crypto: atmel-ecc - reject hardware ECDH without a public key
In the Linux kernel, the following vulnerability has been resolved:
crypto: atmel-ecc - reject hardware ECDH without a public key
The hardware ECDH path in atmel_ecdh_compute_shared_secret() uses the
private key stored in the device. However, the public key is cached only
after atmel_ecdh_set_secret() successfully generated that private key
for the current tfm.
atmel_ecdh_generate_public_key() already rejects requests when no public
key is cached. Add the same check to atmel_ecdh_compute_shared_secret()
to prevent the device from using a private key that was not generated
for the current tfm.
crypto: atmel-sha204a - fix heap info leak on I2C transfer failure
In the Linux kernel, the following vulnerability has been resolved:
crypto: atmel-sha204a - fix heap info leak on I2C transfer failure
The nonblocking RNG path allocates a work_data structure to track the
state of an in-flight asynchronous I2C request. This pointer is stored
in rng->priv and later consumed by the read path once the transaction
completes.
If the underlying I2C transfer fails, the completion callback is invoked
with a non-zero status. In this case, the allocated work_data is not
usable for producing RNG output and must not remain associated with the
hwrng state.
Previously, the failure path only logged a warning but left th
crypto: sa2ul - stop probe if context pool creation fails
In the Linux kernel, the following vulnerability has been resolved:
crypto: sa2ul - stop probe if context pool creation fails
sa_ul_probe() calls sa_init_mem() to create the DMA pool used for
security context buffers, but ignores its return value. If pool creation
fails, probe still continues with DMA setup, algorithm registration and
child population even though later request setup depends on that pool.
Stop probing when sa_init_mem() fails, and route that failure to the PM
cleanup path without attempting to destroy an uncreated DMA pool.
crypto: rk3288 - fail ahash requests on HASH idle timeout
In the Linux kernel, the following vulnerability has been resolved:
crypto: rk3288 - fail ahash requests on HASH idle timeout
rk_hash_run() waits for RK_CRYPTO_HASH_STS to become idle after the
final DMA transfer, but ignores the poll result. If the hash engine
never becomes idle, the driver still reads the digest registers and
finalizes the request with the previous success value.
Store the poll result and finalize the request with the timeout error
before reading the digest registers.
crypto: keembay - Fix AEAD unregister count in error path
In the Linux kernel, the following vulnerability has been resolved:
crypto: keembay - Fix AEAD unregister count in error path
register_aes_algs() registers the AEAD algorithms before registering the
skcipher algorithms. If skcipher registration fails, the function unwinds
the earlier AEAD registration with crypto_engine_unregister_aeads(), but it
passes ARRAY_SIZE(algs), which is the skcipher table size.
Use ARRAY_SIZE(algs_aead) for the AEAD unwind path so the unregister helper
iterates over the same table that was registered. Also clarify the nearby
comment: the crypto registration helpers clean up algorithms registered
within the same
nvme-apple: Use acquire/release for queue enabled state
In the Linux kernel, the following vulnerability has been resolved:
nvme-apple: Use acquire/release for queue enabled state
apple_nvme_init_queue() initializes queue state and then marks the queue
enabled. The interrupt and request paths check enabled before using that
queue state.
The old wmb() after WRITE_ONCE(enabled, true) does not publish the
earlier initialization before enabled becomes visible. Use a release store
when enabling the queue and acquire loads when testing it.
Although the shutdown-side enabled accesses are not used for publishing
queue initialization, use helpers for them as well for consistency.
nvmet-rdma: fix response resource leak on queue teardown
In the Linux kernel, the following vulnerability has been resolved:
nvmet-rdma: fix response resource leak on queue teardown
When an nvme target with rdma transport is removed while I/Os are in
flight, a response can be posted but its send completion is never
delivered before the connection is torn down. As a result
nvmet_rdma_send_done() and nvmet_rdma_release_rsp() are never called for
the response, and this leaks the allocated RDMA read/write context and
request SGLs.
