linux-gcp-5.15 vulnerabilities · Page 180

power: supply: ab8500: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: ab8500: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler has

• Update to 5.15.0-1112.122~20.04.1

iommu/vt-d: Clear Present bit before tearing down context entry

In the Linux kernel, the following vulnerability has been resolved: iommu/vt-d: Clear Present bit before tearing down context entry When tearing down a context entry, the current implementation zeros the entire 128-bit entry using multiple 64-bit writes. This creates a window where the hardware can fetch a "torn" entry — where some fields are already zeroed while the 'Present' bit is still set — leading to unpredictable behavior or spurious faults. While x86 provides strong write ordering, the compiler may reorder writes to the two 64-bit halves of the context entry. Even without compiler reordering, the hardware fetch is not guaranteed to

ext4: fix e4b bitmap inconsistency reports

In the Linux kernel, the following vulnerability has been resolved: ext4: fix e4b bitmap inconsistency reports A bitmap inconsistency issue was observed during stress tests under mixed huge-page workloads. Ext4 reported multiple e4b bitmap check failures like: ext4_mb_complex_scan_group:2508: group 350, 8179 free clusters as per group info. But got 8192 blocks Analysis and experimentation confirmed that the issue is caused by a race condition between page migration and bitmap modification. Although this timing window is extremely narrow, it is still hit in practice: folio_lock ext4_mb_load_buddy __migrate_folio c

tpm: tpm_i2c_infineon: Fix locality leak on get_burstcount() failure

In the Linux kernel, the following vulnerability has been resolved: tpm: tpm_i2c_infineon: Fix locality leak on get_burstcount() failure get_burstcount() can return -EBUSY on timeout. When this happens, the function returns directly without releasing the locality that was acquired at the beginning of tpm_tis_i2c_send(). Use goto out_err to ensure proper cleanup when get_burstcount() fails.

• Update to 5.15.0-1112.122~20.04.1

net: stmmac: fix oops when split header is enabled

In the Linux kernel, the following vulnerability has been resolved: net: stmmac: fix oops when split header is enabled For GMAC4, when split header is enabled, in some rare cases, the hardware does not fill buf2 of the first descriptor with payload. Thus we cannot assume buf2 is always fully filled if it is not the last descriptor. Otherwise, the length of buf2 of the second descriptor will be calculated wrong and cause an oops: Unable to handle kernel paging request at virtual address ffff00019246bfc0 ... x2 : 0000000000000040 x1 : ffff00019246bfc0 x0 : ffff00009246c000 Call trace: dcache_inval_poc+0x28/0x58 (P) dma_direct_sync_single_f

power: supply: goldfish: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: goldfish: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler h

• Update to 5.15.0-1112.122~20.04.1

fs/ntfs3: Fix slab-out-of-bounds read in DeleteIndexEntryRoot

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: Fix slab-out-of-bounds read in DeleteIndexEntryRoot In the 'DeleteIndexEntryRoot' case of the 'do_action' function, the entry size ('esize') is retrieved from the log record without adequate bounds checking. Specifically, the code calculates the end of the entry ('e2') using: e2 = Add2Ptr(e1, esize); It then calculates the size for memmove using 'PtrOffset(e2, ...)', which subtracts the end pointer from the buffer limit. If 'esize' is maliciously large, 'e2' exceeds the used buffer size. This results in a negative offset which, when cast to size_t for memmov

