virtio: break and reset virtio devices on device_shutdown()
In the Linux kernel, the following vulnerability has been resolved:
virtio: break and reset virtio devices on device_shutdown()
Hongyu reported a hang on kexec in a VM. QEMU reported invalid memory
accesses during the hang.
Invalid read at addr 0x102877002, size 2, region '(null)', reason: rejected
Invalid write at addr 0x102877A44, size 2, region '(null)', reason: rejected
...
It was traced down to virtio-console. Kexec works fine if virtio-console
is not in use.
The issue is that virtio-console continues to write to the MMIO even after
underlying virtio-pci device is reset.
Additionally, Eric noticed that IOMMUs are reset before de
dmaengine: ti: k3-udma-glue: Drop skip_fdq argument from k3_udma_glue_reset_rx_chn
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: ti: k3-udma-glue: Drop skip_fdq argument from k3_udma_glue_reset_rx_chn
The user of k3_udma_glue_reset_rx_chn() e.g. ti_am65_cpsw_nuss can
run on multiple platforms having different DMA architectures.
On some platforms there can be one FDQ for all flows in the RX channel
while for others there is a separate FDQ for each flow in the RX channel.
So far we have been relying on the skip_fdq argument of
k3_udma_glue_reset_rx_chn().
Instead of relying on the user to provide this information, infer it
based on DMA architecture during k3_udma_glue_request_rx_chn() and
clk: sunxi-ng: h616: Reparent GPU clock during frequency changes
In the Linux kernel, the following vulnerability has been resolved:
clk: sunxi-ng: h616: Reparent GPU clock during frequency changes
The H616 manual does not state that the GPU PLL supports
dynamic frequency configuration, so we must take extra care when changing
the frequency. Currently any attempt to do device DVFS on the GPU lead
to panfrost various ooops, and GPU hangs.
The manual describes the algorithm for changing the PLL
frequency, which the CPU PLL notifier code already support, so we reuse
that to reparent the GPU clock to GPU1 clock during frequency
changes.
cpufreq: amd-pstate: Remove unnecessary driver_lock in set_boost
In the Linux kernel, the following vulnerability has been resolved:
cpufreq: amd-pstate: Remove unnecessary driver_lock in set_boost
set_boost is a per-policy function call, hence a driver wide lock is
unnecessary. Also this mutex_acquire can collide with the mutex_acquire
from the mode-switch path in status_store(), which can lead to a
deadlock. So, remove it.
drm/xe/vf: Perform early GT MMIO initialization to read GMDID
In the Linux kernel, the following vulnerability has been resolved:
drm/xe/vf: Perform early GT MMIO initialization to read GMDID
VFs need to communicate with the GuC to obtain the GMDID value
and existing GuC functions used for that assume that the GT has
it's MMIO members already setup. However, due to recent refactoring
the gt->mmio is initialized later, and any attempt by the VF to use
xe_mmio_read|write() from GuC functions will lead to NPD crash due
to unset MMIO register address:
[] xe 0000:00:02.1: [drm] Running in SR-IOV VF mode
[] xe 0000:00:02.1: [drm] GT0: sending H2G MMIO 0x5507
[] BUG: unable to handle page fault for address:
kasan: avoid sleepable page allocation from atomic context
In the Linux kernel, the following vulnerability has been resolved:
kasan: avoid sleepable page allocation from atomic context
apply_to_pte_range() enters the lazy MMU mode and then invokes
kasan_populate_vmalloc_pte() callback on each page table walk iteration.
However, the callback can go into sleep when trying to allocate a single
page, e.g. if an architecutre disables preemption on lazy MMU mode enter.
On s390 if make arch_enter_lazy_mmu_mode() -> preempt_enable() and
arch_leave_lazy_mmu_mode() -> preempt_disable(), such crash occurs:
[ 0.663336] BUG: sleeping function called from invalid context at ./include/linux/sched/mm.h:321
In the Linux kernel, the following vulnerability has been resolved:
accel/ivpu: Fix locking order in ivpu_job_submit
Fix deadlock in job submission and abort handling.
