wifi: mac80211: fix slab-out-of-bounds read in ieee80211_monitor_select_queue()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix slab-out-of-bounds read in ieee80211_monitor_select_queue()
ieee80211_monitor_select_queue() validates the skb length using skb->len
before dereferencing pointers into skb->data to access the 802.11 header.
However, skb->len includes data in both the linear head buffer and
non-linear fragments/pages. When AF_PACKET sends a packet large enough to
become non-linear, the 802.11 header at skb->data + len_rthdr may extend
past the linear head buffer even though skb->len appears sufficient.
This leads to a slab-out-of-bounds read when accessing hdr->frame_con
net: systemport: Fix buffer overflow in bcm_sysport_get_stats()
In the Linux kernel, the following vulnerability has been resolved:
net: systemport: Fix buffer overflow in bcm_sysport_get_stats()
When running on SYSTEMPORT Lite, certain statistics are unsupported and
skipped during bcm_sysport_get_stats(). The variable 'j' tracks the
compacted index into the destination data buffer, whereas 'i' iterates
over all elements in bcm_sysport_gstrings_stats.
Because the buffer allocated by ethtool is sized only according to
bcm_sysport_get_sset_count(), storing values at data[i] instead of
data[j] writes past the allocated array bounds, leading to memory
corruption.
Fix this by writing to data[j] instead of
In the Linux kernel, the following vulnerability has been resolved:
tipc: prevent GCM nonce reuse on peer key changes
TIPC can encrypt traffic between nodes using a different transmit key
for each node. In this mode, the AES-GCM nonce for a packet sent to a
known peer consists of a 32-bit prefix (a per-key salt XOR the peer's
address) followed by a 64-bit counter. That counter is stored in the
peer's RX crypto object. When the peer reports a change in which key
it uses to receive packets, TIPC resets this counter. The sender can
still be using the same TX key and salt, so subsequent packets reuse
earlier nonces. This nonce reuse breaks conf
In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: fix rx Scatter-Gather support
When a received frame is larger than dma_buf_sz, the DMA scatters it
across multiple RX descriptors (rx Scatter-Gather). The secondary RX
buffer (sec_page) was only allocated and programmed when split-header
(SPH) was active, so for regular frames buffer2 was neither allocated
nor backed by a valid mapping. As soon as an incoming frame overflowed
buffer1, the DMA wrote the overflow into the unmapped secondary-buffer
address, triggering an SMMU translation fault on IOMMU-based platforms:
arm-smmu 15000000.iommu: Unhandled context f
seg6: ensure packet data is writable before modifying SRH and IPv6 DA
In the Linux kernel, the following vulnerability has been resolved:
seg6: ensure packet data is writable before modifying SRH and IPv6 DA
advance_nextseg() modifies the SRH Segments Left field and the IPv6
destination address without ensuring the packet data is writable.
seg6_next_csid_advance_arg() has the same problem when it advances the
NEXT-C-SID argument in the destination address.
The skb may be cloned, for example by an AF_PACKET socket receiving on
the ingress device. advance_nextseg() and seg6_next_csid_advance_arg()
then write into the packet data shared with the clone. A read from that
socket can return the modified packet inst
bpf: Wait for an RCU tasks grace period before freeing trampoline progs
In the Linux kernel, the following vulnerability has been resolved:
bpf: Wait for an RCU tasks grace period before freeing trampoline progs
When a prog is detached from a trampoline, it is freed after an RCU
grace period, or an RCU tasks trace one if it is sleepable. This covers
the tasks that are running the prog, since the prog's enter helper takes
the matching read lock before the prog is called. On a preemptible
kernel, it doesn't cover a task that was preempted in the trampoline
just before the enter helper. That task holds no lock yet, and it calls
the prog after it was freed:
BUG: KASAN: vmalloc-out-of-bounds in __bpf_prog_enter_r
bpf: Skip detached progs in trampoline images that are still in use
In the Linux kernel, the following vulnerability has been resolved:
bpf: Skip detached progs in trampoline images that are still in use
bpf_tramp_image_put() makes sure a trampoline image is not freed while
a task may still be running in it, but nothing similar is done for the
progs called by that image. Detach drops the last prog reference right
away and the prog is freed after grace periods, on the basis that a
task still in the traced function skips the fexit progs once the nop at
ip_after_call is patched to a jump.