These leaks are recreated by running blktests nvme/061 with the rdma
transport and the siw driver. Kernel kmemleak feature reports them as
follows:
unreferenced object
In the Linux kernel, the following vulnerability has been resolved:
cgroup/cpuset: Make nr_deadline_tasks an atomic_t
The nr_deadline_tasks variable in the cpuset structure was introduced by
commit 6c24849f5515 ("sched/cpuset: Keep track of SCHED_DEADLINE task
in cpusets"). It is reported by sashiko [1] that nr_deadline_tasks
can currently be modified by inc_dl_tasks_cs() under rq->lock and
by cpuset_attach() under cpuset_mutex. So if both updates happen
simultaneously, the nr_deadline_tasks variable can be corrupted leading
to incorrect operations down the road.
Fix that by changing its type to atomic_t so that nr_deadline_tasks
are alway
wifi: mac80211_hwsim: avoid NULL skb in stop queue drain
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: avoid NULL skb in stop queue drain
mac80211_hwsim_stop() drops any frames left in data->pending. The loop
currently checks skb_queue_empty() and then dequeues separately.
That split is racy with TX status handling, which can remove a pending
frame under the queue lock. If the last entry is removed after the empty
check, skb_dequeue() returns NULL and the stop path passes that NULL skb
to ieee80211_free_txskb().
Use skb_dequeue() as the loop condition instead. The dequeue result is the
object that stop owns and frees, and a concurrent status completio
clk: qcom: gdsc: tear down per-domain genpds in gdsc_unregister()
In the Linux kernel, the following vulnerability has been resolved:
clk: qcom: gdsc: tear down per-domain genpds in gdsc_unregister()
gdsc_unregister() removes the OF provider entry and tears down the
parent/subdomain wiring, but never calls pm_genpd_remove() on the
individual generic_pm_domain structures registered by gdsc_init():
void gdsc_unregister(struct gdsc_desc *desc)
{
struct device *dev = desc->dev;
size_t num = desc->num;
gdsc_pm_subdomain_remove(desc, num);
of_genpd_del_provider(dev->of_node);
}
That leaves dangling entries on the global gpd_list. After a provider
unbind/rebind cycle (deferred-probe replay during e
thermal/drivers/rcar: Fix error checking in probe()
In the Linux kernel, the following vulnerability has been resolved:
thermal/drivers/rcar: Fix error checking in probe()
This code accidentally calls thermal_zone_device_enable() before checking
whether thermal_zone_device_register_with_trips() failed. Move the call
until later to avoid an error pointer dereference of "priv->zone".
The driver works differently depending on if we are using OF thermal or
not. We use thermal_add_hwmon_sysfs() if we are using OF thermal and
call thermal_zone_device_enable() if not. We can share same error check
for if either of these fail.
Moving the thermal_zone_device_enable() call is a bit cleaner as wel
usb: gadget: r8a66597: avoid double free of ep0_req in probe error path
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: r8a66597: avoid double free of ep0_req in probe error path
If usb_add_gadget_udc() fails, r8a66597_probe() jumps to err_add_udc
and frees ep0_req, then falls through to clean_up2 where ep0_req is
freed again when it is non-NULL.
Remove the redundant free from err_add_udc and keep the cleanup in
clean_up2 so the request is released exactly once.
