vxlan: use pskb_network_may_pull() in route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use pskb_network_may_pull() in route_shortcircuit()
route_shortcircuit() currently calls pskb_may_pull(skb, sizeof(struct iphdr))
(or ipv6hdr), which checks if bytes are available starting from skb->data.
However, in vxlan_xmit(), skb->data points to the MAC header, so
skb_network_offset(skb) is ETH_HLEN (14 bytes). Using pskb_may_pull(skb, 20)
only checks 20 bytes from skb->data (which is 14 bytes MAC header + 6 bytes of
IP header), leaving the rest of the IP header potentially un-pulled in non-linear
frags. Subsequent dereferences of ip_hdr(skb)->daddr can read be
tracing: Check return value of __register_event() in trace_module_add_events()
In the Linux kernel, the following vulnerability has been resolved:
tracing: Check return value of __register_event() in trace_module_add_events()
trace_module_add_events() ignores the return value of __register_event()
and unconditionally calls __add_event_to_tracers() for each event.
If __register_event() fails (for example, if event_init() fails), the
trace_event_call is not added to ftrace_events list, but
__add_event_to_tracers() still creates a trace_event_file pointing to it.
If module loading subsequently fails and module memory is freed, tracing
state retains a stale trace_event_call pointer in trace_event_file,
leading to a use-a
gpio: pch: use raw_spinlock_t for the register lock
In the Linux kernel, the following vulnerability has been resolved:
gpio: pch: use raw_spinlock_t for the register lock
pch_irq_type() is registered as the irq_chip .irq_set_type callback and
takes chip->spinlock with spin_lock_irqsave(). This callback is reached
from __setup_irq() -> __irq_set_trigger() -> chip->irq_set_type() while
the caller holds desc->lock, a raw_spinlock_t, with hardirqs disabled.
That context is not sleepable, but on PREEMPT_RT a regular spinlock_t is
an rtmutex-backed sleeping lock, so acquiring it there is invalid.
This was confirmed on a PREEMPT_RT kernel with lockdep
(PROVE_RAW_LOCK_NESTING and DEBUG_ATOMIC_SLE
net: openvswitch: fix skb leak on flow key update failure during ct
In the Linux kernel, the following vulnerability has been resolved:
net: openvswitch: fix skb leak on flow key update failure during ct
ovs_ct_execute() always steals or frees the skb on failure while
ovs_flow_key_update() does not. So, if it fails and we return right
away, the skb ends up leaked.
Fix that by breaking instead and letting the common error handling
code at the bottom of the loop to free the skb properly.
This is a very unlikely scenario as it requires the packet to become
unparseable by applying a set of actions on a previously parseable skb,
but should be fixed nevertheless.
Reported by Sashiko.
i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
In the Linux kernel, the following vulnerability has been resolved:
i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
Fix a severe AB/BA deadlock between the Common Clock Framework (CCF)
and the I2C adapter lock, which triggers when an I2C-controlled clock
generator client (like the Si5351) is registered or modified under the CCF.
During an i2c client clock (generator) frequency change, the CCF acquires its global
'prepare_lock' mutex and the driver calls i2c_transfer() to update the client's
chip registers, stalling for the adapter's I2C bus lock.
Concurrently, an independent, parallel transfer on the same
In the Linux kernel, the following vulnerability has been resolved:
can: ems_usb: validate CPC message lengths
ems_usb_read_bulk_callback() walks CPC messages packed in one USB
receive buffer.
Check that each declared message fits in the URB payload. Also require the
type-specific payload to cover the fields used by the CAN, state, error and
overrun handlers.
can: kvaser_usb_leaf: kvaser_usb_leaf_wait_cmd(): validate received command extents
In the Linux kernel, the following vulnerability has been resolved:
can: kvaser_usb_leaf: kvaser_usb_leaf_wait_cmd(): validate received command extents
The wait and bulk receive paths walk variable-length commands from a
USB buffer. A nonzero command shorter than CMD_HEADER_LEN can still be
dispatched, and the wait path copies a matching command into a fixed
caller-owned struct kvaser_cmd using the device-provided length.
