SUNRPC: wait for in-flight client TLS handshake callback
In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: wait for in-flight client TLS handshake callback
xs_tls_handshake_sync() gives xs_tls_handshake_done() a reference to the
lower transport before submitting the handshake request. On timeout or
signal, the synchronous waiter drops that reference after calling
tls_handshake_cancel().
handshake_req_cancel() returns false when handshake_complete() has
already marked the request complete. In that case the completion callback
can still be running, so dropping the callback-owned reference in the
waiter can free the lower transport before xs_tls_handshake_done() stores
xpr
svcrdma: Reorder rpcrdma_rn_unregister before rdma_destroy_id
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Reorder rpcrdma_rn_unregister before rdma_destroy_id
svc_rdma_free() caches rdma->sc_cm_id->device before teardown,
then calls rdma_destroy_id(sc_cm_id) which frees the cm_id.
rpcrdma_rn_unregister() follows, but between those two calls
the transport's sc_rn entry is still installed in the device's
rd_xa. A concurrent ib_unregister_device walk can dispatch
svc_rdma_xprt_done() against the now-freed sc_cm_id.
Move rpcrdma_rn_unregister() before rdma_destroy_id() so the
transport's notification entry is removed from the xarray before
the cm_id it references is destr
svcrdma: Clear sc_cm_id when ADDR_CHANGE replacement fails
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Clear sc_cm_id when ADDR_CHANGE replacement fails
When svc_rdma_listen_handler() handles RDMA_CM_EVENT_ADDR_CHANGE,
it creates a replacement listener cm_id and returns 1, telling
the CM core to destroy the old one. If the replacement allocation
fails, sc_cm_id still points at the old cm_id that the CM core is
about to destroy. Any subsequent dereference of sc_cm_id --
such as svc_rdma_detach()'s rdma_disconnect() call -- is a
use-after-free.
NULL sc_cm_id on the failure path and guard svc_rdma_detach()'s
rdma_disconnect() call against NULL so that the listener can
svcrdma: Fix offset arithmetic in read_chunk_range
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Fix offset arithmetic in read_chunk_range
svc_rdma_read_chunk_range() walks a Read chunk's segment list to
build a sub-range starting at byte offset and spanning length bytes
for a Position-Zero or Call chunk. Two arithmetic defects in the
per-segment loop produce wrong DMA lengths and a u32 underflow:
pcl_for_each_segment(segment, chunk) {
if (offset > segment->rs_length) {
offset -= segment->rs_length;
continue;
}
dummy.rs_handle = segment->rs_handle;
dummy.rs_length = m
svcrdma: Fix pcl_for_each_segment for empty chunks
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Fix pcl_for_each_segment for empty chunks
When a parsed chunk list contains a chunk whose ch_segcount is zero,
pcl_for_each_segment computes its inclusive upper bound as
&chunk->ch_segments[ch_segcount - 1]. ch_segcount is u32, so the
subtraction wraps to 0xFFFFFFFF and the bound lands far past the
ch_segments flex array. The loop body then walks unrelated memory at
sizeof(struct svc_rdma_segment) stride until it faults.
A zero-segcount chunk is reachable from the wire:
xdr_check_write_chunk() only rejects segcount values greater than
rc_maxpages, and pcl_alloc_wr
svcrdma: Reject connection when transport allocation fails
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Reject connection when transport allocation fails
handle_connect_req() returns without action when
svc_rdma_create_xprt() fails to allocate the new transport.
The CM core returns 0 for CONNECT_REQUEST events, so it does
not destroy the new rdma_cm_id. Each allocation failure under
memory pressure leaks one rdma_cm_id, and a remote peer driving
connection attempts can amplify this.
