Input: synaptics-rmi4 - bound the F54 report size to the allocated buffer
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - bound the F54 report size to the allocated buffer
rmi_f54_work() reads a diagnostics report from the device into
f54->report_data, sizing the transfer with rmi_f54_get_report_size():
report_size = rmi_f54_get_report_size(f54);
...
for (i = 0; i < report_size; i += F54_REPORT_DATA_SIZE) {
int size = min(F54_REPORT_DATA_SIZE, report_size - i);
...
rmi_read_block(.., f54->report_data + i, size);
}
report_data is allocated once at probe from F54's own electrode counts
(array3_size(f54->num_tx_electrodes, f54->num_rx_electrodes, sizeof(u16))),
Input: synaptics-rmi4 - block s_input when F54 queue is busy
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - block s_input when F54 queue is busy
Changing the input (diagnostic report type) mid-stream changes the
report size. Since V4L2 buffers are allocated based on the size at
stream start, changing the input while streaming could lead to a
heap buffer overflow if the new size is larger than the allocated
buffers.
Prevent this by blocking VIDIOC_S_INPUT with -EBUSY if the V4L2 queue
is busy (streaming).
Input: synaptics-rmi4 - propagate F54 worker errors to V4L2 queue
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - propagate F54 worker errors to V4L2 queue
Previously, rmi_f54_buffer_queue() waited for the worker thread to
finish but ignored whether it succeeded. If the worker failed (e.g.,
due to a timeout or register read failure), the queue thread would
silently return success, delivering stale or uninitialized memory to
userspace.
Add a 'report_error' field to struct f54_data to store the worker's exit
status. Check this field in rmi_f54_buffer_queue() after the worker
finishes, and mark the buffer as VB2_BUF_STATE_ERROR if an error
occurred.
crypto: qce - fix error path in devm_qce_register_algs
In the Linux kernel, the following vulnerability has been resolved:
crypto: qce - fix error path in devm_qce_register_algs
If ops->register_algs() fails, the error path repeatedly calls the same
ops->unregister_algs() from the failed registration. Use the loop index
to unregister the previously registered algorithms instead.
gpio: ml-ioh: use raw_spinlock_t for the register lock
In the Linux kernel, the following vulnerability has been resolved:
gpio: ml-ioh: use raw_spinlock_t for the register lock
ioh_irq_type() is registered as the irq_chip .irq_set_type callback and
takes chip->spinlock with spin_lock_irqsave(). This callback is reached
from __setup_irq() -> __irq_set_trigger() -> chip->irq_set_type() while
the caller holds desc->lock, a raw_spinlock_t, with hardirqs disabled.
That context is not sleepable, but on PREEMPT_RT a regular spinlock_t is
an rtmutex-backed sleeping lock, so acquiring it there is invalid.
ioh_irq_enable() and ioh_irq_disable() take the same lock from the
.irq_enable/.irq_disable callb
libceph: fix multiple unsafe decodes in decode_locker()
In the Linux kernel, the following vulnerability has been resolved:
libceph: fix multiple unsafe decodes in decode_locker()
decode_locker() in cls_lock_client.c contains three unsafe decode
operations that allow a malicious or compromised OSD to trigger
slab-out-of-bounds reads:
1. ceph_decode_copy() at the locker_id_t name field has no preceding
bounds check. With p == end after ceph_start_decoding() accepts
struct_len=0, this reads sizeof(ceph_entity_name) = 9 bytes past
the validated buffer boundary.
2. *p += sizeof(struct ceph_timespec) after the locker_info_t header
is an unchecked pointer advance. A malicious OSD can pos
openrisc: signal: do not restore privileged SR bits on sigreturn
In the Linux kernel, the following vulnerability has been resolved:
openrisc: signal: do not restore privileged SR bits on sigreturn
restore_sigcontext() copies the whole supervision register (SR) from the
signal frame and only clears SPR_SR_SM before the value is reloaded into
the hardware SR (through ESR and l.rfe) on the return to user space. All
other SR bits are left under user control.
An unprivileged task can thus return from a signal handler through a
crafted sigframe that clears SPR_SR_DME. With the data MMU disabled the
CPU performs no translation or protection on data accesses, so the task
gains read and write access to arbitr
In the Linux kernel, the following vulnerability has been resolved:
Input: sur40 - fix input device registration ordering
In sur40_probe(), input_register_device() was previously called early before
the V4L2 video device and vb2_queue components were fully initialized. If
userspace opened the input device immediately upon registration, sur40_open()
would trigger and start the sur40_poll() worker thread. This worker thread
invokes sur40_process_video() and accesses the uninitialized vb2_queue
structure, leading to a data race and potential system crash.
Furthermore, if V4L2 or video registration failed after input_register_device()
succeede
libceph: Avoid using invalid osd indices from primary_temp
In the Linux kernel, the following vulnerability has been resolved:
libceph: Avoid using invalid osd indices from primary_temp
A corrupted osdmap received from a Ceph monitor or OSD may contain osd
indices in its pg_temp, primary_temp, pg_upmap, and pg_upmap_items parts
that don't exist, i.e., that are greater than max_osd or smaller than
CEPH_HOMELESS_OSD (-1). These indices are used to create the up and
acting set in ceph_pg_to_up_acting_osds(), called from calc_target().
While most of these osd indices are checked, the one from primary_temp
is not. Subsequently, this may lead to calc_target() returning this
(potentially invalid) index as
libceph: fix OOB read in decode_watchers() via missing bounds check
In the Linux kernel, the following vulnerability has been resolved:
libceph: fix OOB read in decode_watchers() via missing bounds check
ceph_start_decoding() validates that struct_len bytes remain in the
buffer after the encoding header, but accepts struct_len=0 as valid:
ceph_decode_need(p, end, 0, bad) always passes. When a malicious or
compromised OSD sends an obj_list_watch_response_t reply with
struct_len=0, ceph_start_decoding() returns success with p == end,
leaving zero bytes guaranteed for subsequent reads.
The immediately following ceph_decode_32(p) in decode_watchers() has
no preceding bounds check. With p == end this is a 4-byt
mmc: atmel-mci: Fix use-after-free in atmci_remove due to race condition
In the Linux kernel, the following vulnerability has been resolved:
mmc: atmel-mci: Fix use-after-free in atmci_remove due to race condition
In atmci_probe, &host->bh_work is bound with atmci_work_func, and
atmci_interrupt, atmci_timeout_timer and atmci_dma_complete can all
queue this work on system_bh_wq.
If we remove the module, atmci_remove makes cleanup and the memory
allocated for host with devm_kzalloc() is released after the remove
callback returns, while the work mentioned above may still be pending
or running. The sequence of operations that may lead to a UAF bug is
as follows:
CPU0 CPU1
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Free all memory if cp_init() fails
The routine cp_free() is called to unpin/free any memory once an I/O
is completed successfully, or if cp_prefetch() fails. But if cp_init()
fails, and cp->initialized is not enabled, the same routine cannot be
used to free all the memory.
An attempt to address this exists in ccwchain_handle_ccw(), where a
single call to ccwchain_free() is made for the currently-processed
CCW segment. But this will leak other segments (created as a result
of a Transfer in Channel) that had been allocated as part of the same
channel program.
s390/vfio_ccw: Limit the number of channel program segments
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Limit the number of channel program segments
The processing of channel programs, and the CCWs within them, is done
recursively. As such, there is an arbitrary (but not architectural)
limit to the number of CCWs that can exist in a single channel program.
The vfio-ccw logic breaks these channel programs into segments whenever
it encounters a Transfer-In-Channel (TIC) CCW, and the combined number
of segments count towards the global limit. Impose an equivalent limit
to the number of segments until such logic can be made non-recursive.
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Cancel existing workqueues
The initialization of the io_work and crw_work workqueues begs the
question of whether they should be un-initialized. Add the corresponding
cleanup tags in _release_dev to ensure work isn't dispatched after
the private struct is free'd.
s390/vfio_ccw: Ensure index for read/write regions are within range
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Ensure index for read/write regions are within range
The introduction of the capability chain rightly clamped the
region indexes to the range of the capabilities itself, but
neglected to do so for the existing read/write regions which
should also be enforced.
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Ensure first IDAW remains constant
The first IDAW in a list does not need to be on a 2K/4K boundary
like all others, and so is read separately to accurately calculate
the size of the buffer needed to read the full IDAL.
Verify that the address found in the first IDAW is unchanged between
reads, to ensure a consistent set of IDAWs being worked with.
s390/vfio_ccw: Fix out of bounds check on CCW array
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Fix out of bounds check on CCW array
The routine ccwchain_calc_length() counts the number of channel
command words (CCWs) that are chained together in a single channel
program, and rejects anything larger than CCWCHAIN_LEN_MAX (256) CCWs.
The loop itself is "do..while (count < 257)", and while the logic in
is_cpa_within_range() correctly adjusts between the 0-index array of
CCWs and the count of CCWs starting at 1, this means it would look
at a possible 257th CCW before ending the loop and (correctly)
returning an error.
Fix this by restructuring the loop t
In the Linux kernel, the following vulnerability has been resolved:
s390/vfio_ccw: Selectively expand io_mutex
The io_mutex was defined to serialize the io_regions, but then has
also sort of been associated with the I/O themselves because of
the close relationship they share.
With the handful of races that are possible, the choices are either to:
A) expand the scope of io_mutex to close these remaining windows, or
B) reduce the scope of io_mutex to just io_region, and introduce a new
lock mechanism for the remaining I/O resources
This patch implements A, since B brings with it a lot more interactions
that would need to be tracked an
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: validate GEM_CREATE domain combinations
AMDGPU_GEM_CREATE checked domain bits against AMDGPU_GEM_DOMAIN_MASK,
but did not validate domain combinations. Userspace could combine
CPU|GTT|VRAM with DOORBELL, GDS, GWS, or OA, making
amdgpu_bo_placement_from_domain() exceed AMDGPU_BO_MAX_PLACEMENTS and
hit BUG_ON().
Allow combinations only within CPU/GTT/VRAM, and require non-CPU/GTT/
VRAM domains to be specified one at a time. Return -EINVAL for invalid
combinations in amdgpu_gem_create_ioctl().
v2: Rename helper from amdgpu_gem_domain_valid() to
amdgpu_gem_are
drm/amdgpu: Fix UVD decode image min size calculation
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Fix UVD decode image min size calculation
This needs to use pitch instead of width. Also reject pitch
over 4096 to avoid overflow.
(cherry picked from commit b41c8cb12e202b220353332ab87dc01a11f69304)