In the Linux kernel, the following vulnerability has been resolved:
net: usb: catc: enable basic endpoint checking
catc_probe() fills three URBs with hardcoded endpoint pipes without
verifying the endpoint descriptors:
- usb_sndbulkpipe(usbdev, 1) and usb_rcvbulkpipe(usbdev, 1) for TX/RX
- usb_rcvintpipe(usbdev, 2) for interrupt status
A malformed USB device can present these endpoints with transfer types
that differ from what the driver assumes.
Add a catc_usb_ep enum for endpoint numbers, replacing magic constants
throughout. Add usb_check_bulk_endpoints() and usb_check_int_endpoints()
calls after usb_set_interface() to verify endp
ext4: fix dirtyclusters double decrement on fs shutdown
In the Linux kernel, the following vulnerability has been resolved:
ext4: fix dirtyclusters double decrement on fs shutdown
fstests test generic/388 occasionally reproduces a warning in
ext4_put_super() associated with the dirty clusters count:
WARNING: CPU: 7 PID: 76064 at fs/ext4/super.c:1324 ext4_put_super+0x48c/0x590 [ext4]
Tracing the failure shows that the warning fires due to an
s_dirtyclusters_counter value of -1. IOW, this appears to be a
spurious decrement as opposed to some sort of leak. Further tracing
of the dirty cluster count deltas and an LLM scan of the resulting
output identified the cause as a double decrement in the
sched/rt: Skip currently executing CPU in rto_next_cpu()
In the Linux kernel, the following vulnerability has been resolved:
sched/rt: Skip currently executing CPU in rto_next_cpu()
CPU0 becomes overloaded when hosting a CPU-bound RT task, a non-CPU-bound
RT task, and a CFS task stuck in kernel space. When other CPUs switch from
RT to non-RT tasks, RT load balancing (LB) is triggered; with
HAVE_RT_PUSH_IPI enabled, they send IPIs to CPU0 to drive the execution
of rto_push_irq_work_func. During push_rt_task on CPU0,
if next_task->prio < rq->donor->prio, resched_curr() sets NEED_RESCHED
and after the push operation completes, CPU0 calls rto_next_cpu().
Since only CPU0 is overloaded in this scenario
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not keep dest_dst if dev is going down
There is race between the netdev notifier ip_vs_dst_event()
and the code that caches dst with dev that is going down.
As the FIB can be notified for the closed device after our
handler finishes, it is possible valid route to be returned
and cached resuling in a leaked dev reference until the dest
is not removed.
To prevent new dest_dst to be attached to dest just after the
handler dropped the old one, add a netif_running() check
to make sure the notifier handler is not currently running
for device that is closing.
power: supply: sbs-battery: Fix use-after-free in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: sbs-battery: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handle
In the Linux kernel, the following vulnerability has been resolved:
fat: avoid parent link count underflow in rmdir
Corrupted FAT images can leave a directory inode with an incorrect
i_nlink (e.g. 2 even though subdirectories exist). rmdir then
unconditionally calls drop_nlink(dir) and can drive i_nlink to 0,
triggering the WARN_ON in drop_nlink().
Add a sanity check in vfat_rmdir() and msdos_rmdir(): only drop the
parent link count when it is at least 3, otherwise report a filesystem
error.
In the Linux kernel, the following vulnerability has been resolved:
ext4: don't cache extent during splitting extent
Caching extents during the splitting process is risky, as it may result
in stale extents remaining in the status tree. Moreover, in most cases,
the corresponding extent block entries are likely already cached before
the split happens, making caching here not particularly useful.
Assume we have an unwritten extent, and then DIO writes the first half.
[UUUUUUUUUUUUUUUU] on-disk extent U: unwritten extent
[UUUUUUUUUUUUUUUU] extent status tree
|<- ->| ----> dio write this range
First, when ext4_split_extent_at()
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
In the Linux kernel, the following vulnerability has been resolved:
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
icmp_route_lookup() performs multiple route lookups to find a suitable
route for sending ICMP error messages, with special handling for XFRM
(IPsec) policies.
The lookup sequence is:
1. First, lookup output route for ICMP reply (dst = original src)
2. Pass through xfrm_lookup() for policy check
3. If blocked (-EPERM) or dst is not local, enter "reverse path"
4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec
which reverses the original packet's flow (saddr<->daddr swapped)
5. If fl4_dec.saddr
ext4: drop extent cache when splitting extent fails
In the Linux kernel, the following vulnerability has been resolved:
ext4: drop extent cache when splitting extent fails
When the split extent fails, we might leave some extents still being
processed and return an error directly, which will result in stale
extent entries remaining in the extent status tree. So drop all of the
remaining potentially stale extents if the splitting fails.
apparmor: Fix & Optimize table creation from possibly unaligned memory
In the Linux kernel, the following vulnerability has been resolved:
apparmor: Fix & Optimize table creation from possibly unaligned memory
Source blob may come from userspace and might be unaligned.