Reject nonzero commands that do not contain the fixed header or that
extend beyond the current USB buffer item. In the wait path, also reject
a matching command that exceeds the destination before copying it.
can: peak_usb: add bounds check for USB channel index
In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: add bounds check for USB channel index
The channel control index ctrl_idx is derived from rx->len which comes
directly from a device USB payload. The mask 0x0f allows values 0-15, but
the array size of usb_if->dev[] is only 2. Values 2-15 cause heap
out-of-bounds read, eventually causing kernel panic in the IRQ context.
Add bounds checking for ctrl_idx before the array access in both
pcan_usb_pro_handle_canmsg() and pcan_usb_pro_handle_error().
can: peak_usb: peak_usb_start(): fix double free of transfer buffer on URB submit error
In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: peak_usb_start(): fix double free of transfer buffer on URB submit error
In peak_usb_start(), each RX URB transfer buffer is allocated with kmalloc()
and the URB is flagged URB_FREE_BUFFER so that the final usb_free_urb() also
frees the transfer buffer.
If usb_submit_urb() fails, the error path frees the buffer explicitly with
kfree(buf) and then calls usb_free_urb(urb). Because URB_FREE_BUFFER is set,
usb_free_urb() -> urb_destroy() frees the same buffer a second time, a double
free of the transfer buffer.
BUG: KASAN: double-free in usb_free_urb.part.0+0
can: peak_usb: validate uCAN receive record lengths
In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: validate uCAN receive record lengths
pcan_usb_fd_decode_buf() walks uCAN records packed in one USB
receive buffer.
Require each record to contain the fixed header for its type, and verify
CAN payload bytes before copying them into the skb.
drm/vmwgfx: validate DRAW_PRIMITIVES header size before division
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: validate DRAW_PRIMITIVES header size before division
vmw_cmd_draw() computes
maxnum = (header->size - sizeof(cmd->body)) / sizeof(*decl);
where header->size is u32 and is taken straight from the user-supplied
command stream. When header->size is less than sizeof(cmd->body) the
unsigned subtraction wraps to nearly 4 GiB, producing a huge maxnum.
Any user-controlled cmd->body.numVertexDecls then passes the bound and
the loop dereferences decl[i] far past the end of the kernel command
bounce buffer, producing an out-of-bounds read of kernel memory.
Reject unde
drm/vmwgfx: bound DMA command body size against suffix pointer
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: bound DMA command body size against suffix pointer
vmw_cmd_dma() locates the DMA suffix at
(unsigned long) &cmd->body + header->size - sizeof(*suffix)
without checking that header->size is large enough to contain both
cmd->body and the suffix. An undersized header makes the suffix
pointer underflow back into the previous command in the bounce
buffer. The verifier later writes suffix->maximumOffset, clobbering
verified fields of an already-relocated earlier command -- a TOCTOU
on the device-visible command stream that lets one command rewrite
another's GMR i
fbcon: fix NULL pointer dereference for a console without vc_data
In the Linux kernel, the following vulnerability has been resolved:
fbcon: fix NULL pointer dereference for a console without vc_data
fbcon_new_modelist() runs when a framebuffer's modelist changes. For each
console mapped to it with fb_display[i].mode set, it reads vc_cons[i].d and
passes the vc_num to fbcon_set_disp(). This assumes a console with a mode
set has a vc_data, but it can be NULL. fbcon_set_disp() sets
fb_display[i].mode before it checks vc_data, and fbcon_deinit() leaves the
mode set after the vc_data is freed. fbcon_new_modelist() then dereferences
the NULL vc_data.
Keep fb_display[i].mode set only while the console has a vc
drm/radeon: fix integer overflow in radeon_align_pitch()
In the Linux kernel, the following vulnerability has been resolved:
drm/radeon: fix integer overflow in radeon_align_pitch()
radeon_align_pitch() has the same kind of overflow issue as the old
amdgpu helper: both the alignment round-up add and the final
'aligned * cpp' calculation can overflow signed int.
