In the Linux kernel, the following vulnerability has been resolved:
ocfs2: reject oversized group bitmap descriptors
ocfs2_validate_gd_parent() only bounds bg_bits against the parent
allocator's chain geometry. A malicious descriptor can still claim a
bg_size/bg_bits pair that exceeds the bitmap bytes that physically fit in
the group descriptor block, so later bitmap scans and bit updates can run
past bg_bitmap.
Add a physical-cap check based on ocfs2_group_bitmap_size() for the parent
allocator type and reject descriptors whose bg_size or bg_bits exceed that
capacity. Keep the existing chain geometry check so both the on-disk
bitmap lay
fbdev: Fix fb_new_modelist to prevent null-ptr-deref in fb_videomode_to_var
In the Linux kernel, the following vulnerability has been resolved:
fbdev: Fix fb_new_modelist to prevent null-ptr-deref in fb_videomode_to_var
info->var, a framebuffer's current mode, is expected to have a matching
entry in info->modelist. var_to_display() relies on this and treats a
failed fb_match_mode() as "This should not happen". fb_set_var() keeps it
true by adding the mode to the list on every change, and
do_register_framebuffer() does the same at registration.
store_modes() replaces the modelist from userspace. fb_new_modelist()
validates the new modes but does not check that info->var still has a
match. It relies on fbcon_new_mod
In the Linux kernel, the following vulnerability has been resolved:
fbdev: omap2: fix use-after-free in omapfb_mmap
omapfb_mmap() has a race condition with OMAPFB_SETUP_PLANE ioctl that
can lead to use-after-free:
The fb_mmap() entry point holds mm_lock but not lock (fb_info->lock),
while ioctl handlers like OMAPFB_SETUP_PLANE hold lock but not mm_lock.
This allows concurrent execution.
In omapfb_mmap():
1. rg = omapfb_get_mem_region(ofbi->region); // Get old region ref
2. start = omapfb_get_region_paddr(ofbi); // Read from NEW region
3. len = fix->smem_len; // Read from NEW region
4. vm_iomap_mem
In the Linux kernel, the following vulnerability has been resolved:
i2c: core: fix adapter registration race
Adapters can be looked up based on their id using i2c_get_adapter()
which takes a reference to the embedded struct device.
Make sure that the adapter (including its struct device) has been
initialised before adding it to the IDR to avoid accessing uninitialised
data which could, for example, lead to NULL-pointer dereferences or
use-after-free.
Note that the i2c-dev chardev, which is registered from a bus notifier,
currently uses i2c_get_adapter() so the adapter needs to be added to the
IDR before registration.
In the Linux kernel, the following vulnerability has been resolved:
nfsd: release layout stid on setlease failure
nfs4_alloc_stid() publishes the new stid into cl->cl_stateids via
idr_alloc_cyclic() under cl_lock before returning to
nfsd4_alloc_layout_stateid(). When nfsd4_layout_setlease() then
fails, the error path frees the layout stateid directly with
kmem_cache_free() without ever calling idr_remove(), leaving the
IDR slot pointing at freed slab memory. Any subsequent IDR walker
(states_show, client teardown) dereferences the dangling pointer.
The correct teardown for an IDR-published stid is nfs4_put_stid(),
which removes the IDR slo
In the Linux kernel, the following vulnerability has been resolved:
nfsd: fix posix_acl leak on SETACL decode failure
nfsaclsvc_decode_setaclargs() and nfs3svc_decode_setaclargs() each
call nfs_stream_decode_acl() twice, first for NFS_ACL and then for
NFS_DFACL. Each successful call transfers ownership of a freshly
allocated posix_acl into argp->acl_access or argp->acl_default. If
the first call succeeds but the second fails, the decoder returns
false and argp->acl_access is left dangling.
ACLPROC2_SETACL.pc_release was wired to nfssvc_release_attrstat and
ACLPROC3_SETACL.pc_release was wired to nfs3svc_release_fhandle.
Both only call fh
NFSv4/flexfiles: reject zero filehandle version count
In the Linux kernel, the following vulnerability has been resolved:
NFSv4/flexfiles: reject zero filehandle version count
ff_layout_alloc_lseg() decodes the filehandle-version array count
from the flexfiles layout body. The value is used as the count for
kzalloc_objs(), and the current code only rejects NULL.
A zero count yields ZERO_SIZE_PTR, which can be stored in
dss_info->fh_versions even though later flexfiles paths assume that at
least one filehandle version exists.
Reject fh_count == 0 before the allocation, matching the existing zero
version_count validation in the flexfiles GETDEVICEINFO parser.
A QEMU/KASAN run with a malformed
NFSv4/pNFS: reject zero-length r_addr in nfs4_decode_mp_ds_addr
In the Linux kernel, the following vulnerability has been resolved:
NFSv4/pNFS: reject zero-length r_addr in nfs4_decode_mp_ds_addr
nfs4_decode_mp_ds_addr() decodes the r_netid and r_addr opaques of a
netaddr4 from a GETDEVICEINFO multipath-DS body, then immediately
calls strrchr(buf, '.') to locate the port separator. Both decodes
use xdr_stream_decode_string_dup(), and the current code checks only
"nlen < 0" / "rlen < 0" before dereferencing the returned string.
When the on-wire opaque has length zero, xdr_stream_decode_opaque_inline()
returns 0 and xdr_stream_decode_string_dup() falls through to its
"*str = NULL; return ret" tail, leavi
fuse: re-lock request before replacing page cache folio
In the Linux kernel, the following vulnerability has been resolved:
fuse: re-lock request before replacing page cache folio
fuse_try_move_folio() unlocks the request on entry but does not
re-lock it on the success path. This means fuse_chan_abort() can end the
request and free the fuse_io_args (eg fuse_readpages_end()) while the
subsequent copy chain logic after fuse_try_move_folio() accesses the
fuse_io_args, leading to use-after-free issues.
Fix this by calling lock_request() before replace_page_cache_folio().
This ensures the request is locked on the success path which will
prevent the fuse_io_args from being freed while the later copyi
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vce: Prevent partial address patches
In the case that only one of lo/hi is valid, the patching could result
in a bad address written to in FW.
drm/amdgpu: zero-initialize GART table on allocation
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: zero-initialize GART table on allocation
GART TLB is flushed after unmapping but not after mapping. Since
amdgpu_bo_create_kernel() does not zero-initialize the buffer, when a
single PTE is written the TLB may speculatively load other uninitialized
entries from the same cacheline. Those garbage entries can appear valid,
and a subsequent write to another PTE in the same cacheline may cause the
GPU to use a stale garbage PTE from the TLB.
Fix this by calling memset_io() to zero-initialize the GART table with
gart_pte_flags immediately after allocation.
Using AMD
In the Linux kernel, the following vulnerability has been resolved:
udf: reject descriptors with oversized CRC length
udf_read_tagged() skips CRC verification when descCRCLength +
sizeof(struct tag) exceeds the block size. A crafted UDF image can
set descCRCLength to an oversized value to bypass CRC validation
entirely; the descriptor is then accepted based solely on the 8-bit
tag checksum, which is trivially recomputable.
Reject such descriptors instead of silently accepting them. A
legitimate single-block descriptor should never have a CRC length that
exceeds the block.
f2fs: fix fsck inconsistency caused by incorrect nat_entry flag usage
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix fsck inconsistency caused by incorrect nat_entry flag usage
f2fs_need_dentry_mark() reads nat_entry flags without mutual exclusion
with the checkpoint path, which can result in an incorrect inode block
marking state. The scenario is as follows:
create & write & fsync 'file A' write checkpoint
- f2fs_do_sync_file // inline inode
- f2fs_write_inode // inode folio is dirty
- f2fs_write_checkpoint
- f2fs_flush_merged_writes
High · CVSS 8.8EPSS 1.37%Public exploitNo fix published
KVM: x86: Fix shadow paging use-after-free due to unexpected role
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Fix shadow paging use-after-free due to unexpected role
Commit 0cb2af2ea66ad ("KVM: x86: Fix shadow paging use-after-free due
to unexpected GFN") fixed a shadow paging mismatch between stored and
computed GFNs; the bug could be triggered by changing a PDE mapping from
outside the guest, and then deleting a memslot. The rmap_remove()
call would miss entries created after the PDE change because the GFN
of the leaf SPTE does not match the GFN of the struct kvm_mmu_page.
