In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb: 6fire: Avoid embedded URBs
The USB 6fire driver uses URBs embedded in different structs for PCM,
MIDI and communication, and this is basically a buggy implementation
nowadays; since a URB is managed with a refcount, this may lead to a
UAF when the URB is released asynchronously.
For addressing the problem, this patch converts those embedded URBs to
ones that are properly allocated via usb_alloc_urb(). The
pcm_urb.packets[] is gone, as it's allocated by usb_alloc_urb(), hence
it's found in urb.iso_frame_desc[] instead.
The conversions are rather straightforward
net/sched: codel: bound the dropping loop per dequeue call
In the Linux kernel, the following vulnerability has been resolved:
net/sched: codel: bound the dropping loop per dequeue call
The CoDel control law schedules the next drop one interval/sqrt(count)
after the previous drop, using the configured interval
(codel_params.interval). For very small intervals the scheduled step
rounds down to zero, so the dropping loop in codel_dequeue() never
advances and drains the entire backlog under the qdisc lock in one
call - an unprivileged user can trigger a soft lockup this way.
Fix in the shared codel code used by both codel and fq_codel:
1. Make the control-law step at least 1 tick so the dropping loo
wifi: mwifiex: fix IRQ leak using wrong index in MSI-X error path
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix IRQ leak using wrong index in MSI-X error path
mwifiex_pcie_request_irq() registers each MSI-X vector with a per-index
dev_id (&card->msix_ctx[i]). On a request_irq() failure the cleanup loop
"for (j = 0; j < i; j++)" frees msix_entries[j].vector but passes the
failed index's &card->msix_ctx[i] as the dev_id. free_irq() matches on
(irq, dev_id), so it fails to find the action registered with
&card->msix_ctx[j]: the already-requested IRQ j is not freed (leaked) and
free_irq() warns about freeing a non-existent IRQ. Use &card->msix_ctx[j].
wifi: mac80211: don't warn when an IBSS has no channel to scan
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: don't warn when an IBSS has no channel to scan
ieee80211_request_ibss_scan() warns when regulatory leaves no
allowed channel, but that can happen as the regdomain can change
while IBSS is operating, and it can continue to operate briefly
during the 60s grace period until it's shut down.
Just remove the warning in this case.
wifi: cfg80211: undo netns switch if renaming the wiphy fails
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: undo netns switch if renaming the wiphy fails
Once all the interfaces have been moved, cfg80211_switch_netns()
moves the wiphy itself by setting its network namespace and then
renaming it, which makes sysfs move it. The rename can fail (but
only on allocation failures), leaving things mixed up and hitting
the warning there.
Ignoring it isn't great, undo the move and let the change fail
in this case. If undo fails then WARN, then things would again
be stuck in two different network namespaces.
wifi: mac80211_hwsim: don't hand frames to mac80211 while stopping
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: don't hand frames to mac80211 while stopping
The code checks ->started for frames coming from wmediumd, but the
radio can be stopped after the check and before frame delivery,
causing mac80211 to hit the WARN_ON(!local->started).
Expand the mutex for this case and synchronise against it when the
radio is stopped to avoid being able to hit the warning with hwsim.
Drop the error print that would've complicated the error path, it
only triggers for allocation failures (already noisy) and malformed
frames anyway.
wifi: mac80211: reset the AP_VLAN tailroom counter on ifdown
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: reset the AP_VLAN tailroom counter on ifdown
On ifup, AP_VLAN interfaces get crypto_tx_tailroom_needed_cnt from
the AP interface, but it's never decremented again unless the AP is
also brought down. Thus, bringing the same AP_VLAN up again will
increment the counter again and eventually hit the sanity check:
WARN_ON_ONCE(sdata->crypto_tx_tailroom_needed_cnt !=
master->crypto_tx_tailroom_needed_cnt);
Reset it on ifdown to avoid that.
wifi: mac80211: require a peer station for TDLS setup confirm
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: require a peer station for TDLS setup confirm
It's nonsense for the setup confirm to go to station that
doesn't even exist, and it hits a warning when building
the frame:
WARN_ON_ONCE(!sta || !ap_sta)
Only accept WLAN_TDLS_SETUP_CONFIRM when the station is
already there as a TDLS station. Need to copy the call
to ieee80211_tdls_prep_mgmt_packet() since the existing
WLAN_TDLS_DISCOVERY_REQUEST already falls through to it.
