linux-fips vulnerabilities · Page 197

btrfs: replace BTRFS_MAX_EXTENT_SIZE with fs_info->max_extent_size

In the Linux kernel, the following vulnerability has been resolved: btrfs: replace BTRFS_MAX_EXTENT_SIZE with fs_info->max_extent_size On zoned filesystem, data write out is limited by max_zone_append_size, and a large ordered extent is split according the size of a bio. OTOH, the number of extents to be written is calculated using BTRFS_MAX_EXTENT_SIZE, and that estimated number is used to reserve the metadata bytes to update and/or create the metadata items. The metadata reservation is done at e.g, btrfs_buffered_write() and then released according to the estimation changes. Thus, if the number of extent increases massively, the reserved

firmware: arm_scpi: Ensure scpi_info is not assigned if the probe fails

In the Linux kernel, the following vulnerability has been resolved: firmware: arm_scpi: Ensure scpi_info is not assigned if the probe fails When scpi probe fails, at any point, we need to ensure that the scpi_info is not set and will remain NULL until the probe succeeds. If it is not taken care, then it could result use-after-free as the value is exported via get_scpi_ops() and could refer to a memory allocated via devm_kzalloc() but freed when the probe fails.

dm raid: fix address sanitizer warning in raid_resume

In the Linux kernel, the following vulnerability has been resolved: dm raid: fix address sanitizer warning in raid_resume There is a KASAN warning in raid_resume when running the lvm test lvconvert-raid.sh. The reason for the warning is that mddev->raid_disks is greater than rs->raid_disks, so the loop touches one entry beyond the allocated length.

• Update to 4.15.0-1100.111

dm raid: fix address sanitizer warning in raid_status

In the Linux kernel, the following vulnerability has been resolved: dm raid: fix address sanitizer warning in raid_status There is this warning when using a kernel with the address sanitizer and running this testsuite: https://gitlab.com/cki-project/kernel-tests/-/tree/main/storage/swraid/scsi_raid ================================================================== BUG: KASAN: slab-out-of-bounds in raid_status+0x1747/0x2820 [dm_raid] Read of size 4 at addr ffff888079d2c7e8 by task lvcreate/13319 CPU: 0 PID: 13319 Comm: lvcreate Not tainted 5.18.0-0.rc3.<snip> #1 Hardware name: Red Hat KVM, BIOS 0.5.1 01/01/2011 Call Trace: <TASK> dump_sta

• Update to 4.15.0-1100.111

apparmor: fix reference count leak in aa_pivotroot()

In the Linux kernel, the following vulnerability has been resolved: apparmor: fix reference count leak in aa_pivotroot() The aa_pivotroot() function has a reference counting bug in a specific path. When aa_replace_current_label() returns on success, the function forgets to decrement the reference count of “target”, which is increased earlier by build_pivotroot(), causing a reference leak. Fix it by decreasing the refcount of “target” in that path.

• Update to 4.15.0-1100.111

net: tap: NULL pointer derefence in dev_parse_header_protocol when skb->dev is null

In the Linux kernel, the following vulnerability has been resolved: net: tap: NULL pointer derefence in dev_parse_header_protocol when skb->dev is null Fixes a NULL pointer derefence bug triggered from tap driver. When tap_get_user calls virtio_net_hdr_to_skb the skb->dev is null (in tap.c skb->dev is set after the call to virtio_net_hdr_to_skb) virtio_net_hdr_to_skb calls dev_parse_header_protocol which needs skb->dev field to be valid. The line that trigers the bug is in dev_parse_header_protocol (dev is at offset 0x10 from skb and is stored in RAX register) if (!dev->header_ops || !dev->header_ops->parse_protocol) 22e1: mov 0x1

