scsi: libiscsi: Fix stale-data leak into the SCSI sense buffer
In the Linux kernel, the following vulnerability has been resolved:
scsi: libiscsi: Fix stale-data leak into the SCSI sense buffer
iscsi_scsi_cmd_rsp() copies the sense data of a SCSI Response from the
target-supplied data segment. The segment carries a 2-byte sense length
followed by the sense bytes, so it must hold 2 + senselen bytes, but the
bounds check only requires datalen >= senselen:
senselen = get_unaligned_be16(data);
if (datalen < senselen)
goto invalid_datalen;
memcpy(sc->sense_buffer, data + 2,
min_t(uint16_t, senselen, SCSI_SENSE_BUFFERSIZE));
A target that returns a SCSI Response whose datalen equals senselen
scsi: libiscsi_tcp: Bound SCSI Response data segment to the connection buffer
In the Linux kernel, the following vulnerability has been resolved:
scsi: libiscsi_tcp: Bound SCSI Response data segment to the connection buffer
iscsi_tcp_hdr_dissect() receives the data segment of several PDU types
into the fixed-size conn->data buffer, which is allocated for
ISCSI_DEF_MAX_RECV_SEG_LEN (8192) bytes. For the LOGIN_RSP, TEXT_RSP,
REJECT and ASYNC_EVENT opcodes the dissect path already rejects a PDU
whose DataSegmentLength exceeds that buffer.
The SCSI Command Response (ISCSI_OP_SCSI_CMD_RSP) path also copies its
data segment (sense/response data) into conn->data via
iscsi_tcp_data_recv_prep(), but it does so without the s
hwmon: (nct6775-core) Fix number of temperature registers for NCT6116
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (nct6775-core) Fix number of temperature registers for NCT6116
Unlike NCT6106, NCT6116 only has three temperature registers, and with
it only three temperature source and temperature source configuration
registers. The register addresses match those of NCT6106 and can be
re-used.
The code used a separate array to list the temperature source registers
for NCT6116, but used the size of the NCT6106 register array to set
the number of registers. The NCT6106 register array provides six addresses,
while the temperature source register array for NCT6116 only provides three
net: do not send ICMP/NDISC Redirects when peer allocation fails
In the Linux kernel, the following vulnerability has been resolved:
net: do not send ICMP/NDISC Redirects when peer allocation fails
When inet_getpeer_v4() or inet_getpeer_v6() fails to allocate a peer entry
under memory pressure or tree size caps, redirect handlers previously fell
back to sending un-rate-limited ICMP/NDISC Redirect messages.
In IPv4, ip_rt_send_redirect() called icmp_send() directly when peer == NULL.
In IPv6, ip6_forward() and ndisc_send_redirect() passed a NULL peer into
inet_peer_xrlim_allow(), which returned true when peer == NULL.
Because ICMP/NDISC Redirects are not part of the default global rate limit
mask (sysct
hwmon: (nct6775-core) Prevent access to unsupported weight registers
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (nct6775-core) Prevent access to unsupported weight registers
Sashiko reports:
During initialization of the nct6116 chip, the driver sets data->pwm_num
to 5. However, it assigns several NCT6106 register arrays (such as
NCT6106_REG_WEIGHT_DUTY_STEP, NCT6106_REG_WEIGHT_TEMP_SEL, and
NCT6106_REG_WEIGHT_TEMP_*) to data->REG_PWM and data->REG_WEIGHT_TEMP.
These arrays only contain 3 elements.
In nct6775_update_pwm(), the driver iterates up to data->pwm_num. If
data->has_pwm has bits 3 or 4 set (which is structurally possible for
nct6116), the loop attempts to read eleme
In the Linux kernel, the following vulnerability has been resolved:
forcedeth: fix UAF of txrx_stats in nv_remove
nv_remove() frees the per-CPU txrx_stats before unregister_netdev().
Until unregister completes, ndo_get_stats64, the NAPI/xmit data path,
and nv_close()/drain may still access txrx_stats, leading to a
use-after-free.
