HID: appleir: fix UAF on pending key_up_timer in remove()
In the Linux kernel, the following vulnerability has been resolved:
HID: appleir: fix UAF on pending key_up_timer in remove()
appleir_remove() runs hid_hw_stop() before timer_delete_sync().
hid_hw_stop() synchronously unregisters the HID input device via
hid_disconnect() -> hidinput_disconnect() -> input_unregister_device(),
which drops the last reference and frees the underlying input_dev when
no userspace handle holds it open.
key_up_tick() reads appleir->input_dev and calls input_report_key() /
input_sync() on it. The timer is armed from appleir_raw_event() with
a HZ/8 (~125 ms) timeout on every keydown and key-repeat report. If a
key
HID: lg-g15: cancel pending work on remove to fix a use-after-free
In the Linux kernel, the following vulnerability has been resolved:
HID: lg-g15: cancel pending work on remove to fix a use-after-free
lg_g15_data is allocated with devm and holds a work item. The report
handlers schedule that work straight from device input.
lg_g15_event() and lg_g15_v2_event() do it on the backlight cycle key,
and lg_g510_leds_event() does it too. The worker dereferences the
lg_g15_data back through container_of.
The driver had no remove callback and never cancelled the work. So if a
report scheduled the work and the keyboard was then unplugged, devres
freed lg_g15_data while the work was still pending or running, and th
hfs/hfsplus: fix u32 overflow in check_and_correct_requested_length
In the Linux kernel, the following vulnerability has been resolved:
hfs/hfsplus: fix u32 overflow in check_and_correct_requested_length
check_and_correct_requested_length() compares (off + len) against
node_size using u32 arithmetic. When the caller passes a large len
value (e.g. from an underflowed subtraction in hfs_brec_remove()),
off + len can wrap past 2^32 and produce a small result, causing the
bounds check to pass when it should fail.
For example, with off=14 and len=0xFFFFFFF2 (underflowed from
data_off - keyoffset - size in hfs_brec_remove), off + len wraps to 6,
which is less than a typical node_size of 512, so the check passes
hfs/hfsplus: zero-initialize buffer in hfs_bnode_read
In the Linux kernel, the following vulnerability has been resolved:
hfs/hfsplus: zero-initialize buffer in hfs_bnode_read
hfs_bnode_read() can return early without writing to the output buffer
when is_bnode_offset_valid() fails or when check_and_correct_requested_
length() corrects the length to zero. Callers such as hfs_bnode_read_
u16() and hfs_bnode_read_u8() pass stack-allocated buffers and use the
result unconditionally, leading to KMSAN uninit-value reports.
Rather than initializing at each individual call site, zero the buffer
at the start of hfs_bnode_read() before any validation checks. This
ensures all callers in both hfs and h
nilfs2: reject CLEAN_SEGMENTS ioctl with out-of-range segment numbers
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: reject CLEAN_SEGMENTS ioctl with out-of-range segment numbers
Syzbot reported a hung task in nilfs_transaction_begin() where multiple
tasks performing chmod() on a nilfs2 mount blocked for over 143 seconds
waiting to acquire ns_segctor_sem for read:
INFO: task syz.0.17:5918 blocked for more than 143 seconds.
Call Trace:
schedule+0x164/0x360
rwsem_down_read_slowpath+0x6d9/0x940
down_read+0x99/0x2e0
nilfs_transaction_begin+0x364/0x710 fs/nilfs2/segment.c:221
nilfs_setattr+0x124/0x2c0 fs/nilfs2/inode.c:921
notify_change+0xc1a/0xf40
chmod_commo
In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject fragmented frames in devmap
Devmap broadcast redirects clone the packet for all but the last
destination.
For native XDP, that clone path copies only the linear xdp_frame data,
while fragmented frames keep skb_shared_info in tailroom outside the
linear area. Cloning such a frame leaves XDP_FLAGS_HAS_FRAGS set but
without valid frag metadata, and the later free path can interpret
uninitialized tail data as skb_shared_info, leading to an out-of-bounds
access during frame return.
Reject fragmented native XDP frames in dev_map_enqueue_clone().
