usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer
uvc_send_response() builds the UVC control response from a user-supplied
struct uvc_request_data:
req->length = min_t(unsigned int, uvc->event_length, data->length);
...
memcpy(req->buf, data->data, req->length);
req->length is clamped to uvc->event_length, which is taken from the
host control request wLength (up to UVC_MAX_REQUEST_SIZE, 64), and to
data->length, which comes from the UVCIOC_SEND_RESPONSE ioctl and is
only checked for being negative. The source buffer data->data is only
60 bytes, so a
USB: serial: io_edgeport: cap received transmit credits
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: io_edgeport: cap received transmit credits
The interrupt-status packet reports transmit credits returned by the
device. edge_interrupt_callback() adds the 16-bit value to txCredits
without checking maxTxCredits.
edge_write() uses txCredits minus the software FIFO count as the amount
of data that fits. Since the FIFO is allocated with maxTxCredits bytes,
txCredits exceeding maxTxCredits can cause OOB write in ring buffer.
Cap accumulated credits at maxTxCredits. Conforming devices should never
hit the cap.
In the Linux kernel, the following vulnerability has been resolved:
firewire: net: Fix fragmented datagram reassembly
fwnet_frag_new() keeps a sorted list of received fragments for a partial
datagram. When a new fragment is adjacent to an existing fragment, the
code checks whether the new fragment also closes the gap to the next or
previous list entry.
Those neighbor lookups currently assume that the current fragment always
has a real next or previous fragment. At a list edge, the next or
previous entry is the list head, not a struct fwnet_fragment_info.
The gap checks also compare against the old edge of the current fragment
instead of t
wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler
The firmware-controlled num_msg field (u8, 0-255) drives the loop in
ath6kl_wmi_tx_complete_event_rx() without validation against the buffer
length. This allows out-of-bounds reads of up to 1020 bytes past the
WMI event buffer when the firmware sends an inflated num_msg.
Add a check that the buffer is large enough to hold the fixed struct
and the num_msg variable-length entries.
wifi: ath6kl: fix OOB read from firmware IE lengths in connect event
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath6kl: fix OOB read from firmware IE lengths in connect event
The firmware-controlled beacon_ie_len, assoc_req_len, and assoc_resp_len
fields in ath6kl_wmi_connect_event_rx() are not validated against the
buffer length. Their sum (up to 765) can exceed the actual WMI event
data, causing out-of-bounds reads during IE parsing and state corruption
of wmi->is_wmm_enabled.
Add a check that the total IE length fits within the buffer.
wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read
In the Linux kernel, the following vulnerability has been resolved:
wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read
When the firmware sends a command response with a length mismatch,
carl9170_cmd_callback() logs the mismatch and calls carl9170_restart()
but then falls through to memcpy(ar->readbuf, buffer + 4, len - 4).
Since len comes from the firmware and can exceed ar->readlen, this
copies more data than the readbuf was allocated for.
Bound the memcpy to min(len - 4, ar->readlen) so that the response
is still completed -- avoiding repeated restarts from queued garbage --
while preventing an overread past the resp
wifi: carl9170: fix OOB read from off-by-two in TX status handler
In the Linux kernel, the following vulnerability has been resolved:
wifi: carl9170: fix OOB read from off-by-two in TX status handler
The bounds check in carl9170_tx_process_status() uses
`i > ((cmd->hdr.len / 2) + 1)` which is off by two, allowing
2 extra iterations past valid _tx_status entries when the firmware-
controlled hdr.ext exceeds hdr.len/2. Fix by using the correct
comparison `i >= (cmd->hdr.len / 2)`.
wifi: carl9170: fix buffer overflow in rx_stream failover path
In the Linux kernel, the following vulnerability has been resolved:
wifi: carl9170: fix buffer overflow in rx_stream failover path
The failover continuation in carl9170_rx_stream() copies the full tlen
from the second USB transfer instead of capping at rx_failover_missing
bytes. When both transfers are near maximum size, the total exceeds the
65535-byte failover SKB, triggering skb_over_panic.
Limit the copy size to the missing byte count.
[Fix checkpatch CHECK:PARENTHESIS_ALIGNMENT]
net/packet: avoid fanout hook re-registration after unregister
In the Linux kernel, the following vulnerability has been resolved:
net/packet: avoid fanout hook re-registration after unregister
packet_set_ring() temporarily detaches a socket from packet delivery while
reconfiguring its ring. It records the previous running state, clears
po->num, unregisters the protocol hook when needed, drops po->bind_lock,
and later restores po->num and re-registers the hook from the saved
was_running value.
That unlocked window can race with NETDEV_UNREGISTER. The notifier can
observe the socket as not running, skip __unregister_prot_hook(), and
invalidate the per-socket binding by setting po->ifindex to -1 and cle
iommu/amd: Wait for completion instead of returning early in iommu_completion_wait()
In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Wait for completion instead of returning early in iommu_completion_wait()
need_sync is a per-IOMMU flag shared by all domains and devices behind
that IOMMU. It is set whenever a command is queued with sync == true and
cleared when a completion-wait (CWAIT) command is queued. However, a
cleared need_sync only means that a covering CWAIT has been queued, not
that all previously queued commands have actually completed in hardware.
iommu_completion_wait() read need_sync locklessly and returned early
when it was false. This breaks the "block until all previously queu
In the Linux kernel, the following vulnerability has been resolved:
wan: wanxl: Only reset hardware after BAR mapping
wanxl_pci_init_one() stores the freshly allocated card in driver data
before the PLX BAR is mapped. Several early probe failures then unwind
through wanxl_pci_remove_one(), including failure to allocate the coherent
status area or to restore the DMA mask.
wanxl_pci_remove_one() unconditionally calls wanxl_reset(), and
wanxl_reset() dereferences card->plx. On those early failures card->plx
is still NULL, so the error path can dereference a NULL MMIO pointer.
Only issue the hardware reset once the BAR mapping exists. The
wifi: mwifiex: bound uAP association event IEs to the event buffer
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: bound uAP association event IEs to the event buffer
mwifiex_process_uap_event() handles EVENT_UAP_STA_ASSOC by exposing the
(re)association request IEs that the firmware copies into the event:
sinfo->assoc_req_ies = &event->data[len];
len = (u8 *)sinfo->assoc_req_ies - (u8 *)&event->frame_control;
sinfo->assoc_req_ies_len = le16_to_cpu(event->len) - (u16)len;
event->len is supplied by the device firmware and is never validated,
and the subtraction is unchecked. assoc_req_ies points into
adapter->event_body[MAX_EVENT_SIZE], a fixed-size array embedded in
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
sctp_auth_ep_add_chunkid() uses SCTP_NUM_CHUNK_TYPES (20) as the
capacity limit for ep->auth_chunk_list, allowing it to hold up to
20 chunk entries (param_hdr.length up to 24). However, the copy
destination asoc->c.auth_chunks in struct sctp_cookie is only
SCTP_AUTH_MAX_CHUNKS (16) entries (20 bytes). When more than 16
chunks are added, sctp_association_init() memcpy overflows the
destination by up to 4 bytes.
Fix by using SCTP_AUTH_MAX_CHUNKS as the capacity limit, matching
the destination capacity.
sctp: auth: verify auth requirement when auth_chunk is NULL
In the Linux kernel, the following vulnerability has been resolved:
sctp: auth: verify auth requirement when auth_chunk is NULL
sctp_auth_chunk_verify() returns true unconditionally when
chunk->auth_chunk is NULL, silently skipping authentication.
This is incorrect when:
1. skb_clone() failed in the BH receive path, leaving auth_chunk
NULL. In sctp_endpoint_bh_rcv() asoc is NULL for new
connections, so the early sctp_auth_recv_cid() check cannot
catch this.
2. No AUTH chunk precedes COOKIE-ECHO, so skb_clone() is never
called and auth_chunk remains NULL.
Fix by checking sctp_auth_recv_cid() when auth_chunk is NULL:
if authent
drm/amdkfd: Check bounds in allocate_event_notification_slot
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Check bounds in allocate_event_notification_slot
The valid event ids go from 0 to KFD_SIGNAL_EVENT_LIMIT
allocate_event_notification_slot has an option to specify
an event id to allocate at, used by CRIU. We weren't checking
the bounds on that value.
Check them.
v2: Lower bounds check is unecessary because of idr_alloc
already rejecting negative numbers. Upper bounds check should
be KFD_SIGNAL_EVENT_LIMIT since the signal mode mappings might
not yet exist
(cherry picked from commit 6853f1f6cbbeb3f53ebbbd7286536aeb2c5d5f50)
drm/amdkfd: Check bounds on CRIU restore queue type and mqd size
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Check bounds on CRIU restore queue type and mqd size
We weren't checking whether the values provided in the private
data in kfd CRIU restore were within bounds.
For queue type, add a KFD_QUEUE_TYPE_MAX and ensure the provided
type is less than it.
For mqd_size, add new function mqd_size_from_queue_type and confirm
that the provided mqd_size matches expectations.
(cherry picked from commit f19d8086f6644083c913d70bfdeee20e1b6f46a5)
drm/amdkfd: fix 32-bit overflow in CWSR total size calculation
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: fix 32-bit overflow in CWSR total size calculation
total_cwsr_size was computed in 32-bit before being used as a BO/SVM
allocation size.
With large ctx_save_restore_area_size and debug_memory_size
multiplied by the XCC count, the product can wrap,
yielding an undersized CWSR save area that firmware later overruns.
Promote total_cwsr_size to u64 and use check_add_overflow()/
check_mul_overflow() in both kfd_queue_acquire_buffers() and
kfd_queue_release_buffers().
(cherry picked from commit 319f7e13423ae3f486b9aea82f9ad2d6af0ee608)
drm/amdgpu/sdma7.0: replace BUG_ON() with WARN_ON()
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/sdma7.0: replace BUG_ON() with WARN_ON()
There's no need to crash the kernel for these cases.
(cherry picked from commit 9723a8bed3aa251a26bee4583bac9d8fb064dd44)
drm/amdgpu/sdma6.0: replace BUG_ON() with WARN_ON()
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/sdma6.0: replace BUG_ON() with WARN_ON()
There's no need to crash the kernel for these cases.
(cherry picked from commit c17a508a7d652da3728f8bbc481bfffe96d65a87)
drm/amdgpu/sdma5.2: replace BUG_ON() with WARN_ON()
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/sdma5.2: replace BUG_ON() with WARN_ON()
There's no need to crash the kernel for these cases.
(cherry picked from commit ae658afc7f47f6147371ec42cc6b1a793dfdb5af)