Reject the connection by returning a non-zero status from the
CM event handler, which tells the CM core to destroy the
orphaned cm_id.
svcrdma: Reject inline replies that overflow the pull-up buffer
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Reject inline replies that overflow the pull-up buffer
An RPC-over-RDMA client can request a reply, such as an NFS READ
payload, without providing a Write list or a Reply chunk to carry
it. When such a reply needs more scatter/gather entries than the
device's Send Queue supports, svc_rdma_pull_up_needed() selects
pull-up and svc_rdma_pull_up_reply_msg() linearizes the whole
reply into sctxt->sc_xprt_buf. That buffer is only sc_max_req_size
bytes, while the reply on this path is bounded only by the client's
request, so svc_rdma_xb_linearize() copies past the end of
svcrdma: Reject Read lists that exceed the page budget
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Reject Read lists that exceed the page budget
Individual Read segment lengths are validated at decode time, but
nothing prevents a requester from sending multiple segments whose
cumulative length exceeds the rq_pages array budget. When one
segment fills the page array exactly, the runtime guard in
svc_rdma_build_read_segment() is bypassed because len reaches zero.
A subsequent segment then accesses the NULL sentinel slot at
rq_pages[rq_maxpages], resulting in a NULL pointer dereference during
DMA mapping.
Accumulate pages across all Read segments and reject the me
svcrdma: Use svc_xprt_put to free listener on create failure
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Use svc_xprt_put to free listener on create failure
svc_rdma_create() calls kfree(cma_xprt) when
svc_rdma_create_listen_id() fails. svc_xprt_init() has already
acquired a net namespace reference via get_net_track(); kfree
bypasses svc_xprt_free() which releases it.
Replace the kfree() with svc_xprt_put() so the kref_init birth
reference drops to zero and svc_xprt_free() dispatches
svc_rdma_free() to clean up properly. sc_cm_id is still NULL
at that point; the preceding patch added the necessary NULL
guard in svc_rdma_free().
svc_xprt_free() also drops the module
svcrdma: Validate Read chunk positions before reconstruction
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: Validate Read chunk positions before reconstruction
The RPC/RDMA Read chunk position field is supplied by the remote
client and stored verbatim in the parsed chunk list.
xdr_count_read_segments() checks only 4-byte alignment; it never
compares the position against the received inline body length.
In the single-chunk path, svc_rdma_read_complete_one() splits the
head and tail kvecs at ch_position. A position past the inline
body underflows the tail length, exposing adjacent slab memory to
the upper XDR decoder.
In the multi-chunk path, svc_rdma_read_multiple_chunk
In the Linux kernel, the following vulnerability has been resolved:
udf: reject VAT indexes equal to the entry count
UDF 1.50 virtual partition mapping uses the VAT as an array of physical
block mappings. s_num_entries stores the number of entries in that array,
not the highest valid index. The valid VAT indexes are therefore below
s_num_entries.
udf_get_pblock_virt15() currently rejects only indexes greater than
s_num_entries. A crafted image can request index s_num_entries, pass the
bounds check, and make the kernel read one entry past the allocated VAT table.
Change the check to reject block >= s_num_entries, so the count is handled as
wifi: ath6kl: clamp assoc request/response lengths before subtracting IE offsets
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath6kl: clamp assoc request/response lengths before subtracting IE offsets
ath6kl_cfg80211_connect_event() subtracts fixed IE offsets from
assoc_req_len (-= 4) and assoc_resp_len (-= 6), both u8, with no lower
bound. The aggregate check recently added to ath6kl_wmi_connect_event_rx()
bounds the declared lengths from above (their sum must fit the received
event), but an assoc request/response shorter than its fixed offset still
underflows here: the u8 wraps to ~250, and cfg80211_connect_result() /
cfg80211_roamed() then treat that wrapped value as the IE length and cop
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: cancel pending mlo_pm_work
If the device is reset, suspended or unregistered within that window,
the pending work can still run and access vif/bss data that may already
be freed, or send MCU commands while the firmware is not available.
Add cancel_delayed_work_sync(&dev->mlo_pm_work) in all relevant teardown
and suspend paths:
- mt7925_mac_reset_work() (chip reset recovery)
- mt7925e_unregister_device() (PCIe unbind)
- mt7925_pci_suspend() (PCIe bus suspend)
- mt7925_suspend() (mac80211 suspend)
- mt7925u_suspend(
media: staging/ipu7: fix async notifier UAF on probe error path
In the Linux kernel, the following vulnerability has been resolved:
media: staging/ipu7: fix async notifier UAF on probe error path
isys_register_devices() registers the V4L2 async notifier via
isys_notifier_init(). If a subsequent probe step such as
isys_fw_log_init() fails, isys_probe() jumps to the out_cleanup label
which only calls isys_unregister_devices(). That helper tears down the
video devices, subdevices, V4L2 device and media device, but never
unregisters or cleans up the async notifier.