Add the same restri
bpf: Allow LPM map access from sleepable BPF programs
In the Linux kernel, the following vulnerability has been resolved:
bpf: Allow LPM map access from sleepable BPF programs
trie_lookup_elem() annotates its rcu_dereference_check() walks with
only rcu_read_lock_bh_held(). Because rcu_dereference_check(p, c)
resolves to "c || rcu_read_lock_held()", this passes for XDP/NAPI and
classic RCU readers but fails for sleepable BPF programs, which enter
via __bpf_prog_enter_sleepable() and hold only rcu_read_lock_trace().
trie_update_elem() and trie_delete_elem() have the same problem in a
different form: they walk the trie with plain rcu_dereference(), which
asserts rcu_read_lock_held() uncondition
net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
kalmia_rx_fixup() computes usb_packet_length = skb->len - (2 *
KALMIA_HEADER_LENGTH) as a u16, guarded only by a pre-loop check that
skb->len is at least KALMIA_HEADER_LENGTH, which is 6. A device can
deliver a short bulk-IN frame with skb->len in the 6 to 11 range, or
leave a short trailing remainder on a later loop iteration. Either case
underflows usb_packet_length to about 65530.
That bypasses the usb_packet_length < ether_packet_length truncation path.
The device-supplied ether_packet_length, a le16 up to 65
usb: cdnsp: fix stream context array leak in cdnsp_alloc_stream_info()
In the Linux kernel, the following vulnerability has been resolved:
usb: cdnsp: fix stream context array leak in cdnsp_alloc_stream_info()
cdnsp_alloc_stream_info() allocates stream_info->stream_ctx_array with
cdnsp_alloc_stream_ctx(). If a later stream ring allocation or stream
mapping update fails, the error path frees the allocated stream rings
and stream_rings array, but leaves stream_ctx_array allocated.
Free the stream context array before falling through to the stream_rings
cleanup path.
In the Linux kernel, the following vulnerability has been resolved:
usb: free iso schedules on failed submit
EHCI and FOTG210 isochronous submits build an ehci_iso_sched before
linking the URB to the endpoint queue, and keep the staged schedule in
urb->hcpriv until iso_stream_schedule() and the link helpers consume it.
If the controller is no longer accessible, or usb_hcd_link_urb_to_ep()
fails, submit jumps to done_not_linked before that handoff happens and
leaks the staged schedule still attached to urb->hcpriv.
Free the staged schedule from done_not_linked when submit fails before
the URB is linked and clear urb->hcpriv after the free.
usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler
The OTG branch of composite_setup() falls back to the first
configuration when none is selected:
if (cdev->config)
config = cdev->config;
else
config = list_first_entry(&cdev->configs,
struct usb_configuration, list);
if (!config)
goto done;
...
memcpy(req->buf, config->descriptors[0], value);
list_first_entry() never returns NULL. On an empty list it returns
container_of() of the list head. So the "if (!config)" check is dead.
When cdev->configs is empty, config points at the head i
usb: gadget: udc: Fix use-after-free in gadget_match_driver
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: udc: Fix use-after-free in gadget_match_driver
The udc structure acts as the management structure for the gadget,
but their lifecycles are decoupled. A race condition exists where
usb_del_gadget() frees the udc memory (e.g., via mode-switch work)
while gadget_match_driver() concurrently accesses the freed udc memory
(e.g., via configfs), causing a Use-After-Free (UAF) that triggers a
NULL pointer dereference when the freed memory is zeroed:
[39430.908615][ T1171] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
[39430.911397
usb: gadget: f_printer: take kref only for successful open
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_printer: take kref only for successful open
printer_open() returns -EBUSY when the character device is already
open, but it increments dev->kref regardless of the return value. VFS
does not call ->release() for a failed open, so every rejected second
open permanently leaks one reference.
Move kref_get() into the successful-open branch.
USB: idmouse: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: idmouse: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use t
In the Linux kernel, the following vulnerability has been resolved:
USB: ldusb: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect
Submitted write URBs are not stopped on close() and therefore need to be
stopped unconditionally on disconnect() to avoid use-after-free in the
completion handler.
USB: iowarrior: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the lock object
USB: legousbtower: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: legousbtower: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still
USB: misc: uss720: unregister parport on probe failure
In the Linux kernel, the following vulnerability has been resolved:
USB: misc: uss720: unregister parport on probe failure
uss720_probe() registers a parport before reading the 1284 register used
to detect unsupported Belkin F5U002 adapters. If get_1284_register()
fails, the error path drops the driver private data and the USB device
reference, but leaves the parport device registered.
Leaving the port registered is more than a private allocation leak:
parport_register_port() has already reserved a parport number and
registered the parport bus device, while pp->private_data still points at
the private data that the common error path is abo
In the Linux kernel, the following vulnerability has been resolved:
usb: mtu3: unmap request DMA on queue failure
mtu3_gadget_queue() maps the request before checking whether
the QMU GPD ring can accept another transfer. the request is
returned with -EAGAIN before it is linked on the endpoint
request list if mtu3_prepare_transfer() fails.
Normal completion and dequeue paths unmap requests from
mtu3_req_complete(), but this error path never reaches that
helper, so the DMA mapping is left active. Unmap the request
before returning from the failed queue path.