linux-gcp-fips vulnerabilities · Page 147

audit: fix possible soft lockup in __audit_inode_child()

In the Linux kernel, the following vulnerability has been resolved: audit: fix possible soft lockup in __audit_inode_child() Tracefs or debugfs maybe cause hundreds to thousands of PATH records, too many PATH records maybe cause soft lockup. For example: 1. CONFIG_KASAN=y && CONFIG_PREEMPTION=n 2. auditctl -a exit,always -S open -k key 3. sysctl -w kernel.watchdog_thresh=5 4. mkdir /sys/kernel/debug/tracing/instances/test There may be a soft lockup as follows: watchdog: BUG: soft lockup - CPU#45 stuck for 7s! [mkdir:15498] Kernel panic - not syncing: softlockup: hung tasks Call trace: dump_backtrace+0x0/0x30c show_stac

spmi: Add a check for remove callback when removing a SPMI driver

In the Linux kernel, the following vulnerability has been resolved: spmi: Add a check for remove callback when removing a SPMI driver When removing a SPMI driver, there can be a crash due to NULL pointer dereference if it does not have a remove callback defined. This is one such call trace observed when removing the QCOM SPMI PMIC driver: dump_backtrace.cfi_jt+0x0/0x8 dump_stack_lvl+0xd8/0x16c panic+0x188/0x498 __cfi_slowpath+0x0/0x214 __cfi_slowpath+0x1dc/0x214 spmi_drv_remove+0x16c/0x1e0 device_release_driver_internal+0x468/0x79c driver_detach+0x11c/0x1a0 bus_remove_driver+0xc4/0x124 driver_unregister+0x58/0x84 cleanup_module+

usb: idmouse: fix an uninit-value in idmouse_open

In the Linux kernel, the following vulnerability has been resolved: usb: idmouse: fix an uninit-value in idmouse_open In idmouse_create_image, if any ftip_command fails, it will go to the reset label. However, this leads to the data in bulk_in_buffer[HEADER..IMGSIZE] uninitialized. And the check for valid image incurs an uninitialized dereference. Fix this by moving the check before reset label since this check only be valid if the data after bulk_in_buffer[HEADER] has concrete data. Note that this is found by KMSAN, so only kernel compilation is tested.

• Update to 4.15.0-2054.59

staging: rtl8192u: Fix use after free in ieee80211_rx()

In the Linux kernel, the following vulnerability has been resolved: staging: rtl8192u: Fix use after free in ieee80211_rx() We cannot dereference the "skb" pointer after calling ieee80211_monitor_rx(), because it is a use after free.

• Update to 4.15.0-2055.60

s390/lcs: Fix return type of lcs_start_xmit()

In the Linux kernel, the following vulnerability has been resolved: s390/lcs: Fix return type of lcs_start_xmit() With clang's kernel control flow integrity (kCFI, CONFIG_CFI_CLANG), indirect call targets are validated against the expected function pointer prototype to make sure the call target is valid to help mitigate ROP attacks. If they are not identical, there is a failure at run time, which manifests as either a kernel panic or thread getting killed. A proposed warning in clang aims to catch these at compile time, which reveals: drivers/s390/net/lcs.c:2090:21: error: incompatible function pointer types initializing 'netdev_tx_t (*)

• Update to 4.15.0-2055.60

regulator: core: fix resource leak in regulator_register()

In the Linux kernel, the following vulnerability has been resolved: regulator: core: fix resource leak in regulator_register() I got some resource leak reports while doing fault injection test: OF: ERROR: memory leak, expected refcount 1 instead of 100, of_node_get()/of_node_put() unbalanced - destroy cset entry: attach overlay node /i2c/pmic@64/regulators/buck1 unreferenced object 0xffff88810deea000 (size 512): comm "490-i2c-rt5190a", pid 253, jiffies 4294859840 (age 5061.046s) hex dump (first 32 bytes): 00 00 00 00 ad 4e ad de ff ff ff ff 00 00 00 00 .....N.......... ff ff ff ff ff ff ff ff a0 1e 00 a1 ff ff ff ff ..

