ALSA: usb-audio: Complete cleanup after system-resume errors
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Complete cleanup after system-resume errors
A failed system resume can leave the card unusable until reboot.
usb_audio_resume() jumps to err_out when snd_usb_pcm_resume() or
snd_usb_mixer_resume() fails. The error path skips the out: block, which
restores D0 and decrements chip->num_suspended_intf.
The card stays in SNDRV_CTL_POWER_D3hot, so later control access blocks in
snd_power_ref_and_wait(). USB core logs an interface resume callback error.
It does not retry that callback, so a later callback cannot complete the
skipped cleanup.
usb_audio_suspend()
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: option: fix slab OOB read in interrupt URB callback
The interrupt URB buffer is allocated in setup_port_interrupt_in() based
on the endpoint's wMaxPacketSize:
buffer_size = usb_endpoint_maxp(epd);
port->interrupt_in_buffer = kmalloc(buffer_size, GFP_KERNEL);
When a USB device declares wMaxPacketSize = 8 on its interrupt IN
endpoint, the buffer is allocated from kmalloc-8 cache (exactly
8 bytes).
If the device sends a short packet (actual_length < wMaxPacketSize),
the URB completes with status == 0 and the callback proceeds to read:
data[sizeof(s
USB: c67x00: fix use-after-free in c67x00_add_iso_urb()
In the Linux kernel, the following vulnerability has been resolved:
USB: c67x00: fix use-after-free in c67x00_add_iso_urb()
When TD creation fails for the last packet of an isochronous URB,
c67x00_add_iso_urb() gives the URB back before updating the endpoint
scheduling state.
c67x00_giveback_urb() frees the URB private data, and the completion
callback may release the final URB reference. The following accesses to
urbp->ep_data, urb->interval, and urbp->cnt can therefore use freed
memory.
Update next_frame and cnt before giving back the failed final packet,
making the giveback the last operation that uses the URB and its private
data.
Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept
rfcomm_sock_recvmsg() completes a deferred setup by calling
rfcomm_dlc_accept() without holding any RFCOMM lock:
if (test_and_clear_bit(RFCOMM_DEFER_SETUP, &d->flags)) {
rfcomm_dlc_accept(d);
return 0;
}
and rfcomm_dlc_accept() dereferences the session on its first line:
struct sock *sk = d->session->sock->sk;
Every other path that touches d->session runs under rfcomm_mutex:
rfcomm_dlc_open(), rfcomm_dlc_close(), rfcomm_dlc_exists(),
rfcomm_dlc_send_rpn(), and the RFCOMM thread through
rfcomm_proc
rndis_host: add overflow check in rndis_rx_fixup()
In the Linux kernel, the following vulnerability has been resolved:
rndis_host: add overflow check in rndis_rx_fixup()
Add an overflow check to ensure that data_offset + data_len + 8 does not
wrap, which would enable an OOB read of the USB data buffer.
In the Linux kernel, the following vulnerability has been resolved:
ALSA: dummy: Check card index validity at probe
snd_dummy_probe() blindly trusts that the given devptr->id value is
within the proper card index range. It's OK for the devices the
driver itself creates at the module probe time, but if the device is
bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
ocfs2: fix missing metadata reservation for large xattrs
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix missing metadata reservation for large xattrs
[BUG]
lsetxattr() panics the kernel when setting a large xattr value on a
fragmented filesystem where the file already has an external xattr
block.
[CAUSE]
ocfs2_calc_xattr_set_need() never reserves metadata blocks for a new
xattr value's extent tree when the file already has an external xattr
block. The not_found path leaves meta_add at zero, so meta_ac is NULL
when ocfs2_xattr_extend_allocation() runs.
A new value root has room for a single extent record. On a fragmented
filesystem, the allocator cannot satisfy th
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: reject invalid block index in GC ioctl
Syzbot reported list corruption caused by a double list_add_tail() call on
bh->b_assoc_buffers within nilfs_lookup_dirty_data_buffers().