• Update to 5.15.0-1112.122~20.04.1

btrfs: fix EEXIST abort due to non-consecutive gaps in chunk allocation

In the Linux kernel, the following vulnerability has been resolved: btrfs: fix EEXIST abort due to non-consecutive gaps in chunk allocation I have been observing a number of systems aborting at insert_dev_extents() in btrfs_create_pending_block_groups(). The following is a sample stack trace of such an abort coming from forced chunk allocation (typically behind CONFIG_BTRFS_EXPERIMENTAL) but this can theoretically happen to any DUP chunk allocation. [81.801] ------------[ cut here ]------------ [81.801] BTRFS: Transaction aborted (error -17) [81.801] WARNING: fs/btrfs/block-group.c:2876 at btrfs_create_pending_block_groups+0x721/0x77

net: mctp: ensure our nlmsg responses are initialised

In the Linux kernel, the following vulnerability has been resolved: net: mctp: ensure our nlmsg responses are initialised Syed Faraz Abrar (@farazsth98) from Zellic, and Pumpkin (@u1f383) from DEVCORE Research Team working with Trend Micro Zero Day Initiative report that a RTM_GETNEIGH will return uninitalised data in the pad bytes of the ndmsg data. Ensure we're initialising the netlink data to zero, in the link, addr and neigh response messages.

• Update to 5.15.0-1118.128~20.04.1

ksmbd: call ksmbd_vfs_kern_path_end_removing() on some error paths

In the Linux kernel, the following vulnerability has been resolved: ksmbd: call ksmbd_vfs_kern_path_end_removing() on some error paths There are two places where ksmbd_vfs_kern_path_end_removing() needs to be called in order to balance what the corresponding successful call to ksmbd_vfs_kern_path_start_removing() has done, i.e. drop inode locks and put the taken references. Otherwise there might be potential deadlocks and unbalanced locks which are caught like: BUG: workqueue leaked lock or atomic: kworker/5:21/0x00000000/7596 last function: handle_ksmbd_work 2 locks held by kworker/5:21/7596: #0: ffff8881051ae448 (sb_writers#3){.+.

• Update to 5.15.0-1112.122~20.04.1

net: usb: catc: enable basic endpoint checking

In the Linux kernel, the following vulnerability has been resolved: net: usb: catc: enable basic endpoint checking catc_probe() fills three URBs with hardcoded endpoint pipes without verifying the endpoint descriptors: - usb_sndbulkpipe(usbdev, 1) and usb_rcvbulkpipe(usbdev, 1) for TX/RX - usb_rcvintpipe(usbdev, 2) for interrupt status A malformed USB device can present these endpoints with transfer types that differ from what the driver assumes. Add a catc_usb_ep enum for endpoint numbers, replacing magic constants throughout. Add usb_check_bulk_endpoints() and usb_check_int_endpoints() calls after usb_set_interface() to verify endp

ext4: fix dirtyclusters double decrement on fs shutdown

In the Linux kernel, the following vulnerability has been resolved: ext4: fix dirtyclusters double decrement on fs shutdown fstests test generic/388 occasionally reproduces a warning in ext4_put_super() associated with the dirty clusters count: WARNING: CPU: 7 PID: 76064 at fs/ext4/super.c:1324 ext4_put_super+0x48c/0x590 [ext4] Tracing the failure shows that the warning fires due to an s_dirtyclusters_counter value of -1. IOW, this appears to be a spurious decrement as opposed to some sort of leak. Further tracing of the dirty cluster count deltas and an LLM scan of the resulting output identified the cause as a double decrement in the

• Update to 5.15.0-1112.122~20.04.1

sched/rt: Skip currently executing CPU in rto_next_cpu()

In the Linux kernel, the following vulnerability has been resolved: sched/rt: Skip currently executing CPU in rto_next_cpu() CPU0 becomes overloaded when hosting a CPU-bound RT task, a non-CPU-bound RT task, and a CFS task stuck in kernel space. When other CPUs switch from RT to non-RT tasks, RT load balancing (LB) is triggered; with HAVE_RT_PUSH_IPI enabled, they send IPIs to CPU0 to drive the execution of rto_push_irq_work_func. During push_rt_task on CPU0, if next_task->prio < rq->donor->prio, resched_curr() sets NEED_RESCHED and after the push operation completes, CPU0 calls rto_next_cpu(). Since only CPU0 is overloaded in this scenario

