crypto: atmel-sha204a - fix heap info leak on I2C transfer failure
In the Linux kernel, the following vulnerability has been resolved:
crypto: atmel-sha204a - fix heap info leak on I2C transfer failure
The nonblocking RNG path allocates a work_data structure to track the
state of an in-flight asynchronous I2C request. This pointer is stored
in rng->priv and later consumed by the read path once the transaction
completes.
If the underlying I2C transfer fails, the completion callback is invoked
with a non-zero status. In this case, the allocated work_data is not
usable for producing RNG output and must not remain associated with the
hwrng state.
Previously, the failure path only logged a warning but left th
crypto: sa2ul - stop probe if context pool creation fails
In the Linux kernel, the following vulnerability has been resolved:
crypto: sa2ul - stop probe if context pool creation fails
sa_ul_probe() calls sa_init_mem() to create the DMA pool used for
security context buffers, but ignores its return value. If pool creation
fails, probe still continues with DMA setup, algorithm registration and
child population even though later request setup depends on that pool.
Stop probing when sa_init_mem() fails, and route that failure to the PM
cleanup path without attempting to destroy an uncreated DMA pool.
crypto: keembay - Fix AEAD unregister count in error path
In the Linux kernel, the following vulnerability has been resolved:
crypto: keembay - Fix AEAD unregister count in error path
register_aes_algs() registers the AEAD algorithms before registering the
skcipher algorithms. If skcipher registration fails, the function unwinds
the earlier AEAD registration with crypto_engine_unregister_aeads(), but it
passes ARRAY_SIZE(algs), which is the skcipher table size.
Use ARRAY_SIZE(algs_aead) for the AEAD unwind path so the unregister helper
iterates over the same table that was registered. Also clarify the nearby
comment: the crypto registration helpers clean up algorithms registered
within the same
In the Linux kernel, the following vulnerability has been resolved:
RDMA/irdma: Add refcounting to user ring MRs
Prevent userspace from deregistering the MRs that back QP/CQ/SRQ rings
by bumping the MR's refcount upon association.
nvmet-rdma: fix response resource leak on queue teardown
In the Linux kernel, the following vulnerability has been resolved:
nvmet-rdma: fix response resource leak on queue teardown
When an nvme target with rdma transport is removed while I/Os are in
flight, a response can be posted but its send completion is never
delivered before the connection is torn down. As a result
nvmet_rdma_send_done() and nvmet_rdma_release_rsp() are never called for
the response, and this leaks the allocated RDMA read/write context and
request SGLs.
These leaks are recreated by running blktests nvme/061 with the rdma
transport and the siw driver. Kernel kmemleak feature reports them as
follows:
unreferenced object
In the Linux kernel, the following vulnerability has been resolved:
cgroup/cpuset: Make nr_deadline_tasks an atomic_t
The nr_deadline_tasks variable in the cpuset structure was introduced by
commit 6c24849f5515 ("sched/cpuset: Keep track of SCHED_DEADLINE task
in cpusets"). It is reported by sashiko [1] that nr_deadline_tasks
can currently be modified by inc_dl_tasks_cs() under rq->lock and
by cpuset_attach() under cpuset_mutex. So if both updates happen
simultaneously, the nr_deadline_tasks variable can be corrupted leading
to incorrect operations down the road.
Fix that by changing its type to atomic_t so that nr_deadline_tasks
are alway
wifi: mac80211_hwsim: avoid NULL skb in stop queue drain
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: avoid NULL skb in stop queue drain
mac80211_hwsim_stop() drops any frames left in data->pending. The loop
currently checks skb_queue_empty() and then dequeues separately.
That split is racy with TX status handling, which can remove a pending
frame under the queue lock. If the last entry is removed after the empty
check, skb_dequeue() returns NULL and the stop path passes that NULL skb
to ieee80211_free_txskb().
Use skb_dequeue() as the loop condition instead. The dequeue result is the
object that stop owns and frees, and a concurrent status completio
time/namespace: Validate nanosecond field in proc_timens_set_offset()
In the Linux kernel, the following vulnerability has been resolved:
time/namespace: Validate nanosecond field in proc_timens_set_offset()
The function validates tv_sec to be within [-KTIME_SEC_MAX, KTIME_SEC_MAX]
but never validates that tv_nsec is within the valid range of
[0, NSEC_PER_SEC-1] before using it in timespec64_add().
timespec64_add() expects both timespec64 structures to have normalized
values with tv_nsec in the range [0, 999999999]. If off->val.tv_nsec
contains invalid values (negative or >= NSEC_PER_SEC), it could lead to
incorrect calculations or unexpected behavior.
Add validation to ensure tv_nsec is within the valid ra
clk: qcom: gdsc: tear down per-domain genpds in gdsc_unregister()
In the Linux kernel, the following vulnerability has been resolved:
clk: qcom: gdsc: tear down per-domain genpds in gdsc_unregister()
gdsc_unregister() removes the OF provider entry and tears down the
parent/subdomain wiring, but never calls pm_genpd_remove() on the
individual generic_pm_domain structures registered by gdsc_init():
void gdsc_unregister(struct gdsc_desc *desc)
{
struct device *dev = desc->dev;
size_t num = desc->num;
gdsc_pm_subdomain_remove(desc, num);
of_genpd_del_provider(dev->of_node);
}
That leaves dangling entries on the global gpd_list. After a provider
unbind/rebind cycle (deferred-probe replay during e
thermal/drivers/rcar: Fix error checking in probe()
In the Linux kernel, the following vulnerability has been resolved:
thermal/drivers/rcar: Fix error checking in probe()
This code accidentally calls thermal_zone_device_enable() before checking
whether thermal_zone_device_register_with_trips() failed. Move the call
until later to avoid an error pointer dereference of "priv->zone".