x86/apic: Don't disable x2APIC if locked

In the Linux kernel, the following vulnerability has been resolved: x86/apic: Don't disable x2APIC if locked The APIC supports two modes, legacy APIC (or xAPIC), and Extended APIC (or x2APIC). X2APIC mode is mostly compatible with legacy APIC, but it disables the memory-mapped APIC interface in favor of one that uses MSRs. The APIC mode is controlled by the EXT bit in the APIC MSR. The MMIO/xAPIC interface has some problems, most notably the APIC LEAK [1]. This bug allows an attacker to use the APIC MMIO interface to extract data from the SGX enclave. Introduce support for a new feature that will allow the BIOS to lock the APIC in x2AP

ALSA: line6: fix stack overflow in line6_midi_transmit

In the Linux kernel, the following vulnerability has been resolved: ALSA: line6: fix stack overflow in line6_midi_transmit Correctly calculate available space including the size of the chunk buffer. This fixes a buffer overflow when multiple MIDI sysex messages are sent to a PODxt device.

• Update to 4.15.0-2055.60

wifi: ar5523: Fix use-after-free on ar5523_cmd() timed out

In the Linux kernel, the following vulnerability has been resolved: wifi: ar5523: Fix use-after-free on ar5523_cmd() timed out syzkaller reported use-after-free with the stack trace like below [1]: [ 38.960489][ C3] ================================================================== [ 38.963216][ C3] BUG: KASAN: use-after-free in ar5523_cmd_tx_cb+0x220/0x240 [ 38.964950][ C3] Read of size 8 at addr ffff888048e03450 by task swapper/3/0 [ 38.966363][ C3] [ 38.967053][ C3] CPU: 3 PID: 0 Comm: swapper/3 Not tainted 6.0.0-09039-ga6afa4199d3d-dirty #18 [ 38.968464][ C3] Hardware name: QEMU Standard PC (i440FX + PIIX,

• Update to 4.15.0-2055.60

md/raid1: stop mdx_raid1 thread when raid1 array run failed

In the Linux kernel, the following vulnerability has been resolved: md/raid1: stop mdx_raid1 thread when raid1 array run failed fail run raid1 array when we assemble array with the inactive disk only, but the mdx_raid1 thread were not stop, Even if the associated resources have been released. it will caused a NULL dereference when we do poweroff. This causes the following Oops: [ 287.587787] BUG: kernel NULL pointer dereference, address: 0000000000000070 [ 287.594762] #PF: supervisor read access in kernel mode [ 287.599912] #PF: error_code(0x0000) - not-present page [ 287.605061] PGD 0 P4D 0 [ 287.607612] Oops: 000

• Update to 4.15.0-2055.60

scsi: qla2xxx: Clear cmds after chip reset

In the Linux kernel, the following vulnerability has been resolved: scsi: qla2xxx: Clear cmds after chip reset Commit aefed3e5548f ("scsi: qla2xxx: target: Fix offline port handling and host reset handling") caused two problems: 1. Commands sent to FW, after chip reset got stuck and never freed as FW is not going to respond to them anymore. 2. BUG_ON(cmd->sg_mapped) in qlt_free_cmd(). Commit 26f9ce53817a ("scsi: qla2xxx: Fix missed DMA unmap for aborted commands") attempted to fix this, but introduced another bug under different circumstances when two different CPUs were racing to call qlt_unmap_sg() at the same time: BUG_

ima: Handle error code returned by ima_filter_rule_match()

In the Linux kernel, the following vulnerability has been resolved: ima: Handle error code returned by ima_filter_rule_match() In ima_match_rules(), if ima_filter_rule_match() returns -ENOENT due to the rule being NULL, the function incorrectly skips the 'if (!rc)' check and sets 'result = true'. The LSM rule is considered a match, causing extra files to be measured by IMA. This issue can be reproduced in the following scenario: After unloading the SELinux policy module via 'semodule -d', if an IMA measurement is triggered before ima_lsm_rules is updated, in ima_match_rules(), the first call to ima_filter_rule_match() returns -ESTALE. This

isdn: mISDN: hfcsusb: fix memory leak in hfcsusb_probe()

In the Linux kernel, the following vulnerability has been resolved: isdn: mISDN: hfcsusb: fix memory leak in hfcsusb_probe() In hfcsusb_probe(), the memory allocated for ctrl_urb gets leaked when setup_instance() fails with an error code. Fix that by freeing the urb before freeing the hw structure. Also change the error paths to use the goto ladder style. Compile tested only. Issue found using a prototype static analysis tool.

wifi: rtl8xxxu: Fix memory leaks with RTL8723BU, RTL8192EU

In the Linux kernel, the following vulnerability has been resolved: wifi: rtl8xxxu: Fix memory leaks with RTL8723BU, RTL8192EU The wifi + bluetooth combo chip RTL8723BU can leak memory (especially?) when it's connected to a bluetooth audio device. The busy bluetooth traffic generates lots of C2H (card to host) messages, which are not freed correctly. To fix this, move the dev_kfree_skb() call in rtl8xxxu_c2hcmd_callback() inside the loop where skb_dequeue() is called. The RTL8192EU leaks memory because the C2H messages are added to the queue and left there forever. (This was fine in the past because it probably wasn't sending any C2H mess

btrfs: fix race when deleting quota root from the dirty cow roots list

In the Linux kernel, the following vulnerability has been resolved: btrfs: fix race when deleting quota root from the dirty cow roots list When disabling quotas we are deleting the quota root from the list fs_info->dirty_cowonly_roots without taking the lock that protects it, which is struct btrfs_fs_info::trans_lock. This unsynchronized list manipulation may cause chaos if there's another concurrent manipulation of this list, such as when adding a root to it with ctree.c:add_root_to_dirty_list(). This can result in all sorts of weird failures caused by a race, such as the following crash: [337571.278245] general protection fault, proba

RDMA/rxe: Fix the error "trying to register non-static key in rxe_cleanup_task"

In the Linux kernel, the following vulnerability has been resolved: RDMA/rxe: Fix the error "trying to register non-static key in rxe_cleanup_task" In the function rxe_create_qp(), rxe_qp_from_init() is called to initialize qp, internally things like rxe_init_task are not setup until rxe_qp_init_req(). If an error occurred before this point then the unwind will call rxe_cleanup() and eventually to rxe_qp_do_cleanup()/rxe_cleanup_task() which will oops when trying to access the uninitialized spinlock. If rxe_init_task is not executed, rxe_cleanup_task will not be called.

btrfs: fix race between balance and cancel/pause

In the Linux kernel, the following vulnerability has been resolved: btrfs: fix race between balance and cancel/pause Syzbot reported a panic that looks like this: assertion failed: fs_info->exclusive_operation == BTRFS_EXCLOP_BALANCE_PAUSED, in fs/btrfs/ioctl.c:465 ------------[ cut here ]------------ kernel BUG at fs/btrfs/messages.c:259! RIP: 0010:btrfs_assertfail+0x2c/0x30 fs/btrfs/messages.c:259 Call Trace: <TASK> btrfs_exclop_balance fs/btrfs/ioctl.c:465 [inline] btrfs_ioctl_balance fs/btrfs/ioctl.c:3564 [inline] btrfs_ioctl+0x531e/0x5b30 fs/btrfs/ioctl.c:4632 vfs_ioctl fs/ioctl.c:51 [inline] __do_sys_ioctl

ext4: set goal start correctly in ext4_mb_normalize_request

In the Linux kernel, the following vulnerability has been resolved: ext4: set goal start correctly in ext4_mb_normalize_request We need to set ac_g_ex to notify the goal start used in ext4_mb_find_by_goal. Set ac_g_ex instead of ac_f_ex in ext4_mb_normalize_request. Besides we should assure goal start is in range [first_data_block, blocks_count) as ext4_mb_initialize_context does. [ Added a check to make sure size is less than ar->pright; otherwise we could end up passing an underflowed value of ar->pright - size to ext4_get_group_no_and_offset(), which will trigger a BUG_ON later on. - TYT ]

drm/msm/hdmi: Add missing check for alloc_ordered_workqueue

In the Linux kernel, the following vulnerability has been resolved: drm/msm/hdmi: Add missing check for alloc_ordered_workqueue Add check for the return value of alloc_ordered_workqueue as it may return NULL pointer and cause NULL pointer dereference in `hdmi_hdcp.c` and `hdmi_hpd.c`. Patchwork: https://patchwork.freedesktop.org/patch/517211/

powerpc/pseries: fix possible memory leak in ibmebus_bus_init()

In the Linux kernel, the following vulnerability has been resolved: powerpc/pseries: fix possible memory leak in ibmebus_bus_init() If device_register() returns error in ibmebus_bus_init(), name of kobject which is allocated in dev_set_name() called in device_add() is leaked. As comment of device_add() says, it should call put_device() to drop the reference count that was set in device_initialize() when it fails, so the name can be freed in kobject_cleanup().