When a thread aborts currently executing jobs due to a fault,
it first locks the global lock protecting submitted_jobs (#1).
After the last job is destroyed, it proceeds to release the related context
and locks file_priv (#2). Meanwhile, in the job submission thread,
the file_priv lock (#2) is taken first, and then the submitted_jobs
lock (#1) is obtained when a job is added to the submitted jobs list.
CPU0 CPU1
----
ublk: fix race between io_uring_cmd_complete_in_task and ublk_cancel_cmd
In the Linux kernel, the following vulnerability has been resolved:
ublk: fix race between io_uring_cmd_complete_in_task and ublk_cancel_cmd
ublk_cancel_cmd() calls io_uring_cmd_done() to complete uring_cmd, but
we may have scheduled task work via io_uring_cmd_complete_in_task() for
dispatching request, then kernel crash can be triggered.
Fix it by not trying to canceling the command if ublk block request is
started.
um: work around sched_yield not yielding in time-travel mode
In the Linux kernel, the following vulnerability has been resolved:
um: work around sched_yield not yielding in time-travel mode
sched_yield by a userspace may not actually cause scheduling in
time-travel mode as no time has passed. In the case seen it appears to
be a badly implemented userspace spinlock in ASAN. Unfortunately, with
time-travel it causes an extreme slowdown or even deadlock depending on
the kernel configuration (CONFIG_UML_MAX_USERSPACE_ITERATIONS).
Work around it by accounting time to the process whenever it executes a
sched_yield syscall.
netfs: Only create /proc/fs/netfs with CONFIG_PROC_FS
In the Linux kernel, the following vulnerability has been resolved:
netfs: Only create /proc/fs/netfs with CONFIG_PROC_FS
When testing a special config:
CONFIG_NETFS_SUPPORTS=y
CONFIG_PROC_FS=n
The system crashes with something like:
[ 3.766197] ------------[ cut here ]------------
[ 3.766484] kernel BUG at mm/mempool.c:560!
[ 3.766789] Oops: invalid opcode: 0000 [#1] SMP NOPTI
[ 3.767123] CPU: 0 UID: 0 PID: 1 Comm: swapper/0 Tainted: G W
[ 3.767777] Tainted: [W]=WARN
[ 3.767968] Hardware name: QEMU Standard PC (i440FX + PIIX, 1996),
[ 3.768523] RIP: 0010:mempool_alloc_slab.cold+0x17/0x19
[ 3.768847] Code:
drm/amd/display: prevent hang on link training fail
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: prevent hang on link training fail
[Why]
When link training fails, the phy clock will be disabled. However, in
enable_streams, it is assumed that link training succeeded and the
mux selects the phy clock, causing a hang when a register write is made.
[How]
When enable_stream is hit, check if link training failed. If it did, fall
back to the ref clock to avoid a hang and keep the system in a recoverable
state.
In the Linux kernel, the following vulnerability has been resolved:
mm/vmscan: don't try to reclaim hwpoison folio
Syzkaller reports a bug as follows:
Injecting memory failure for pfn 0x18b00e at process virtual address 0x20ffd000
Memory failure: 0x18b00e: dirty swapcache page still referenced by 2 users
Memory failure: 0x18b00e: recovery action for dirty swapcache page: Failed
page: refcount:2 mapcount:0 mapping:0000000000000000 index:0x20ffd pfn:0x18b00e
memcg:ffff0000dd6d9000
anon flags: 0x5ffffe00482011(locked|dirty|arch_1|swapbacked|hwpoison|node=0|zone=2|lastcpupid=0xfffff)
raw: 005ffffe00482011 dead000000000100 dead000000000122 ffff
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Keep write operations atomic
syzbot reported a NULL pointer dereference in __generic_file_write_iter. [1]
Before the write operation is completed, the user executes ioctl[2] to clear
the compress flag of the file, which causes the is_compressed() judgment to
return 0, further causing the program to enter the wrong process and call the
wrong ops ntfs_aops_cmpr, which triggers the null pointer dereference of
write_begin.