net: atlantic: fix aq_vec index out of range error

In the Linux kernel, the following vulnerability has been resolved: net: atlantic: fix aq_vec index out of range error The final update statement of the for loop exceeds the array range, the dereference of self->aq_vec[i] is not checked and then leads to the index out of range error. Also fixed this kind of coding style in other for loop. [ 97.937604] UBSAN: array-index-out-of-bounds in drivers/net/ethernet/aquantia/atlantic/aq_nic.c:1404:48 [ 97.937607] index 8 is out of range for type 'aq_vec_s *[8]' [ 97.937608] CPU: 38 PID: 3767 Comm: kworker/u256:18 Not tainted 5.19.0+ #2 [ 97.937610] Hardware name: Dell Inc. Precision 7865 To

net: bgmac: Fix a BUG triggered by wrong bytes_compl

In the Linux kernel, the following vulnerability has been resolved: net: bgmac: Fix a BUG triggered by wrong bytes_compl On one of our machines we got: kernel BUG at lib/dynamic_queue_limits.c:27! Internal error: Oops - BUG: 0 [#1] PREEMPT SMP ARM CPU: 0 PID: 1166 Comm: irq/41-bgmac Tainted: G W O 4.14.275-rt132 #1 Hardware name: BRCM XGS iProc task: ee3415c0 task.stack: ee32a000 PC is at dql_completed+0x168/0x178 LR is at bgmac_poll+0x18c/0x6d8 pc : [<c03b9430>] lr : [<c04b5a18>] psr: 800a0313 sp : ee32be14 ip : 000005ea fp : 00000bd4 r10: ee558500 r9 : c0116298 r8 : 00000002 r7 : 00000000 r6 : ef128810 r5 : 0199326

pinctrl: nomadik: Fix refcount leak in nmk_pinctrl_dt_subnode_to_map

In the Linux kernel, the following vulnerability has been resolved: pinctrl: nomadik: Fix refcount leak in nmk_pinctrl_dt_subnode_to_map of_parse_phandle() returns a node pointer with refcount incremented, we should use of_node_put() on it when not need anymore. Add missing of_node_put() to avoid refcount leak."

• Update to 4.15.0-1100.111

iavf: Fix adminq error handling

In the Linux kernel, the following vulnerability has been resolved: iavf: Fix adminq error handling iavf_alloc_asq_bufs/iavf_alloc_arq_bufs allocates with dma_alloc_coherent memory for VF mailbox. Free DMA regions for both ASQ and ARQ in case error happens during configuration of ASQ/ARQ registers. Without this change it is possible to see when unloading interface: 74626.583369: dma_debug_device_change: device driver has pending DMA allocations while released from device [count=32] One of leaked entries details: [device address=0x0000000b27ff9000] [size=4096 bytes] [mapped with DMA_BIDIRECTIONAL] [mapped as coherent]

iavf: Fix reset error handling

In the Linux kernel, the following vulnerability has been resolved: iavf: Fix reset error handling Do not call iavf_close in iavf_reset_task error handling. Doing so can lead to double call of napi_disable, which can lead to deadlock there. Removing VF would lead to iavf_remove task being stuck, because it requires crit_lock, which is held by iavf_close. Call iavf_disable_vf if reset fail, so that driver will clean up remaining invalid resources. During rapid VF resets, HW can fail to setup VF mailbox. Wrong error handling can lead to iavf_remove being stuck with: [ 5218.999087] iavf 0000:82:01.0: Failed to init adminq: -53 ... [ 5267.18921

net: dsa: mv88e6060: prevent crash on an unused port

In the Linux kernel, the following vulnerability has been resolved: net: dsa: mv88e6060: prevent crash on an unused port If the port isn't a CPU port nor a user port, 'cpu_dp' is a null pointer and a crash happened on dereferencing it in mv88e6060_setup_port(): [ 9.575872] Unable to handle kernel NULL pointer dereference at virtual address 00000014 ... [ 9.942216] mv88e6060_setup from dsa_register_switch+0x814/0xe84 [ 9.948616] dsa_register_switch from mdio_probe+0x2c/0x54 [ 9.954433] mdio_probe from really_probe.part.0+0x98/0x2a0 [ 9.960375] really_probe.part.0 from driver_probe_device+0x30/0x10c [ 9.967029] driver_

drm/meson: Fix refcount bugs in meson_vpu_has_available_connectors()

In the Linux kernel, the following vulnerability has been resolved: drm/meson: Fix refcount bugs in meson_vpu_has_available_connectors() In this function, there are two refcount leak bugs: (1) when breaking out of for_each_endpoint_of_node(), we need call the of_node_put() for the 'ep'; (2) we should call of_node_put() for the reference returned by of_graph_get_remote_port() when it is not used anymore.

