In the Linux kernel, the following vulnerability has been resolved:
ata: pata_sl82c105: fix bridge revision use-after-free
pci_get_slot() returns a referenced PCI device. Commit 44c10138fd4b
("PCI: Change all drivers to use pci_device->revision") replaced a
configuration-space read with direct access to the cached revision field,
but left that access after pci_dev_put(). The bridge may therefore be freed
before its revision is read.
Read the revision before dropping the reference.
net: remove CAP_SYS_RAWIO zero-padding in dev_validate_header
In the Linux kernel, the following vulnerability has been resolved:
net: remove CAP_SYS_RAWIO zero-padding in dev_validate_header
dev_validate_header() reads dev->hard_header_len directly when
zero-padding short link layer headers for CAP_SYS_RAWIO holders:
if (capable(CAP_SYS_RAWIO)) {
memset(ll_header + len, 0, dev->hard_header_len - len);
return true;
}
Packet send paths call dev_validate_header() on skbs whose headroom was
allocated from an earlier hard_header_len read. If the device is
reconfigured so that dev->hard_header_len increases before validation,
the memset writes past the reserved buffer, an out-of-b
mm/percpu-km: fix bitmap overflow and accounting in pcpu_create_chunk()
In the Linux kernel, the following vulnerability has been resolved:
mm/percpu-km: fix bitmap overflow and accounting in pcpu_create_chunk()
In pcpu_create_chunk(), nr_pages is the total contiguous backing
allocation, i.e., nr_units * pcpu_unit_pages, but pcpu_chunk_populated()
uses it to set chunk->populated, whose size is pcpu_unit_pages, bitmap.
Since bit N in chunk->populated means page offset N inside every unit is
backed. When nr_units > 1, the function writes beyond chunk->populated.
Fix it by using chunk->nr_pages.
It also fixes the global pcpu_nr_empty_pop_pages accounting, since
pcpu_balance_free() only iterates up to chunk->nr
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate Adaptation Indication parameter length
The Adaptation Layer Indication parameter contains a fixed 32-bit
Adaptation Code Point after its parameter header. However,
sctp_verify_param() accepts a header-only parameter because the generic
parameter walker only requires the header to be present.
sctp_process_param() then reads adaptation_ind beyond the declared
parameter. When the malformed parameter is last in an INIT, the read
starts at the receive skb tail, and the value is copied into the state
cookie returned in the INIT ACK. This may disclose four receive-
ipvs: do not propagate one-packet flag to synced conns
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not propagate one-packet flag to synced conns
Synced connections can be created before their destination exists. When
the destination is later added, ip_vs_bind_dest() copies connection flags
from the destination into cp->flags.
IP_VS_CONN_F_ONE_PACKET connections are not synced. If a synced
connection inherits IP_VS_CONN_F_ONE_PACKET while it is already hashed,
expiry can treat it as a one-packet connection and skip unlinking the
existing conn_tab node, leaving stale hash nodes pointing at a freed
struct ip_vs_conn.
Drop IP_VS_CONN_F_ONE_PACKET from destination
can: softing: fw_parse(): validate firmware record spans
In the Linux kernel, the following vulnerability has been resolved:
can: softing: fw_parse(): validate firmware record spans
fw_parse() reads a fixed record header, a firmware-provided payload,
and a trailing checksum without knowing the end of the firmware blob. A
truncated record can therefore make those reads exceed the blob.
The same record also supplies addresses and lengths for writes into
DPRAM. The generic loader uses wrap-prone mixed signed arithmetic for its
bounds check, while the application loader does not bound the staging
copy at all.
Pass the firmware end to the parser and validate the full source record.
Use a signed wide
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
In the Linux kernel, the following vulnerability has been resolved:
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
mmio_trace_rw() and mmio_trace_mapping() retrieve mmio_trace_array into
tr and pass it to __trace_mmiotrace_rw() and __trace_mmiotrace_map().
If these functions are invoked while mmio_trace_array is NULL (e.g. before
initialization or after disabled), accessing tr->array_buffer.buffer will
result in a NULL pointer dereference crash.
