net/smc: bound the peer rkey counts in SMC-Rv2 LLC messages
In the Linux kernel, the following vulnerability has been resolved:
net/smc: bound the peer rkey counts in SMC-Rv2 LLC messages
On a link whose device has max_recv_sge == 1 there is no shared v2 receive
buffer, and smc_llc_save_add_link_rkeys() takes the v2 extension from 44
bytes past the start of the queue entry's inline message:
ext = (struct smc_llc_msg_add_link_v2_ext *)(llc_msg + SMC_WR_TX_SIZE);
The entry is a 72-byte allocation and the extension starts at offset 68, so
ext->num_rkeys at offset 94 is already past it. This happens on every
SMC-Rv2 link addition, whatever the peer sends:
[ 2.490065] BUG: KASAN: slab-out-of-bo
net/smc: carry oversized SMC-Rv2 LLC messages in the queue entry
In the Linux kernel, the following vulnerability has been resolved:
net/smc: carry oversized SMC-Rv2 LLC messages in the queue entry
smc_llc_rmt_delete_rkey() and smc_llc_save_add_link_rkeys() read the part
of a v2 message that does not fit into the 44-byte union smc_llc_msg, and
both bound themselves by the size of the buffer it landed in, not by what
arrived. On a link with a shared v2 receive buffer a 44-byte
DELETE_RKEY_V2 declaring 255 rkeys reaches rkey[9..254] in whatever an
earlier message left in lgr->wr_rx_buf_v2, and passes each of them to
smc_rtoken_delete(). One of those 255 matched a registered rtoken and
deleted it. An ADD_LI
net/smc: do not dereference an unset send buffer on the SMC-D teardown path
In the Linux kernel, the following vulnerability has been resolved:
net/smc: do not dereference an unset send buffer on the SMC-D teardown path
smc_close_stream_wait() calls smc_tx_prepared_sends() from inside its
sk_wait_event() condition, and sk_wait_event() evaluates that condition
once with the socket lock released. smcd_buf_detach() clears
conn->sndbuf_desc from smc_conn_kill() under lock_sock(), so a link group
terminating while a socket waits there leaves the helper dereferencing
NULL, faulting out of close(). SIOCOUTQ reads the field by hand, and
smc_close_cancel_work() drops the lock across two cancel_*_sync() calls.
Sample the po
net/smc: fix socket refcount leak in smc_switch_conns()
In the Linux kernel, the following vulnerability has been resolved:
net/smc: fix socket refcount leak in smc_switch_conns()
smc_switch_conns() takes a reference on the SMC socket before dropping
lgr->conns_lock, so the connection stays alive while the CDC slot is
fetched:
sock_hold(&smc->sk);
read_unlock_bh(&lgr->conns_lock);
/* pre-fetch buffer outside of send_lock, might sleep */
rc = smc_cdc_get_free_slot(conn, to_lnk, &wr_buf, NULL, &pend);
if (rc)
goto err_out;
The err_out label only drops the wr_tx link reference, so this early exit
returns without the matching sock_put(). The
net/smc: fix use-after-free in smc_rx_pipe_buf_release()
In the Linux kernel, the following vulnerability has been resolved:
net/smc: fix use-after-free in smc_rx_pipe_buf_release()
smc_rx_splice() hands RMB pages to a pipe and takes a socket reference
per entry so the smc_sock stays alive until the reader finishes. The
connection does not: a concurrent close runs smc_conn_free(), which
releases the receive buffer back to the link group pool.
smc_rx_pipe_buf_release() tests sk_state before taking the socket lock.
The state can change between the test and the lock, and
smc_rx_update_cons() then dereferences conn->rmb_desc and walks
conn->lgr, which smc_conn_free() has already released. On the
is_
net/smc: fix use-after-free of the LLC qentry in smc_llc_srv_add_link()
In the Linux kernel, the following vulnerability has been resolved:
net/smc: fix use-after-free of the LLC qentry in smc_llc_srv_add_link()
smc_llc_srv_add_link() keeps add_llc pointing into the queue entry:
add_llc = &qentry->msg.add_link; smc_llc.c:1482
...
smc_llc_save_add_link_info(link_new, add_llc); smc_llc.c:1494
smc_llc_flow_qentry_del(&lgr->llc_flow_lcl); smc_llc.c:1495
...
u8 *llc_msg = smc_link_shared_v2_rxbuf(link) ?