Free the stats only after unregister_netdev().
hwmon: (adt7470) Fix busy-loop and I2C flooding in update thread
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (adt7470) Fix busy-loop and I2C flooding in update thread
When userspace configures 'auto_update_interval' to 0 via sysfs, the
background kthread executes schedule_timeout_interruptible(0), which
returns immediately.
If 'num_temp_sensors' is concurrently or previously set to 0, the
msleep_interruptible() delay inside adt7470_read_temperatures() also
becomes 0. This combination forces the background thread into a tight,
unbounded busy-loop, hogging the CPU and flooding the I2C bus with a
continuous stream of transactions.
Fix this vulnerability by raising the lower
net/sched: cls_u32: validate offshift to prevent shift-out-of-bounds
In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_u32: validate offshift to prevent shift-out-of-bounds
u32_change() copies the user-provided tc_u32_sel.offshift (unsigned char,
0-255) into the kernel knode object without bounds validation. When a
packet later hits u32_classify() with TC_U32_VAROFFSET set, it evaluates
`ntohs(offmask & *data) >> offshift` where the left operand is a 16-bit
value promoted to a 32-bit int. Any offshift >= 32 is undefined behavior
per C11 6.5.7p3, triggerable by an unprivileged user via user/network
namespaces.
UBSAN: shift-out-of-bounds in net/sched/cls_u32.c:236:43
shift exp
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: fix UAF in l2cap_le_connect_rsp
l2cap_le_connect_rsp() obtains a channel via
__l2cap_get_chan_by_ident() but neither holds a reference nor uses
l2cap_chan_hold_unless_zero() before locking and operating on it.
A concurrent l2cap_chan_del() triggered by a remote disconnect can
free the channel between the lookup and l2cap_chan_lock(), causing
a use-after-free.
The BR/EDR counterpart l2cap_connect_rsp() and the sibling handler
l2cap_le_command_rej() already use l2cap_chan_hold_unless_zero()
to safely hold a reference, but l2cap_le_connect_rsp() was left
unp
octeontx2-af: Block VFs from clobbering special CGX PKIND state
In the Linux kernel, the following vulnerability has been resolved:
octeontx2-af: Block VFs from clobbering special CGX PKIND state
PF and VF NIX LFs that share a CGX LMAC reuse the same hardware PKIND
programming. When HiGig2 or EDSA parsing is enabled, a VF NIX LF alloc must
not reset the LMAC RX PKIND or default TX parse config over the PF setup.
Add cgx_get_pkind() and rvu_cgx_is_pkind_config_permitted() so VFs skip
cgx_set_pkind(), rvu_npc_set_pkind(), and NIX_AF_LFX_TX_PARSE_CFG updates
when the LMAC is using NPC_RX_HIGIG_PKIND or NPC_RX_EDSA_PKIND.
net: sxgbe: free TX rings on RX allocation failure
In the Linux kernel, the following vulnerability has been resolved:
net: sxgbe: free TX rings on RX allocation failure
When RX descriptor ring allocation fails, init_dma_desc_rings() only
frees the partially allocated RX rings and returns. The TX rings that
were allocated earlier in the same function are leaked.
Rearrange error labels to clean up TX rings upon RX failures.
pinctrl: devicetree: don't free uninitialized dev_name on error path
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: devicetree: don't free uninitialized dev_name on error path
dt_remember_or_free_map() duplicates dev_name for each map entry. If
kstrdup_const() fails, dt_free_map() frees dev_name in all num_maps
entries, including entries that have not been initialized.
Some pinctrl drivers, including pinctrl-imx, allocate the map with
kmalloc() and leave dev_name for the core to initialize. The untouched
entries therefore contain uninitialized data which is passed to
kfree_const().
Reproduced on qemu's mcimx6ul-evk (pinctrl-imx) with failslab injection
while binding the pinctr
audit: fix potential use-after-free in audit_del_rule()
In the Linux kernel, the following vulnerability has been resolved:
audit: fix potential use-after-free in audit_del_rule()
`audit_del_rule()` destroys `e->rule.exe` via `audit_remove_mark_rule()`
before unlinking the rule from RCU-visible filter lists and waiting for a
grace period. Concurrent readers in `audit_filter()` and
`audit_filter_rules()` still dereference `e->rule.exe`, while the fsnotify
mark can be freed on an independent lifetime path. This creates a
use-after-free window during rule deletion.
