nvmet: fix pre-auth out-of-bounds heap read in Discovery Get Log Page
In the Linux kernel, the following vulnerability has been resolved:
nvmet: fix pre-auth out-of-bounds heap read in Discovery Get Log Page
nvmet_execute_disc_get_log_page() validates only the dword alignment
of the host-supplied Log Page Offset (lpo). The 64-bit offset is then
added to a small kzalloc'd buffer that holds the discovery log page
and the result is passed straight to nvmet_copy_to_sgl(), which
memcpy()s data_len bytes out to the host with no source-side bound
check:
u64 offset = nvmet_get_log_page_offset(req->cmd); /* 64-bit host */
size_t data_len = nvmet_get_log_page_len(req->cmd); /* 32-bit host */
...
partitions: aix: bound the pp_count scan to the ppe array
In the Linux kernel, the following vulnerability has been resolved:
partitions: aix: bound the pp_count scan to the ppe array
aix_partition() reads the physical volume descriptor into a fixed-size
struct pvd and then scans its physical-partition-extent array:
int numpps = be16_to_cpu(pvd->pp_count);
...
for (i = 0; i < numpps; i += 1) {
struct ppe *p = pvd->ppe + i;
...
lp_ix = be16_to_cpu(p->lp_ix);
pvd points at a single kmalloc()'d struct pvd whose ppe[] member holds a
fixed ARRAY_SIZE(pvd->ppe) (1016) entries, but the loop runs up to the
on-disk pp_count. pp_count is an unvalidated __be16 read straight from
the descriptor, s
isofs: bound Rock Ridge symlink components to the SL record
In the Linux kernel, the following vulnerability has been resolved:
isofs: bound Rock Ridge symlink components to the SL record
get_symlink_chunk() and the SL handling in
parse_rock_ridge_inode_internal() walk the variable-length components of
a Rock Ridge "SL" (symbolic link) record. Each component is a two-byte
header (flags, len) followed by len bytes of text, so it occupies
slp->len + 2 bytes. Both loops read slp->len and advance to the next
component, and get_symlink_chunk() additionally does
memcpy(rpnt, slp->text, slp->len), but neither checks that the component
lies within the SL record before dereferencing it.
A crafted SL recor
crypto: ecc - Fix carry overflow in vli multiplication
In the Linux kernel, the following vulnerability has been resolved:
crypto: ecc - Fix carry overflow in vli multiplication
The carry flag calculation fails when r01.m_high is saturated
(0xFFFFFFFFFFFFFFFF) and addition of lower bits overflows.
The condition (r01.m_high < product.m_high) doesn't handle the case
where r01.m_high == product.m_high and an additional carry exists
from lower-bit overflow.
When commit 3c4b23901a0c ("crypto: ecdh - Add ECDH software support")
introduced crypto/ecc.c, it split the muladd() function in the
micro-ecc library into separate mul_64_64() and add_128_128() helpers.
It seems the check got lost in translat
crypto: drbg - Fix returning success on failure in CTR_DRBG
In the Linux kernel, the following vulnerability has been resolved:
crypto: drbg - Fix returning success on failure in CTR_DRBG
drbg_ctr_generate() sometimes returns success when it fails, leaving the
output buffer uninitialized. Fix it.
crypto: qat - protect service table iterations with service_lock
In the Linux kernel, the following vulnerability has been resolved:
crypto: qat - protect service table iterations with service_lock
The service_table list is protected by service_lock when entries are
added or removed (in adf_service_add() and adf_service_remove()), but
several functions iterate over the list without holding this lock.
A concurrent adf_service_register() or adf_service_unregister() call
could modify the list during traversal, leading to list corruption or
a use-after-free.