drop_monitor: fix out-of-bounds write in reset_per_cpu_data()
In the Linux kernel, the following vulnerability has been resolved:
drop_monitor: fix out-of-bounds write in reset_per_cpu_data()
In reset_per_cpu_data(), al is computed as:
al = sizeof(struct net_dm_alert_msg);
al += dm_hit_limit * sizeof(struct net_dm_drop_point);
al += sizeof(struct nlattr);
skb = genlmsg_new(al, GFP_KERNEL);
...
nla = nla_reserve(skb, NLA_UNSPEC, sizeof(struct net_dm_alert_msg));
...
msg = nla_data(nla);
memset(msg, 0, al);
Because al includes sizeof(struct nlattr) (the 4-byte attribute header),
genlmsg_new() allocates al bytes of tailroom starting at nla.
However, msg points to nl
selinux: always fill AVC decision in avc_has_perm_noaudit()
In the Linux kernel, the following vulnerability has been resolved:
selinux: always fill AVC decision in avc_has_perm_noaudit()
avc_has_perm_noaudit() is documented to return a copy of the access
decision in @avd, but its early return for an empty requested permission
set leaves the buffer untouched. All callers pass an uninitialized
stack variable and afterwards feed it to avc_audit(), and the inode hook
even stores it in the per-task decision cache.
Fill in a deny-all, audit-all decision, similar to avd_init(), so every
caller receives a defined value at no cost on the hot path.
In the Linux kernel, the following vulnerability has been resolved:
watchdog: rtd119x: Avoid division by zero
clk_get_rate() could return 0. Avoid a division by zero panic.
In the Linux kernel, the following vulnerability has been resolved:
wifi: rsi: fix heap OOB write on key removal
When a key is removed (data == NULL), rsi_hal_load_key() runs:
memset(&set_key[FRAME_DESC_SZ], 0, frame_len - FRAME_DESC_SZ);
set_key is a struct rsi_set_key *, so the subscript is scaled by
sizeof(struct rsi_set_key) (160 bytes): &set_key[FRAME_DESC_SZ] is
skb->data + 2560, and the memset writes 144 zero bytes starting
2.4KB past the end of the 160-byte skb data buffer, corrupting
unrelated heap objects. The intended byte offset would have been
(u8 *)set_key + FRAME_DESC_SZ.
The write fires on every DISABLE_KEY callback, so
wifi: mac80211: avoid WARN in set_bitrate_mask when sdata not in driver
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: avoid WARN in set_bitrate_mask when sdata not in driver
ieee80211_set_bitrate_mask() checks if the interface is running via
ieee80211_sdata_running(), but it does not check if the interface is
still present in the driver.
When sdata is running but IEEE80211_SDATA_IN_DRIVER is not set, the
call reaches drv_set_bitrate_mask() in driver-ops.h which hits
wlan1: Failed check-sdata-in-driver check, flags: 0x0
WARNING: net/mac80211/driver-ops.h:884 at drv_set_bitrate_mask
Syzkaller triggers this via wext SIOCSIWRATE ioctl. The Call Trace shows
wext_ioctl_dis
drm/virtio: Fix a NULL vs ERR_PTR() bug in virtio_gpu_user_framebuffer_create()
In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: Fix a NULL vs ERR_PTR() bug in virtio_gpu_user_framebuffer_create()
Smatch complains that returning a NULL here will lead to a NULL pointer
dereference in drm_mode_addfb2(). Return an error pointer instead.
net: iptunnel: fix stale transport header during tunnel decapsulation
In the Linux kernel, the following vulnerability has been resolved:
net: iptunnel: fix stale transport header during tunnel decapsulation
Syzbot reported a crash in qdisc_pkt_len_segs_init() caused by a stale
transport_header offset after tunnel decapsulation.