Use inode lock to synchronize ioctl and write to avoid this case.
[1]
Unable to handle kernel NULL pointer dereference at virtual address 000000
bpf: check changes_pkt_data property for extension programs
In the Linux kernel, the following vulnerability has been resolved:
bpf: check changes_pkt_data property for extension programs
When processing calls to global sub-programs, verifier decides whether
to invalidate all packet pointers in current state depending on the
changes_pkt_data property of the global sub-program.
Because of this, an extension program replacing a global sub-program
must be compatible with changes_pkt_data property of the sub-program
being replaced.
This commit:
- adds changes_pkt_data flag to struct bpf_prog_aux:
- this flag is set in check_cfg() for main sub-program;
- in jit_subprogs() for other sub-programs;
-
bpf: track changes_pkt_data property for global functions
In the Linux kernel, the following vulnerability has been resolved:
bpf: track changes_pkt_data property for global functions
When processing calls to certain helpers, verifier invalidates all
packet pointers in a current state. For example, consider the
following program:
__attribute__((__noinline__))
long skb_pull_data(struct __sk_buff *sk, __u32 len)
{
return bpf_skb_pull_data(sk, len);
}
SEC("tc")
int test_invalidate_checks(struct __sk_buff *sk)
{
int *p = (void *)(long)sk->data;
if ((void *)(p + 1) > (void *)(long)sk->data_end) return TCX_DROP;
skb_pull_data(sk, 0);
ksmbd: fix use-after-free in smb_break_all_levII_oplock()
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix use-after-free in smb_break_all_levII_oplock()
There is a room in smb_break_all_levII_oplock that can cause racy issues
when unlocking in the middle of the loop. This patch use read lock
to protect whole loop.
In the Linux kernel, the following vulnerability has been resolved:
perf: Fix hang while freeing sigtrap event
Perf can hang while freeing a sigtrap event if a related deferred
signal hadn't managed to be sent before the file got closed:
perf_event_overflow()
task_work_add(perf_pending_task)
fput()
task_work_add(____fput())
task_work_run()
____fput()
perf_release()
perf_event_release_kernel()
_free_event()
perf_pending_task_sync()
task_work_cancel() -> FAILED
rcuwait_wait_event()
Once task_work_run() is running, the list of
In the Linux kernel, the following vulnerability has been resolved:
perf/dwc_pcie: fix duplicate pci_dev devices
During platform_device_register, wrongly using struct device
pci_dev as platform_data caused a kmemdup copy of pci_dev. Worse
still, accessing the duplicated device leads to list corruption as its
mutex content (e.g., list, magic) remains the same as the original.
wifi: ath12k: Avoid memory leak while enabling statistics
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: Avoid memory leak while enabling statistics
Driver uses monitor destination rings for extended statistics mode and
standalone monitor mode. In extended statistics mode, TLVs are parsed from
the buffer received from the monitor destination ring and assigned to the
ppdu_info structure to update per-packet statistics. In standalone monitor
mode, along with per-packet statistics, the packet data (payload) is
captured, and the driver updates per MSDU to mac80211.
When the AP interface is enabled, only extended statistics mode is
activated. As part of enabling moni
drm/xe/vf: Don't try to trigger a full GT reset if VF
In the Linux kernel, the following vulnerability has been resolved:
drm/xe/vf: Don't try to trigger a full GT reset if VF
VFs don't have access to the GDRST(0x941c) register that driver
uses to reset a GT. Attempt to trigger a reset using debugfs:
$ cat /sys/kernel/debug/dri/0000:00:02.1/gt0/force_reset
or due to a hang condition detected by the driver leads to:
[ ] xe 0000:00:02.1: [drm] GT0: trying reset from force_reset [xe]
[ ] xe 0000:00:02.1: [drm] GT0: reset queued
[ ] xe 0000:00:02.1: [drm] GT0: reset started
[ ] ------------[ cut here ]------------
[ ] xe 0000:00:02.1: [drm] GT0: VF is trying to write 0x1 to an inaccessibl