posix-cpu-timers: Fix pid refcount leak in do_cpu_nanosleep() error path
In the Linux kernel, the following vulnerability has been resolved:
posix-cpu-timers: Fix pid refcount leak in do_cpu_nanosleep() error path
In do_cpu_nanosleep(), posix_cpu_timer_create() takes a pid reference
via get_pid() and stores it in timer.it.cpu.pid. If the subsequent
posix_cpu_timer_set() call fails, the function returns immediately
without calling posix_cpu_timer_del() to release the pid reference,
causing a leak.
Fix it by calling posix_cpu_timer_del() before the unlock-and-return
on the error path, consistent with the other exit paths in the same
function.
HID: appleir: fix UAF on pending key_up_timer in remove()
In the Linux kernel, the following vulnerability has been resolved:
HID: appleir: fix UAF on pending key_up_timer in remove()
appleir_remove() runs hid_hw_stop() before timer_delete_sync().
hid_hw_stop() synchronously unregisters the HID input device via
hid_disconnect() -> hidinput_disconnect() -> input_unregister_device(),
which drops the last reference and frees the underlying input_dev when
no userspace handle holds it open.
key_up_tick() reads appleir->input_dev and calls input_report_key() /
input_sync() on it. The timer is armed from appleir_raw_event() with
a HZ/8 (~125 ms) timeout on every keydown and key-repeat report. If a
key
nilfs2: reject CLEAN_SEGMENTS ioctl with out-of-range segment numbers
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: reject CLEAN_SEGMENTS ioctl with out-of-range segment numbers
Syzbot reported a hung task in nilfs_transaction_begin() where multiple
tasks performing chmod() on a nilfs2 mount blocked for over 143 seconds
waiting to acquire ns_segctor_sem for read:
INFO: task syz.0.17:5918 blocked for more than 143 seconds.
Call Trace:
schedule+0x164/0x360
rwsem_down_read_slowpath+0x6d9/0x940
down_read+0x99/0x2e0
nilfs_transaction_begin+0x364/0x710 fs/nilfs2/segment.c:221
nilfs_setattr+0x124/0x2c0 fs/nilfs2/inode.c:921
notify_change+0xc1a/0xf40
chmod_commo
net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
kalmia_rx_fixup() computes usb_packet_length = skb->len - (2 *
KALMIA_HEADER_LENGTH) as a u16, guarded only by a pre-loop check that
skb->len is at least KALMIA_HEADER_LENGTH, which is 6. A device can
deliver a short bulk-IN frame with skb->len in the 6 to 11 range, or
leave a short trailing remainder on a later loop iteration. Either case
underflows usb_packet_length to about 65530.
That bypasses the usb_packet_length < ether_packet_length truncation path.
The device-supplied ether_packet_length, a le16 up to 65
In the Linux kernel, the following vulnerability has been resolved:
usb: free iso schedules on failed submit
EHCI and FOTG210 isochronous submits build an ehci_iso_sched before
linking the URB to the endpoint queue, and keep the staged schedule in
urb->hcpriv until iso_stream_schedule() and the link helpers consume it.
If the controller is no longer accessible, or usb_hcd_link_urb_to_ep()
fails, submit jumps to done_not_linked before that handoff happens and
leaks the staged schedule still attached to urb->hcpriv.
Free the staged schedule from done_not_linked when submit fails before
the URB is linked and clear urb->hcpriv after the free.
usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler
The OTG branch of composite_setup() falls back to the first
configuration when none is selected:
if (cdev->config)
config = cdev->config;
else
config = list_first_entry(&cdev->configs,
struct usb_configuration, list);
if (!config)
goto done;
...
memcpy(req->buf, config->descriptors[0], value);
list_first_entry() never returns NULL. On an empty list it returns
container_of() of the list head. So the "if (!config)" check is dead.
When cdev->configs is empty, config points at the head i
usb: gadget: udc: Fix use-after-free in gadget_match_driver
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: udc: Fix use-after-free in gadget_match_driver
The udc structure acts as the management structure for the gadget,
but their lifecycles are decoupled. A race condition exists where
usb_del_gadget() frees the udc memory (e.g., via mode-switch work)
while gadget_match_driver() concurrently accesses the freed udc memory
(e.g., via configfs), causing a Use-After-Free (UAF) that triggers a
NULL pointer dereference when the freed memory is zeroed:
[39430.908615][ T1171] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
[39430.911397
usb: gadget: f_printer: take kref only for successful open
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_printer: take kref only for successful open
printer_open() returns -EBUSY when the character device is already
open, but it increments dev->kref regardless of the return value. VFS
does not call ->release() for a failed open, so every rejected second
open permanently leaks one reference.
Move kref_get() into the successful-open branch.
USB: idmouse: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: idmouse: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use t
In the Linux kernel, the following vulnerability has been resolved:
USB: ldusb: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect
Submitted write URBs are not stopped on close() and therefore need to be
stopped unconditionally on disconnect() to avoid use-after-free in the
completion handler.
USB: iowarrior: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the lock object
USB: legousbtower: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: legousbtower: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still
USB: serial: digi_acceleport: fix broken rx after throttle
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix broken rx after throttle
If the port is closed while throttled, the read urb is never resubmitted
and the port will not receive any further data until the device is
reconnected (or the driver is rebound).
Clear the throttle flags and submit the urb if needed when opening the
port.
USB: serial: digi_acceleport: fix hard lockup on disconnect
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix hard lockup on disconnect
If submitting the OOB write urb fails persistently (e.g if the device is
being disconnected) the driver would loop indefinitely with interrupts
disabled.
Check for urb submission errors when sending OOB commands to avoid
hanging if, for example, open(), set_termios() or close() races with a
physical disconnect.
This is issue was flagged by Sashiko when reviewing an unrelated change
to the driver.
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix write buffer corruption
The digi_write_inb_command() is supposed to wait for the write urb to
become available or return an error, but instead it updates the transfer
buffer and tries to resubmit the urb on timeout.
To make things worse, for commands like break control where no timeout
is used, the driver would corrupt the urb immediately due to a broken
jiffies comparison (on 32-bit machines this takes five minutes of uptime
to trigger due to INITIAL_JIFFIES).
Fix this by adding the missing return on timeout and waiting
indefinitely when
USB: ulpi: fix memory leak on registration failure
In the Linux kernel, the following vulnerability has been resolved:
USB: ulpi: fix memory leak on registration failure
The allocated device name is never freed on early ULPI device
registration failures.
Fix this by initialising the device structure earlier and releasing the
initial reference whenever registration fails.
udf: validate VAT header length against the VAT inode size
In the Linux kernel, the following vulnerability has been resolved:
udf: validate VAT header length against the VAT inode size
udf_load_vat() takes the virtual partition's start offset straight from
the on-disk VAT 2.0 header without checking it against the VAT inode
size:
map->s_type_specific.s_virtual.s_start_offset =
le16_to_cpu(vat20->lengthHeader);
map->s_type_specific.s_virtual.s_num_entries =
(sbi->s_vat_inode->i_size -
map->s_type_specific.s_virtual.s_start_offset) >> 2;
lengthHeader is a fully attacker-controlled 16-bit value. If it exceeds
the VAT inode size, the s_num_entries subtraction underflows to a huge
count, wh
udf: validate sparing table length as an entry count, not a byte count
In the Linux kernel, the following vulnerability has been resolved:
udf: validate sparing table length as an entry count, not a byte count
udf_load_sparable_map() accepts a sparing table when
sizeof(*st) + le16_to_cpu(st->reallocationTableLen) > sb->s_blocksize
is false, i.e. it treats reallocationTableLen as a number of BYTES that
must fit in the block. But the table is walked as an array of 8-byte
sparingEntry elements:
for (i = 0; i < le16_to_cpu(st->reallocationTableLen); i++) {
struct sparingEntry *entry = &st->mapEntry[i];
... entry->origLocation ...
}
in udf_get_pblock_spar15() and udf_relocate_blocks(). A
reallocationTa
partitions: aix: bound the pp_count scan to the ppe array
In the Linux kernel, the following vulnerability has been resolved:
partitions: aix: bound the pp_count scan to the ppe array
aix_partition() reads the physical volume descriptor into a fixed-size
struct pvd and then scans its physical-partition-extent array:
int numpps = be16_to_cpu(pvd->pp_count);
...
for (i = 0; i < numpps; i += 1) {
struct ppe *p = pvd->ppe + i;
...
lp_ix = be16_to_cpu(p->lp_ix);
pvd points at a single kmalloc()'d struct pvd whose ppe[] member holds a
fixed ARRAY_SIZE(pvd->ppe) (1016) entries, but the loop runs up to the
on-disk pp_count. pp_count is an unvalidated __be16 read straight from
the descriptor, s