p PatchFirst

PatchFirst · Aktuelle Sicherheitslücken

Sicherheitslücken in openssl

In den letzten 30 Tagen veröffentlichte Sicherheitslücken für openssl: 0. Davon im KEV-Katalog: 0.

Sicherheitslücken filtern
Filter zurücksetzen

Sicherheitslücken: 29

  1. ALPINE-CVE-2019-1563

    Niedrig · CVSS 3.7Korrektur verfügbar

    ALPINE-CVE-2019-1563

    In situations where an attacker receives automated notification of the success or failure of a decryption attempt an attacker, after sending a very large number of messages to be decrypted, can recover a CMS/PKCS7 transported encryption key or decrypt any RSA encrypted message that was encrypted with the public RSA key, using a Bleichenbacher padding oracle attack. Applications are not affected if they use a certificate together with the private RSA key to the CMS_decrypt or PKCS7_decrypt functions to select the correct recipient info to decrypt. Fixed in OpenSSL 1.1.1d (Affected 1.1.1-1.1.1c). Fixed in OpenSSL 1.1.0l (Affected 1.1.0-1.1.0k).

    • Auf 1.0.2t-r0 aktualisieren
    Veröffentlicht Aktualisiert
  2. ALPINE-CVE-2019-1547

    Mittel · CVSS 4.7Korrektur verfügbar

    ALPINE-CVE-2019-1547

    Normally in OpenSSL EC groups always have a co-factor present and this is used in side channel resistant code paths. However, in some cases, it is possible to construct a group using explicit parameters (instead of using a named curve). In those cases it is possible that such a group does not have the cofactor present. This can occur even where all the parameters match a known named curve. If such a curve is used then OpenSSL falls back to non-side channel resistant code paths which may result in full key recovery during an ECDSA signature operation. In order to be vulnerable an attacker would have to have the ability to time the creation of

    • Auf 1.0.2t-r0 aktualisieren
    Veröffentlicht Aktualisiert
  3. ALPINE-CVE-2019-1559

    Mittel · CVSS 5.9Korrektur verfügbar

    ALPINE-CVE-2019-1559

    If an application encounters a fatal protocol error and then calls SSL_shutdown() twice (once to send a close_notify, and once to receive one) then OpenSSL can respond differently to the calling application if a 0 byte record is received with invalid padding compared to if a 0 byte record is received with an invalid MAC. If the application then behaves differently based on that in a way that is detectable to the remote peer, then this amounts to a padding oracle that could be used to decrypt data. In order for this to be exploitable "non-stitched" ciphersuites must be in use. Stitched ciphersuites are optimised implementations of certain comm

    • Auf 1.0.2r-r0 aktualisieren
    Veröffentlicht Aktualisiert
  4. ALPINE-CVE-2018-0734

    Mittel · CVSS 5.9Korrektur verfügbar

    ALPINE-CVE-2018-0734

    The OpenSSL DSA signature algorithm has been shown to be vulnerable to a timing side channel attack. An attacker could use variations in the signing algorithm to recover the private key. Fixed in OpenSSL 1.1.1a (Affected 1.1.1). Fixed in OpenSSL 1.1.0j (Affected 1.1.0-1.1.0i). Fixed in OpenSSL 1.0.2q (Affected 1.0.2-1.0.2p).

    • Auf 1.0.2q-r0 aktualisieren
    Veröffentlicht Aktualisiert
  5. ALPINE-CVE-2018-0732

    Hoch · CVSS 7.5Korrektur verfügbar

    ALPINE-CVE-2018-0732

    During key agreement in a TLS handshake using a DH(E) based ciphersuite a malicious server can send a very large prime value to the client. This will cause the client to spend an unreasonably long period of time generating a key for this prime resulting in a hang until the client has finished. This could be exploited in a Denial Of Service attack. Fixed in OpenSSL 1.1.0i-dev (Affected 1.1.0-1.1.0h). Fixed in OpenSSL 1.0.2p-dev (Affected 1.0.2-1.0.2o).

    • Auf 1.0.2o-r1 aktualisieren
    Veröffentlicht Aktualisiert
  6. ALPINE-CVE-2018-0737

    Mittel · CVSS 5.9Korrektur verfügbar

    ALPINE-CVE-2018-0737

    The OpenSSL RSA Key generation algorithm has been shown to be vulnerable to a cache timing side channel attack. An attacker with sufficient access to mount cache timing attacks during the RSA key generation process could recover the private key. Fixed in OpenSSL 1.1.0i-dev (Affected 1.1.0-1.1.0h). Fixed in OpenSSL 1.0.2p-dev (Affected 1.0.2b-1.0.2o).

    • Auf 1.0.2o-r1 aktualisieren
    Veröffentlicht Aktualisiert
  7. ALPINE-CVE-2018-0739

    Mittel · CVSS 6.5Korrektur verfügbar

    ALPINE-CVE-2018-0739

    Constructed ASN.1 types with a recursive definition (such as can be found in PKCS7) could eventually exceed the stack given malicious input with excessive recursion. This could result in a Denial Of Service attack. There are no such structures used within SSL/TLS that come from untrusted sources so this is considered safe. Fixed in OpenSSL 1.1.0h (Affected 1.1.0-1.1.0g). Fixed in OpenSSL 1.0.2o (Affected 1.0.2b-1.0.2n).

