walk() folds the offset back into a single element with
(off - moff) % t->size, but never checks that the element type has a size.
BTF takes an empty struct, so this in program BTF
/* event could be empty */
struct event {
#ifdef HAVE_TIMESTAMP
__u64 ts;
#endif
};
struct batch {
int nr;
struct event events[];
};
divides by zero at prog load time. Getting there needs a PTR_TO_BTF_ID that
is not MEM_ALLOC, e.g. a plain read of a
tcp: Skip cond_resched() in inet_csk_listen_stop() under BPF context
In the Linux kernel, the following vulnerability has been resolved:
tcp: Skip cond_resched() in inet_csk_listen_stop() under BPF context
bpf_sock_destroy() runs from the tcp iterator, under rcu_read_lock(). If
the sock is a listener that still has children in its accept queue,
tcp_abort() ends up in inet_csk_listen_stop() and the cond_resched()
there trips the debug check:
BUG: sleeping function called from invalid context at net/ipv4/inet_connection_sock.c:1523
in_atomic(): 0, irqs_disabled(): 0, non_block: 0, pid: 628, name: test_progs
preempt_count: 0, expected: 0
RCU nest depth: 1, expected: 0
locks held by test_progs/628: 3, last CPU#
bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch()
In the Linux kernel, the following vulnerability has been resolved:
bpf: Avoid soft lockup in __htab_map_lookup_and_delete_batch()
__htab_map_lookup_and_delete_batch() has no rescheduling point. The
batch count bounds how many entries are copied out, not how many
buckets are visited, so one BPF_MAP_LOOKUP_BATCH call can walk the
map end to end. The empty-bucket fast path is worse: it stays inside
a single rcu_read_lock() / bpf_disable_instrumentation() section for
any run of consecutive empty buckets.
That holds up on small maps, but it falls apart at scale. On a
144-CPU arm64 host running a CONFIG_PREEMPT_NONE kernel, periodic
BPF_MAP_LOO
bpf: Fix out-of-bounds read of rtt_min in sock_ops
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix out-of-bounds read of rtt_min in sock_ops
A sockops prog reading skops->rtt_min never checks the sk type: on the
tcp_conn_request() path sock_ops->sk is a request_sock (non-full), and the
ctx rewrite casts it to a tcp_sock (full) and reads rtt_min past the end of
the request_sock, returning dirty adjacent memory.
SEC("sockops")
int prog(struct bpf_sock_ops *skops)
{
switch (skops->op) {
case BPF_SOCK_OPS_RWND_INIT:
leak = skops->rtt_min; /* reads the request_sock OOB */
...
}
}
For instance one such read returned rtt_min=0xffff8881, the high half
bpf: Fix UAF due to concurrent consumption of ttrace lists in alloc_bulk
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix UAF due to concurrent consumption of ttrace lists in alloc_bulk
Syzkaller repeatedly triggered UAF splats related to nodes in
waiting_for_gp_ttrace within the bpf memalloc:
BUG: KASAN: slab-use-after-free in llist_del_first+0x85/0x110 lib/llist.c:61
Read of size 8 at addr ffff8881572cd080 by task syz.4.470/5112
...
llist_del_first+0x85/0x110 lib/llist.c:61
alloc_bulk+0x193/0x460 kernel/bpf/memalloc.c:229
bpf_mem_refill+0x386/0x560 kernel/bpf/memalloc.c:436
Freed by task 14:
...
__free_rcu kernel/bpf/memalloc.c:281 [inline]
__free_rcu_tasks_trace+0x48/0xd0
bpf, arm64: set up the frame pointer for the exception callback
In the Linux kernel, the following vulnerability has been resolved:
bpf, arm64: set up the frame pointer for the exception callback
A program acting as exception boundary saves all callee-saved registers,
so build_prologue() takes the exception_cb path and never calls
push_callee_regs(). That is the only place find_used_callee_regs() runs,
and with it the only place ctx->fp_used is set, so the callback prologue
does not emit the
mov x25, sp
that points BPF_REG_FP at the frame the callback runs on. x25 keeps
whatever it held when bpf_throw() was called. If the throw came from a
subprogram that uses its own BPF stack, that is the subprogr
HID: amd_sfh: Validate PCI BAR size before mapping
In the Linux kernel, the following vulnerability has been resolved:
HID: amd_sfh: Validate PCI BAR size before mapping
The amd_sfh driver maps PCI BAR 2 using pcim_iomap_regions() and
subsequently accesses MMIO registers at offsets up to 0x10958 (e.g.,
AMD_P2C_MSG3 at 0x1068C). However, the driver never validates that the BAR
size is large enough to cover these accesses. If the driver is bound to a
device with a smaller BAR 2, this leads to an out-of-bounds memory access
and a page fault during the probe function.
For example, a page fault can occur when reading from privdata->mmio +
AMD_P2C_MSG3 in mp2_select_ops():
BUG: unable to hand
In the Linux kernel, the following vulnerability has been resolved:
KVM: riscv: Fix NACL hfence entry update order
The SBI v3.0 specification (section 15.1.2) requires a nested HFENCE
entry to be populated as follows:
1) find an unused entry with Config.Pending == 0
2) update the Page_Number and Page_Count words
3) update the Config word with Config.Pending set
__kvm_riscv_nacl_hfence() writes the Config word first, so the SBI
implementation (or NACL hardware) can observe a pending entry with
pnum/pcount values left over from the previous use of that entry,
resulting in incorrect TLB flush ranges.
Write pnum and pcount first and the Confi