The driver works differently depending on if we are using OF thermal or
not. We use thermal_add_hwmon_sysfs() if we are using OF thermal and
call thermal_zone_device_enable() if not. We can share same error check
for if either of these fail.
Moving the thermal_zone_device_enable() call is a bit cleaner as wel
usb: gadget: r8a66597: avoid double free of ep0_req in probe error path
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: r8a66597: avoid double free of ep0_req in probe error path
If usb_add_gadget_udc() fails, r8a66597_probe() jumps to err_add_udc
and frees ep0_req, then falls through to clean_up2 where ep0_req is
freed again when it is non-NULL.
Remove the redundant free from err_add_udc and keep the cleanup in
clean_up2 so the request is released exactly once.
Issue found using a prototype static analysis tool
and confirmed by code review.
udf: Mark LVID buffer as uptodate before marking it dirty
In the Linux kernel, the following vulnerability has been resolved:
udf: Mark LVID buffer as uptodate before marking it dirty
When an I/O error occurs while writing the Logical Volume Integrity
Descriptor (LVID) buffer to the block device, the block layer's completion
handler (`end_buffer_write_sync()`) clears the `BH_Uptodate` flag on the
buffer. However, the buffer still contains valid LVID data in memory. If
the filesystem is subsequently remounted read-write or synced,
`udf_open_lvid()` or `udf_sync_fs()` will modify the LVID buffer and call
`mark_buffer_dirty()`. This triggers a spurious
`WARN_ON_ONCE(!buffer_uptodate(bh))` warning in
bpf: Fix vmlinux BTF prep race in bpf_get_btf_vmlinux
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix vmlinux BTF prep race in bpf_get_btf_vmlinux
bpf_get_btf_vmlinux() lazily parses the vmlinux BTF under the
bpf_verifier_lock, but publishes the result through a plain store
and re-checks it through a plain lockless load. Nothing orders
the stores initializing the struct btf inside btf_parse_vmlinux()
against the store publishing the pointer: On a weakly ordered
arch, a concurrent first-time caller taking the lockless fast
path could in principle observe the pointer before the parsed
contents are visible. The mutex_unlock() does not help such a
reader given it only
In the Linux kernel, the following vulnerability has been resolved:
platform/x86: dell-privacy: Fix race condition
Accessing priv->features_present needs to happen with the list mutex
being held, otherwise priv can be freed at any moment.
platform/x86: dell-wmi-base: Fix resource leak on module load failure
In the Linux kernel, the following vulnerability has been resolved:
platform/x86: dell-wmi-base: Fix resource leak on module load failure
We need to properly clean up the SMBIOS request and the privacy driver
when the module load fails.
platform/x86: lg-laptop: Fix LED resource handling
In the Linux kernel, the following vulnerability has been resolved:
platform/x86: lg-laptop: Fix LED resource handling
The event notification callback might access kbd_backlight even
when it was not successfully registered with the LED subsystem.
The same happens inside acpi_remove(), where the LED devices are
unregistered unconditionally.
Fix this by tracking the availability of the kbd_backlight LED
device and use devm_led_classdev_register() to let devres take
care of unregistering the LED devices during removal. For this
the parent device of the LED devices is changed to the native
platform device.
usb: gadget: configfs: fix out-of-bounds read of qw_sign
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: configfs: fix out-of-bounds read of qw_sign
os_desc_qw_sign_show() passes OS_STRING_QW_SIGN_LEN as the input
length to utf16s_to_utf8s(), but that argument counts UTF-16 code
units while OS_STRING_QW_SIGN_LEN (14) is the byte size of qw_sign[].
The array holds only OS_STRING_QW_SIGN_LEN / 2 (7) code units, so the
conversion reads up to 7 units (14 bytes) past the end of qw_sign[]
into the following members of struct gadget_info when the stored
signature fills the array without a NUL terminator, exposing those
bytes through the configfs attribute.
The store pat
usb: fix UAF when probe runs concurrent to dyn ID removal
In the Linux kernel, the following vulnerability has been resolved:
usb: fix UAF when probe runs concurrent to dyn ID removal
Dynamic IDs are only guaranteed to be valid when usb_dynids_lock is held,
as remove_id_store can free the node. Thus, make a copy in
usb_probe_interface. Clarify the documentation that the id parameter is
only valid during the probe.
USB serial has the same pattern, but it does not need fixing as the IDs
cannot be removed via sysfs.
platform/mellanox: mlxbf-pmc: Check ACPI_COMPANION() against NULL
In the Linux kernel, the following vulnerability has been resolved:
platform/mellanox: mlxbf-pmc: Check ACPI_COMPANION() against NULL
Every platform driver can be forced to match a device that doesn't match
its list of device IDs because of device_match_driver_override(), so
platform drivers that rely on the existence of a device's ACPI companion
object need to verify its presence.
mlxbf_pmc_probe() passes the result of ACPI_COMPANION() to
acpi_device_hid(), which dereferences it, so force-binding the driver to
a device without an ACPI companion leads to a NULL pointer dereference.
Accordingly, add a requisite ACPI_COMPANION() check again
platform/surface: acpi-notify: Check ACPI companion before use
In the Linux kernel, the following vulnerability has been resolved:
platform/surface: acpi-notify: Check ACPI companion before use
Since every platform driver can be forced to match a device that doesn't
match its list of device IDs because of device_match_driver_override(),
platform drivers that rely on the existence of a device's ACPI companion
object should verify its presence.
san_probe() dereferences the result of ACPI_COMPANION() when installing
the GSBUS address space handler, so force-binding the driver to a device
without an ACPI companion leads to a NULL pointer dereference. The
dereference was introduced when the probe function