A similar hole however remains if the modified PDE points to a non-leaf
page. In this case the
Bluetooth: L2CAP: use chan timer to close channels in cleanup_listen()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: use chan timer to close channels in cleanup_listen()
l2cap_chan_close() removes the channel from conn->chan_l, which
must be done under conn->lock. cleanup_listen() runs under the
parent sk_lock, so acquiring conn->lock would invert the
established conn->lock -> chan->lock -> sk_lock order.
Instead of calling l2cap_chan_close() directly, schedule
l2cap_chan_timeout with delay 0 to close the channel
asynchronously. The timeout handler already acquires conn->lock
and chan->lock in the correct order.
The timer is only armed when chan->conn is still set: i
In the Linux kernel, the following vulnerability has been resolved:
net: rds: clear i_sends on setup unwind
The RDS IB connection teardown path is written so it can run during
partial startup and on repeated shutdown attempts. It uses NULL
pointers to distinguish resources that are still owned from resources
that have already been released.
When rds_ib_setup_qp() fails after allocating i_sends but before
allocating i_recvs, the sends_out path frees i_sends without clearing
the pointer. A later shutdown pass can still treat that stale pointer
as a live send ring allocation.
Clear i_sends after vfree() in the error unwind path so the existi
arm64: errata: Mitigate TLBI errata on various Arm CPUs
In the Linux kernel, the following vulnerability has been resolved:
arm64: errata: Mitigate TLBI errata on various Arm CPUs
A number of CPUs developed by Arm suffer from errata whereby a broadcast
TLBI;DSB sequence may complete before the global observation of writes
which are translated by an affected TLB entry.
These errata ONLY affect the completion of memory accesses which have
been translated by an invalidated TLB entry, and these errata DO NOT
affect the actual invalidation of TLB entries. TLB entries are removed
correctly.
This issue has been assigned CVE ID CVE-2025-10263.
To mitigate this issue, Arm recommends that software foll
In the Linux kernel, the following vulnerability has been resolved:
hsr: Remove WARN_ONCE() in hsr_addr_is_self().
syzbot reported the warning [0] in hsr_addr_is_self(),
whose assumption is simply wrong.
hsr->self_node is cleared in hsr_del_self_node(), which
is called from hsr_dellink().
Since dev->rtnl_link_ops->dellink() is called before
unregister_netdevice_many(), there is a window when
user can find the device but without hsr->self_node.
Let's remove WARN_ONCE() in hsr_addr_is_self().
[0]:
HSR: No self node
WARNING: net/hsr/hsr_framereg.c:39 at hsr_addr_is_self+0x211/0x3f0 net/hsr/hsr_framereg.c:39, CPU#0: syz.4.16848/17220
Module
signal: clear JOBCTL_PENDING_MASK for caller in zap_other_threads()
In the Linux kernel, the following vulnerability has been resolved:
signal: clear JOBCTL_PENDING_MASK for caller in zap_other_threads()
When a multi-threaded process receives a stop signal (e.g., SIGSTOP),
do_signal_stop() sets JOBCTL_STOP_PENDING and JOBCTL_STOP_CONSUME on all
threads and sets signal->group_stop_count to the number of threads. If
one of the threads concurrently calls execve(), de_thread() invokes
zap_other_threads() to kill all other threads. zap_other_threads()
aborts the pending group stop by resetting signal->group_stop_count to 0
and clears the JOBCTL_PENDING_MASK for all other threads. However, it
fails to clear the j
netfilter: nf_conntrack: destroy stale expectfn expectations on unregister
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack: destroy stale expectfn expectations on unregister
NAT helpers such as nf_nat_h323 store a raw pointer to module text in
exp->expectfn (e.g. ip_nat_q931_expect). nf_ct_helper_expectfn_unregister()
only unlinks the callback descriptor and never walks the expectation table,
so an expectation pending at module removal survives with a dangling
exp->expectfn into freed module text.
When the expected connection arrives, init_conntrack() invokes
exp->expectfn(), now a stale pointer into the unloaded module. Reproduced
on a KASAN build by loading the H.323