mm/percpu-km: fix bitmap overflow and accounting in pcpu_create_chunk()
In the Linux kernel, the following vulnerability has been resolved:
mm/percpu-km: fix bitmap overflow and accounting in pcpu_create_chunk()
In pcpu_create_chunk(), nr_pages is the total contiguous backing
allocation, i.e., nr_units * pcpu_unit_pages, but pcpu_chunk_populated()
uses it to set chunk->populated, whose size is pcpu_unit_pages, bitmap.
Since bit N in chunk->populated means page offset N inside every unit is
backed. When nr_units > 1, the function writes beyond chunk->populated.
Fix it by using chunk->nr_pages.
It also fixes the global pcpu_nr_empty_pop_pages accounting, since
pcpu_balance_free() only iterates up to chunk->nr
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate Adaptation Indication parameter length
The Adaptation Layer Indication parameter contains a fixed 32-bit
Adaptation Code Point after its parameter header. However,
sctp_verify_param() accepts a header-only parameter because the generic
parameter walker only requires the header to be present.
sctp_process_param() then reads adaptation_ind beyond the declared
parameter. When the malformed parameter is last in an INIT, the read
starts at the receive skb tail, and the value is copied into the state
cookie returned in the INIT ACK. This may disclose four receive-
In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcm: wake linked drain waiters on unlink
snd_pcm_drain() on a linked stream parks an on-stack wait entry on the
drained peer's runtime->sleep, and after schedule_timeout() removes it
only if that peer is still found in the caller's group. If group
membership changes during the wait and the sleep ends by signal or
timeout (so autoremove_wake_function() does not run), finish_wait() is
skipped and snd_pcm_drain() returns with the entry still queued on that
stream's sleep list; a later wake_up() then walks a freed stack frame.
This is reachable by unlinking either the dr
In the Linux kernel, the following vulnerability has been resolved:
igc: remove napi_synchronize() in igc_down()
When an AF_XDP zero-copy application is killed abruptly, the XSK pool is
torn down but NAPI keeps polling. igc_clean_rx_irq_zc() then returns the
full budget on every poll, so napi_complete_done() never clears
NAPI_STATE_SCHED.
igc_down() calls napi_synchronize() before napi_disable(), so it spins
forever waiting for that bit and the interface never goes down. Drop the
napi_synchronize() and let napi_disable() do the job -- it sets
NAPI_STATE_DISABLE, which forces the stuck poll to complete. Reorder it
ahead of igc_set_queue_nap
ipvs: do not propagate one-packet flag to synced conns
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not propagate one-packet flag to synced conns
Synced connections can be created before their destination exists. When
the destination is later added, ip_vs_bind_dest() copies connection flags
from the destination into cp->flags.
IP_VS_CONN_F_ONE_PACKET connections are not synced. If a synced
connection inherits IP_VS_CONN_F_ONE_PACKET while it is already hashed,
expiry can treat it as a one-packet connection and skip unlinking the
existing conn_tab node, leaving stale hash nodes pointing at a freed
struct ip_vs_conn.
Drop IP_VS_CONN_F_ONE_PACKET from destination
In the Linux kernel, the following vulnerability has been resolved:
io_uring: preserve task restrictions across exec
Per-task restrictions apply to all rings created by a task. Once
installed, they should not be dropped across exec.
For a task that has used io_uring, the exec cancellation path calls
__io_uring_free(). This frees both the task context and the per-task
restriction, so a ring created after exec is unrestricted.
Split task context cleanup into io_uring_free_tctx(), and use it from
the exec cancellation path. Keep __io_uring_free() for final task
cleanup, where both the context and restriction are released.
spi: spi-qpic-snand: write the feature value before executing SET_FEATURE
In the Linux kernel, the following vulnerability has been resolved:
spi: spi-qpic-snand: write the feature value before executing SET_FEATURE
qcom_spi_send_cmdaddr() programs NAND_FLASH_CMD/NAND_EXEC_CMD and submits
the descriptors, which makes the controller execute the command
immediately. For SPINAND_SET_FEATURE the value to be written is only
placed into NAND_FLASH_FEATURES afterwards, by qcom_spi_io_op(), in a
second submission - so the chip is programmed with whatever that register
happened to hold from a previous operation, and the intended value is only
applied by the *next* SET_FEATURE.
Measured on a TP-Link Archer AX55 v1 (IPQ501
power: supply: max17040: handle missing status supplier
In the Linux kernel, the following vulnerability has been resolved:
power: supply: max17040: handle missing status supplier
MAX17040 does not report charger state itself, so the driver forwards
POWER_SUPPLY_PROP_STATUS to a supplier power supply. If no supplier is
registered, power_supply_get_property_from_supplier() returns -ENODEV and
leaves the output value untouched.
max17040_get_property() currently ignores that error and returns success,
so userspace can read an uninitialized status value from the battery power
supply. This happens on systems that use the fuel gauge without a charger
supplier relationship in firmware.
Return POWER_S
In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Fix undersized format-check buffer
fmt_buffer_size in dasd_eckd_check_device_format() is declared as
int, even though one of the multiplicands, sizeof(struct eckd_count),
is a size_t. The expression
trkcount * rpt_max * sizeof(struct eckd_count)
is therefore correctly evaluated at 64-bit width, but the result is
silently truncated when it is stored back into the 32-bit
fmt_buffer_size variable. For a sufficiently large track range
(start_unit/stop_unit are caller-controlled) this truncation
yields a buffer size far smaller than the number of tracks actually
s390/zcrypt: Fix wrong domain value verification with EP11 CPRBs
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix wrong domain value verification with EP11 CPRBs
There is a wrong upper limit check for the domain value when an EP11
CPRB is processed for sending to a crypto card. This check is only
active on custom device nodes but may lead to access heap memory
behind perms->adm when an administrative CPRB is sent.
