In the Linux kernel, the following vulnerability has been resolved:
crypto: sun8i-ss - Remove crypto_rng interface
Since the crypto_rng interface for hardware PRNGs is unused and is
redundant with hwrng and the actual Linux RNG, it's being phased out.
Most drivers for it were already removed. Go ahead and remove the
sun8i-ss support which is one of the only remaining ones.
As usual for crypto_rng, this driver was also buggy: its ->generate()
function had a use-after-free vulnerability due to using
wait_for_completion_interruptible_timeout() without handling shutting
down the DMA operation if a signal is sent. Also, it had a buffer
overre
In the Linux kernel, the following vulnerability has been resolved:
crypto: qce - fix CCM AAD buffer underallocation
The AAD buffer allocated in qce_aead_ccm_prepare_buf_assoclen()
can be smaller than the length later programmed into the DMA
scatterlist.
The allocation size is currently calculated as:
ALIGN(assoclen, 16) + MAX_CCM_ADATA_HEADER_LEN
while the DMA length is set to:
ALIGN(assoclen + adata_header_len, 16)
Since ALIGN() does not distribute over addition, the allocation
can be smaller than the DMA length. For example, when
assoclen = 32 and adata_header_len = 2:
allocation = ALIGN(32, 16) + 6 = 38
DMA length = ALIGN(
In the Linux kernel, the following vulnerability has been resolved:
crypto: mxs-dcp - fix source scatterlist length access
mxs_dcp_aes_block_crypt() uses sg_dma_len() without mapping the source
scatterlist with dma_map_sg() first. Therefore, sg_dma_len() is invalid
and could return zero or a stale DMA length, causing encryption and
decryption to process the wrong number of bytes when
CONFIG_NEED_SG_DMA_LENGTH=y.
Use the original scatterlist length instead.
In the Linux kernel, the following vulnerability has been resolved:
usb: core: Add lock to usb_wakeup_notification()
Add a spin lock to usb_wakeup notification to prevent a race condition
with dereferencing freed memory. This could be hit by the xHCI driver as
it calls this function from an IRQ and could race with the
hub_disconnect() function, which properly grabs this lock to protect the
state of the device.
ALSA: usb-audio: fix OOB write in snd_usbmidi_novation_output()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write in snd_usbmidi_novation_output()
snd_usbmidi_novation_output() lays out a two-byte header at
transfer_buffer[0..1] and passes &transfer_buffer[2] together with a
length of ep->max_transfer - 2 to snd_rawmidi_transmit():
count = snd_rawmidi_transmit(ep->ports[0].substream,
&transfer_buffer[2],
ep->max_transfer - 2);
ep->max_transfer comes from the output endpoint's wMaxPacketSize via
usb_maxpacket(). A malformed or malicious device can advertise a bulk
OUT endpoint with a wMaxPacketSize of 1 - the USB core only clamps this
ALSA: usb-audio: Complete cleanup after system-resume errors
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Complete cleanup after system-resume errors
A failed system resume can leave the card unusable until reboot.
usb_audio_resume() jumps to err_out when snd_usb_pcm_resume() or
snd_usb_mixer_resume() fails. The error path skips the out: block, which
restores D0 and decrements chip->num_suspended_intf.
The card stays in SNDRV_CTL_POWER_D3hot, so later control access blocks in
snd_power_ref_and_wait(). USB core logs an interface resume callback error.
It does not retry that callback, so a later callback cannot complete the
skipped cleanup.
usb_audio_suspend()
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: option: fix slab OOB read in interrupt URB callback
The interrupt URB buffer is allocated in setup_port_interrupt_in() based
on the endpoint's wMaxPacketSize:
buffer_size = usb_endpoint_maxp(epd);
port->interrupt_in_buffer = kmalloc(buffer_size, GFP_KERNEL);
When a USB device declares wMaxPacketSize = 8 on its interrupt IN
endpoint, the buffer is allocated from kmalloc-8 cache (exactly
8 bytes).