As a result the notifier stays chained in the global notifier_list while
the enclosing struct ipu7_isys is freed by devres, leading to list
cor
sched/core: Make core-sched flips wait for in-flight selections
In the Linux kernel, the following vulnerability has been resolved:
sched/core: Make core-sched flips wait for in-flight selections
Core scheduling's pick_next_task() operates on all sibling rqs under one
acquisition of the shared core-wide lock. A ->pick_task() that releases the
rq lock leaves every sibling __lock momentarily free, letting
__sched_core_flip(false) complete mid-selection and rebind rq_lockp() under
it. The selection resumes on the split locks, touching sibling state it no
longer protects, and __schedule() finally releases a lock that was never
taken while leaking the one that was.
Count in-flight core-wide selections in th
scsi: core: Fill in DMA padding bytes in scsi_alloc_sgtables()
In the Linux kernel, the following vulnerability has been resolved:
scsi: core: Fill in DMA padding bytes in scsi_alloc_sgtables()
During fuzz testing, the following issue was discovered:
BUG: KMSAN: uninit-value in __dma_map_sg_attrs+0x217/0x310
__dma_map_sg_attrs+0x217/0x310
dma_map_sg_attrs+0x4a/0x70
ata_qc_issue+0x9f8/0x1420
__ata_scsi_queuecmd+0x1657/0x1740
ata_scsi_queuecmd+0x79a/0x920
scsi_queue_rq+0x4472/0x4f40
blk_mq_dispatch_rq_list+0x1cca/0x3ee0
__blk_mq_sched_dispatch_requests+0x458/0x630
blk_mq_sched_dispatch_requests+0x15b/0x340
__blk_mq_run_hw_queue+0xe5/0x250
__blk_mq_delay_run_hw_queue+0x138/0x780
blk_mq_run_hw
scsi: fnic: Use GFP_ATOMIC for VLAN alloc under spinlock
In the Linux kernel, the following vulnerability has been resolved:
scsi: fnic: Use GFP_ATOMIC for VLAN alloc under spinlock
fnic_fcoe_process_vlan_resp() allocates a VLAN descriptor with
kzalloc_obj() (default GFP_KERNEL) while holding vlans_lock via
spin_lock_irqsave(). GFP_KERNEL may sleep, which is not allowed in this
atomic context and can trigger a sleeping-from-invalid-context warning
or deadlock.
Pass GFP_ATOMIC so the allocation is safe under the IRQ-safe spinlock.
remoteproc: scp: Fix device reference leak on failed lookup
In the Linux kernel, the following vulnerability has been resolved:
remoteproc: scp: Fix device reference leak on failed lookup
Make sure to drop the reference taken to the SCP device when attempting
to look up its driver data before the driver has been bound.
Note that holding a reference to a device does not prevent its driver
data from going away.
qede: Fix NULL pointer dereference in TPA fragment processing
In the Linux kernel, the following vulnerability has been resolved:
qede: Fix NULL pointer dereference in TPA fragment processing
Under memory pressure, the qede driver encounters NULL pointer
dereferences when processing TPA continuation fragments.
Commit 8a8633978b84 ("qede: Add build_skb() support.") accidentally
dropped the assignment of tpa_info->buffer.data in qede_tpa_start().
When memory pressure causes an SKB allocation failure in qede_tpa_start(),
the driver sets tpa_start_fail = true and attempts to recycle the physical
page later in qede_tpa_end() via qede_reuse_page(). However, because
buffer.data was left uninitialized (NULL
RDMA/cxgb4: Cancel reg_work before freeing device on remove
In the Linux kernel, the following vulnerability has been resolved:
RDMA/cxgb4: Cancel reg_work before freeing device on remove
c4iw_uld_state_change() queues reg_work to register the RDMA device.
c4iw_remove() can free ctx->dev while this work is pending or running,
leaving c4iw_register_device() accessing the freed device.
Cancel reg_work before removing the device. The registration work can
tear down ctx->dev when registration fails, so do not unregister or
deallocate it again in that case.
This issue was found by an in-house static analysis tool.