That leaves out a task sleeping in a sleepable prog that runs before
the detached one, which no grace period waits for:
net: bcmgenet: fix NULL dereference in set_coalesce before first open
In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: fix NULL dereference in set_coalesce before first open
The Rx ring priv and index are only set in bcmgenet_init_rx_ring(),
which runs at open. Setting the Rx coalescing parameters on an interface
that was never opened, e.g. "ethtool -C eth0 rx-usecs 50", dereferences
a NULL ring->priv. The oops happens with RTNL held, so networking
stays stuck until a reboot:
Unable to handle kernel paging request at virtual address 0000000000002788
pc : bcmgenet_set_rx_coalesce.isra.0+0x10/0x88
lr : bcmgenet_set_coalesce+0xe8/0x180
Call trace:
bcmgenet_set_rx_coa
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: allocate dummy netdev sooner
The RX rings and the shared NAPI are carried by an internal "dummy" netdev
(eth->dummy_dev). mtk_probe() creates that dummy device, and adds the
shared tx/rx NAPI to it, only after the MAC netdevs have been registered.
That order has been there since the MT7623 support was added and leaves a
window in which the netdevs are visible to the network core before the
shared NAPI and the dummy device exist.
If anything brings the first netdev up during that window (e.g. netifd
opening the WAN link the instant the interface
ipvs: filter some flags received in the backup server
In the Linux kernel, the following vulnerability has been resolved:
ipvs: filter some flags received in the backup server
While the IPVS SYNC protocol is not secure by design
we can still protect the backup server from messages that
can wreak havoc.
This commit addresses problems from received connection flags
or their combinations. We now drop messages as follows:
1. the NO_CPORT+TEMPLATE combination allows lookups for normal
connections to hit template which can break in many ways.
While the master does not sync connections with NO_CPORT flag,
i.e. before they are established, we still accept NO_CPORT
without TEMPLATE.
2. ONE_PACKET: i
netfilter: flowtable: generalize pending status bit
In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: generalize pending status bit
Rename NF_FLOW_HW_PENDING to NF_FLOW_PENDING and use it to inhibit the
flowtable GC worker until pending hw offload work has been completed.
Apparently, nf_flow_offload_stats() can schedule work to retrieve stats
while the flow is being removed by GC.
And this bit can also be used in a follow up patch to disable GC until
the flow has been fully added in both directions.
Revert the reordering done in commit d644b23afe1e ("netfilter:
flowtable: publish HW_DEAD after worker is done") to prevent a race
between GC and hw off
perf: Fix race between perf_event_exit_task() and perf_pending_task()
In the Linux kernel, the following vulnerability has been resolved:
perf: Fix race between perf_event_exit_task() and perf_pending_task()
A race condition exists between perf_event_exit_task() and
perf_pending_task() during begin_new_exec().
During begin_new_exec(), perf_event_exit_task() may be called, and the
PF_EXITING flag is not set on task. So perf_sigtrap() continues to execute
and triggers WARN_ON_ONCE(event->ctx->task != current).
Since both task exit and exec paths can call perf_event_exit_task() which
sets ctx->task to TASK_TOMBSTONE, fix this by explicitly checking if
event->ctx->task equals TASK_TOMBSTONE and dropping the red
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx6: fix firmware leak on teardown
The firmware requested in gfx_v6_0_init_microcode() is not released
when the GFX block is torn down, leaking the firmware resources.
Add gfx_v6_0_free_microcode() and call it from gfx_v6_0_sw_fini()
to release the PFP, ME, CE and RLC firmware.
(cherry picked from commit 386e81346f95ab0be5a82c5535de932e7a456924)
drm/amdgpu: fix ACP MFD device leak on init failure
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix ACP MFD device leak on init failure
acp_hw_init() registers ACP child devices with mfd_add_devices() before
attaching them to the ACP power domain and initializing the hardware.
If attaching a child to the power domain fails, or if the ACP reset or
clock enable operation times out, the failure path frees only the
source cell, resource, and platform-data allocations. The child
platform devices already registered by mfd_add_devices() remain
registered and are never released.
Remove the children from the power domain and unregister the MFD
devices on failures
nitro_enclaves: fix use-after-free on SLOT_ALLOC failure
In the Linux kernel, the following vulnerability has been resolved:
nitro_enclaves: fix use-after-free on SLOT_ALLOC failure
When ne_create_vm_ioctl() fails the SLOT_ALLOC request after
anon_inode_getfile() has succeeded, the error path calls
fput(enclave_file) and then frees ne_enclave.
In normal userspace context, fput() defers the final __fput() via
task_work. ne_enclave_release() therefore runs after ne_enclave has
already been freed and dereferences ne_enclave->slot_uid, causing a
use-after-free: KASAN: slab-use-after-free in ne_enclave_release.
The enclave has no slot allocated and is not yet linked into the
enclaves list on this er
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix port tear down use-after-free
Some drivers for multiport devices access port driver data from
completion handlers of shared URBs submitted at attach() or first open()
and stopped at disconnect() or last close(), respectively.
A simple NULL check before accessing the driver data makes sure that a
port state container has at least been allocated, but a completion
handler can still race with port tear down.
Reorder the disconnect handling so that ports are not deregistered (and
their driver data freed) until after all ports have been hung up and the
driver d
usb: storage: sierra_ms: reject short SWoC info transfers
In the Linux kernel, the following vulnerability has been resolved:
usb: storage: sierra_ms: reject short SWoC info transfers
sierra_get_swoc_info() requests sizeof(struct swoc_info) (60) bytes
from the device via usb_control_msg(), but its callers only treat a
negative return value as failure. A device that answers the
vendor-specific GetSwocInfo request with a short IN transfer is
therefore accepted, leaving the tail of the freshly allocated
(kmalloc(), non-zeroing) swoc_info buffer uninitialized.
truinst_show() subsequently prints swocInfo->rev, swocInfo->LinuxSKU
and swocInfo->LinuxVer from that buffer into the world-readable
(0444) "t
usb: gadget: f_uac1_legacy: validate bRequest index in generic_{set,get}_cmd
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_uac1_legacy: validate bRequest index in generic_{set,get}_cmd
generic_set_cmd() and generic_get_cmd() use the low nibble of
ctrl->bRequest as an index into con->data[]:
u8 cmd = (ctrl->bRequest & 0x0F); /* 0 .. 15 */
...
con->data[cmd] = value; /* OOB when cmd >= 5 */
struct usb_audio_control (include/linux/usb/audio.h) declares data as
a 5-element array, so indices 5 through 15 write (or read) up to 44
bytes past the end of the array on the heap.
A malicious USB host can craft a class-specific SET_CUR / GET_CUR
request with an arbi
usb: gadget: aspeed-vhub: cancel wake work on device removal
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: aspeed-vhub: cancel wake work on device removal
wake_work is armed from the gadget .wakeup callback to resume suspended
downstream ports, and it is never cancelled in ast_vhub_remove(), so a
work item queued before or during removal can run after devm has freed
vhub and its ports, a use-after-free.
Cancelling the work alone is not sufficient: usb_gadget_wakeup() takes
no lock and the unbind path never clears wakeup_en, so a remote-wakeup
request in flight on another CPU can re-arm the work after the cancel
and before vhub is freed.
ast_vhub_del_dev() already
USB: gadget: dummy-hcd: Fix wait for outstanding request completions
In the Linux kernel, the following vulnerability has been resolved:
USB: gadget: dummy-hcd: Fix wait for outstanding request completions
The dummy-hcd driver emulates synchronize_irq() by waiting until its
private callback_usage counter drops to 0 (with the private lock not
held). This counter is incremented whenever a gadget driver callback
occurs (which requires the private lock to be dropped), but not when a
request completion handler is called.
This is an oversight. Request completion is triggered by timer
interrupts (emulating device IRQs in a real UDC), and the interrupt
handlers are supposed to have completed when the synchronize_