If that wraps, radeon_mode_dumb_create() can end up returning an
invalid pitch or creating a zero-sized dumb buffer.
Fix this by using check_add_overflow() for the alignment round-up and
check_mul_overflow() for the final pitch calculation, returning 0 on
overflow. Also reject zero pitch and size in
radeon_mode_dumb_create().
Found via
drm/radeon: fix memory leak in radeon_ring_restore() on lock failure
In the Linux kernel, the following vulnerability has been resolved:
drm/radeon: fix memory leak in radeon_ring_restore() on lock failure
radeon_ring_restore() takes ownership of the data buffer allocated by
radeon_ring_backup(). The caller (radeon_gpu_reset()) only frees it in
the non-restore branch; in the restore branch it relies on
radeon_ring_restore() to free it.
If radeon_ring_lock() fails, the function returned early without calling
kvfree(data), leaking the ring backup buffer on every GPU reset that
fails at the lock stage. During repeated GPU resets this causes
cumulative kernel memory exhaustion.
Free data before returning the e
wifi: ath9k: fix OOB access from firmware tx status queue ID
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: fix OOB access from firmware tx status queue ID
ath_tx_edma_tasklet() accesses sc->tx.txq[ts.qid] where ts.qid is a
4-bit hardware field (0-15), but the txq array only has
ATH9K_NUM_TX_QUEUES (10) entries. A qid >= 10 causes an OOB array
access.
Add a bounds check on ts.qid before using it as an array index.
ipv6: addrconf: bail out of dad_failure when state is no longer POSTDAD
In the Linux kernel, the following vulnerability has been resolved:
ipv6: addrconf: bail out of dad_failure when state is no longer POSTDAD
addrconf_dad_failure() transitions ifp->state from DAD to POSTDAD
via addrconf_dad_end(), which drops ifp->lock on return. The lock
is re-acquired after net_info_ratelimited(). A concurrent
ipv6_del_addr() can take the lock in that window, set ifp->state
to DEAD and run list_del_rcu(&ifp->if_list).
addrconf_dad_failure() then overwrites DEAD with ERRDAD at errdad:
and schedules a new dad_work. The work calls ipv6_del_addr()
again, hitting the already-poisoned list entry:
general protection fault:
ALSA: seq: oss: Fix UAF at handling events with embedded SysEx data
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: oss: Fix UAF at handling events with embedded SysEx data
The OSS sequencer processes the input MIDI bytes into a sequencer
event to be dispatched later (in snd_seq_oss_midi_putc() called from
snd_seq_oss_process_event()). When it's a SysEx data, the event
record contains data.ext.ptr pointer to the original SysEx bytes, and
the referred data is copied into the pool afterwards at dispatching.
The problem is that, if the sequencer port gets closed concurrently
before the dispatch, the OSS sequencer core also releases the
resources (in snd_seq_oss_midi_check_exit_p
ALSA: seq: midi: Serialize output teardown with event_input
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: midi: Serialize output teardown with event_input
event_process_midi() borrows msynth->output_rfile.output and then
passes the substream to dump_midi() and snd_rawmidi_kernel_write()
without synchronizing with the output open/close transition.
midisynth_use() also publishes output_rfile before
snd_rawmidi_output_params() has finished.
The last midisynth_unuse() can therefore release the same rawmidi file
and free substream->runtime before snd_rawmidi_kernel_write1() takes
its runtime buffer reference. That leaves the event_input path using a
stale substream or ru
configfs_lookup(): don't leave ->s_dentry dangling on failure
In the Linux kernel, the following vulnerability has been resolved:
configfs_lookup(): don't leave ->s_dentry dangling on failure
Normally ->s_dentry is cleared when dentry it's pointing to becomes
negative (on eviction, realistically). However, that only happens
if dentry gets to be positive in the first place; in case of inode
allocation failure dentry never becomes positive, so ->d_iput()
is not called at all.
We do part of what normally would've been done by configfs_d_iput()
(dropping the reference to configfs_dirent) manually, but we do
not clear ->s_dentry there. Sloppy as it is, it does not matter in
case of configfs_create_{dir,