Fix this by adding an explicit NULL check for tr at the beginning of
__trace_mmiotrace_rw() and __trace_mmiotrace_map().
vxlan: re-fetch eth header after route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: re-fetch eth header after route_shortcircuit()
Before route_shortcircuit(), the eth header pointer is cached from eth_hdr(skb).
Inside route_shortcircuit(), pskb_may_pull() can be called, which may
reallocate skb->head.
In this case, returning to vxlan_xmit() leaves the cached eth pointer pointing to
freed memory, leading to a use-after-free when dereferencing eth->h_dest.
Fix this by updating eth = eth_hdr(skb) after calling route_shortcircuit().
perf sched: Fix register_pid() overflow, strcpy, and BUG_ON
In the Linux kernel, the following vulnerability has been resolved:
perf sched: Fix register_pid() overflow, strcpy, and BUG_ON
register_pid() has several issues when processing untrusted perf.data:
1. Integer overflow: (pid + 1) * sizeof(struct task_desc *) can wrap
to a small value on 32-bit systems when pid is large (e.g.
0x40000000), causing realloc to return a tiny buffer followed by
out-of-bounds writes in the initialization loop.
2. Heap buffer overflow: strcpy(task->comm, comm) copies the
untrusted comm string into a fixed 20-byte COMM_LEN buffer with
no length check.
3. BUG_ON on allocation failure: perf.data is u
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
In the Linux kernel, the following vulnerability has been resolved:
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
machine__resolve() accesses env->cpu[al->cpu].socket_id after checking
al->cpu >= 0 and env->cpu != NULL, but without validating al->cpu
against env->nr_cpus_avail. Since al->cpu comes from the untrusted
perf.data sample, a crafted file with a large CPU index causes an
out-of-bounds heap read.
Use perf_env__get_cpu_topology() which validates both NULL and bounds.
Also bounds-check al->cpu before the cast to struct perf_cpu (int16_t):
without this, values like 65536 silently truncate to 0, bypassing the
acc
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_nat: reject unsupported target families
xt_nat SNAT and DNAT target handlers assume IP-family conntrack state
is present and can dereference a NULL pointer when instantiated from an
unsupported family through nft_compat. A bridge-family compat rule can
therefore trigger a NULL-dereference in nf_nat_setup_info().
Reject non-IP families in xt_nat_checkentry() so unsupported targets
cannot be installed. Keep NFPROTO_INET allowed for valid inet NAT
compat users and leave the runtime fast path unchanged.
[ The crash was fixed via
9dbba7e694ec ("netfilter: nft_c
mmc: vub300: defer reset until cmd_mutex is unlocked
In the Linux kernel, the following vulnerability has been resolved:
mmc: vub300: defer reset until cmd_mutex is unlocked
vub300_cmndwork_thread() holds cmd_mutex while it sends a command and
waits for the command response. If the response wait times out,
__vub300_command_response() kills the command URBs and then synchronously
resets the USB device through usb_reset_device().
That reset path re-enters the driver through vub300_pre_reset(), which
also takes cmd_mutex. The worker therefore tries to acquire the same
mutex recursively while it is still holding it from the command path.
This issue was found by our static analysis tool and th
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
In the Linux kernel, the following vulnerability has been resolved:
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
With a list_for_each() loop, if we don't find the item we are looking for
in the list, then the loop exits with the iterator, which is "dbell" in
this loop, pointing to invalid memory.
This code uses the "found" variable to determine if we have found the
doorbell we are looking for or not. However, the problem that the "found"
variable needs to be set to false at the start of each iteration,
otherwise after the first correct doorbell, then everything is marked as
found.
Reset the "found" to false at the start o
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: don't BUG_ON an invalid journal dinode
[BUG]
A fuzzed OCFS2 image can corrupt the current slot journal dinode while
mount is still in progress. The mount path first reports the invalid
journal block and then crashes in shutdown:
kernel BUG at fs/ocfs2/journal.c:1034!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_journal_toggle_dirty+0x2d6/0x340 fs/ocfs2/journal.c:1034
Call Trace:
ocfs2_journal_shutdown+0x414/0xc30 fs/ocfs2/journal.c:1116
ocfs2_mount_volume fs/ocfs2/super.c:1785 [inline]
ocfs2_fill_super+0x30a9/0x3cd0 fs/ocfs2/super.c:1083
get_t
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
In the Linux kernel, the following vulnerability has been resolved:
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
Use get_unaligned_be32() and put_unaligned_be32() to safely read and
write the timestamp fields. This prevents performance degradation due to
unaligned memory access or even a crash on strict alignment
architectures.
This follows the implementation of timestamp parsing in the networking
stack at tcp_parse_options() and synproxy_parse_options().
net/sched: sch_fq_codel: Do not call qdisc_tree_reduce_backlog during peek before restoring qlen
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_fq_codel: Do not call qdisc_tree_reduce_backlog during peek before restoring qlen
Whenever fq_codel drops packets during peek, it calls
qdisc_tree_reduce_backlog. An issue arises because it calls
qdisc_tree_reduce_backlog before it reincrements the qlen. If qlen drops
to zero, but peek returns an skb, the parent's qlen_notify callback will be
executed even though fq_codel still has 1 packet on the queue and, thus,
will mistakenly deactivate the parent's class causing issues like a recent
report [1] and a wild memory access in qfq:
[ 29.371146][ T360] Oops
ALSA: seq: oss: Serialize readq reset state with q->lock
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: oss: Serialize readq reset state with q->lock
snd_seq_oss_readq_clear() resets qlen, head, and tail without
q->lock even though the normal reader and producer paths serialize the
same ring state under that spinlock. A reset can therefore race
snd_seq_oss_readq_free() or snd_seq_oss_readq_put_event() and leave
stale records in the queue, drop freshly queued ones, or report the
wrong readiness after wakeup. KCSAN reports a data race between
snd_seq_oss_readq_clear() and snd_seq_oss_readq_free().
Take q->lock while clearing the ring and resetting input_time. Factor
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
In the Linux kernel, the following vulnerability has been resolved:
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
fsl_emb_pmu_del() unconditionally calls put_cpu_var(cpu_hw_events) at
the 'out:' label, but only calls the matching get_cpu_var() after the
'i < 0' early-return check. When event->hw.idx is negative the
function jumps to 'out:' without having taken get_cpu_var(), and the
trailing put_cpu_var() then issues an unmatched preempt_enable(),
underflowing preempt_count.
On a CONFIG_PREEMPT=y kernel preempt_count would underflow and
eventually present as a 'scheduling while atomic' BUG.
Move put_cpu_var() to pair with g
char: tlclk: fix use-after-free in tlclk_cleanup()
In the Linux kernel, the following vulnerability has been resolved:
char: tlclk: fix use-after-free in tlclk_cleanup()
This patch improves the module cleanup process in the tlclk driver to
prevent potential use-after-free and race conditions.
Currently, the file_operations structure does not specify the .owner
field, which could allow the module to be unloaded while user-space
processes are still interacting with the device. Additionally, the
tlclk_cleanup() function frees the alarm_events memory before ensuring
that blocked processes in the waitqueue are fully awakened and that the
switchover_timer has completed.
To address these cases,
HID: picolcd: prevent NULL pointer dereference in picolcd_send_and_wait()
In the Linux kernel, the following vulnerability has been resolved:
HID: picolcd: prevent NULL pointer dereference in picolcd_send_and_wait()
In picolcd_send_and_wait(), an integer overflow of the signed loop counter
'k' can theoretically lead to a NULL pointer dereference of 'raw_data'.
If the loop executes more than INT_MAX times, 'k' becomes negative,
making the condition 'k < size' true even when 'size' is 0.
Change the type of 'k' to 'unsigned int' to prevent the overflow and
eliminate the out-of-bounds access.
Found by Linux Verification Center (linuxtesting.org) with the Svace static
analysis tool.
[[email protected]: extended hash