(u8 *)lgr->wr_rx_buf_v2 : (u8 *)add_llc; smc_llc.c:1504
smc_llc_save_add_link_rkeys(link, link_new, llc_msg); smc_llc.c:1506
smc_llc_flow_qentry_del() kfree()s the entry, so on a link without a s
net/smc: stop killed, freed and out_of_sync sharing a byte
In the Linux kernel, the following vulnerability has been resolved:
net/smc: stop killed, freed and out_of_sync sharing a byte
The three connection state flags are single-bit bitfields, so they occupy
one byte of struct smc_connection and every store to one is a
read-modify-write of the other two:
u8 killed : 1;
u8 freed : 1;
u8 out_of_sync : 1;
They are not written under a common lock. smc_cdc_msg_validate() sets
out_of_sync from the receive tasklet, while smc_conn_kill() sets killed
from process context under lock_sock(), and the receive path does not defer
to the backlog when the socket is owned -- smc_cdc_msg_recv() tak
net/smc: unregister the connection before draining the rx tasklet
In the Linux kernel, the following vulnerability has been resolved:
net/smc: unregister the connection before draining the rx tasklet
smc_conn_free() calls smc_ism_unset_conn() only while the link group is
still on its device list, and never sets conn->killed.
smc_lgr_terminate_sched() unlinks the group immediately and defers killing
its connections to a work item, so a connection freed in that window keeps
its smcd->conn[] slot with both gates in smcd_handle_irq() open, and the
device can re-arm the receive tasklet after tasklet_kill() has returned. On
the DMB-nocopy path the ghost send buffer is freed right after that drain,
so the re-arm
In the Linux kernel, the following vulnerability has been resolved:
net: cap advertised IP tunnel headroom
IP tunnel devices derive their advertised needed_headroom from lower
output devices. A stack of user-created devices can make the derived
value larger than the 16-bit skb header offsets can represent. Once IP
output reserves it, skb head expansion can wrap those offsets.
The runtime transmit path already caps a growing needed_headroom at 512.
Apply the same cap when tunnel configuration publishes needed_headroom
derived from a lower output device.
Capping the advertised value is safe: IP tunnel transmit still expands
the skb when a p
High · CVSS 7.8EPSS 0.13%Public exploitNo fix published
net: skbuff: don't touch shared zerocopy state in skb_tx_error()
In the Linux kernel, the following vulnerability has been resolved:
net: skbuff: don't touch shared zerocopy state in skb_tx_error()
skb_tx_error() completes the zerocopy uarg and clears
SKBFL_ALL_ZEROCOPY, and skb_zcopy_downgrade_managed() clears
SKBFL_MANAGED_FRAG_REFS. Both live in skb_shinfo(), which every clone
shares, while the caller only owns the reference it is about to drop.
Through a clone it tells the producer its pages are free and drops
SKBFL_SHARED_FRAG for an skb that is still in flight.
Open vSwitch reaches this with a non-last OVS_ACTION_ATTR_RECIRC:
clone_execute() sends a skb_clone() into ovs_dp_process_packet() while
d
In the Linux kernel, the following vulnerability has been resolved:
seg6: reset IP6CB after IPv6 decapsulation
decap_and_validate() pulls the outer SRv6 headers and makes the inner
packet the skb network header. The IPv6 control block still contains
values collected while parsing the outer packet, including nhoff and
extension-header flags.
End.DX6 and End.DT6 route the inner IPv6 packet directly to the IPv6
input path. An unprivileged user can reach End.DT6 from a user and net
namespace by installing a local SID and injecting an outer packet with
Hop-by-Hop and Destination Options headers followed by an SRH and a
minimal inner IPv6 packet
mfd: qnap-mcu: keep the reply buffer alive past a command timeout
In the Linux kernel, the following vulnerability has been resolved:
mfd: qnap-mcu: keep the reply buffer alive past a command timeout
qnap_mcu_exec() publishes an on-stack buffer to the receive path:
unsigned char rx[QNAP_MCU_RX_BUFFER_SIZE];
...
reply->data = rx;
reply->length = length;
and qnap_mcu_receive_buf() writes into it from the serdev receive path,
which runs out of flush_to_ldisc() and is not serialized against
qnap_mcu_exec() at all. bus_lock cannot cover it, because qnap_mcu_exec()
holds that mutex across wait_for_completion_timeout().
