PatchFirst · Latest vulnerabilities
Vulnerabilities published for linux-xilinx-zynqmp in the last 30 days: 484. Listed in the KEV catalogue: 0.
Vulnerabilities: 5333
In the Linux kernel, the following vulnerability has been resolved: blk-throttle: prevent overflow while calculating wait time There is a problem found by code review in tg_with_in_bps_limit() that 'bps_limit * jiffy_elapsed_rnd' might overflow. Fix the problem by calling mul_u64_u64_div_u64() instead.
In the Linux kernel, the following vulnerability has been resolved: tpm: acpi: Call acpi_put_table() to fix memory leak The start and length of the event log area are obtained from TPM2 or TCPA table, so we call acpi_get_table() to get the ACPI information, but the acpi_get_table() should be coupled with acpi_put_table() to release the ACPI memory, add the acpi_put_table() properly to fix the memory leak. While we are at it, remove the redundant empty line at the end of the tpm_read_log_acpi().
In the Linux kernel, the following vulnerability has been resolved: drm/meson: explicitly remove aggregate driver at module unload time Because component_master_del wasn't being called when unloading the meson_drm module, the aggregate device would linger forever in the global aggregate_devices list. That means when unloading and reloading the meson_dw_hdmi module, component_add would call into try_to_bring_up_aggregate_device and find the unbound meson_drm aggregate device. This would in turn dereference some of the aggregate_device's struct entries which point to memory automatically freed by the devres API when unbinding the aggregate d
In the Linux kernel, the following vulnerability has been resolved: drm: Fix potential null-ptr-deref due to drmm_mode_config_init() drmm_mode_config_init() will call drm_mode_create_standard_properties() and won't check the ret value. When drm_mode_create_standard_properties() failed due to alloc, property will be a NULL pointer and may causes the null-ptr-deref. Fix the null-ptr-deref by adding the ret value check. Found null-ptr-deref while testing insert module bochs: general protection fault, probably for non-canonical address 0xdffffc000000000c: 0000 [#1] SMP KASAN PTI KASAN: null-ptr-deref in range [0x0000000000000060-0x00000000
In the Linux kernel, the following vulnerability has been resolved: drm/gma500: Fix null dereference in hdmi teardown pci_set_drvdata sets the value of pdev->driver_data to NULL, after which the driver_data obtained from the same dev is dereferenced in oaktrail_hdmi_i2c_exit, and the i2c_dev is extracted from it. To prevent this, swap these calls. Found by Linux Verification Center (linuxtesting.org) with Svacer.
In the Linux kernel, the following vulnerability has been resolved: mm/hugetlb: fix folio is still mapped when deleted Migration may be raced with fallocating hole. remove_inode_single_folio will unmap the folio if the folio is still mapped. However, it's called without folio lock. If the folio is migrated and the mapped pte has been converted to migration entry, folio_mapped() returns false, and won't unmap it. Due to extra refcount held by remove_inode_single_folio, migration fails, restores migration entry to normal pte, and the folio is mapped again. As a result, we triggered BUG in filemap_unaccount_folio. The log is as follows:
In the Linux kernel, the following vulnerability has been resolved: net: mscc: ocelot: Fix use-after-free caused by cyclic delayed work The origin code calls cancel_delayed_work() in ocelot_stats_deinit() to cancel the cyclic delayed work item ocelot->stats_work. However, cancel_delayed_work() may fail to cancel the work item if it is already executing. While destroy_workqueue() does wait for all pending work items in the work queue to complete before destroying the work queue, it cannot prevent the delayed work item from being rescheduled within the ocelot_check_stats_work() function. This limitation exists because the delayed work item is
In the Linux kernel, the following vulnerability has been resolved: scsi: mvsas: Fix use-after-free bugs in mvs_work_queue During the detaching of Marvell's SAS/SATA controller, the original code calls cancel_delayed_work() in mvs_free() to cancel the delayed work item mwq->work_q. However, if mwq->work_q is already running, the cancel_delayed_work() may fail to cancel it. This can lead to use-after-free scenarios where mvs_free() frees the mvs_info while mvs_work_queue() is still executing and attempts to access the already-freed mvs_info. A typical race condition is illustrated below: CPU 0 (remove) | CPU 1 (delayed work call
In the Linux kernel, the following vulnerability has been resolved: scsi: target: target_core_configfs: Add length check to avoid buffer overflow A buffer overflow arises from the usage of snprintf to write into the buffer "buf" in target_lu_gp_members_show function located in /drivers/target/target_core_configfs.c. This buffer is allocated with size LU_GROUP_NAME_BUF (256 bytes). snprintf(...) formats multiple strings into buf with the HBA name (hba->hba_group.cg_item), a slash character, a devicename (dev-> dev_group.cg_item) and a newline character, the total formatted string length may exceed the buffer size of 256 bytes. Since snprin