Analysis revealed that the root cause was the insertion of a page/folio
with a page index of ULONG_MAX into the page cache via the GC ioctl.
filemap_get_folios_tag(), called by nilfs_lookup_dirty_data_buffers(),
repeatedly detects a dirty folio with a page index of ULONG_MAX due to
index wrap-around, leading to duplicate processing of dirty buffers.
As a preparatory step, the GC ioctl loads
nfc: digital: clamp SENSF_RES length to the destination buffer
In the Linux kernel, the following vulnerability has been resolved:
nfc: digital: clamp SENSF_RES length to the destination buffer
digital_in_recv_sensf_res() memcpy()s resp->len bytes from a remote
NFC-F device response into the NFC_SENSF_RES_MAXSIZE-byte target.sensf_res
field without an upper-bound check. A nearby malicious NFC-F device can
send an oversized SENSF_RES response to overflow the stack-local struct
nfc_target.
Clamp resp->len to NFC_SENSF_RES_MAXSIZE before the copy.
Found by 0sec automated security-research tooling (https://0sec.ai).
In the Linux kernel, the following vulnerability has been resolved:
nfc: microread: validate target discovery payload lengths
microread_target_discovered() parses target discovery payloads from
skb->data according to the HCI gate. The fixed field offsets and UID
copies were checked only against the destination nfc_target buffers, not
against the actual skb length.
Validate that each gate-specific payload contains the fixed fields and
UID bytes before reading or copying them.
nfc: llcp: bound the connect_sn TLV walk to the skb
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: bound the connect_sn TLV walk to the skb
Commit 27256cdb290e ("nfc: llcp: bound SNL TLV parsing to the skb and
add length checks") fixed the unbounded TLV walk in nfc_llcp_recv_snl(),
and commit d8bd2dedbde5 ("nfc: llcp: fix OOB read and u8 offset wrap in
TLV parsers") subsequently bounded nfc_llcp_parse_gb_tlv() and
nfc_llcp_parse_connection_tlv(). One sibling parser sharing the same
pattern remains unbounded: nfc_llcp_connect_sn().
nfc_llcp_connect_sn() walks a TLV list, reading a two-byte header
(type, length) followed by length bytes of value, without checki
nfc: llcp: reject PDUs shorter than the LLCP header
In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: reject PDUs shorter than the LLCP header
Every LLCP PDU begins with a two-byte header (DSAP/SSAP + PTYPE), but the
receive path never checked that a frame is at least LLCP_HEADER_SIZE bytes
before parsing it.
nfc_llcp_rx_skb() reads the header via nfc_llcp_ptype()/nfc_llcp_dsap()/
nfc_llcp_ssap(), which dereference pdu->data[0] and pdu->data[1], and a
CONNECT or CC PDU then computes
tlv_array_len = skb->len - LLCP_HEADER_SIZE;
as a size_t and hands it to the TLV walk. When the frame is shorter than
the header the subtraction wraps to a huge value and the walk
In the Linux kernel, the following vulnerability has been resolved:
nfc: pn533: purge fragmented skbs during cleanup
pn53x_common_clean() purges resp_q before freeing the common PN533 state,
but it leaves fragment_skb untouched. The fragmentation helpers queue
transmit fragments there while sending large initiator or target-mode
frames, and those skbs remain owned by the driver until they are sent or
discarded.
If the device is removed while fragments are still queued, the common
cleanup path frees the PN533 state without releasing the queued fragment
skbs, leaking them.
Purge fragment_skb during cleanup alongside resp_q.
nfc: nci: add data_len bound checks to activation parameter extractors
In the Linux kernel, the following vulnerability has been resolved:
nfc: nci: add data_len bound checks to activation parameter extractors
nci_extract_activation_params_iso_dep() and
nci_extract_activation_params_nfc_dep() read an inner length byte from
the NCI RF_INTF_ACTIVATED_NTF payload and use it to memcpy() into fixed
kernel buffers, but neither function receives the caller-validated
activation_params_len. A crafted NCI notification with
activation_params_len=1 and an inner length byte of up to 20 (NFC-A) or
50 (NFC-B) causes memcpy() to read that many bytes past the one valid
byte in the activation params region -- a slab out-of-bou
nfc: nci: fix out-of-bounds write in nci_target_auto_activated()
In the Linux kernel, the following vulnerability has been resolved:
nfc: nci: fix out-of-bounds write in nci_target_auto_activated()
nci_target_auto_activated() appends a target to the fixed-size array
ndev->targets[NCI_MAX_DISCOVERED_TARGETS] and increments ndev->n_targets
without first checking the array is full; unlike its sibling
nci_add_new_target(), which bails out when n_targets already equals
NCI_MAX_DISCOVERED_TARGETS.