• Update to 4.15.0-1100.111

usb: host: ohci-ppc-of: Fix refcount leak bug

In the Linux kernel, the following vulnerability has been resolved: usb: host: ohci-ppc-of: Fix refcount leak bug In ohci_hcd_ppc_of_probe(), of_find_compatible_node() will return a node pointer with refcount incremented. We should use of_node_put() when it is not used anymore.

• Update to 4.15.0-1100.111

scsi: lpfc: Prevent buffer overflow crashes in debugfs with malformed user input

In the Linux kernel, the following vulnerability has been resolved: scsi: lpfc: Prevent buffer overflow crashes in debugfs with malformed user input Malformed user input to debugfs results in buffer overflow crashes. Adapt input string lengths to fit within internal buffers, leaving space for NULL terminators.

clk: qcom: ipq8074: dont disable gcc_sleep_clk_src

In the Linux kernel, the following vulnerability has been resolved: clk: qcom: ipq8074: dont disable gcc_sleep_clk_src Once the usb sleep clocks are disabled, clock framework is trying to disable the sleep clock source also. However, it seems that it cannot be disabled and trying to do so produces: [ 245.436390] ------------[ cut here ]------------ [ 245.441233] gcc_sleep_clk_src status stuck at 'on' [ 245.441254] WARNING: CPU: 2 PID: 223 at clk_branch_wait+0x130/0x140 [ 245.450435] Modules linked in: xhci_plat_hcd xhci_hcd dwc3 dwc3_qcom leds_gpio [ 245.456601] CPU: 2 PID: 223 Comm: sh Not tainted 5.18.0-rc4 #215 [ 245.463889] Hardw

• Update to 4.15.0-1100.111

gadgetfs: ep_io - wait until IRQ finishes

In the Linux kernel, the following vulnerability has been resolved: gadgetfs: ep_io - wait until IRQ finishes after usb_ep_queue() if wait_for_completion_interruptible() is interrupted we need to wait until IRQ gets finished. Otherwise complete() from epio_complete() can corrupt stack.

• Update to 4.15.0-1100.111

cxl: Fix a memory leak in an error handling path

In the Linux kernel, the following vulnerability has been resolved: cxl: Fix a memory leak in an error handling path A bitmap_zalloc() must be balanced by a corresponding bitmap_free() in the error handling path of afu_allocate_irqs().

• Update to 4.15.0-1100.111

drivers:md:fix a potential use-after-free bug

In the Linux kernel, the following vulnerability has been resolved: drivers:md:fix a potential use-after-free bug In line 2884, "raid5_release_stripe(sh);" drops the reference to sh and may cause sh to be released. However, sh is subsequently used in lines 2886 "if (sh->batch_head && sh != sh->batch_head)". This may result in an use-after-free bug. It can be fixed by moving "raid5_release_stripe(sh);" to the bottom of the function.

• Update to 4.15.0-1100.111

ext4: block range must be validated before use in ext4_mb_clear_bb()

In the Linux kernel, the following vulnerability has been resolved: ext4: block range must be validated before use in ext4_mb_clear_bb() Block range to free is validated in ext4_free_blocks() using ext4_inode_block_valid() and then it's passed to ext4_mb_clear_bb(). However in some situations on bigalloc file system the range might be adjusted after the validation in ext4_free_blocks() which can lead to troubles on corrupted file systems such as one found by syzkaller that resulted in the following BUG kernel BUG at fs/ext4/ext4.h:3319! PREEMPT SMP NOPTI CPU: 28 PID: 4243 Comm: repro Kdump: loaded Not tainted 5.19.0-rc6+ #1 Hardware name: