In the Linux kernel, the following vulnerability has been resolved:
net: cap advertised IP tunnel headroom
IP tunnel devices derive their advertised needed_headroom from lower
output devices. A stack of user-created devices can make the derived
value larger than the 16-bit skb header offsets can represent. Once IP
output reserves it, skb head expansion can wrap those offsets.
The runtime transmit path already caps a growing needed_headroom at 512.
Apply the same cap when tunnel configuration publishes needed_headroom
derived from a lower output device.
Capping the advertised value is safe: IP tunnel transmit still expands
the skb when a p
High · CVSS 7.8EPSS 0.13%Public exploitNo fix published
net: skbuff: don't touch shared zerocopy state in skb_tx_error()
In the Linux kernel, the following vulnerability has been resolved:
net: skbuff: don't touch shared zerocopy state in skb_tx_error()
skb_tx_error() completes the zerocopy uarg and clears
SKBFL_ALL_ZEROCOPY, and skb_zcopy_downgrade_managed() clears
SKBFL_MANAGED_FRAG_REFS. Both live in skb_shinfo(), which every clone
shares, while the caller only owns the reference it is about to drop.
Through a clone it tells the producer its pages are free and drops
SKBFL_SHARED_FRAG for an skb that is still in flight.
Open vSwitch reaches this with a non-last OVS_ACTION_ATTR_RECIRC:
clone_execute() sends a skb_clone() into ovs_dp_process_packet() while
d
In the Linux kernel, the following vulnerability has been resolved:
seg6: reset IP6CB after IPv6 decapsulation
decap_and_validate() pulls the outer SRv6 headers and makes the inner
packet the skb network header. The IPv6 control block still contains
values collected while parsing the outer packet, including nhoff and
extension-header flags.
End.DX6 and End.DT6 route the inner IPv6 packet directly to the IPv6
input path. An unprivileged user can reach End.DT6 from a user and net
namespace by installing a local SID and injecting an outer packet with
Hop-by-Hop and Destination Options headers followed by an SRH and a
minimal inner IPv6 packet
mfd: sm501: Fix potential memory leaks during remove
In the Linux kernel, the following vulnerability has been resolved:
mfd: sm501: Fix potential memory leaks during remove
The memory allocated for struct sm501_devdata in sm501_pci_probe() and
sm501_plat_probe() is not freed by the corresponding remove functions
sm501_pci_remove() and sm501_plat_remove(). Fix that by adding a call to
kfree().
ALSA: 6fire: bound the MIDI event length from the device
In the Linux kernel, the following vulnerability has been resolved:
ALSA: 6fire: bound the MIDI event length from the device
usb6fire_comm_receiver_handler() forwards a MIDI event using a length
byte the device supplies, with no bound and no check that the transfer
delivered that many bytes:
if (!urb->status) {
if (rt->receiver_buffer[0] == 0x10) /* midi in event */
if (midi_rt)
midi_rt->in_received(midi_rt,
rt->receiver_buffer + 2,
rt->receiver_buffer[1]);
}
receiver_buffer is a 64-byte kzalloc() buffer (COMM_RECEIVER_BUFSIZE), so
only 62 bytes follow the two-byte header. receiver_buffer[1] is a u8 the
device choo
In the Linux kernel, the following vulnerability has been resolved:
ALSA: aloop: Check card index validity at probe
aloop driver blindly trusts that the given devptr->id value is within
the proper card index range at probe. It's OK for the devices the
driver itself creates at the module probe time, but if the device is
bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
ALSA: bcd2000: clear the URB pointers on disconnect
In the Linux kernel, the following vulnerability has been resolved:
ALSA: bcd2000: clear the URB pointers on disconnect
bcd2000_free_usb_related_resources() frees both URBs and leaves the
pointers behind:
usb_kill_urb(bcd2k->midi_out_urb);
usb_kill_urb(bcd2k->midi_in_urb);
usb_free_urb(bcd2k->midi_out_urb);
usb_free_urb(bcd2k->midi_in_urb);
The rawmidi device outlives that call. A substream that is still open
when the device is unplugged reaches bcd2000_midi_send() from the
trigger path on close. That function writes to the freed URB and then
hands it to the USB core:
bcd2k->midi_out_urb->transfer_buffer_length = BUFSIZE;
...
r
In the Linux kernel, the following vulnerability has been resolved:
ALSA: mpu401: Check card index validity at probe
mpu401 driver blindly trusts that the given devptr->id value is within
the proper card index range at probe. It's OK for the devices the
driver itself creates at the module probe time, but if the device is
bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
In the Linux kernel, the following vulnerability has been resolved:
ALSA: mts64: Check card index validity at probe
Although mts64 driver has a check of the given devptr->id value, it
doesn't check for a negative id, which is often given as "none" or
such value when bound via sysfs. This may lead to OOB access for
index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
ALSA: pcxhr: initialize mutexes before requesting threaded IRQ
In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcxhr: initialize mutexes before requesting threaded IRQ
pcxhr_probe() requests pcxhr_threaded_irq() before initializing
mgr->lock, even though the threaded handler takes that mutex.
Initialize the manager locks before request_threaded_irq() so an
early interrupt cannot run against uninitialized mutex state during
probe.
ALSA: portman2x4: Check card index validity at probe
In the Linux kernel, the following vulnerability has been resolved:
ALSA: portman2x4: Check card index validity at probe
Although portman2x4 driver has a check of the given devptr->id value,
it doesn't check for a negative id, which is often given as "none" or
such value when bound via sysfs. This may lead to OOB access for
index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
ALSA: serial-u16550: Check card index validity at probe
In the Linux kernel, the following vulnerability has been resolved:
ALSA: serial-u16550: Check card index validity at probe
serial-u16550 driver blindly trusts that the given devptr->id value is
within the proper card index range at probe. It's OK for the devices
the driver itself creates at the module probe time, but if the device
is bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
In the Linux kernel, the following vulnerability has been resolved:
ALSA: virmidi: Check card index validity at probe
virmidi driver blindly trusts that the given devptr->id value is
within the proper card index range at probe. It's OK for the devices
the driver itself creates at the module probe time, but if the device
is bound manually via sysfs interface, this could be -1 as "none", and
this leads to OOB access for index[] and other parameters.
Add a sanity check for the card index and warn/correct it if it's a
value out of the range.
dm-stats: fix a crash if allocation of per-cpu data fails
In the Linux kernel, the following vulnerability has been resolved:
dm-stats: fix a crash if allocation of per-cpu data fails
If "dm_kvzalloc(percpu_alloc_size, cpu_to_node(cpu))" fails, the code
jumps to the "out" label and calls dm_stat_free. dm_stat_free does
"for_each_possible_cpu(cpu) { dm_kvfree(s->stat_percpu[cpu][0].histogram,
s->histogram_alloc_size);", which crashes with NULL pointer dereference
if s->stat_percpu[cpu] is NULL.
This commit fixes the bug by testing s->stat_percpu[cpu] for NULL before
using it.
wifi: brcmfmac: Fix memory leak in brcmf_sdio_read_control()
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: Fix memory leak in brcmf_sdio_read_control()
The memory allocated for buf is not freed in some of the error paths in
brcmf_sdio_read_control(). Fix that by adding vfree() calls.
[arend: rework as suggested by Johannes]
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In iwl_op_mode_dvm_start(), jumping to out_free_eeprom currently bypasses
the out_free_eeprom_blob label. Consequently, error paths triggered after
successfully parsing the EEPROM free priv->nvm_data but leak
priv->eeprom_blob.
Fix this memory leak by reordering the error handling labels so
that out_free_eeprom falls through to out_free_eeprom_blob.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under d
wifi: rtl8xxxu: fix use-after-free from rx_urb_wq on stop
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtl8xxxu: fix use-after-free from rx_urb_wq on stop
rtl8xxxu arms rx_urb_wq from the RX completion path:
rtl8xxxu_rx_complete() hands the URB to rtl8xxxu_queue_rx_urb(), which
queues it on rx_urb_pending_list and, once the list grows past
RTL8XXXU_RX_URB_PENDING_WATER, schedules rx_urb_wq. The worker
rtl8xxxu_rx_urb_work() drains rx_urb_pending_list, recovers priv through
container_of, and resubmits each URB through rtl8xxxu_submit_rx_urb(),
which anchors it on rx_anchor and dereferences priv->udev.
rtl8xxxu_stop() cancels the sibling work items (c2hcmd_work, ra_wat
wifi: mwifiex: Detach sync cmd buffer on interrupted wait
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: Detach sync cmd buffer on interrupted wait
mwifiex synchronous commands keep the caller-provided data buffer in
cmd_node->data_buf. Several callers pass stack-allocated objects there.
If wait_event_interruptible_timeout() is interrupted, the caller can
return and release that stack object while the firmware command is still
the current command. A late firmware response then reaches the normal
response handler, which can copy data through cmd_node->data_buf into the
stale stack address.
This fixes a stack corruption observed during repeated association and
d
In the Linux kernel, the following vulnerability has been resolved:
vsock/virtio: flush works in dependency order
virtio_vsock_remove() stops the virtqueues and then flushes each work
item before freeing the enclosing virtio_vsock. The current order does
not account for dependencies between those items: tx_work may queue
send_pkt_work, and send_pkt_work may queue rx_work.
In particular, send_pkt_work can set restart_rx and release tx_lock.
The remove path can then stop the queues and flush rx_work before
send_pkt_work queues it. Although the later send_pkt_work flush waits
for that producer to finish, nothing waits for the newly queued r
w1: ds28e17: reject an oversize length on an I2C block read
In the Linux kernel, the following vulnerability has been resolved:
w1: ds28e17: reject an oversize length on an I2C block read
w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire
to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the
device. The downstream slave puts a length byte in buf[0]. The driver
then reads that many bytes into buf[1] with w1_f19_i2c_read().
buf[0] is controlled by the device and can be 0 to 255.
w1_f19_i2c_read() only rejects a zero count. The caller buffer is
I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read
run past it, up to about 222 bytes out of bounds.