net: mctp i3c: clean up notifier and buses if driver register fails
In the Linux kernel, the following vulnerability has been resolved:
net: mctp i3c: clean up notifier and buses if driver register fails
mctp_i3c_mod_init() registers the I3C bus notifier and then walks the
existing buses with i3c_for_each_bus_locked(mctp_i3c_bus_add_new, NULL)
before registering the I3C device driver. If i3c_driver_register()
fails, the function returns the error directly, leaving the notifier
registered and every mctp_i3c_bus object created for the existing buses
allocated. The notifier is left pointing into the module that failed to
load and the bus list is leaked.
Mirror the module exit path on this failure: unregiste
tipc: fix infinite loop in __tipc_nl_compat_dumpit
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix infinite loop in __tipc_nl_compat_dumpit
cmd->dumpit callback can return a negative errno, causing an infinite
loop due to the while(len) condition. As the loop never terminates,
genl_mutex is never released, and other tasks waiting on it starve in D
state.
Check dumpit's return value, propagate it and jump to err_out on error.
cifs: fix cifsFileInfo leak on kmalloc failure in deferred close drain paths
In the Linux kernel, the following vulnerability has been resolved:
cifs: fix cifsFileInfo leak on kmalloc failure in deferred close drain paths
In cifs_close_deferred_file(), cifs_close_all_deferred_files(), and
cifs_close_deferred_file_under_dentry(), when a pending deferred close
is cancelled via cancel_delayed_work(), the subsequent kmalloc_obj() to
add the file to the local processing list may fail under memory pressure.
The loop breaks immediately, but the cancelled work is no longer pending
(it would have called _cifsFileInfo_put()), and the cfile is never added
to file_head for processing. The cifsFileInfo reference and the open
se
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: guard HE capability lookups
mt7915_mcu_bss_he_tlv() and mt7915_mcu_sta_bfer_tlv() both run after
checking HE support, then dereference the HE PHY capability returned by
mt76_connac_get_he_phy_cap(). That helper can return NULL when no
capability entry matches the vif type.
Fetch the capability before appending the TLV and skip the HE-specific
setup when no matching capability is available.
wifi: mt76: connac: fix possible NULL-pointer deref in mt76_connac_mcu_uni_bss_he_tlv()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: connac: fix possible NULL-pointer deref in mt76_connac_mcu_uni_bss_he_tlv()
mt76_connac_get_he_phy_cap routine can theoretically return NULL so
check cap pointer before dereferencing it.
wifi: mt76: mt7996: check pointer returned by mt76_connac_get_he_phy_cap()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: check pointer returned by mt76_connac_get_he_phy_cap()
mt76_connac_get_he_phy_cap routine can theoretically return NULL so
check cap pointer before dereferencing it.
wifi: mt76: mt7996: fix possible NULL-pointer deref in mt7996_mcu_sta_bfer_eht()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: fix possible NULL-pointer deref in mt7996_mcu_sta_bfer_eht()
mt76_connac_get_eht_phy_cap routine can theoretically return NULL so
check cap pointer before dereferencing it.
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: fix 802.1X-SHA256 call trace warning
Based on wpa_auth as 1x_256 mode, need to set up
"use_fwsup" with BRCMF_PROFILE_FWSUP_1X.
Or it will happen trace warning when call brcmf_cfg80211_set_pmk().
[ 4481.831101] ------------[ cut here ]------------
[ 4481.831102] WARNING: CPU: 1 PID: 2997 at
drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c:7242 brcmf_cfg80211_set_pmk+0x77/0xd0 [brcmfmac]
[...]
[ 4481.831202] Call Trace:
[ 4481.831204] <TASK>
[ 4481.831205] nl80211_set_pmk+0x183/0x250 [cfg80211]
[ 4481.831233] genl_family_rcv_msg_doit+0xea/0x150
In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: hvs/v3d: Fix null dereference in unbind
The hvs and v3d drivers use dev_get_drvdata(master) in their unbind
functions. Since the vc4-drm gets removed before its dependent drivers
(vc4_hvs/vc4_v3d) the vc4_hvs_unbind/vc4_v3d_unbind functions try to
get drvdata of its master and fails with a null dereference error.