In the Linux kernel, the following vulnerability has been resolved: media: b2c2: Fix use-after-free causing by irq_check_work in flexcop_pci_remove The original code uses cancel_delayed_work() in flexcop_pci_remove(), which does not guarantee that the delayed work item irq_check_work has fully completed if it was already running. This leads to use-after-free scenarios where flexcop_pci_remove() may free the flexcop_device while irq_check_work is still active and attempts to dereference the device. A typical race condition is illustrated below: CPU 0 (remove) | CPU 1 (delayed work callback) flexcop_pci_remove()
In the Linux kernel, the following vulnerability has been resolved: media: i2c: tc358743: Fix use-after-free bugs caused by orphan timer in probe The state->timer is a cyclic timer that schedules work_i2c_poll and delayed_work_enable_hotplug, while rearming itself. Using timer_delete() fails to guarantee the timer isn't still running when destroyed, similarly cancel_delayed_work() cannot ensure delayed_work_enable_hotplug has terminated if already executing. During probe failure after timer initialization, these may continue running as orphans and reference the already-freed tc358743_state object through tc358743_irq_poll_timer. The follow
In the Linux kernel, the following vulnerability has been resolved: media: tuner: xc5000: Fix use-after-free in xc5000_release The original code uses cancel_delayed_work() in xc5000_release(), which does not guarantee that the delayed work item timer_sleep has fully completed if it was already running. This leads to use-after-free scenarios where xc5000_release() may free the xc5000_priv while timer_sleep is still active and attempts to dereference the xc5000_priv. A typical race condition is illustrated below: CPU 0 (release thread) | CPU 1 (delayed work callback) xc5000_release() | xc5000_do_timer_s
In the Linux kernel, the following vulnerability has been resolved: media: rc: fix races with imon_disconnect() Syzbot reports a KASAN issue as below: BUG: KASAN: use-after-free in __create_pipe include/linux/usb.h:1945 [inline] BUG: KASAN: use-after-free in send_packet+0xa2d/0xbc0 drivers/media/rc/imon.c:627 Read of size 4 at addr ffff8880256fb000 by task syz-executor314/4465 CPU: 2 PID: 4465 Comm: syz-executor314 Not tainted 6.0.0-rc1-syzkaller #0 Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.14.0-2 04/01/2014 Call Trace: <TASK> __dump_stack lib/dump_stack.c:88 [inline] dump_stack_lvl+0xcd/0x134 lib/dump_stack.c:106 print_a
In the Linux kernel, the following vulnerability has been resolved: can: hi311x: populate ndo_change_mtu() to prevent buffer overflow Sending an PF_PACKET allows to bypass the CAN framework logic and to directly reach the xmit() function of a CAN driver. The only check which is performed by the PF_PACKET framework is to make sure that skb->len fits the interface's MTU. Unfortunately, because the sun4i_can driver does not populate its net_device_ops->ndo_change_mtu(), it is possible for an attacker to configure an invalid MTU by doing, for example: $ ip link set can0 mtu 9999 After doing so, the attacker could open a PF_PACKET socket us
In the Linux kernel, the following vulnerability has been resolved: can: sun4i_can: populate ndo_change_mtu() to prevent buffer overflow Sending an PF_PACKET allows to bypass the CAN framework logic and to directly reach the xmit() function of a CAN driver. The only check which is performed by the PF_PACKET framework is to make sure that skb->len fits the interface's MTU. Unfortunately, because the sun4i_can driver does not populate its net_device_ops->ndo_change_mtu(), it is possible for an attacker to configure an invalid MTU by doing, for example: $ ip link set can0 mtu 9999 After doing so, the attacker could open a PF_PACKET socket
In the Linux kernel, the following vulnerability has been resolved: can: mcba_usb: populate ndo_change_mtu() to prevent buffer overflow Sending an PF_PACKET allows to bypass the CAN framework logic and to directly reach the xmit() function of a CAN driver. The only check which is performed by the PF_PACKET framework is to make sure that skb->len fits the interface's MTU. Unfortunately, because the mcba_usb driver does not populate its net_device_ops->ndo_change_mtu(), it is possible for an attacker to configure an invalid MTU by doing, for example: $ ip link set can0 mtu 9999 After doing so, the attacker could open a PF_PACKET socket u
In the Linux kernel, the following vulnerability has been resolved: i40e: add validation for ring_len param The `ring_len` parameter provided by the virtual function (VF) is assigned directly to the hardware memory context (HMC) without any validation. To address this, introduce an upper boundary check for both Tx and Rx queue lengths. The maximum number of descriptors supported by the hardware is 8k-32. Additionally, enforce alignment constraints: Tx rings must be a multiple of 8, and Rx rings must be a multiple of 32.
In the Linux kernel, the following vulnerability has been resolved: i40e: fix idx validation in i40e_validate_queue_map Ensure idx is within range of active/initialized TCs when iterating over vf->ch[idx] in i40e_validate_queue_map().
In the Linux kernel, the following vulnerability has been resolved: i40e: fix idx validation in config queues msg Ensure idx is within range of active/initialized TCs when iterating over vf->ch[idx] in i40e_vc_config_queues_msg().
In the Linux kernel, the following vulnerability has been resolved: i40e: fix input validation logic for action_meta Fix condition to check 'greater or equal' to prevent OOB dereference.
Check your installed stack and versions against the current vulnerability feeds.