Issue found using a prototype static analysis tool
and confirmed by code review.
udf: Mark LVID buffer as uptodate before marking it dirty
In the Linux kernel, the following vulnerability has been resolved:
udf: Mark LVID buffer as uptodate before marking it dirty
When an I/O error occurs while writing the Logical Volume Integrity
Descriptor (LVID) buffer to the block device, the block layer's completion
handler (`end_buffer_write_sync()`) clears the `BH_Uptodate` flag on the
buffer. However, the buffer still contains valid LVID data in memory. If
the filesystem is subsequently remounted read-write or synced,
`udf_open_lvid()` or `udf_sync_fs()` will modify the LVID buffer and call
`mark_buffer_dirty()`. This triggers a spurious
`WARN_ON_ONCE(!buffer_uptodate(bh))` warning in
bpf: Fix vmlinux BTF prep race in bpf_get_btf_vmlinux
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix vmlinux BTF prep race in bpf_get_btf_vmlinux
bpf_get_btf_vmlinux() lazily parses the vmlinux BTF under the
bpf_verifier_lock, but publishes the result through a plain store
and re-checks it through a plain lockless load. Nothing orders
the stores initializing the struct btf inside btf_parse_vmlinux()
against the store publishing the pointer: On a weakly ordered
arch, a concurrent first-time caller taking the lockless fast
path could in principle observe the pointer before the parsed
contents are visible. The mutex_unlock() does not help such a
reader given it only
bpf: Fix use-after-free on mm_struct in bpf_find_vma()
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix use-after-free on mm_struct in bpf_find_vma()
bpf_find_vma() reads task->mm and calls mmap_read_trylock(mm) without
holding a reference on the mm. On a foreign task, a concurrent exit_mm()
can free the mm_struct between the lockless read and the trylock,
resulting in a use-after-free. mm_struct is not SLAB_TYPESAFE_BY_RCU.
For the current task, task->mm is stable. For a foreign task, pin the mm
under task->alloc_lock and release it with mmput_async(), mirroring commit
d8e27d2d22b6 ("bpf: fix mm lifecycle in open-coded task_vma iterator").
Use spin_trylock() instea
bus: mhi: ep: Fix device refcount leak in the error path of MHI device creation
In the Linux kernel, the following vulnerability has been resolved:
bus: mhi: ep: Fix device refcount leak in the error path of MHI device creation
mhi_ep_create_device() takes one device reference for the UL channel and
another for the DL channel after allocating the transfer device. These
references are normally released by mhi_ep_destroy_device() before the
device itself is removed.
If dev_set_name() or device_add() fails, the error path currently drops
only one reference. The remaining channel references keep the device
from being released and leave the channels associated with a device that
was never registered.
Route both failures t
In the Linux kernel, the following vulnerability has been resolved:
printk: Fix possible console use-after-free
When emitting a record via legacy printing, it is possible that a handover
to another legacy printing context occurs. When a context has performed a
handover, the console SRCU read lock is released and the pointer to the
console struct might now be invalid. Therefore, after calling
nbcon_legacy_emit_next_record() or console_emit_next_record(), it is
necessary to check if a handover occurred _before_ further @con usage.
Sashiko pointed out that console_flush_one_record() was not doing this.
In console_flush_one_record(), after em
ACPI: RISC-V: Check acpi_get_handle() status in riscv_acpi_add_prt_dep()
In the Linux kernel, the following vulnerability has been resolved:
ACPI: RISC-V: Check acpi_get_handle() status in riscv_acpi_add_prt_dep()
In riscv_acpi_add_prt_dep(), the acpi_get_handle() call can fail which
would leave link_handle uninitialized.
Fix it by checking the acpi_get_handle() return status and skip the entry
if it fails.
In the Linux kernel, the following vulnerability has been resolved:
ACPI: RISC-V: Fix riscv_acpi_add_prt_dep() loop handling
The loop in riscv_acpi_add_prt_dep() includes error conditions that are
handled in a dubious - if not outright wrong - way, by continuining the
loop (which skips and misses the entry pointer update to point to the next
entry).
Rewrite the loop as a for loop (that handles the continuation correctly)
and wrap the condition and update statements using helper functions to make
it cleaner.
In the Linux kernel, the following vulnerability has been resolved:
platform/x86: dell-privacy: Fix race condition
Accessing priv->features_present needs to happen with the list mutex
being held, otherwise priv can be freed at any moment.