Use the data pointer passed to the unbind functions directly instead of
dev_get_drvdata(master). This avoids using potentially freed memory.
In the Linux kernel, the following vulnerability has been resolved:
amt: re-read skb header pointers after every pull
Several AMT receive and transmit paths cache a pointer into the skb head
(ip_hdr(), ipv6_hdr(), eth_hdr() or the AMT message header) and then call
a helper that can reallocate that head before the cached pointer is used
again. pskb_may_pull(), ip_mc_may_pull(), ipv6_mc_may_pull(),
iptunnel_pull_header(), ip_mc_check_igmp() and ipv6_mc_check_mld() can all
free the old head and move the data, so a pointer taken before the call
dangles afterwards and the later access is a use-after-free of the freed
head.
The affected sites a
net: hsr: fix memory leak on slave unregistration by removing synced VLANs
In the Linux kernel, the following vulnerability has been resolved:
net: hsr: fix memory leak on slave unregistration by removing synced VLANs
When an HSR master device is brought UP, it auto-adds VLAN 0 via
vlan_vid0_add(), which propagates VID 0 to its slave devices (slave A and B).
If a slave device is later unregistered while HSR is active (e.g., during
netns cleanup or interface destruction), hsr_del_port() is called to
detach the slave port from the HSR master. However, hsr_del_port() currently
does not delete the VLAN IDs that were synced to the slave device by HSR.
As a result, the slave device retains a refcount on VID 0 (and any
sctp: auth: verify auth requirement when auth_chunk is NULL
In the Linux kernel, the following vulnerability has been resolved:
sctp: auth: verify auth requirement when auth_chunk is NULL
sctp_auth_chunk_verify() returns true unconditionally when
chunk->auth_chunk is NULL, silently skipping authentication.
This is incorrect when:
1. skb_clone() failed in the BH receive path, leaving auth_chunk
NULL. In sctp_endpoint_bh_rcv() asoc is NULL for new
connections, so the early sctp_auth_recv_cid() check cannot
catch this.
2. No AUTH chunk precedes COOKIE-ECHO, so skb_clone() is never
called and auth_chunk remains NULL.
Fix by checking sctp_auth_recv_cid() when auth_chunk is NULL:
if authent
vmxnet3: fix BUG_ON in vmxnet3_get_hdr_len() for Geneve packets
In the Linux kernel, the following vulnerability has been resolved:
vmxnet3: fix BUG_ON in vmxnet3_get_hdr_len() for Geneve packets
vmxnet3_get_hdr_len() assumes gdesc->rcd.v4/v6/tcp always describe the
outer header, but for a Geneve-encapsulated packet the device can set
them based on the inner header instead, signalled by the
VMXNET3_RCD_HDR_INNER_SHIFT bit in the completion descriptor. Since the
function never skips the outer encapsulation, this mismatch triggers:
- BUG_ON(hdr.ipv4->protocol != IPPROTO_TCP), because the outer
protocol is UDP (Geneve), not TCP.
- BUG_ON(hdr.eth->h_proto != ...), when the tunnel's outer and inner
IP v
tipc: fix u16 MTU truncation in media and bearer MTU validation
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix u16 MTU truncation in media and bearer MTU validation
Both TIPC_NL_MEDIA_SET and TIPC_NL_BEARER_SET accept user-supplied
MTU values but only enforce a minimum bound, not a maximum. When a user
sets the MTU to a value exceeding U16_MAX (65535), it passes validation
but is silently truncated when assigned to u16 fields l->mtu and
l->advertised_mtu in tipc_link_create(). Values like 65536 (0x10000)
truncate to 0, causing a division by zero in tipc_link_set_queue_limits()
which computes TIPC_MAX_PUBL / (l->mtu / ITEM_SIZE). Other overflowing
values (e.g. 65537-131071)
net: qrtr: restrict socket creation to the initial network namespace
In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: restrict socket creation to the initial network namespace
QRTR keeps its entire port and node state in module-global variables
that are not partitioned per network namespace: qrtr_local_nid is a
single global node id (always 1) and qrtr_ports is a single global
xarray. qrtr_port_lookup() and qrtr_local_enqueue() operate on that
global state with no network-namespace check, and qrtr_create() places
no restriction on the namespace a socket is created in.