BUG: unable to handle page fault for address: ffffed102091a42e
Oops: Oops: 0000 [#1] SMP KASAN NOPTI
CPU: 0 UID: 0 PID: 340 Comm: qdisc_uaf_repro Not tainted 7.2.0-rc4-00061-g248951ddc14d #256 PREEMPT(full)
Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.16.3-debian-1.16.3-2 04/01/2014
RIP: 0010:__asan_load2
<IRQ>
qdisc_pkt_len_segs_init (net/core/dev.c:4145)
__dev_queue_x
s390/ipl: Fix NULL deref in kdump without re-IPL parm block
In the Linux kernel, the following vulnerability has been resolved:
s390/ipl: Fix NULL deref in kdump without re-IPL parm block
Some IPL types, like HMC FTP boot or QEMU direct kernel boot, might
not provide an IPL parameter block. In this case, reipl_type_init()
selects IPL_TYPE_UNKNOWN, and reipl_block_actual remains NULL.
kdump passes the re-IPL parameter block to the dump kernel through
os_info. Before commit 3b9678472bab ("s390/ipl: correct kdump reipl
block checksum calculation"), the os_info entry was added only for
IPL types which initialized reipl_block_actual. That commit moved the
os_info update to machine_crash_shutdown(), maki
s390/ipl: Fix NULL deref in dump_reipl without re-IPL parm block
In the Linux kernel, the following vulnerability has been resolved:
s390/ipl: Fix NULL deref in dump_reipl without re-IPL parm block
Unlike kdump, which passes the re-IPL parameter block through os_info,
the stand-alone dump passes it through the IPL parm block address and
checksum in lowcore.
Some IPL types, like HMC FTP boot or QEMU direct kernel boot, might not
provide an IPL parameter block. In this case reipl_type_init() selects
IPL_TYPE_UNKNOWN and reipl_block_actual remains NULL. Nevertheless,
dump_reipl_run() unconditionally dereferences it when preparing the
lowcore fields. This may happen to work by chance when address zero
conta
locking/lockdep: Invalidate stale class_cache entries for zapped classes
In the Linux kernel, the following vulnerability has been resolved:
locking/lockdep: Invalidate stale class_cache entries for zapped classes
syzbot reported a lockdep splat hitting DEBUG_LOCKS_WARN_ON(1) in
hlock_class() due to an invalid class_idx:
WARNING: kernel/locking/lockdep.c:238 at __lock_acquire+0x382/0x2cf0 kernel/locking/lockdep.c:5203
Workqueue: wg-crypt-wg0 wg_packet_tx_worker
RIP: 0010:hlock_class kernel/locking/lockdep.c:238 [inline]
RIP: 0010:check_wait_context kernel/locking/lockdep.c:4870 [inline]
RIP: 0010:__lock_acquire+0x389/0x2cf0 kernel/locking/lockdep.c:5203
Call Trace:
<IRQ>
lock_acquire+0x106/0x3
net: ipv4: Fix UDP length overflow with PMTU discover and big MTU
In the Linux kernel, the following vulnerability has been resolved:
net: ipv4: Fix UDP length overflow with PMTU discover and big MTU
This commit bounds cork->base.fragsize to IP_MAX_MTU to avoid a
possible overflow of UDP length that triggers a WARN in
udp_set_len_short when setsockopt IP_MTU_DISCOVER is set to
IP_PMTUDISC_PROBE, and a large packet is sent over a netdev with an
unusually large MTU.
Steps to reproduce:
1. Set device MTU bigger than IP_MAX_MTU + 20. cork->base.fragsize will
be set to that MTU in ip_setup_cork.
2. Set IP_MTU_DISCOVER to IP_PMTUDISC_PROBE. It lets maxnonfragsize be
set to device MTU (cork->fragsize) in
drm/amdgpu: skip gfx switch_power_profile during GPU reset
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: skip gfx switch_power_profile during GPU reset
During resume from GPU reset, the gfx idle work may invoke switch_power_profile
before the reset completes. This causes the following assert error because the
register access occurs without first releasing the GPU reset semaphore:
[ 1576.768935] CR2: 0000559ea133ead0 CR3: 00000002e6c42000 CR4: 0000000000350ef0
[ 1576.768940] Call Trace:
[ 1576.768944] <TASK>
[ 1576.768953] amdgpu_device_rreg+0x21/0x50 [amdgpu]
[ 1576.769158] smu_msg_v1_send_msg+0x1a4/0x6e0 [amdgpu]
[ 1576.769437] smu_cmn_send_smc_msg_with_param