Try to optize the copying process by avoiding unaligned memory accesses.
- Added Fixes tag
- Added "Fix &" to description as this doesn't just optimize but fixes
a potential unaligned memory access
[jj: remove duplicate word "convert" in comment trigger checkpatch warning]
xen-netback: reject zero-queue configuration from guest
In the Linux kernel, the following vulnerability has been resolved:
xen-netback: reject zero-queue configuration from guest
A malicious or buggy Xen guest can write "0" to the xenbus key
"multi-queue-num-queues". The connect() function in the backend only
validates the upper bound (requested_num_queues > xenvif_max_queues)
but not zero, allowing requested_num_queues=0 to reach
vzalloc(array_size(0, sizeof(struct xenvif_queue))), which triggers
WARN_ON_ONCE(!size) in __vmalloc_node_range().
On systems with panic_on_warn=1, this allows a guest-to-host denial
of service.
The Xen network interface specification requires
the queue count to be
power: supply: cpcap-battery: Fix use-after-free in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: cpcap-battery: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ hand
iio: sca3000: Fix a resource leak in sca3000_probe()
In the Linux kernel, the following vulnerability has been resolved:
iio: sca3000: Fix a resource leak in sca3000_probe()
spi->irq from request_threaded_irq() not released when
iio_device_register() fails. Add an return value check and jump to a
common error handler when iio_device_register() fails.
HID: intel-ish-hid: fix NULL-ptr-deref in ishtp_bus_remove_all_clients
In the Linux kernel, the following vulnerability has been resolved:
HID: intel-ish-hid: fix NULL-ptr-deref in ishtp_bus_remove_all_clients
During a warm reset flow, the cl->device pointer may be NULL if the
reset occurs while clients are still being enumerated. Accessing
cl->device->reference_count without a NULL check leads to a kernel panic.
This issue was identified during multi-unit warm reboot stress clycles.
Add a defensive NULL check for cl->device to ensure stability under
such intensive testing conditions.
KASAN: null-ptr-deref in range [0000000000000000-0000000000000007]
Workqueue: ish_fw_update_wq fw_reset_work_fn
Call Trace:
mfd: arizona: Fix regulator resource leak on wm5102_clear_write_sequencer() failure
In the Linux kernel, the following vulnerability has been resolved:
mfd: arizona: Fix regulator resource leak on wm5102_clear_write_sequencer() failure
The wm5102_clear_write_sequencer() helper may return an error
and just return, bypassing the cleanup sequence and causing
regulators to remain enabled, leading to a resource leak.
Change the direct return to jump to the err_reset label to
properly free the resources.
tpm: st33zp24: Fix missing cleanup on get_burstcount() error
In the Linux kernel, the following vulnerability has been resolved:
tpm: st33zp24: Fix missing cleanup on get_burstcount() error
get_burstcount() can return -EBUSY on timeout. When this happens,
st33zp24_send() returns directly without releasing the locality
acquired earlier.
Use goto out_err to ensure proper cleanup when get_burstcount() fails.
SUNRPC: auth_gss: fix memory leaks in XDR decoding error paths
In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: auth_gss: fix memory leaks in XDR decoding error paths
The gssx_dec_ctx(), gssx_dec_status(), and gssx_dec_name()
functions allocate memory via gssx_dec_buffer(), which calls
kmemdup(). When a subsequent decode operation fails, these
functions return immediately without freeing previously
allocated buffers, causing memory leaks.
The leak in gssx_dec_ctx() is particularly relevant because
the caller (gssp_accept_sec_context_upcall) initializes several
buffer length fields to non-zero values, resulting in memory
allocation:
struct gssx_ctx rctxh = {
.exp
power: supply: wm97xx: Fix NULL pointer dereference in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: wm97xx: Fix NULL pointer dereference in power_supply_changed()
In `probe()`, `request_irq()` is called before allocating/registering a
`power_supply` handle. If an interrupt is fired between the call to
`request_irq()` and `power_supply_register()`, the `power_supply` handle
will be used uninitialized in `power_supply_changed()` in
`wm97xx_bat_update()` (triggered from the interrupt handler). This will
lead to a `NULL` pointer dereference since
Fix this racy `NULL` pointer dereference by making sure the IRQ is
requested _after_ the registration of the `power
pinctrl: single: fix refcount leak in pcs_add_gpio_func()
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: single: fix refcount leak in pcs_add_gpio_func()
of_parse_phandle_with_args() returns a device_node pointer with refcount
incremented in gpiospec.np. The loop iterates through all phandles but
never releases the reference, causing a refcount leak on each iteration.
Add of_node_put() calls to release the reference after extracting the
needed arguments and on the error path when devm_kzalloc() fails.
This bug was detected by our static analysis tool and verified by my
code review.
power: supply: act8945a: Fix use-after-free in power_supply_changed()
In the Linux kernel, the following vulnerability has been resolved:
power: supply: act8945a: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler h