drm/amd/display: use kvzalloc to allocate struct dc
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use kvzalloc to allocate struct dc
struct dc has grown large over time (most of it the two inlined
dc_scratch_space copies) and now sits close to the page allocator's 4 MiB
contiguous allocation limit. Its actual size is not fixed by the source
alone, it also depends on the compiler and the .config, so it can easily
cross 4 MiB, e.g. with a newer GCC or a config change.
dc_create() allocates it with kzalloc(). Once struct dc exceeds 4 MiB the
request is rounded up to order 11 (8 MiB), which is above MAX_PAGE_ORDER,
so the page allocator warns and returns N
libceph: bound get_version reply decode to front len
In the Linux kernel, the following vulnerability has been resolved:
libceph: bound get_version reply decode to front len
handle_get_version_reply() uses msg->front_alloc_len as the decode
boundary for MON_GET_VERSION_REPLY. That is the size of the reused
reply buffer, not the number of bytes actually received.
A truncated reply can therefore pass ceph_decode_need() and decode the
second u64 from stale tail bytes left in the buffer by an earlier
message, causing an uninitialized memory read.
Use msg->front.iov_len as the receive-side decode boundary, matching
other libceph reply handlers and limiting decoding to the bytes that
were actual
vxlan: require CAP_NET_ADMIN in the device netns for changelink
In the Linux kernel, the following vulnerability has been resolved:
vxlan: require CAP_NET_ADMIN in the device netns for changelink
A tunnel changelink() operates on at most two netns, dev_net(dev) and
the sticky underlay netns vxlan->net. They differ once the device is
created in or moved to a netns other than the one the request runs in.
The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev),
so a caller privileged there but not in vxlan->net can rewrite a vxlan
device whose underlay lives in vxlan->net.
vxlan_changelink() validates and applies the new configuration against
vxlan->net (vxlan_config_validate(vxlan->net, .
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx8: drop unecessary BUG_ON()
There's no need to crash the kernel for this case.
(cherry picked from commit 4d7c25208ca612b754f3bf39e9f16e725b828891)
KVM: x86/mmu: Fix use-after-free on vendor module reload
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86/mmu: Fix use-after-free on vendor module reload
mmu_destroy_caches() destroys pte_list_desc_cache and
mmu_page_header_cache, but leaves both pointers unchanged. The pointers
live in kvm.ko, and therefore survive when a vendor module is unloaded
while kvm.ko remains loaded.
If creation of pte_list_desc_cache fails during a subsequent vendor
module load, its assignment sets pte_list_desc_cache to NULL and the
error path calls mmu_destroy_caches(). mmu_page_header_cache still
points to the cache destroyed during the preceding vendor module
unload. Passing that sta
gpu: host1x: Fix use-after-free in host1x_bo_clear_cached_mappings
In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Fix use-after-free in host1x_bo_clear_cached_mappings
__host1x_bo_unpin() drops the last reference to the mapping and frees
it, so we can't dereference mapping afterwards. The cache itself
outlives the mapping, so use the cache local variable instead.
IB/mad: Drop unmatched RMPP responses before reassembly
In the Linux kernel, the following vulnerability has been resolved:
IB/mad: Drop unmatched RMPP responses before reassembly
Kernel-handled RMPP receive processing starts reassembly for active
DATA responses before the response is matched to an outstanding send.
The normal match happens later, after ib_process_rmpp_recv_wc() has
either assembled a complete message or consumed the segment.
That ordering lets an unsolicited response that routes to a kernel
RMPP agent by the high TID bits allocate or extend RMPP receive state
before the full TID and source address are checked against a real
request. A reordered burst can therefore reach the re
wifi: cfg80211: cancel sched scan results work on unregister
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: cancel sched scan results work on unregister
cfg80211_sched_scan_results() can queue rdev->sched_scan_res_wk from a
driver result notification while a scheduled scan request is present. The
work callback recovers the containing cfg80211_registered_device and then
locks the wiphy and walks the scheduled-scan request list.
wiphy_unregister() already makes the wiphy unreachable and drains rdev work
items before cfg80211_dev_free() can release the object, but it does not
drain sched_scan_res_wk. A queued or running result work item can therefore
cross the unreg
wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one()
In the Linux kernel, the following vulnerability has been resolved:
wifi: ipw2100: fix potential memory leak in ipw2100_pci_init_one()
The memory allocated in the ipw2100_alloc_device() function is not freed
in some of the error paths in ipw2100_pci_init_one(). Fix that by
converting the direct return into a goto to the error path return.
The error path when pci_enable_device() fails cannot jump to fail, since
at this point priv is not set, so perform error handling inline.
wifi: cfg80211: Fix an error handling path in cfg80211_wext_siwscan()
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: Fix an error handling path in cfg80211_wext_siwscan()
If the test against IEEE80211_MAX_SSID_LEN fails, then 'creq' leaks.
Use the existing error handling path to fix it.
wifi: libertas: fix memory leak in helper_firmware_cb()
In the Linux kernel, the following vulnerability has been resolved:
wifi: libertas: fix memory leak in helper_firmware_cb()
helper_firmware_cb() neglects to free the single-stage firmware image
after a successful async load, leading to a memory leak in the USB
firmware-download path.