Add correct limit (AP_DOMAINS = 256) checking to fix this.
s390/zcrypt: Fix missing mem scrub at clear key import in cca_clr2cipherkey()
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix missing mem scrub at clear key import in cca_clr2cipherkey()
The helper function _ip_cprb_helper() uses internal buffer memory for
building and processing CPRBs. After use this buffer was never
scrubbed which could lead to leaving for example clear key material in
memory which could be exposed via tricky reuse of this same memory.
Extend the _ip_cprb_helper() function with another parameter 'scrub'
used to steer scrubbing of this buffer. So now the caller has the
opportunity to decide if scrubbing is needed or not.
Extend the clear key to secure key token
In the Linux kernel, the following vulnerability has been resolved:
can: j1939: transport: j1939_session_fresh_new(): initialize receive buffer
Zero the allocated buffer in j1939_session_fresh_new() to ensure it
contains no residual data.
While there is a potential performance impact if users allocate maximum
sized ETP buffers, most real-world use cases are not noticeably affected
since the maximum known buffer size is typically around 65K.
[mkl: add Message-ID]
can: softing: fw_parse(): validate firmware record spans
In the Linux kernel, the following vulnerability has been resolved:
can: softing: fw_parse(): validate firmware record spans
fw_parse() reads a fixed record header, a firmware-provided payload,
and a trailing checksum without knowing the end of the firmware blob. A
truncated record can therefore make those reads exceed the blob.
The same record also supplies addresses and lengths for writes into
DPRAM. The generic loader uses wrap-prone mixed signed arithmetic for its
bounds check, while the application loader does not bound the staging
copy at all.
Pass the firmware end to the parser and validate the full source record.
Use a signed wide
drm/amd/display: check if dml21_add_phantom_plane() is successful
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: check if dml21_add_phantom_plane() is successful
Verify that the phantom plane was allocated to avoid a later
segfault.
(cherry picked from commit 5adb54abe5a8e82cbff7f8806db30a5f4924329f)
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use proper context for logging
The same as the rest of the code, get_ss_info_from_atombios() uses
calc_pll_cs->ctx->logger for logging. But calc_pll_cs->ctx is
initialized only later in calc_pll_max_vco_construct(). Therefore, any
output using DC_LOG_SYNC() leads to a NULL pointer deference in
get_ss_info_from_atombios().
According to Sashiko, the very same problem exists in
dce112_get_pix_clk_dividers() and dcn3_get_pix_clk_dividers() too.
To avoid accessing the NULL context, use clk_src->base.ctx->logger
everywhere. That context in base is initialized e
drm/amdkfd: Fix missing authorization check in KFD_IOC_DBG_TRAP_DISABLE
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Fix missing authorization check in KFD_IOC_DBG_TRAP_DISABLE
Prevent unauthorized termination of active GPU debug sessions.
Previously, users with /dev/kfd access could terminate another process's
debug session without proper ownership or ptrace authorization.
(cherry picked from commit 4db4c5ffd5585b72622ecf6ffedf2da258ee23f5)
drm/vmwgfx: fix guest_memory_dirty bitfield clobbered as size
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: fix guest_memory_dirty bitfield clobbered as size
Two sites in vmwgfx_resource.c assign boolean literals to
res->guest_memory_size, which is an unsigned long allocation-size
field; the intended target is the adjacent res->guest_memory_dirty
bitfield. After the assignments the field holds 0 or 1 instead of
the resource's MOB allocation size:
- vmw_resource_release() writes 0 (false), and
- vmw_resource_unbind_list() writes 1 (true).
Subsequent revalidation paths read guest_memory_size when computing
the dirty page range (vmw_bo_dirty_transfer_to_re
drm/vmwgfx: enforce cursor size limits for MOB cursors
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: enforce cursor size limits for MOB cursors
vmw_cursor_plane_atomic_check() bounds cursor width and height only
on the legacy update path; the SVGA_CAP2_CURSOR_MOB path -- the
default on modern hosts -- accepts any size. When the requested size
exceeds SVGA_REG_CURSOR_MAX_DIMENSION or SVGA_REG_MOB_MAX_SIZE,
vmw_cursor_mob_get() returns -EINVAL and leaves vps->cursor.mob NULL.
Its return value is then discarded in vmw_cursor_plane_prepare_fb(),
so the subsequent vmw_cursor_update_mob() calls
vmw_bo_map_and_cache(NULL) and oopses inside
vmw_bo_map_and_cache_size()
drm/vmwgfx: validate external BO copy bounds for both stride paths
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: validate external BO copy bounds for both stride paths
vmw_external_bo_copy() trusts caller-supplied offsets, strides, and
heights and operates on imported dma-buf vmaps:
- The equal-stride memcpy() bound was clamped after subtracting the
offsets from dst_size and src_size; an offset larger than the BO
size wraps the unsigned subtraction to a huge value and the
resulting memcpy() runs off the end of the vmap. dst_stride *
height is also a u32 multiplication that can overflow.
- The non-equal-stride row-by-row path had no bound at all. The
KVM: arm64: vgic: Avoid double-deactivate of IRQs in the nested context
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: vgic: Avoid double-deactivate of IRQs in the nested context
In the nested state, the physical interrupt has already been
deactivated through the HW bit in the LR. The extra deactivation
would be harmless but can hit an errata case on AmpereOne, so
avoid it here.
On AmpereOne, deactivating a physical interrupt through
ICC_DIR_EL1 or ICC_EOIR1_EL1 (depending on EOImode) which is not
active, but is the highest priority pending interrupt causes the
cpu to lose the interrupt pending state and also prevents the
delivery of future interrupts.