ndev->n_targets is only cleared by nci_clear_target_list(), so an NFCC
that repeatedly re-runs discovery (RF_DISCOVER_RSP, which re-enters
NCI_DISCOVERY without clearing the target list) and reports an
auto-activate
nfc: nci: fix uninit-value in the RF discover/activated NTF handlers
In the Linux kernel, the following vulnerability has been resolved:
nfc: nci: fix uninit-value in the RF discover/activated NTF handlers
nci_rf_discover_ntf_packet() and nci_rf_intf_activated_ntf_packet() each
parse a notification into an on-stack struct (nci_rf_discover_ntf /
nci_rf_intf_activated_ntf) that is not initialised. The RF
technology-specific parameters are only extracted when
rf_tech_specific_params_len is non-zero, so a notification that reports a
zero length leaves the rf_tech_specific_params union uninitialised - and
both handlers then pass it to nci_add_new_protocol(), which reads it:
- discover: nci_add_new_target() ->
In the Linux kernel, the following vulnerability has been resolved:
ipv4: reject undersized MTUs in ip_do_fragment()
ip_do_fragment() subtracts the IPv4 header length from the effective
MTU and passes the resulting payload MTU to ip_frag_next().
If the effective MTU is smaller than hlen + 8, ip_frag_next() rounds
the fragment payload length down to zero. The fragmentation state then
never makes forward progress: state->left, state->ptr and state->offset
stay unchanged while ip_do_fragment() keeps allocating and transmitting
header-only fragments until the softlockup detector fires.
This is reproducible with a route installed using "mtu lo
nvmet-tcp: Do not WARN on remotely-controlled oversized SGL allocations
In the Linux kernel, the following vulnerability has been resolved:
nvmet-tcp: Do not WARN on remotely-controlled oversized SGL allocations
When fuzzing the nvme target code, I tripped a kernel warning in
nvmet_tcp_map_data() because the length passed into the allocator is
controlled by the remote initiator.
A remote initiator that sends a command with an SGL claiming a huge
number, can create a scatterlist and iovec allocation of over 1 million
entries, which causes the backing kmalloc call to exceed MAX_PAGE_ORDER
and then the page allocator will trip on a WARN_ON_ONCE_GFP() message:
WARNING: mm/page_alloc.c:5280 __alloc_frozen_pages_
fbdev: Wrap user-invoked calls to fb_set_var() in helper
In the Linux kernel, the following vulnerability has been resolved:
fbdev: Wrap user-invoked calls to fb_set_var() in helper
Handle fbcon during display updates in fb_set_var_from_user(). Check
with fbcon if the mode change is possible, update hardware state and
finally update fbcon. Update all callers.
Only the FBIOPUT_VSCREENINFO ioctl currently does all steps. Other
mode-changes callers in sysfs and driver code are missing fbcon-related
steps.
With the new helper, ps3fb and sh_mobile_lcdcfb no longer maintain
fbcon state themselves.
fbdev: serialize mode sysfs access with lock_fb_info()
In the Linux kernel, the following vulnerability has been resolved:
fbdev: serialize mode sysfs access with lock_fb_info()
show_mode(), show_modes(), and store_mode() access fb_info->modelist
and fb_info->mode without holding lock_fb_info(). store_modes() takes
lock_fb_info() while replacing the modelist and freeing the old one.
A concurrent reader or writer can load a pointer to an old modelist
entry before store_modes() frees it, then dereference freed memory or
store a stale freed pointer in fb_info->mode.
Take lock_fb_info() in show_mode(), show_modes(), and store_mode() to
serialize with store_modes(). In show_mode(), copy the mode t