drbd: reject data replies with an out-of-range payload size
In the Linux kernel, the following vulnerability has been resolved:
drbd: reject data replies with an out-of-range payload size
recv_dless_read() receives a P_DATA_REPLY from a peer into the bio of an
outstanding read request. The peer-supplied payload length reaches it as
the signed int data_size, and two peer-controlled inputs can make it
negative. With a negotiated data-integrity-alg the digest length is
subtracted first, so a reply whose payload is smaller than the digest
underflows data_size. With no integrity algorithm (the default) data_size
is assigned from the unsigned h95/h100 wire length and drbdd() never
bounds it for a payload-
riscv: Prevent NULL pointer dereference in machine_kexec_prepare()
In the Linux kernel, the following vulnerability has been resolved:
riscv: Prevent NULL pointer dereference in machine_kexec_prepare()
A NULL pointer dereference issue is noticed in riscv's
machine_kexec_prepare(), where image->segment[i].buf might be NULL and
copied unchecked.
The NULL buf comes from ima_add_kexec_buffer(), where kbuf is added by
kexec_add_buffer(), but kbuf.buffer is NULL, then it is copied without
a check in machine_kexec_prepare():
kexec_file_load
-> kimage_file_alloc_init()
-> kimage_file_prepare_segments()
-> ima_add_kexec_buffer()
-> kexec_add_buffer()
-> machine_kexec_prepar
tracing/osnoise: Call synchronize_rcu() when unregistering
In the Linux kernel, the following vulnerability has been resolved:
tracing/osnoise: Call synchronize_rcu() when unregistering
This ensures that any RCU readers traversing the instance list
have finished, before releasing the reference on the tracer that
the instance points to.
cgroup/cpuset: rebind mm mempolicy to effective_mems, not mems_allowed
In the Linux kernel, the following vulnerability has been resolved:
cgroup/cpuset: rebind mm mempolicy to effective_mems, not mems_allowed
Creating a child cpuset where cpuset.mems is never set leads to a div/0
when a VMA mempolicy with MPOL_F_RELATIVE_NODES rebinds in response to a
CPU hotplug event.
Reproduction steps:
1) Create a cgroup w/ cpuset controls (do not set cpuset.mems)
2) Move the task into the child cpuset
3) Create a VMA mempolicy for that task with MPOL_F_RELATIVE_NODES
4) unplug and hotplug a cpu
echo 0 > /sys/devices/system/cpu/cpu1/online
echo 1 > /sys/devices/system/cpu/cpu1/online
5) mempolicy rebind
pmdomain: imx93-blk-ctrl: Extract PHY as shared domain for DSI/CSI
In the Linux kernel, the following vulnerability has been resolved:
pmdomain: imx93-blk-ctrl: Extract PHY as shared domain for DSI/CSI
The MIPI DSI and CSI domains share control bits for clock and reset, which
can lead to incorrect behavior if one domain disables the shared resource
while the other is still active.
To fix the issue, introduce a shared MIPI PHY power domain to own the
common resources and make DSI and CSI its subdomains. This ensures the
shared bits are properly managed and not disabled while still in use.
pmdomain: imx: Fix i.MX8MP VC8000E power up sequence
In the Linux kernel, the following vulnerability has been resolved:
pmdomain: imx: Fix i.MX8MP VC8000E power up sequence
Per errata[1]:
ERR050531: VPU_NOC power down handshake may hang during VC8000E/VPUMIX
power up/down cycling.
Description: VC8000E reset de-assertion edge and AXI clock may have a
timing issue.
Workaround: Set bit2 (vc8000e_clk_en) of BLK_CLK_EN_CSR to 0 to gate off
both AXI clock and VC8000E clock sent to VC8000E and AXI clock sent to
VPU_NOC m_v_2 interface during VC8000E power up(VC8000E reset is
de-asserted by HW)
Add a bool variable is_errata_err050531 in
'struct imx8m_blk_ctrl_domain_data' to represent whether the w
wifi: rt2x00: avoid full teardown before work setup in probe
In the Linux kernel, the following vulnerability has been resolved:
wifi: rt2x00: avoid full teardown before work setup in probe
rt2x00lib_probe_dev() uses the full rt2x00lib_remove_dev() teardown for
all probe failures. However, drv_data allocation and workqueue allocation
can fail before intf_work, autowakeup_work and sleep_work have been
initialized.
Do not enter the full remove path until the probe has reached the point
where those work items are set up. Return directly for drv_data allocation
failure, and use a small early cleanup path for workqueue allocation
failure.
This issue was found by our static analysis tool and then confirm
wifi: mac80211: fix memory leak in ieee80211_register_hw()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix memory leak in ieee80211_register_hw()
If kmemdup() fails while copying supported band structures, the error
path jumps to fail_rate. This skips rate_control_deinitialize() and
leaks the initialized local->rate_ctrl.
Fix this by adding a fail_band label that shares the rate-control cleanup
path before falling through to the remaining teardown.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Man
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btrtl: validate firmware patch bounds
rtlbt_parse_firmware() copies patch_length - 4 bytes before appending the
firmware version. A malformed firmware patch shorter than the version field
can make this subtraction underflow and turn the copy into an oversized
read and write during Bluetooth setup.