As a result an unprivileged process that creates an AF_QIPCRTR socket
in a separate network namespace, e.g. via
net/mlx5: Fix MCIA register buffer overflow on 32 dword reads
In the Linux kernel, the following vulnerability has been resolved:
net/mlx5: Fix MCIA register buffer overflow on 32 dword reads
The MCIA register can return up to 32 dwords (128 bytes) when the device
advertises the mcia_32dwords capability, but struct
mlx5_ifc_mcia_reg_bits only defines dword_0..11, leaving room for just
12 dwords (48 bytes) of data.
mlx5_query_mcia() clamps the read size to mlx5_mcia_max_bytes() and then
memcpy()s that many bytes out of the register, potentially reading past
the end of the 'out' buffer. On kernels built with FORTIFY_SOURCE this
is caught as a buffer overflow while reading the module EEPROM via
ethtool:
idpf: fix max_vport related crash on allocation error during init
In the Linux kernel, the following vulnerability has been resolved:
idpf: fix max_vport related crash on allocation error during init
Set adapter->max_vports only after successful allocation of vports, netdevs
and vport_config buffers. This fixes possible crashes on reset or rmmod,
following failed allocation on init
[ 305.981402] idpf 0000:83:00.0: enabling device (0100 -> 0102)
[ 305.994464] idpf 0000:83:00.0: Device HW Reset initiated
[ 320.416872] BUG: kernel NULL pointer dereference, address: 0000000000000000
[ 320.416918] #PF: supervisor read access in kernel mode
[ 320.416942] #PF: error_code(0x0000) - not-present page
[ 320.
rds: tcp: unregister sysctl before tearing down listen socket
In the Linux kernel, the following vulnerability has been resolved:
rds: tcp: unregister sysctl before tearing down listen socket
rds_tcp_exit_net() frees the per-netns RDS TCP listen socket via
rds_tcp_kill_sock() before unregistering the per-netns sysctl table. Since
rds_tcp_skbuf_handler() derives the netns from
rtn->rds_tcp_listen_sock->sk, a concurrent sysctl write can race with
netns teardown and dereference the freed socket/sk.
KASAN reports the race as:
BUG: KASAN: slab-use-after-free in rds_tcp_skbuf_handler+0x2aa/0x2e0
rds_tcp_skbuf_handler net/rds/tcp.c:721
proc_sys_call_handler fs/proc/proc_sys
tipc: fix integer overflow in tipc_recvmsg() and tipc_recvstream()
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix integer overflow in tipc_recvmsg() and tipc_recvstream()
In tipc_recvmsg(), the copy length is computed as:
copy = min_t(int, dlen - offset, buflen);
buflen is size_t but min_t(int, ...) casts it to int. When buflen
exceeds INT_MAX (e.g. 0xFFFFFFFF via io_uring provided buffers), it
wraps negative, wins the comparison, and the negative copy length
propagates to simple_copy_to_iter() where int-to-size_t promotion
makes it SIZE_MAX, triggering a WARN_ON. tipc_recvstream() has the
same pattern.
Kernel panic - not syncing: kernel: panic_on_warn set ...
RIP: 0
net: drop_monitor: fix info leak in NET_DM_ATTR_PAYLOAD
In the Linux kernel, the following vulnerability has been resolved:
net: drop_monitor: fix info leak in NET_DM_ATTR_PAYLOAD
net_dm_packet_report_fill() and net_dm_hw_packet_report_fill() open code
the NET_DM_ATTR_PAYLOAD attribute to avoid zeroing the packet payload
before overwriting it with skb_copy_bits().
skb_put() reserves nla_total_size(payload_len), i.e. the header plus the
NLA_ALIGN() padding, but only payload_len bytes are copied in. When
payload_len is not a multiple of 4 the 1-3 padding bytes are never
initialized and are leaked to user space inside the netlink message.
KMSAN confirms the leak for the software path when the pac