If the device sends a short packet (actual_length < wMaxPacketSize),
the URB completes with status == 0 and the callback proceeds to read:
data[sizeof(s
USB: c67x00: fix use-after-free in c67x00_add_iso_urb()
In the Linux kernel, the following vulnerability has been resolved:
USB: c67x00: fix use-after-free in c67x00_add_iso_urb()
When TD creation fails for the last packet of an isochronous URB,
c67x00_add_iso_urb() gives the URB back before updating the endpoint
scheduling state.
c67x00_giveback_urb() frees the URB private data, and the completion
callback may release the final URB reference. The following accesses to
urbp->ep_data, urb->interval, and urbp->cnt can therefore use freed
memory.
Update next_frame and cnt before giving back the failed final packet,
making the giveback the last operation that uses the URB and its private
data.
wifi: mt76: mt7925: ensure tx headroom in usb_sdio_tx_prepare_skb
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: ensure tx headroom in usb_sdio_tx_prepare_skb
mt7925_usb_sdio_tx_prepare_skb() pushes a TX descriptor and a USB
header onto every skb and assumes the headroom for them is already
there. That holds for locally generated traffic, where mac80211
reserves hw->extra_tx_headroom, but forwarded frames are sent through
ieee80211_8023_xmit(), which does not reserve it. Bridge a wired
interface to an mt7925u AP and the first forwarded frame that arrives
short panics the kernel:
skbuff: skb_under_panic: len:415 put:4 tail:0x19b end:0x640 dev:wlan1
kernel BUG at
usb: usbfs: fix use-after-free of usb_device in usbdev_release()
In the Linux kernel, the following vulnerability has been resolved:
usb: usbfs: fix use-after-free of usb_device in usbdev_release()
usbdev_release() drops its reference to the struct usb_device before
draining the list of completed async URBs, but that drain path reads back
through the same object: free_async() calls dec_usb_memory_use_count()
for any URB whose buffer came from the usbfs mmap() region, and its first
statement is bus_to_hcd(ps->dev->bus).
After a disconnect the usbfs reference can be the last one, in which case
usb_put_dev() frees the device and the subsequent loop reads offset 80 of
freed memory and uses the result as a s
nfc: st21nfca: validate ATR_REQ length against the received frame
In the Linux kernel, the following vulnerability has been resolved:
nfc: st21nfca: validate ATR_REQ length against the received frame
st21nfca_tm_recv_atr_req() checks that the received ATR_REQ frame is at
least ST21NFCA_ATR_REQ_MIN_SIZE and that the self-declared atr_req->length
is at least sizeof(struct st21nfca_atr_req), but never checks that
atr_req->length does not exceed the actual received length (skb->len).
st21nfca_tm_send_atr_res() then trusts the declared length:
gb_len = atr_req->length - sizeof(struct st21nfca_atr_req);
...
memcpy(atr_res->gbi, atr_req->gbi, gb_len);
so an RF peer that sends a short frame but sets atr_req
mailbox: mchp-ipc-sbi: Add null check for devm_kasprintf()
In the Linux kernel, the following vulnerability has been resolved:
mailbox: mchp-ipc-sbi: Add null check for devm_kasprintf()
Add a check to see if devm_kasprintf() is not NULL in
mchp_ipc_get_cluster_aggr_irq(), returning -ENOMEM if the function
failed.
nvmet: pci-epf: put CQ ref on create_cq mapping failure
In the Linux kernel, the following vulnerability has been resolved:
nvmet: pci-epf: put CQ ref on create_cq mapping failure
nvmet_pci_epf_create_cq() calls nvmet_cq_create(), which takes a
reference on the controller and installs the completion queue. If the
subsequent PCI address-space mapping fails or returns a too-small partial
mapping, the function jumps to err_internal / err_unmap_queue without
calling nvmet_cq_put(). The matching put in nvmet_pci_epf_delete_cq() is
gated on NVMET_PCI_EPF_Q_LIVE, which is only set after the mapping
succeeds, so teardown never releases these references. A remote PCI host
that drives Create IO CQ command
xfs: don't livelock in scrub on a circular unlinked list
In the Linux kernel, the following vulnerability has been resolved:
xfs: don't livelock in scrub on a circular unlinked list
LOLLM points out that online fsck can livelock if an unlinked inode list
contains a loop. Use a bitmap to detect cycles.
Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept
rfcomm_sock_recvmsg() completes a deferred setup by calling
rfcomm_dlc_accept() without holding any RFCOMM lock:
if (test_and_clear_bit(RFCOMM_DEFER_SETUP, &d->flags)) {
rfcomm_dlc_accept(d);
return 0;
}
and rfcomm_dlc_accept() dereferences the session on its first line:
struct sock *sk = d->session->sock->sk;
Every other path that touches d->session runs under rfcomm_mutex:
rfcomm_dlc_open(), rfcomm_dlc_close(), rfcomm_dlc_exists(),
rfcomm_dlc_send_rpn(), and the RFCOMM thread through
rfcomm_proc
iommu/tegra241-cmdqv: Fix CMD_SYNC use-after-free on teardown
In the Linux kernel, the following vulnerability has been resolved:
iommu/tegra241-cmdqv: Fix CMD_SYNC use-after-free on teardown
arm_smmu_impl_remove() is registered as a devres action in
arm_smmu_impl_probe(), before arm_smmu_init_queues() allocates
smmu->cmdq.q.base. On a devres unwind, whether a failed probe or an
unbind, the queue is freed first and arm_smmu_impl_remove() then runs
tegra241_cmdqv_remove_vintf(), whose VINTF deinit issues a CMD_SYNC on
the freed memory.
Observed during testing with a QEMU hack that makes the VCMDQ fail to
enable, so the impl reset fails and probe aborts into the devres unwind:
platform NVDA200C:00: t
iommu/iommufd: Fix NULL pointer deref in iommufd_ioas_change_process when racing with iopt_map_file_pages
In the Linux kernel, the following vulnerability has been resolved:
iommu/iommufd: Fix NULL pointer deref in iommufd_ioas_change_process when racing with iopt_map_file_pages
iommufd_ioas_change_process() iterates every IOAS area while only
holding every IOAS iova_rwsem, so it assumes every area has a non-NULL
pages pointer. That assumption can be false when it runs concurrently
with iopt_map_file_pages().
iopt_map_pages() executes in two phases. It first creates the area and
inserts it into the interval tree under iova_rwsem, with area->pages
still NULL. It then drops iova_rwsem and later fills area->pages
under domains_rwsem. This leaves
ALSA: FCP: Use a private URB for the notification endpoint
In the Linux kernel, the following vulnerability has been resolved:
ALSA: FCP: Use a private URB for the notification endpoint
fcp_init_notify() used mixer->urb, which snd_usb_mixer_status_create()
allocates for the optional UAC2 status interrupt endpoint and mixer.c
kills, resubmits and frees. On a device with that endpoint,
fcp_init_notify()'s "already set up" early return fires on the status
URB and returns success without doing anything. No FCP notification
URB is submitted, and cmd_done is left zeroed because it is
initialised past that early return and nowhere else. fcp_init() then
issues init1_opcode and wait_for_completion_timeout()
ALSA: scarlett2: Use a private URB for the notification endpoint
In the Linux kernel, the following vulnerability has been resolved:
ALSA: scarlett2: Use a private URB for the notification endpoint
scarlett2_init_notify() used mixer->urb, which
snd_usb_mixer_status_create() allocates for the UAC2 status interrupt
endpoint and mixer.c manages. On a device with that endpoint, the
"already in use" check fires on the status URB and returns 0 for
success without doing anything. No notification URB is submitted, and
cmd_done is left zeroed because it is initialised past that check and
nowhere else. scarlett2_usb_init() then issues SCARLETT2_USB_INIT_1
and wait_for_completion_timeout() would crash adding to the
rndis_host: add overflow check in rndis_rx_fixup()
In the Linux kernel, the following vulnerability has been resolved:
rndis_host: add overflow check in rndis_rx_fixup()
Add an overflow check to ensure that data_offset + data_len + 8 does not
wrap, which would enable an OOB read of the USB data buffer.