The existing patch_offset + patch_length check can also wrap on 32-bit
architectures. Validate the patch length and range without arithmetic
overflow before allocating or copying the patch.
memstick: ms_block: reject a card that reports too many blocks
In the Linux kernel, the following vulnerability has been resolved:
memstick: ms_block: reject a card that reports too many blocks
msb_ftl_initialize() computes the zone count from the card block count
with no bound:
msb->zone_count = msb->block_count / MS_BLOCKS_IN_ZONE;
...
for (i = 0; i < msb->zone_count; i++)
msb->free_block_count[i] = MS_BLOCKS_IN_ZONE;
msb->block_count is a card value. msb_read_boot_blocks() reads
number_of_blocks from the card boot page and byte swaps it.
free_block_count is a fixed int[MS_MAX_ZONES]. MS_MAX_ZONES is 16, so the
valid indices are 0 to 15. The init loop above indexes it by zone_count.
msb_mark_b
ipvs: fix more places with wrong ipv6 transport offsets
In the Linux kernel, the following vulnerability has been resolved:
ipvs: fix more places with wrong ipv6 transport offsets
Sashiko reports for more incorrect IPv6 transport offsets.
The app code for TCP was assuming IPv4 network header
even after the ipvsh argument was provided. This can
cause problems with apps over IPv6. As for the only
official app in the kernel tree (FTP) this problem is
harmless because we use Netfilter to mangle the FTP
ports and we do not adjust the TCP seq numbers.
Also, provide correct offset of the ICMPV6 header in
ip_vs_out_icmp_v6() for correct checksum checks when
the IPv6 packet has extension headers.
In the Linux kernel, the following vulnerability has been resolved:
ipvs: reload ip header after head reallocation
__ip_vs_get_out_rt() calls skb_ensure_writable() which may
reallocate skb->head.
reset: sunxi: fix memory region leak on ioremap failure
In the Linux kernel, the following vulnerability has been resolved:
reset: sunxi: fix memory region leak on ioremap failure
In sunxi_reset_init(), when ioremap() fails, the memory region obtained
via request_mem_region() is not released, leading to a resource leak.
Add an err_mem_region label to properly release the memory region before
freeing the data structure.
powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()
In the Linux kernel, the following vulnerability has been resolved:
powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()
spufs_mem_mmap_access() computes the local store offset as
address - vma->vm_start, but bounds-checks it against vma->vm_end
instead of the local store size. On 64-bit, offset is always well
below vma->vm_end, so the clamp never fires and len stays unbounded
against the LS_SIZE buffer returned by ctx->ops->get_ls().
Reject offsets at or beyond LS_SIZE and clamp len to the remaining
space, mirroring the guard already used by spufs_mem_mmap_fault() and
spufs_ps_fault().
In the Linux kernel, the following vulnerability has been resolved:
wifi: ieee80211: validate MLE common info length
ieee80211_mle_common_size() uses the first common-info octet as the
common information length for all known MLE types. However,
ieee80211_mle_size_ok() only validates that octet for Basic, Probe
Request, and TDLS MLEs.
Reconfiguration MLEs also skipped the length octet when calculating the
minimum common size, and Priority Access MLEs skipped validation of the
advertised common information length.
Account for the Reconfiguration common-info length octet and validate
the advertised common information length for all known MLE
wifi: mac80211: validate extension-frame layout before RX
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: validate extension-frame layout before RX
Extension frames only have the extension header at the regular 802.11
header offset. The generic RX path can still reach helpers and interface
dispatch code that read regular header address fields before unsupported
extension subtypes are dropped.
mac80211 currently only handles S1G beacon extension frames. Drop other
extension subtypes before they can reach regular-header RX processing.
For S1G beacons, linearize the SKB with the management-frame path and
require the fixed S1G beacon header, including optional fixe
wifi: mwifiex: fix permanently busy scans after multiple roam iterations
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix permanently busy scans after multiple roam iterations
In order for the firmware to sleep, the driver has to confirm a
previously received sleep request. The normal sequence of evets goes
like this:
EVENT_SLEEP -> adapter->ps_state = PS_STATE_PRE_SLEEP -> sleep-confirm
-> SLEEP -> EVENT_AWAKE -> AWAKE.
Before sending the sleep-confirm command, the driver must make sure
there are no commands either running or waiting to be completed.
mwifiex_ret_802_11_associate() unconditionally sets
ps_state = PS_STATE_AWAKE when it processes the association command
resp
In the Linux kernel, the following vulnerability has been resolved:
mtd: mchp23k256: use SPI match data for chip caps
The driver stores chip capacity information in both the OF match table
and the SPI id table. Probe currently uses of_device_get_match_data(),
so a non-OF SPI modalias match falls back to mchp23k256_caps even when
the SPI id table selected a different part.
Use spi_get_device_match_data() so SPI id-table driver_data is consumed
when OF match data is absent. This keeps the existing default fallback
while avoiding the wrong MTD geometry for id-table-only matches.
mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout
lpc32xx_xmit_dma() waits for the DMA completion callback but ignores
wait_for_completion_timeout(). A timed out DMA transfer is therefore
unmapped and reported as successful to the NAND read/write path.
Return -ETIMEDOUT when the completion wait expires. Terminate the DMA
channel before unmapping the scatterlist so the timed out transfer cannot
continue to access the buffer after the error is returned.
device property: initialize the remaining fields of fwnode_handle in fwnode_init()
In the Linux kernel, the following vulnerability has been resolved:
device property: initialize the remaining fields of fwnode_handle in fwnode_init()
If a firmware node is allocated on the stack (for instance: temporary
software node whose life-time we control) or on the heap - but using a
non-zeroing allocation function - and initialized using fwnode_init(),
its secondary pointer will contain uninitialized memory which likely
will be neither NULL nor IS_ERR() and so may end up being dereferenced
(for example: in dev_to_swnode()). Set fwnode->secondary to NULL on
initialization. While at it: initialize the remaining fields of struct
fwnode