In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use proper context for logging
The same as the rest of the code, get_ss_info_from_atombios() uses
calc_pll_cs->ctx->logger for logging. But calc_pll_cs->ctx is
initialized only later in calc_pll_max_vco_construct(). Therefore, any
output using DC_LOG_SYNC() leads to a NULL pointer deference in
get_ss_info_from_atombios().
According to Sashiko, the very same problem exists in
dce112_get_pix_clk_dividers() and dcn3_get_pix_clk_dividers() too.
To avoid accessing the NULL context, use clk_src->base.ctx->logger
everywhere. That context in base is initialized e
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (sht3x) Fix unaligned accesses
Sashiko reports:
In sht3x_update_client(), the 16-bit temperature and humidity values are
extracted from a stack-allocated byte array using be16_to_cpup(). The
pointers passed to this function are calculated as buf and buf + 3. Since
the difference between the two pointers is an odd number of bytes, at
least one of them is guaranteed to be at an unaligned offset.
This will trigger an alignment fault on strict-alignment architectures
such as ARMv5 or SPARC, resulting in a kernel panic.
Fix the problem by using get_unaligned_be16() ins
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
mtk_handle_irq_rx expects a struct mtk_eth * (matching the request_irq
cookie), but mtk_poll_controller incorrectly passed the net_device *.
Calling ndo_poll_controller with CONFIG_NET_POLL_CONTROLLER enabled
would then crash.
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
In the Linux kernel, the following vulnerability has been resolved:
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
mmio_trace_rw() and mmio_trace_mapping() retrieve mmio_trace_array into
tr and pass it to __trace_mmiotrace_rw() and __trace_mmiotrace_map().
If these functions are invoked while mmio_trace_array is NULL (e.g. before
initialization or after disabled), accessing tr->array_buffer.buffer will
result in a NULL pointer dereference crash.
Fix this by adding an explicit NULL check for tr at the beginning of
__trace_mmiotrace_rw() and __trace_mmiotrace_map().
vxlan: re-fetch eth header after route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: re-fetch eth header after route_shortcircuit()
Before route_shortcircuit(), the eth header pointer is cached from eth_hdr(skb).
Inside route_shortcircuit(), pskb_may_pull() can be called, which may
reallocate skb->head.
In this case, returning to vxlan_xmit() leaves the cached eth pointer pointing to
freed memory, leading to a use-after-free when dereferencing eth->h_dest.
Fix this by updating eth = eth_hdr(skb) after calling route_shortcircuit().
i2c: amd-mp2: Unregister callback on adapter add failure
In the Linux kernel, the following vulnerability has been resolved:
i2c: amd-mp2: Unregister callback on adapter add failure
amd_mp2_register_cb() stores the platform I2C context in the MP2 PCI
driver's callback table before the adapter is registered. If
i2c_add_adapter() fails, probe returns and devres frees the context,
but the PCI driver can still dereference the stale pointer from its IRQ
and system-sleep callbacks.
Unregister the callback before returning the adapter registration error.
In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Fix potential NULL pointer dereference
dasd_release_space() checks the implementation of the is_ese()
discipline function before calling it to determine if a given device is
an ESE DASD.
The current usage of the logical AND operator will lead to a NULL
pointer dereference as the function is called even if the function
pointer is NULL.
Fix this by using the logical OR operator.
Drivers: hv: vmbus: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
Drivers: hv: vmbus: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
perf sched: Fix register_pid() overflow, strcpy, and BUG_ON
In the Linux kernel, the following vulnerability has been resolved:
perf sched: Fix register_pid() overflow, strcpy, and BUG_ON
register_pid() has several issues when processing untrusted perf.data:
1. Integer overflow: (pid + 1) * sizeof(struct task_desc *) can wrap
to a small value on 32-bit systems when pid is large (e.g.
0x40000000), causing realloc to return a tiny buffer followed by
out-of-bounds writes in the initialization loop.
2. Heap buffer overflow: strcpy(task->comm, comm) copies the
untrusted comm string into a fixed 20-byte COMM_LEN buffer with
no length check.
3. BUG_ON on allocation failure: perf.data is u
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
In the Linux kernel, the following vulnerability has been resolved:
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
machine__resolve() accesses env->cpu[al->cpu].socket_id after checking
al->cpu >= 0 and env->cpu != NULL, but without validating al->cpu
against env->nr_cpus_avail. Since al->cpu comes from the untrusted
perf.data sample, a crafted file with a large CPU index causes an
out-of-bounds heap read.
Use perf_env__get_cpu_topology() which validates both NULL and bounds.
Also bounds-check al->cpu before the cast to struct perf_cpu (int16_t):
without this, values like 65536 silently truncate to 0, bypassing the
acc
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_nat: reject unsupported target families
xt_nat SNAT and DNAT target handlers assume IP-family conntrack state
is present and can dereference a NULL pointer when instantiated from an
unsupported family through nft_compat. A bridge-family compat rule can
therefore trigger a NULL-dereference in nf_nat_setup_info().