    • Auf 1.0.2o-r0 aktualisieren
    Veröffentlicht Aktualisiert
  8. ALPINE-CVE-2018-0733

    Mittel · CVSS 5.9Korrektur verfügbar

    ALPINE-CVE-2018-0733

    Because of an implementation bug the PA-RISC CRYPTO_memcmp function is effectively reduced to only comparing the least significant bit of each byte. This allows an attacker to forge messages that would be considered as authenticated in an amount of tries lower than that guaranteed by the security claims of the scheme. The module can only be compiled by the HP-UX assembler, so that only HP-UX PA-RISC targets are affected. Fixed in OpenSSL 1.1.0h (Affected 1.1.0-1.1.0g).

    • Auf 1.0.2o-r0 aktualisieren
    Veröffentlicht Aktualisiert
  9. ALPINE-CVE-2017-3738

    Mittel · CVSS 5.9Korrektur verfügbar

    ALPINE-CVE-2017-3738

    There is an overflow bug in the AVX2 Montgomery multiplication procedure used in exponentiation with 1024-bit moduli. No EC algorithms are affected. Analysis suggests that attacks against RSA and DSA as a result of this defect would be very difficult to perform and are not believed likely. Attacks against DH1024 are considered just feasible, because most of the work necessary to deduce information about a private key may be performed offline. The amount of resources required for such an attack would be significant. However, for an attack on TLS to be meaningful, the server would have to share the DH1024 private key among multiple clients, whi

    • Auf 1.0.2n-r0 aktualisieren
    Veröffentlicht Aktualisiert
  10. ALPINE-CVE-2017-3737

    Mittel · CVSS 5.9Korrektur verfügbar

    ALPINE-CVE-2017-3737

    OpenSSL 1.0.2 (starting from version 1.0.2b) introduced an "error state" mechanism. The intent was that if a fatal error occurred during a handshake then OpenSSL would move into the error state and would immediately fail if you attempted to continue the handshake. This works as designed for the explicit handshake functions (SSL_do_handshake(), SSL_accept() and SSL_connect()), however due to a bug it does not work correctly if SSL_read() or SSL_write() is called directly. In that scenario, if the handshake fails then a fatal error will be returned in the initial function call. If SSL_read()/SSL_write() is subsequently called by the application

    • Auf 1.0.2n-r0 aktualisieren
    Veröffentlicht Aktualisiert
  11. ALPINE-CVE-2017-3736

    Mittel · CVSS 6.5Korrektur verfügbar

    ALPINE-CVE-2017-3736

    There is a carry propagating bug in the x86_64 Montgomery squaring procedure in OpenSSL before 1.0.2m and 1.1.0 before 1.1.0g. No EC algorithms are affected. Analysis suggests that attacks against RSA and DSA as a result of this defect would be very difficult to perform and are not believed likely. Attacks against DH are considered just feasible (although very difficult) because most of the work necessary to deduce information about a private key may be performed offline. The amount of resources required for such an attack would be very significant and likely only accessible to a limited number of attackers. An attacker would additionally nee

    • Auf 1.0.2m-r0 aktualisieren
    Veröffentlicht Aktualisiert
  12. ALPINE-CVE-2017-3735

    Mittel · CVSS 5.3Korrektur verfügbar

    ALPINE-CVE-2017-3735

    While parsing an IPAddressFamily extension in an X.509 certificate, it is possible to do a one-byte overread. This would result in an incorrect text display of the certificate. This bug has been present since 2006 and is present in all versions of OpenSSL before 1.0.2m and 1.1.0g.

    • Auf 1.0.2m-r0 aktualisieren
    Veröffentlicht Aktualisiert
  13. ALPINE-CVE-2016-6303

    Kritisch · CVSS 9.8Korrektur verfügbar

    ALPINE-CVE-2016-6303

    Integer overflow in the MDC2_Update function in crypto/mdc2/mdc2dgst.c in OpenSSL before 1.1.0 allows remote attackers to cause a denial of service (out-of-bounds write and application crash) or possibly have unspecified other impact via unknown vectors.

    • Auf 1.0.2h-r3 aktualisieren
    Veröffentlicht Aktualisiert
  14. ALPINE-CVE-2016-2182

    Kritisch · CVSS 9.8Korrektur verfügbar

    ALPINE-CVE-2016-2182

    The BN_bn2dec function in crypto/bn/bn_print.c in OpenSSL before 1.1.0 does not properly validate division results, which allows remote attackers to cause a denial of service (out-of-bounds write and application crash) or possibly have unspecified other impact via unknown vectors.

    • Auf 1.0.2h-r3 aktualisieren
    Veröffentlicht Aktualisiert
  15. ALPINE-CVE-2016-2181

    Hoch · CVSS 7.5Korrektur verfügbar

    ALPINE-CVE-2016-2181

    The Anti-Replay feature in the DTLS implementation in OpenSSL before 1.1.0 mishandles early use of a new epoch number in conjunction with a large sequence number, which allows remote attackers to cause a denial of service (false-positive packet drops) via spoofed DTLS records, related to rec_layer_d1.c and ssl3_record.c.

    • Auf 1.0.2h-r4 aktualisieren
    Veröffentlicht Aktualisiert
  16. ALPINE-CVE-2016-2179

    Hoch · CVSS 7.5Korrektur verfügbar

    ALPINE-CVE-2016-2179

    The DTLS implementation in OpenSSL before 1.1.0 does not properly restrict the lifetime of queue entries associated with unused out-of-order messages, which allows remote attackers to cause a denial of service (memory consumption) by maintaining many crafted DTLS sessions simultaneously, related to d1_lib.c, statem_dtls.c, statem_lib.c, and statem_srvr.c.

    • Auf 1.0.2h-r3 aktualisieren
    Veröffentlicht Aktualisiert

Prüfen Sie Ihren Server

Gleichen Sie Ihren installierten Stack und seine Versionen mit den aktuellen Sicherheitsmeldungen ab.

Prüfen Sie Ihren Server →