Fix this by holding service_lock across all list_for_each_entry()
iterations of service_table in adf_dev_init(), adf_dev_start(),
adf_dev_stop(), adf_
In the Linux kernel, the following vulnerability has been resolved:
crypto: qat - validate RSA CRT component lengths
The generic RSA key parser (rsa_helper.c) bounds each CRT component (p,
q, dp, dq, qinv) by the modulus size n_sz, but qat_rsa_setkey_crt()
allocates half-size DMA buffers (key_sz / 2) and right-aligns each
component with:
memcpy(dst + half_key_sz - len, src, len)
When a CRT component is larger than half_key_sz the subtraction
underflows and memcpy writes past the DMA buffer, causing memory
corruption.
Add a len > half_key_sz check next to the existing !len check for each
of the five CRT components so the driver falls
tracing: Prevent out-of-bounds read in glob matching
In the Linux kernel, the following vulnerability has been resolved:
tracing: Prevent out-of-bounds read in glob matching
String event fields are not necessarily NUL-terminated, so the filter
predicate functions (filter_pred_string(), filter_pred_strloc() and
filter_pred_strrelloc()) pass the field length to the regex match
callbacks, and the length-aware matchers honour it.
regex_match_glob() was the exception: it ignored the length and called
glob_match(), which scans the string until it hits a NUL byte. Some
string fields are not NUL-terminated. One example is the dynamic char
array of the xfs_* namespace tracepoints, which is copied wit
NFSv4: include MAY_WRITE in open permission mask for O_TRUNC
In the Linux kernel, the following vulnerability has been resolved:
NFSv4: include MAY_WRITE in open permission mask for O_TRUNC
POSIX requires write permission to truncate a file, so an open() that
specifies O_TRUNC must be authorized for write access regardless of the
O_ACCMODE access mode.
nfs_open_permission_mask() builds the access mask passed to
nfs_may_open(), which is the local authorization gate for OPENs the
client serves itself from a cached write delegation via the
can_open_delegated() path in nfs4_try_open_cached(). The mask is
derived from O_ACCMODE alone, so an open(O_RDONLY | O_TRUNC) against a
file the caller cannot write
In the Linux kernel, the following vulnerability has been resolved:
i2c: core: fix adapter deregistration race
Adapters can be looked up by their id using i2c_get_adapter() which
takes a reference to the embedded struct device.
Remove the adapter from the IDR before tearing it down during
deregistration (and on registration failure) to make sure its resources
are not accessed after having been freed (e.g. the device name).
Input: synaptics-rmi4 - bound the F30 keymap to the GPIO/LED count
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - bound the F30 keymap to the GPIO/LED count
rmi_f30_map_gpios() allocates gpioled_key_map with
min(gpioled_count, TRACKSTICK_RANGE_END) == at most 6 entries, but
rmi_f30_attention() iterates the full f30->gpioled_count (device query
register, range 0..31) and dereferences gpioled_key_map[i], and
input->keycodemax is set to the full gpioled_count while input->keycode
points at the 6-entry allocation.
A device that reports gpioled_count > 6 with GPIO support enabled
therefore causes an out-of-bounds read on the attention interrupt and
out-of-bounds rea
Input: elan_i2c - prevent division by zero and arithmetic underflow
In the Linux kernel, the following vulnerability has been resolved:
Input: elan_i2c - prevent division by zero and arithmetic underflow
The Elan I2C touchpad driver queries the device for its physical
dimensions and trace counts to calculate the device resolution and width.
However, if the device firmware or device tree provides invalid zero
values for x_traces or y_traces, it results in a fatal division-by-zero
exception leading to a kernel panic during device probe.
Add checks to ensure these parameters are non-zero before performing
the division. If invalid trace values are detected, fall back to a safe
default of 1.
Additionally, prev
Input: goodix - clamp the device-reported contact count
In the Linux kernel, the following vulnerability has been resolved:
Input: goodix - clamp the device-reported contact count
goodix_ts_read_input_report() copies the number of touch points reported
by the device into an on-stack buffer
u8 point_data[2 + GOODIX_MAX_CONTACT_SIZE * GOODIX_MAX_CONTACTS];
which is sized for at most GOODIX_MAX_CONTACTS (10) contacts. The only
runtime check bounds the per-interrupt count against ts->max_touch_num,
but that value is taken verbatim from a 4-bit field of the device
configuration block and is never clamped:
ts->max_touch_num = ts->config[MAX_CONTACTS_LOC] & 0x0f;
The nibble can be 0..15, so a mal
Input: iforce - bound the device-reported force-feedback effect index
In the Linux kernel, the following vulnerability has been resolved:
Input: iforce - bound the device-reported force-feedback effect index
iforce_process_packet() handles a status report (packet id 0x02) by
taking a force-feedback effect index straight from the device wire and
using it to address the per-effect state array:
i = data[1] & 0x7f;
if (data[1] & 0x80) {
if (!test_and_set_bit(FF_CORE_IS_PLAYED,
iforce->core_effects[i].flags))
...
} else if (test_and_clear_bit(FF_CORE_IS_PLAYED,
iforce->core_effects[i].flags)) {
...
}
The index is masked only with 0x7f, so it ranges 0..127, but
core_effects[] holds
Input: touchwin - reset the packet index on every complete packet
In the Linux kernel, the following vulnerability has been resolved:
Input: touchwin - reset the packet index on every complete packet
tw_interrupt() accumulates each non-zero serial byte into a fixed
three-byte buffer with a running index that is only reset once a full
packet has been received *and* the device's two Y bytes agree:
tw->data[tw->idx++] = data;
if (tw->idx == TW_LENGTH && tw->data[1] == tw->data[2]) {
...
tw->idx = 0;
}
The reset is gated on tw->data[1] == tw->data[2], a value the device
controls. A malicious, malfunctioning or counterfeit Touchwindow
peripheral can stream non-zero bytes whose 2nd and 3rd bytes diffe
Input: mms114 - reject an oversized device packet size
In the Linux kernel, the following vulnerability has been resolved:
Input: mms114 - reject an oversized device packet size
mms114_interrupt() reads a packet of touch data from the device into a
fixed-size on-stack buffer
struct mms114_touch touch[MMS114_MAX_TOUCH];
which holds MMS114_MAX_TOUCH (10) events of MMS114_EVENT_SIZE (8) bytes,
i.e. 80 bytes. The length of the I2C read into it is taken verbatim from
the device:
packet_size = mms114_read_reg(data, MMS114_PACKET_SIZE);
if (packet_size <= 0)
goto out;
...
error = __mms114_read_reg(data, MMS114_INFORMATION, packet_size,
(u8 *)touch);
packet_size is a single device registe
fuse: re-lock request before returning from fuse_ref_folio()
In the Linux kernel, the following vulnerability has been resolved:
fuse: re-lock request before returning from fuse_ref_folio()
fuse_ref_folio() unlocks the request but does not re-lock it before
returning. fuse_chan_abort() can end the request and the async end
callback (eg fuse_writepage_free()) can free the args while the
subsequent copy chain logic after fuse_ref_folio() accesses them,
leading to use-after-free issues.
Fix this by locking the request in fuse_ref_folio() before returning.
fpga: region: fix use-after-free in child_regions_with_firmware()
In the Linux kernel, the following vulnerability has been resolved:
fpga: region: fix use-after-free in child_regions_with_firmware()
Move of_node_put(child_region) after the error print to avoid accessing
freed memory when pr_err() references child_region.
[ Yilun: Fix the Fixes tag ]
Input: elan_i2c - validate firmware size before use
In the Linux kernel, the following vulnerability has been resolved:
Input: elan_i2c - validate firmware size before use
Ensure that the firmware file is large enough to contain the expected
number of pages and the signature (which resides at the end of the
firmware blob) before accessing them to prevent potential out-of-bounds
reads.
tty: serial: pch_uart: add check for dma_alloc_coherent()
In the Linux kernel, the following vulnerability has been resolved:
tty: serial: pch_uart: add check for dma_alloc_coherent()
Add a check for dma_alloc_coherent() failure to prevent a potential
NULL pointer dereference in dma_handle_rx(). Properly release DMA
channels and the PCI device reference using a goto ladder if the
allocation fails.