• Update to 5.15.0-1112.122~20.04.1

ipvs: do not keep dest_dst if dev is going down

In the Linux kernel, the following vulnerability has been resolved: ipvs: do not keep dest_dst if dev is going down There is race between the netdev notifier ip_vs_dst_event() and the code that caches dst with dev that is going down. As the FIB can be notified for the closed device after our handler finishes, it is possible valid route to be returned and cached resuling in a leaked dev reference until the dest is not removed. To prevent new dest_dst to be attached to dest just after the handler dropped the old one, add a netif_running() check to make sure the notifier handler is not currently running for device that is closing.

power: supply: sbs-battery: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: sbs-battery: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handle

• Update to 5.15.0-1112.122~20.04.1

fat: avoid parent link count underflow in rmdir

In the Linux kernel, the following vulnerability has been resolved: fat: avoid parent link count underflow in rmdir Corrupted FAT images can leave a directory inode with an incorrect i_nlink (e.g. 2 even though subdirectories exist). rmdir then unconditionally calls drop_nlink(dir) and can drive i_nlink to 0, triggering the WARN_ON in drop_nlink(). Add a sanity check in vfat_rmdir() and msdos_rmdir(): only drop the parent link count when it is at least 3, otherwise report a filesystem error.

• Update to 5.15.0-1112.122~20.04.1

ext4: don't cache extent during splitting extent

In the Linux kernel, the following vulnerability has been resolved: ext4: don't cache extent during splitting extent Caching extents during the splitting process is risky, as it may result in stale extents remaining in the status tree. Moreover, in most cases, the corresponding extent block entries are likely already cached before the split happens, making caching here not particularly useful. Assume we have an unwritten extent, and then DIO writes the first half. [UUUUUUUUUUUUUUUU] on-disk extent U: unwritten extent [UUUUUUUUUUUUUUUU] extent status tree |<- ->| ----> dio write this range First, when ext4_split_extent_at()

• Update to 5.15.0-1112.122~20.04.1

usb: cdns3: fix role switching during resume

In the Linux kernel, the following vulnerability has been resolved: usb: cdns3: fix role switching during resume If the role change while we are suspended, the cdns3 driver switches to the new mode during resume. However, switching to host mode in this context causes a NULL pointer dereference. The host role's start() operation registers a xhci-hcd device, but its probe is deferred while we are in the resume path. The host role's resume() operation assumes the xhci-hcd device is already probed, which is not the case, leading to the dereference. Since the start() operation of the new role is already called, the resume operation can be skipp

• Update to 5.15.0-1112.122~20.04.1

xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path

In the Linux kernel, the following vulnerability has been resolved: xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path icmp_route_lookup() performs multiple route lookups to find a suitable route for sending ICMP error messages, with special handling for XFRM (IPsec) policies. The lookup sequence is: 1. First, lookup output route for ICMP reply (dst = original src) 2. Pass through xfrm_lookup() for policy check 3. If blocked (-EPERM) or dst is not local, enter "reverse path" 4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec which reverses the original packet's flow (saddr<->daddr swapped) 5. If fl4_dec.saddr

powerpc/eeh: fix recursive pci_lock_rescan_remove locking in EEH event handling

In the Linux kernel, the following vulnerability has been resolved: powerpc/eeh: fix recursive pci_lock_rescan_remove locking in EEH event handling The recent commit 1010b4c012b0 ("powerpc/eeh: Make EEH driver device hotplug safe") restructured the EEH driver to improve synchronization with the PCI hotplug layer. However, it inadvertently moved pci_lock_rescan_remove() outside its intended scope in eeh_handle_normal_event(), leading to broken PCI error reporting and improper EEH event triggering. Specifically, eeh_handle_normal_event() acquired pci_lock_rescan_remove() before calling eeh_pe_bus_get(), but eeh_pe_bus_get() itself attempts t

• Update to 5.15.0-1112.122~20.04.1