Reject non-IP families in xt_nat_checkentry() so unsupported targets
cannot be installed. Keep NFPROTO_INET allowed for valid inet NAT
compat users and leave the runtime fast path unchanged.
[ The crash was fixed via
9dbba7e694ec ("netfilter: nft_c
mmc: vub300: defer reset until cmd_mutex is unlocked
In the Linux kernel, the following vulnerability has been resolved:
mmc: vub300: defer reset until cmd_mutex is unlocked
vub300_cmndwork_thread() holds cmd_mutex while it sends a command and
waits for the command response. If the response wait times out,
__vub300_command_response() kills the command URBs and then synchronously
resets the USB device through usb_reset_device().
That reset path re-enters the driver through vub300_pre_reset(), which
also takes cmd_mutex. The worker therefore tries to acquire the same
mutex recursively while it is still holding it from the command path.
This issue was found by our static analysis tool and th
crypto: ccp - Treat zero-length cert chain as query for blob lengths
In the Linux kernel, the following vulnerability has been resolved:
crypto: ccp - Treat zero-length cert chain as query for blob lengths
When handling a PDH export, treat a zero-length userspace cert chain buffer
as a request to query the length of the relevant blobs. Failure to account
for the zero-length buffer trips a BUG_ON() when running with
CONFIG_DEBUG_VIRTUAL=y due to trying to get the physical address of the
ZERO_SIZE_PTR (returned by kzalloc() on the bogus allocation).
kernel BUG at arch/x86/mm/physaddr.c:28 !
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
CPU: 30 UID: 0 PID: 28580 Comm: syz.2.18 Kdump: loaded
Tainted
In the Linux kernel, the following vulnerability has been resolved:
media: atomisp: gc2235: fix UAF and memory leak
gc2235_probe() handles its error paths incorrectly.
If media_entity_pads_init() fails, gc2235_remove() is called, which
tears down the subdev and frees dev, but then still falls through to
atomisp_register_i2c_module(). This results in use-after-free.
If atomisp_register_i2c_module() fails, the media entity and control
handler are left initialized and dev is leaked.
gc2235_remove() unconditionally calls media_entity_cleanup() and
v4l2_ctrl_handler_free(), but these are not initialized at every
error path in gc2235_probe().
firmware: arm_scmi: Fix OOB in scmi_power_name_get()
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Fix OOB in scmi_power_name_get()
scmi_power_name_get() does not validate the domain number passed by the
external caller, which may lead to an out-of-bounds access.
Fix this by returning "unknown" for invalid domains, like
scmi_reset_name_get() does.
In the Linux kernel, the following vulnerability has been resolved:
RDMA/hns: Fix warning in poll cq direct mode
CQs allocated by ib_alloc_cq() always have a comp_handler. Though
in direct mode this handler is never expected to be called, it
is still called when the driver is reset, triggering the following
WARN_ONCE():
Call trace:
ib_cq_completion_direct+0x38/0x60
hns_roce_cq_completion+0x54/0x90 (hns_roce_hw_v2]
hns_roce_handle_device_err+Ox1c8/0x340 [hns_roce_hw_v2]
hns_roce_hw_v2_uninit_instance.constprop.0+0x34/0x70 [hns_roce_hw_v2]
hns_roce_hw_v2_reset_notify+0xc4/0xe0 [hns_roce_hw_v2]
hclge_notify_roce_client+0x60/0xbc [hclge]
hclge
ipv6: guard against possible NULL deref in __in6_dev_stats_get()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: guard against possible NULL deref in __in6_dev_stats_get()
dev_get_by_index_rcu() could return NULL if the original physical
device is unregistered.
Found by Sashiko.
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
In the Linux kernel, the following vulnerability has been resolved:
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
With a list_for_each() loop, if we don't find the item we are looking for
in the list, then the loop exits with the iterator, which is "dbell" in
this loop, pointing to invalid memory.
This code uses the "found" variable to determine if we have found the
doorbell we are looking for or not. However, the problem that the "found"
variable needs to be set to false at the start of each iteration,
otherwise after the first correct doorbell, then everything is marked as
found.
Reset the "found" to false at the start o
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: don't BUG_ON an invalid journal dinode
[BUG]
A fuzzed OCFS2 image can corrupt the current slot journal dinode while
mount is still in progress. The mount path first reports the invalid
journal block and then crashes in shutdown:
kernel BUG at fs/ocfs2/journal.c:1034!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_journal_toggle_dirty+0x2d6/0x340 fs/ocfs2/journal.c:1034
Call Trace:
ocfs2_journal_shutdown+0x414/0xc30 fs/ocfs2/journal.c:1116
ocfs2_mount_volume fs/ocfs2/super.c:1785 [inline]
ocfs2_fill_super+0x30a9/0x3cd0 fs/ocfs2/super.c:1083
get_t
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
In the Linux kernel, the following vulnerability has been resolved:
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
Use get_unaligned_be32() and put_unaligned_be32() to safely read and
write the timestamp fields. This prevents performance degradation due to
unaligned memory access or even a crash on strict alignment
architectures.
This follows the implementation of timestamp parsing in the networking
stack at tcp_parse_options() and synproxy_parse_options().