dm-pcache: validate on-media seg_num against the cache device size
In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: validate on-media seg_num against the cache device size
seg_num is read from the crc32c-only superblock, so whoever supplies the
cache device on a table load (CAP_SYS_ADMIN) controls it. It sizes
cache->segments[] and is the value every later on-media segment id is
bounded against, yet it is never checked against the device. Because
cache_dev->mapping is the direct map of the pmem, CACHE_DEV_SEGMENT() for
a segment id past the device resolves to ordinary kernel memory beyond
the mapping; a new-cache init reaching such an id has cache_seg_init() ->
cache_dev_zero_
dm-pcache: bound the persisted tail-position offset
In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: bound the persisted tail-position offset
cache_pos_decode() takes the persisted key_tail and dirty_tail seg_off from
the cache device and addresses within the segment with it. A seg_off at or
past the segment data_size, controllable by whoever supplies the device
(CAP_SYS_ADMIN), reads past the segment data.
Reject a decoded seg_off that is not below the segment data_size.
dm-pcache: clamp the tail kset read to the segment data region
In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: clamp the tail kset read to the segment data region
The tail-kset read in cache_replay(), the writeback worker and the GC
worker bounds its length by PCACHE_SEG_SIZE - seg_off, the raw segment
size rather than the data region. A tail near the segment end reads past
the segment data into the following control area.
Clamp the read to cache_seg_remain(), the data region.
dm-pcache: detect a cycle in the last-kset chain during replay
In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: detect a cycle in the last-kset chain during replay
cache_replay() follows the on-media last-kset chain by next_cache_seg_id
with no cond_resched(). A forged chain that points back into a segment it
has already visited makes the replay loop follow it forever.
Cap the last-kset hops at cache->n_segs; a valid chain visits each segment
at most once.
dm-pcache: only hand out initialized cache segments
In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: only hand out initialized cache segments
get_cache_segment() scans the segment map up to cache->n_segs, the
physical device segment count, but cache_segs_init() only initializes
the first cache_info->n_segs segments. A crafted image with
cache_info->n_segs smaller than the device count leaves the remaining
pcache_cache_segment structs zeroed (segment.data == NULL), and the
allocator can hand one to cache_kset_close(), which writes through the
returned segment's data pointer with no NULL check.
Bound the allocator's search to cache_info->n_segs so only initialize
dm-pcache: fix use-after-free and invalid seg operations in kset_replay()
In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: fix use-after-free and invalid seg operations in kset_replay()
In kset_replay, when key->seg_gen is stale (key->seg_gen <
key->cache_pos.cache_seg->gen), cache_key_put(key) is called but then
key->cache_pos.cache_seg is accessed as the argument to cache_seg_get().
This is a use-after-free on the freed key memory. Although mempool
recycled memory is not immediately reclaimed or overwritten in practice,
this is still a potential UAF bug.
Additionally, for expired invalid keys, setting the cache->seg_map bit
and calling cache_seg_get() is unreasonable since the cor
i3c: Fix unlocked dereference of dev->desc in i3c_device_get_supported_xfer_mode()
In the Linux kernel, the following vulnerability has been resolved:
i3c: Fix unlocked dereference of dev->desc in i3c_device_get_supported_xfer_mode()
i3c_device_get_supported_xfer_mode() uses dev->desc to obtain the
master controller. However, dev->desc must not be dereferenced unless
bus->lock is held, and this function does not take that lock.
The function only needs access to the master controller associated with
the device's bus. Use dev->bus instead, which is always valid for the
lifetime of the device and does not require dereferencing dev->desc.
i3c: master: adi: initialize the lock before enabling interrupts
In the Linux kernel, the following vulnerability has been resolved:
i3c: master: adi: initialize the lock before enabling interrupts
adi_i3c_master_probe() requests the IRQ and unmasks REG_IRQ_PENDING_CMDR
before the controller's IBI state, transfer queue list and transfer
queue lock are initialized. A pending CMDR interrupt can therefore run
adi_i3c_master_irq() and take master->xferqueue.lock before the dynamic
lock has been initialized.
This issue was found by our static analysis tool and then manually
reviewed against the current tree.
The grounded PoC kept the probe ordering and the IRQ path
adi_i3c_master_probe() -> adi_i3c_master_
i3c: master: Fix info leak and UAF in device unregister path
In the Linux kernel, the following vulnerability has been resolved:
i3c: master: Fix info leak and UAF in device unregister path
i3c_master_unregister_i3c_devs() clears i3cdev->dev->desc before
calling device_unregister(). During device_unregister(),
device_del() emits a KOBJ_REMOVE uevent and unbinds the driver while
the device descriptor is still expected to be valid. As a result,
i3c_device_uevent() and a racing modalias_show() can observe a NULL
desc and fall back to an uninitialized stack struct i3c_device_info,
leaking kernel stack contents in the generated modalias. Driver
.remove() callbacks may also encounter an unexpected NULL
i3c: master: svc: bound IBI payload to the requested max_payload_len
In the Linux kernel, the following vulnerability has been resolved:
i3c: master: svc: bound IBI payload to the requested max_payload_len
svc_i3c_master_handle_ibi() reads the IBI payload from the RX FIFO into
the IBI slot. The loop is bounded by the hardware FIFO size
(SVC_I3C_FIFO_SIZE), not by the slot size.
slot->data points into the IBI pool, which i3c_generic_ibi_alloc_pool()
sizes at max_payload_len per slot. svc_i3c_master_request_ibi() only
rejects a max_payload_len larger than SVC_I3C_FIFO_SIZE, so a driver can
request a smaller one. mctp-i3c requests 1. Each readsb() then copies the
controller RXCOUNT bytes (up to 31) with no che
i3c: renesas: Check that the transfer is valid before accessing it
In the Linux kernel, the following vulnerability has been resolved:
i3c: renesas: Check that the transfer is valid before accessing it
The Renesas I3C driver uses an asynchronous model to transfer data. It
prepares a struct renesas_i3c_xfer, enqueues it, and waits for completion.
The interrupt handler dequeues the transfer, updates/uses it, and signals
the waiting thread.
If the completion times out, the waiting thread dequeues the transfer and
free it. If an interrupt fires after that, the handler may access freed
memory, leading to crashes.
Check that the transfer is still valid before accessing it in the
interrupt handler. With it clea
wifi: brcmfmac: Fix memory leak in brcmf_sdio_read_control()
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: Fix memory leak in brcmf_sdio_read_control()
The memory allocated for buf is not freed in some of the error paths in
brcmf_sdio_read_control(). Fix that by adding vfree() calls.
[arend: rework as suggested by Johannes]
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In iwl_op_mode_dvm_start(), jumping to out_free_eeprom currently bypasses
the out_free_eeprom_blob label. Consequently, error paths triggered after
successfully parsing the EEPROM free priv->nvm_data but leak
priv->eeprom_blob.
Fix this memory leak by reordering the error handling labels so
that out_free_eeprom falls through to out_free_eeprom_blob.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under d
wifi: rtl8xxxu: fix use-after-free from rx_urb_wq on stop
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtl8xxxu: fix use-after-free from rx_urb_wq on stop
rtl8xxxu arms rx_urb_wq from the RX completion path:
rtl8xxxu_rx_complete() hands the URB to rtl8xxxu_queue_rx_urb(), which
queues it on rx_urb_pending_list and, once the list grows past
RTL8XXXU_RX_URB_PENDING_WATER, schedules rx_urb_wq. The worker
rtl8xxxu_rx_urb_work() drains rx_urb_pending_list, recovers priv through
container_of, and resubmits each URB through rtl8xxxu_submit_rx_urb(),
which anchors it on rx_anchor and dereferences priv->udev.
rtl8xxxu_stop() cancels the sibling work items (c2hcmd_work, ra_wat
fuse: copy request headers via a stack buffer for io-uring
In the Linux kernel, the following vulnerability has been resolved:
fuse: copy request headers via a stack buffer for io-uring
The fuse-io-uring transport copies req->in.h out to the ring in
fuse_uring_copy_to_ring() and req->out.h back in fuse_uring_commit().
Both headers live inside the fuse_request slab object, whose cache
(fuse_req_cachep) is created without a usercopy whitelist, so copying
them directly to/from userspace trips CONFIG_HARDENED_USERCOPY and
panics:
usercopy: Kernel memory exposure attempt detected from SLUB object
'fuse_request' (offset 56, size 40)!
kernel BUG at mm/usercopy.c:102!
Oops: invalid opcode: 0000 [#
crypto: iaa - unmap dst before software fallback on decompress
In the Linux kernel, the following vulnerability has been resolved:
crypto: iaa - unmap dst before software fallback on decompress
On a hardware analytics error, decompress retries through the software
fallback, which writes req->dst with the CPU while it is still mapped
DMA_FROM_DEVICE. With SWIOTLB active the later dma_unmap_sg() copies the
stale bounce buffer over req->dst, corrupting the result.
Unmap before the fallback runs. The async path unmaps inline; the sync
path signals the retry with -EAGAIN so iaa_comp_adecompress() runs the
fallback after unmapping.
wifi: mwifiex: Detach sync cmd buffer on interrupted wait
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: Detach sync cmd buffer on interrupted wait
mwifiex synchronous commands keep the caller-provided data buffer in
cmd_node->data_buf. Several callers pass stack-allocated objects there.
If wait_event_interruptible_timeout() is interrupted, the caller can
return and release that stack object while the firmware command is still
the current command. A late firmware response then reaches the normal
response handler, which can copy data through cmd_node->data_buf into the
stale stack address.
This fixes a stack corruption observed during repeated association and
d
wifi: rtlwifi: rtl8192du: check QoS TID before indexing tids
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: rtl8192du: check QoS TID before indexing tids
rtl92du_tx_fill_desc() uses ieee80211_get_tid() to read the QoS TID
from the 802.11 header and then uses it as an index into
sta_entry->tids[]. ieee80211_get_tid() returns the low 4-bit QoS TID
value, so the result can be in the range 0..15.
rtlwifi only allocates MAX_TID_COUNT entries for sta_entry->tids[], and
MAX_TID_COUNT is 9. A QoS TID greater than 8 therefore indexes past the
aggregation state array. Keep the default RTL_AGG_STOP state for
out-of-range TIDs, matching rtl92cu_tx_fill_desc().
This issue was
wifi: rtlwifi: rtl8192du: Fix possible memory leak in rtl92du_init_sw_vars()
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: rtl8192du: Fix possible memory leak in rtl92du_init_sw_vars()
The memory allocated inside rtl92du_init_shared_data() is not freed in
any of the subsequent error paths in rtl92du_init_sw_vars().
Fix that by adding a call to rtl92du_deinit_shared_data() in the error
path.
wifi: rtw88: Fix potential memory leak in rtw_txq_push_skb()
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: Fix potential memory leak in rtw_txq_push_skb()
The skb passed to the rtw_hci_tx_write() is expected to be freed when
the function fails, but the error path in rtw_txq_push_skb() does not
free the skb before returning. This can lead to a memory leak in
rtw_txq_push() where a dequeued skb is passed to rtw_txq_push_skb().