Fix this memory leak by calling release_firmware() immediately after
lbs_fw_loaded() returns.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still present i
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: free AP_VLAN bc_buf SKBs outside IRQ lock
ieee80211_do_stop() removes AP_VLAN packets from the parent AP
ps->bc_buf while holding ps->bc_buf.lock with IRQs disabled. It then
calls ieee80211_free_txskb() before dropping the lock.
ieee80211_free_txskb() is not just a passive SKB release. For SKBs with
TX status state it can report a dropped frame through cfg80211/nl80211,
and that path can reach netlink tap transmit. This is the same reason
the pending queue cleanup in ieee80211_do_stop() already unlinks SKBs
under the queue lock and frees them after IRQ stat
wifi: cfg80211: use wiphy work for socket owner autodisconnect
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: use wiphy work for socket owner autodisconnect
nl80211_netlink_notify() walks the cfg80211 wireless device list when a
NETLINK_GENERIC socket is released. If the socket owns a connection, the
notifier queues the embedded wdev->disconnect_wk work item.
That work is a plain work_struct today. NETDEV_GOING_DOWN cancels it, but a
NETLINK_URELEASE notifier that already observed conn_owner_nlportid can
queue it after that cancel returns. _cfg80211_unregister_wdev() then
removes the wdev from the list and waits for RCU readers, but
synchronize_net() does not drain
wifi: brcmfmac: initialize SDIO data work before cleanup
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: initialize SDIO data work before cleanup
brcmf_sdio_probe() stores the newly allocated bus in sdiodev->bus before
allocating the ordered workqueue. If that allocation fails, the function
jumps to fail and calls brcmf_sdio_remove().
brcmf_sdio_remove() unconditionally cancels bus->datawork. Initialize the
work item before the first failure path that can reach brcmf_sdio_remove(),
so the cleanup path always observes a valid work object.
This issue was found by our static analysis tool and then confirmed by
manual review of the probe error path and the remove
ppp: defer channel free to an RCU grace period to fix pppol2tp RX UAF
In the Linux kernel, the following vulnerability has been resolved:
ppp: defer channel free to an RCU grace period to fix pppol2tp RX UAF
pppol2tp_recv() runs in the L2TP UDP-encap softirq RX path:
l2tp_udp_encap_recv() -> l2tp_recv_common() -> pppol2tp_recv()
-> ppp_input(&po->chan)
It runs under rcu_read_lock() holding only an l2tp_session reference and
takes NO reference on the internal PPP channel (struct channel,
chan->ppp) that ppp_input() dereferences.
The pppox socket is SOCK_RCU_FREE, so 'po' and the embedded ppp_channel
are RCU-safe. But the internal struct channel is a separate allocation
that ppp_release_channel() frees
net/iucv: take a reference on the socket found in afiucv_hs_rcv()
In the Linux kernel, the following vulnerability has been resolved:
net/iucv: take a reference on the socket found in afiucv_hs_rcv()
afiucv_hs_rcv() looks up the destination socket under iucv_sk_list.lock,
drops the lock, and then passes the socket to the afiucv_hs_callback_*()
handlers without holding a reference. AF_IUCV sockets are not
RCU-protected and are freed synchronously by iucv_sock_kill() ->
sock_put(), so a concurrent close can free the socket in the window
between read_unlock() and the handler, which then dereferences freed
memory (for example sk->sk_data_ready() in afiucv_hs_callback_syn()).
Take a reference with sock_hold()
ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered
In the Linux kernel, the following vulnerability has been resolved:
ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered
sata_dwc_enable_interrupts() is called before platform_get_irq() and
ata_host_activate(), leaving the SATA controller's interrupt mask
enabled without a registered handler. If a later step fails (irq
request, phy init, etc.) or if the controller asserts an interrupt
during probe, the irq line may fire with no handler, causing a
spurious interrupt storm.
Move sata_dwc_enable_interrupts() after ata_host_activate() so that
interrupts are only unmasked once the handler is registered and the
core
sctp: fix auth_hmacs array size in struct sctp_cookie
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix auth_hmacs array size in struct sctp_cookie
The auth_hmacs array in struct sctp_cookie is supposed to store a complete
SCTP_AUTH_HMAC_ALGO parameter, which consists of a struct sctp_paramhdr
followed by N HMAC identifiers.
However, the array size was calculated using an extra 2 bytes instead of
sizeof(struct sctp_paramhdr), which is 4 bytes. When four HMAC identifiers
are configured, the HMAC-ALGO parameter stored in the endpoint is larger
than the auth_hmacs buffer in the cookie.
As a result, sctp_association_init() copies beyond the end of auth_hmacs
when init
usb: core: sysfs: add lock to bos_descriptors_read()
In the Linux kernel, the following vulnerability has been resolved:
usb: core: sysfs: add lock to bos_descriptors_read()
Add a lock to the function bos_descriptors_read().
This function accesses udev->bos, which could be simultaneously freed in
usb_reset_and_verify_device(), a function that is commonly called in
drivers all over the kernel.
wifi: at76c50x-usb: avoid length underflow in at76_guess_freq()
In the Linux kernel, the following vulnerability has been resolved:
wifi: at76c50x-usb: avoid length underflow in at76_guess_freq()
at76_guess_freq() checks only that the received frame is at least a bare
802.11 header (24 bytes) before subtracting the fixed management-body
offset:
len -= el_off;
For both beacon and probe response frames, el_off is 36. If the frame is
shorter than el_off, subtracting it causes the calculated IE length to
wrap. The length is eventually passed to cfg80211_find_elem_match() as a
very large unsigned value, so the element walk runs beyond the RX skb.
This path is reached from at76_rx_tasklet() while scanning