Bluetooth: L2CAP: validate frame length before control and FCS access
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: validate frame length before control and FCS access
l2cap_data_rcv() unpacks either a two-byte or four-byte control field
without first ensuring that it is present. A short ERTM or streaming-mode
frame can therefore cause an out-of-bounds read.
There is a second short-frame case when CRC16 is enabled. After the
control field is pulled, l2cap_check_fcs() subtracts two from skb->len
without checking it. If fewer than two bytes remain, the subtraction
wraps; skb_trim() leaves the buffer unchanged and the subsequent FCS
load reads past the logical end of the
Bluetooth: mgmt: fix race in read_unconf_index_list()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: mgmt: fix race in read_unconf_index_list()
read_unconf_index_list() counts unconfigured controllers before allocating
its response, then checks the device flags again while filling it.
hci_dev_list_lock stabilizes list membership, but it does not serialize the
per-device flags. During asynchronous controller setup, the worker can set
HCI_UNCONFIGURED and clear HCI_SETUP between the two passes. A controller
omitted from the allocation count can then become eligible for the fill
pass, causing an out-of-bounds write to rp->index[].
Allocate space for every device
Bluetooth: RFCOMM: fix NULL dereference of dlc->session in RFCOMM_CONNINFO
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: fix NULL dereference of dlc->session in RFCOMM_CONNINFO
The RFCOMM_CONNINFO getsockopt handler accepts a socket that is not
connected as long as deferred setup is enabled:
if (sk->sk_state != BT_CONNECTED &&
!rfcomm_pi(sk)->dlc->defer_setup) {
err = -ENOTCONN;
break;
}
l2cap_sk = rfcomm_pi(sk)->dlc->session->sock->sk;
dlc->defer_setup is set in rfcomm_sock_init() when rfcomm_connect_ind()
creates a child socket for an incoming connection on a listening socket
that has BT_DEFER_SETUP enabled. It is never cleared afterwards. The
session, howeve
In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix create context out-of-bounds reads
smb2_parse_contexts() validates the complete create-context area but
does not limit each record to its Next field before dispatching it. A
malformed chain can therefore expose bytes beyond the current context to
a handler. The QFid handler also used a full response-structure cast
although it only reads DiskFileId.
The SMB2/SMB3 lease parsers made the same layout assumption: they read
LeaseState and LeaseFlags at canonical offsets rather than at
DataOffset. A valid non-canonical DataOffset could therefore yield
unrelate
smb: client: use finish_no_open() for non-regular inodes
In the Linux kernel, the following vulnerability has been resolved:
smb: client: use finish_no_open() for non-regular inodes
An O_CREAT open can find an existing symlink or another non-regular
inode. cifs_atomic_open() calls finish_open() on it and attaches a
cifsFileInfo. Symlink inodes have no CIFS release operation, so the
dentry reference held by cifsFileInfo is leaked. FMODE_OPENED also
prevents the VFS from following the symlink.
Track whether cifs_do_create() returned an open server handle. For
non-regular inodes, close the handle if present, remove the pending
open, and call finish_no_open() so the VFS can continue the lookup.
Do n
smb/server: cancel async requests when closing connection
In the Linux kernel, the following vulnerability has been resolved:
smb/server: cancel async requests when closing connection
An async request may still be waiting when a connection is closed.
This can stop the connection from closing.
Cancel active async requests before waiting for them to finish.
In the Linux kernel, the following vulnerability has been resolved:
accel/amdxdna: Disable device buffer exporting
Device buffers are never intended to be exported. Disable exporting
support explicitly.
EDAC/altera: Use parent device for devres in altr_portb_setup()
In the Linux kernel, the following vulnerability has been resolved:
EDAC/altera: Use parent device for devres in altr_portb_setup()
Anchor the devres group and the devm-managed IRQ requests in altr_portb_setup()
to the actual parent device (device->edac->dev) instead of the embedded struct
device inside the copied per-port altr_edac_device_dev.
This keeps devres_open_group(), devm_request_irq(), devres_remove_group() and
devres_release_group() all referring to the same long-lived device so the
group and the resources allocated inside it are torn down together.
Critical · CVSS 9.3EPSS 0.79%Public exploitNo fix published
ipv4: validate checksum_start before completing checksum
In the Linux kernel, the following vulnerability has been resolved:
ipv4: validate checksum_start before completing checksum
If a packet with bad checksum metadata gets into the ipv4 stack,
skb_checksum_help can corrupt the network header and cause a bunch of
mischief.
This was discovered and reported by Paulos, and has been reporoduced
by others independently since.
We really shouldn't allow such packets in, but as a defence
in depth measure, let's also check before we complete the checksum.
A more complete validation at input is forthcoming, but needs more work.
Critical · CVSS 9.8EPSS 0.45%Public exploitNo fix published
ipv4: free inet_opt and ireq_opt after an RCU grace period
In the Linux kernel, the following vulnerability has been resolved:
ipv4: free inet_opt and ireq_opt after an RCU grace period
tcp_v4_syn_recv_sock() transfers ownership of ireq->ireq_opt to the
child socket (newinet->inet_opt) without copying it.
Another cpu can concurrently process a retransmitted SYN for the same
request socket, and send a SYNACK from tcp_check_req().
tcp_v4_send_synack() and inet_csk_route_req() read ireq->ireq_opt
under rcu_read_lock() only, and ip_build_and_send_pkt() and
ip_options_build() then read opt->optlen twice.
Note that the SYNACK timer itself is not an issue: it holds a
reference on its request socket, and
RDMA/efa: Keep admin queues alive while IRQ is registered
In the Linux kernel, the following vulnerability has been resolved:
RDMA/efa: Keep admin queues alive while IRQ is registered
The management IRQ handler accesses both the admin completion queue and the
async event queue. The driver registered the IRQ before constructing these
queues and destroyed them before freeing the IRQ, so the handler's lifetime
was not contained by the resources it accesses.
Initialize the queues with interrupts masked, request the IRQ, and then
switch to interrupt mode. On removal, reset the device and free the IRQ
before destroying the queues. Also reset the device before destroying the
queues if IRQ registration f
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb: 6fire: Avoid embedded URBs
The USB 6fire driver uses URBs embedded in different structs for PCM,
MIDI and communication, and this is basically a buggy implementation
nowadays; since a URB is managed with a refcount, this may lead to a
UAF when the URB is released asynchronously.
For addressing the problem, this patch converts those embedded URBs to
ones that are properly allocated via usb_alloc_urb(). The
pcm_urb.packets[] is gone, as it's allocated by usb_alloc_urb(), hence
it's found in urb.iso_frame_desc[] instead.
The conversions are rather straightforward
net/sched: codel: bound the dropping loop per dequeue call
In the Linux kernel, the following vulnerability has been resolved:
net/sched: codel: bound the dropping loop per dequeue call
The CoDel control law schedules the next drop one interval/sqrt(count)
after the previous drop, using the configured interval
(codel_params.interval). For very small intervals the scheduled step
rounds down to zero, so the dropping loop in codel_dequeue() never
advances and drains the entire backlog under the qdisc lock in one
call - an unprivileged user can trigger a soft lockup this way.
Fix in the shared codel code used by both codel and fq_codel:
1. Make the control-law step at least 1 tick so the dropping loo
wifi: mwifiex: fix IRQ leak using wrong index in MSI-X error path
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix IRQ leak using wrong index in MSI-X error path
mwifiex_pcie_request_irq() registers each MSI-X vector with a per-index
dev_id (&card->msix_ctx[i]). On a request_irq() failure the cleanup loop
"for (j = 0; j < i; j++)" frees msix_entries[j].vector but passes the
failed index's &card->msix_ctx[i] as the dev_id. free_irq() matches on
(irq, dev_id), so it fails to find the action registered with
&card->msix_ctx[j]: the already-requested IRQ j is not freed (leaked) and
free_irq() warns about freeing a non-existent IRQ. Use &card->msix_ctx[j].
wifi: mac80211: don't warn when an IBSS has no channel to scan
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: don't warn when an IBSS has no channel to scan
ieee80211_request_ibss_scan() warns when regulatory leaves no
allowed channel, but that can happen as the regdomain can change
while IBSS is operating, and it can continue to operate briefly
during the 60s grace period until it's shut down.
Just remove the warning in this case.
wifi: cfg80211: undo netns switch if renaming the wiphy fails
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: undo netns switch if renaming the wiphy fails
Once all the interfaces have been moved, cfg80211_switch_netns()
moves the wiphy itself by setting its network namespace and then
renaming it, which makes sysfs move it. The rename can fail (but
only on allocation failures), leaving things mixed up and hitting
the warning there.
Ignoring it isn't great, undo the move and let the change fail
in this case. If undo fails then WARN, then things would again
be stuck in two different network namespaces.
wifi: mac80211_hwsim: don't hand frames to mac80211 while stopping
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: don't hand frames to mac80211 while stopping
The code checks ->started for frames coming from wmediumd, but the
radio can be stopped after the check and before frame delivery,
causing mac80211 to hit the WARN_ON(!local->started).
Expand the mutex for this case and synchronise against it when the
radio is stopped to avoid being able to hit the warning with hwsim.
Drop the error print that would've complicated the error path, it
only triggers for allocation failures (already noisy) and malformed
frames anyway.
wifi: mac80211: reset the AP_VLAN tailroom counter on ifdown
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: reset the AP_VLAN tailroom counter on ifdown
On ifup, AP_VLAN interfaces get crypto_tx_tailroom_needed_cnt from
the AP interface, but it's never decremented again unless the AP is
also brought down. Thus, bringing the same AP_VLAN up again will
increment the counter again and eventually hit the sanity check:
WARN_ON_ONCE(sdata->crypto_tx_tailroom_needed_cnt !=
master->crypto_tx_tailroom_needed_cnt);
Reset it on ifdown to avoid that.
wifi: mac80211: require a peer station for TDLS setup confirm
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: require a peer station for TDLS setup confirm
It's nonsense for the setup confirm to go to station that
doesn't even exist, and it hits a warning when building
the frame:
WARN_ON_ONCE(!sta || !ap_sta)
Only accept WLAN_TDLS_SETUP_CONFIRM when the station is
already there as a TDLS station. Need to copy the call
to ieee80211_tdls_prep_mgmt_packet() since the existing
WLAN_TDLS_DISCOVERY_REQUEST already falls through to it.
drop_monitor: fix out-of-bounds write in reset_per_cpu_data()
In the Linux kernel, the following vulnerability has been resolved:
drop_monitor: fix out-of-bounds write in reset_per_cpu_data()
In reset_per_cpu_data(), al is computed as:
al = sizeof(struct net_dm_alert_msg);
al += dm_hit_limit * sizeof(struct net_dm_drop_point);
al += sizeof(struct nlattr);
skb = genlmsg_new(al, GFP_KERNEL);
...
nla = nla_reserve(skb, NLA_UNSPEC, sizeof(struct net_dm_alert_msg));
...
msg = nla_data(nla);
memset(msg, 0, al);
Because al includes sizeof(struct nlattr) (the 4-byte attribute header),
genlmsg_new() allocates al bytes of tailroom starting at nla.
However, msg points to nl