Fix this by unlinking the rule from the RCU-visible lists and invoking
`synchronize_rcu()` before calling `audit_remove_mark_rule()` (
Bluetooth: mgmt: fix UAF in pair command cancellation
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: mgmt: fix UAF in pair command cancellation
The pairing completion and authentication failure callbacks look up the
pending MGMT_OP_PAIR_DEVICE command by walking hdev->mgmt_pending. The
lookup returned a command that was still linked on the shared pending list,
without keeping mgmt_pending_lock held for the later dereference and
removal.
A concurrent MGMT_OP_CANCEL_PAIR_DEVICE request can remove and free the
same pending command before the callback uses it. The reverse race is also
possible when cancel_pair_device() gets a command from pending_find() and a
callb
Bluetooth: HIDP: reject frames without a transaction header
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: reject frames without a transaction header
hidp_recv_ctrl_frame() and hidp_recv_intr_frame() read skb->data[0]
before checking that the L2CAP SDU contains a transaction header. A
connected HIDP peer can send an empty basic-mode SDU and make both paths
use an uninitialized byte from skb tailroom.
KMSAN reports the use in hidp_session_run(), with the uninitialized value
originating in __alloc_skb() through vhci_write(). The control path
produces two reports and the interrupt path produces one.
The byte can also be controlled by a malformed lower-layer packe
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: validate numbered report payloads
When hidp_get_raw_report() waits for a numbered report,
hidp_process_data() compares the expected report number with skb->data[0].
A connected HIDP peer can reply with only a DATA transaction header,
leaving the skb empty after the header is removed.
KMSAN reports an uninitialized-value use in hidp_session_run(), with the
value originating in __alloc_skb() through vhci_write(). The transaction
header checks remove the empty-frame reports, but this report remains until
the payload check is added.
The comparison can also co
ALSA: 6fire: Fix UAF at error handling during probe
In the Linux kernel, the following vulnerability has been resolved:
ALSA: 6fire: Fix UAF at error handling during probe
Although 6fire driver had a few fixes for dealing with the early error
handling during the probe phase, it forgot a pending URB before
freeing the resources, which may lead to a UAF.
This patch addresses it by doing the almost same cleanup procedure
like the normal disconnect phase at the error path.
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
snd_usbmidi_akai_output() computes its fill-loop bound
buf_end = ep->max_transfer - MAX_AKAI_SYSEX_LEN - 1;
as a signed int, so a small device-advertised bulk-OUT max_transfer
makes buf_end negative. The loop guard then compares the u32
urb->transfer_buffer_length against that negative int: the usual
arithmetic conversion turns buf_end into a large unsigned value, so the
guard stays true and each iteration keeps appending SysEx framing and
payload bytes past the end of the URB transfer buffer, which is only
max
ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set
When a USB audio endpoint requests full packet transfers via the fill_max
descriptor flag, data_ep_set_params() promotes ep->curpacksize to
ep->maxpacksize. However, maxsize is left at the original sample-rate
derived value.
Since u->buffer_size is allocated as maxsize * packets, the resulting
DMA buffer is far too small for the requested transfer length. When the
USB host controller streams up to curpacksize bytes per packet, it writes
past the end of the buffer via DMA, corrupting kernel heap memory
ALSA: usb-audio: Clamp frame size in implicit-feedback mode
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Clamp frame size in implicit-feedback mode
snd_usb_handle_sync_urb() scales received sync packet sizes by the sender's
stride and stores the result directly in out_packet->packet_size[i]. If a
connected USB device sends an oversized sync packet, this frame count can
exceed ep->maxframesize.
The un-clamped frame count then propagates to the playback endpoint queue,
potentially driving packet transfers beyond the endpoint's hardware frame
limits.
Cap the calculated frame count against ep->maxframesize in
snd_usb_handle_sync_urb() to prevent oversized packet