On a timeout qnap_mcu_exec() returns with reply->data still pointing at
its own frame.
mfd: sm501: Fix potential memory leaks during remove
In the Linux kernel, the following vulnerability has been resolved:
mfd: sm501: Fix potential memory leaks during remove
The memory allocated for struct sm501_devdata in sm501_pci_probe() and
sm501_plat_probe() is not freed by the corresponding remove functions
sm501_pci_remove() and sm501_plat_remove(). Fix that by adding a call to
kfree().
ALSA: 6fire: bound the MIDI event length from the device
In the Linux kernel, the following vulnerability has been resolved:
ALSA: 6fire: bound the MIDI event length from the device
usb6fire_comm_receiver_handler() forwards a MIDI event using a length
byte the device supplies, with no bound and no check that the transfer
delivered that many bytes:
if (!urb->status) {
if (rt->receiver_buffer[0] == 0x10) /* midi in event */
if (midi_rt)
midi_rt->in_received(midi_rt,
rt->receiver_buffer + 2,
rt->receiver_buffer[1]);
}
receiver_buffer is a 64-byte kzalloc() buffer (COMM_RECEIVER_BUFSIZE), so
only 62 bytes follow the two-byte header. receiver_buffer[1] is a u8 the
device choo
In the Linux kernel, the following vulnerability has been resolved:
ALSA: aloop: Check card index validity at probe
aloop driver blindly trusts that the given devptr->id value is within
the proper card index range at probe. It's OK for the devices the
driver itself creates at the module probe time, but if the device is
bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
ALSA: bcd2000: clear the URB pointers on disconnect
In the Linux kernel, the following vulnerability has been resolved:
ALSA: bcd2000: clear the URB pointers on disconnect
bcd2000_free_usb_related_resources() frees both URBs and leaves the
pointers behind:
usb_kill_urb(bcd2k->midi_out_urb);
usb_kill_urb(bcd2k->midi_in_urb);
usb_free_urb(bcd2k->midi_out_urb);
usb_free_urb(bcd2k->midi_in_urb);
The rawmidi device outlives that call. A substream that is still open
when the device is unplugged reaches bcd2000_midi_send() from the
trigger path on close. That function writes to the freed URB and then
hands it to the USB core:
bcd2k->midi_out_urb->transfer_buffer_length = BUFSIZE;
...
r
ALSA: FCP: do not copy out an uninitialised init response
In the Linux kernel, the following vulnerability has been resolved:
ALSA: FCP: do not copy out an uninitialised init response
fcp_ioctl_init() allocates its response buffer with kmalloc() and copies
the whole buffer back to userspace:
buf_size = init.step0_resp_size + init.step2_resp_size;
void *resp __free(kfree) =
kmalloc(buf_size, GFP_KERNEL);
...
if (copy_to_user(arg->resp, resp, buf_size))
return -EFAULT;
Nothing clears the buffer, and the only writer of its leading
step0_resp_size bytes is the step-0 control transfer:
err = snd_usb_ctl_msg(dev, usb_rcvctrlpipe(dev, 0),
FCP_USB_REQ_STEP0,
USB_RECIP_INTERFACE | USB_TYPE
In the Linux kernel, the following vulnerability has been resolved:
ALSA: mpu401: Check card index validity at probe
mpu401 driver blindly trusts that the given devptr->id value is within
the proper card index range at probe. It's OK for the devices the
driver itself creates at the module probe time, but if the device is
bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
In the Linux kernel, the following vulnerability has been resolved:
ALSA: mts64: Check card index validity at probe
Although mts64 driver has a check of the given devptr->id value, it
doesn't check for a negative id, which is often given as "none" or
such value when bound via sysfs. This may lead to OOB access for
index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
ALSA: pcxhr: initialize mutexes before requesting threaded IRQ
In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcxhr: initialize mutexes before requesting threaded IRQ
pcxhr_probe() requests pcxhr_threaded_irq() before initializing
mgr->lock, even though the threaded handler takes that mutex.
Initialize the manager locks before request_threaded_irq() so an
early interrupt cannot run against uninitialized mutex state during
probe.